• Korean Journal of Materials Research
• /
• v.18 no.2
• /
• pp.84-91
• /
• 2008

The effects of the deposition and annealing temperature on the structural, electrical and optical properties of Ag doped ZnO (ZnO : Ag) thin films were investigated. All of the films were deposited with a 2wt% $Ag_2O-doped$ ZnO target using an e-beam evaporator. The substrate temperature varied from room temperature (RT) to $250^{\circ}C$. An undoped ZnO thin film was also fabricated at $150^{\circ}C$ as a reference. The as-grown films were annealed in temperatures ranging from 350 to $650^{\circ}C$ for 5 h in air. The Ag content in the film decreased as the deposition and the post-annealing temperature increased due to the evaporation of the Ag in the film. During the annealing process, grain growth occurred, as confirmed from XRD and SEM results. The as-grown film deposited at RT showed n-type conduction; however, the films deposited at higher temperatures showed p-type conduction. The films fabricated at $150^{\circ}C$ revealed the highest hole concentration of $3.98{\times}1019\;cm^{-3}$ and a resistivity of $0.347\;{\Omega}{\cdot}cm$. The RT PL spectra of the as-grown ZnO : Ag films exhibited very weak emission intensity compared to undoped ZnO; moreover, the emission intensities became stronger as the annealing temperature increased with two main emission bands of near band-edge UV and defect-related green luminescence exhibited. The film deposited at $150^{\circ}C$ and annealed at $350^{\circ}C$ exhibited the lowest value of $I_{vis}/I_{uv}$ of 0.05.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.443-443
• /
• 2012

We fabricated a-IGZO TFT with AZO/Ag/AZO transparent multilayer source/drain contacts by rf magnetron sputtering. Enhanced electrical device performance of a-IGZO TFT with AZO/Ag/AZO multilayer S/D electrodes (W/L = = 400/50 mm) was achieved with a subs-threshold swing of 3.78 V/dec, a minimum off-current of 10-12 A, a threshold voltage of 1.80 V, a field effect mobility of 10.86 cm2/Vs, and an on/off ration of 9x109. It demonstrated the potential application of the AZO/Ag/AZO film as a promising S/D contact material for the fabrication of the high performance TFTs.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1991.10a
• /
• pp.56-59
• /
• 1991

The polyervstalline $Cu_{0.28}Ag_{0.72}InSe_{4.4}S_{0.6}$ thin films are prepared by vacuum heat treatment of laver, which is deposited by direct resisting vacuum evaporation. From optical absorption spetra, the optical hand gap energy is determined to be 1.5[eV] at room temerature. From electrical method. hole concentration, resistivity and mobility are 9.3*$10^{18}$[$cm^{-3}$], 6*$10^{-2}$[$\Omega$$.$cm], 11.2[$\textrm{cm}^2$/V$.$sec] respectively at room temperature.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.9 no.2
• /
• pp.197-206
• /
• 1999

The stochiometric mixture of evaporating materials for the $AgInSe_2$single crystal thin films were prepared from horizontal furnace. Using extrapolation method of X-ray diffraction patterns for the $AgInSe_2$polycrystal, it was found tetragonal structure whose lattice constant $a_0$ and $C_0$ were 6.092 $\AA$ and 11.688 $\AA$, respectively. To obtain the single crystal thin films of AgInSe$_2$, the mixed crystal was deposited on thoroughly etched semi-insulator GaAs(100) substrate by HWE system. The source and substrate temperature were fixed to $610^{\circ}C$ and $450^{\circ}C$ respectively, and the thickness of the single thin films was obtained to 3.8 $\mu\textrm{m}$. The crystallization of single crystal thin films was investigated by the photoluminescence (PL) and double crystal X-ray dirrfaction (DCXD). The Hall effect was measured by the method of van der Pauw and carrier density and mobility dependence on temperature were studied. The carrier density and mobility of $AgInSe_2$single crystal thin films deduced from Hall data are $9.58{\times}10^{22} electron/m^3,\; 3.42{\times}10^{-2}m^2/V{\cdot}s$ at 293 K, respectively. From the photocurrent spectrum by illumination of perpendicular light on the c-axis of the $AgInSe_2$single crystal thin film, the spin orbit coupling $\Delta$So and the crystal field splitting $\Delta$Cr were obtained to 0.29 eV and 0.12 eV at 20 K respectively. From PL peaks measured at 20 K, 881.1 nm (1.4071 eV) and 882.4 nm (1.4051 eV) mean $E_x^U$ the upper polariton and $E_x^L$ the lower polariton of the free exciton $(E_x)$, also 884.1 nm (1.402 eV) express $I_2 peak of donor-bound exciton emission and 885.9 nm (1.3995 Ev) emerges $I_1$ peak of acceptor-bound exciton emission. In addition, the peak observed at 887.5 nm (1.3970 eV) was analyzed to be PL peak due to DAP.

• Electrical & Electronic Materials
• /
• v.7 no.2
• /
• pp.100-106
• /
• 1994

A bilayer film consisting of a layer of a-Se$_{75}$ Ge$_{25}$ with a surface layer of silver -100[.angs.] thick and a monolayer film of a-Se$_{75}$ Ge$_{25}$ are irradiated with 9[keV] Ga$^{+}$ ion beam. The Ga$^{+}$ ion (10$^{16}$ [ions/cm$^{2}$] exposed a-Se$_{75}$ Ge$_{25}$ and Ag/a-Se$_{75}$ Ge$_{25}$ thin films show an increase in optical absorption, and the absorption edge on irradiation with shifts toward longer wavelength. The shift toward longer wavelength called a "darkening effect" is observed also in film exposure to optical radiation(4.5*10$^{20}$ [photons/cm$^{2}$]). The 0.3[eV] edge shift for ion irradiation films is about twice to that obtained on irradiation with photons. These large changes are primarily due to structural changes, which lead to high etch selectivity and high sensitivity.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.08a
• /
• pp.237.2-237.2
• /
• 2013

ReRAM cell, also known as conductive bridging RAM (CBRAM), is a resistive switching memory based on non-volatile formation and dissolution of conductive filament in a solid electrolyte [1,2]. Especially, Chalcogenide-based ReRAM have become a promising candidate due to the simple structure, high density and low power operation than other types of ReRAM but the uniformity of switching parameter is undesirable. It is because diffusion of ions from anode to cathode in solid electrolyte layer is random [3]. That is to say, the formation of conductive filament is not go through the same paths in each switching cycle which is one of the major obstacles for performance improvement of ReRAM devices. Therefore, to control of nonuniform conductive filament formation is a key point to achieve a high performance ReRAM. In this paper, we demonstrated the enhanced repeatable bipolar resistive switching memory characteristics by spreading the Ag nanocrystals (Ag NCs) on amorphous GeSe layer compared to the conventional Ag/GeSe/Pt structure without Ag NCs. The Ag NCs and Ag top electrode act as a metal supply source of our devices. Excellent resistive switching memory characteristics were obtained and improvement of voltage distribution was achieved from the Al/Ag NCs/GeSe/Pt structure. At the same time, a stable DC endurance (>100 cycles) and an excellent data retention (>104 sec) properties was found from the Al/Ag NCs/GeSe/ Pt structured ReRAMs.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07b
• /
• pp.976-979
• /
• 2003

In this study, we formed the 2-dimensional holographic grating in order to mamufactured 2-dimensional photonic crystal in amorphous $As_{40}Ge_{10}Se_{15}S_{35}$ and $Ag/As_{40}Ge_{10}Se_{15}S_{35}$ thin film which have the excellent optical sensetivity using by He-Ne laser(632.8nm). The intensity of incident beam was 2.5mW and incident angle that $2{\theta}$ is $20^{\circ}$. We formed the holographic grating after had formed the 1-dimansional holographic grating and then rotate the sample. We confirmed that 2-dimensional holographic grating result of the figure of diffracted beam and AFM(Atomic Forced Microcopy) image.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.77-78
• /
• 2007

In this paper, we suppose that the 1-dimensional photonic crystal using holography lithography. We used Ag doped amorphous AsGeSeS which belongs in the chalcogenide materials have sensitive photoluminescence property. The purpose of this experiment is the process to complete 3-D photonic crystal after making 2-D photonic crystal. The lattice formation was made an observation by irradiating He-Ne laser with the AsGeSeS film leaned obliquely. Then, by measuring formed diffraction beam, the diffraction lattice was calculated.

• Proceedings of the KIEE Conference
• /
• 1992.07b
• /
• pp.843-846
• /
• 1992

This thesis was investigated on optical-and ion-induced characteristics in positive(a-$Se_{75}Ge_{25}$) and negative (Ag/a-$Se_{75}Ge_{25}$) resists for focused-ion-beam microlithogaphy. The a-$Se_{75}Ge_{25}$ inorganic thin film shows an increase in optical absorption after exposure to$\sim$$10^{16}$ dose(ions/$cm^{2}$) of Ga ions. The observed shift in the absorption edge toward longer wavelengths is consistent with that in films exposed to band-gap photons ($\sim$$10^{20}$ photons/$cm^{2}$). But, ion induced shift is twice as much as that in film exposed to optical radiation. This result may be related with microstructural rearrangements with in the short range of SeGe network. Due to changes in the short range order, the chemical bonding may be affected, which results in increased chemical dissolution in ion-induced film. Also, this resist exhibits good thermal stability because of its high Tg(~220$^{\circ}C$). The composition of deposited film measured by AES is consistent with that of bulk.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.353.1-353.1
• /
• 2016

다공성 물질은 동공의 크기에 따라 미세동공(Micropore), 메조동공(Mesopore), 거대동공(Macropore)으로 나누어 분류한다. 다공성 재료의 장점은 높은 비표면적으로써, 촉매, 센서, 연료전지 전극, 에너지 저장장치 등으로의 이용 가능성을 보여주는 연구가 활발히 보고되고 있다. 종래의 연구는 두 가지 이상의 원소로 구성된 박막을 제작한 후 전기화학적 분해법, 선택적 용해법 등 습식공정을 통해 다공성 구조체를 제작하였다. 하지만 본 연구에서는 Au, Ag 타겟과 $CH_4$ gas를 이용해 ICP-assisted reactive magnetron sputtering 장비를 활용하여 450 nm 두께의 Au-C, Ag-C 박막을 제작하였다. 이후 연속적으로 RF 250 W를 ICP antenna 에 인가하여 $O_2$ plasma dealloying 공정을 통해 탄소(Carbon) 만을 선택적으로 제거함으로써, 건식 공정만으로 Si wafer ($10{\times}10mm^2$) 기판 위에 250 ~ 300 nm 두께의 다공성 Au, Ag 박막을 제작하였다. SEM (Scanning Electron Microscopy)를 활용하여 표면, 단면 형상을 관찰해 다공성 구조를 확인하였으며, AES (Auger Electron Spectroscopy)를 통해 plasma dealloying 전 후 박막의 조성변화를 관찰하였다. 따라서 plasma dealloying 공정으로 제작된 다공성 Au, Ag 박막은 기존의 습식 공정 대비 청결하고 신속한 공정이 가능하며 높은 재현성을 통해 위의 적용분야에 보다 쉽게 사용될 수 있을 것으로 기대된다.