In this paper, we consider the H$_2$(or guaranteed cost control) and H$_{\infty}$ controller design methods for singular(or descriptor) systems with input time delay. Also, a mixed H$_2$and H$_{\infty}$ controller design algorithm is treated by combination of the proposed H$_2$and H$_{\infty}$ controller design method. The sufficient conditions for the existence of controllers and controller design methods are introduced at each Lemma and Theorem. Furthermore, we present optimization problems to get the upper bound of performance measures. The proposed methods are checked by examples.

Optical disk drive has excellent advantage of random accessibility of which performance is measured by access time. However, due to the increased rotational velocity of the disk and constraints of mechanical structure, two-stage seek algorithm which executes coarse and fine seeks sequentially has been adopted in most commercial optical disk drives. Although the laser spot is moved to a target track by a single seek operation, the limited operation range of the fine actuator restricts the application of the fine seek algorithm below a few hundreds of tracks. Especially, excessive movement of the objective lens causes a failure in generation of track-cross pulse and results in an unstable seek operation. In this paper, a new control algorithm for extending the fine seek range is proposed with an appropriate control structure. The coarse actuator is utilized to reduce the misalignment between the objective lens and the laser beam axis, and the fine actuator is controlled to follow the reference velocity trajectory. The proposed algorithm is applied to a CD-ROM drive to show its feasibility and some experimental results are presented.

This paper proposes a simple feedforward compensator in order to decrease the amount of undershoots and overshoots on the step response in nonminimum phase systems. The compensator makes the step type input be a ramp input with saturation for 0$\leq$t<${\alpha}$. It is shown in this paper that the compensated system has small amount of undershoot and overshoot at the price of rise time compared to the system without compensator. Also, provided the system is properly stable, the influence of the design parameter ${\alpha}$ on the step response of the nonminimum phase system is investigated in the case of Type A, and Type B undershoot, which gives a guideline for the compensator design.

An input constrained receding horizon predictive control algorithm for uncertain systems with nonzero set points is proposed. for constant nonzero set points, models with uncertainty can be converted into an augmented incremental system through the use of integrators and the problem is transformed into a zero-state regulation problem for the incremental system. But the original constraints on inputs are converted into constraints on the sum of control inputs at each time instants, which have not been dealt in earlier constrained robust receding horizon control problems. Recursive state bounding technique and worst case minimizing strategy developed in earlier works are applied to the augmented incremental system to yield an offset error free controller. The resulting algorithm is formulated so that it can be solved using LP.

This paper considers the problem of robust stabilization and disturbance attenuation for a class of uncertain singularly perturbed systems with norm-bounded nonlinear uncertainties. It is shown that the state feedback gain matrices can be determined to guarantee the stability of the closed-loop system for all $\varepsilon$$\in$(0, $\infty$). Based on this key result and some standard Riccati inequality approaches for robust control of singularly perturbed systems, a constructive design procedure is developed.

Q-learning is a kind of reinforcement learning where the agent solves the given task based on rewards received from the environment. Most research done in the field of Q-learning has focused on discrete domains, although the environment with which the agent must interact is generally continuous. Thus we need to devise some methods that enable Q-learning to be applicable to the continuous problem domain. In this paper, an extended fuzzy rule is proposed so that it can incorporate Q-learning. The interpolation technique, which is widely used in memory-based learning, is adopted to represent the appropriate Q value for current state and action pair in each extended fuzzy rule. The resulting structure based on the fuzzy inference system has the capability of solving the continuous state about the environment. The effectiveness of the proposed structure is shown through simulation on the cart-pole system.

In this papers, we derive a simple kinematic and dynamic formulation of an unmanned electric bicycle. We also check the controllability of the stabilization problem of bicycle. We propose a new control algorithm for the self stabilization of unmanned bicycle with bounded wheel speed and steering angle by using nonlinear control based on the sliding patch and stuck phenomena which was introduced by W. Ham. We also propose a sort of optimal control strategy for steering angle and driving wheel speed that make the length of bicycle\`s path be the shortest. From the computer simulation results, we prove the validity of the proposed control algorithm.

The software components of embedded control systems get extremely complex as they are designed into distributed systems get extremely complex as they are designed into distributed systems consisting of a large number of inexpensive microcontrollers interconnected by low-bandwidth real-time networks such as the controller area network (CAN). While recently emerging middleware technologies such as CORBA and DCOM address the complexity of distributed programming, they cannot be directly applied to distributed control system design due to their excessive resource demand and inadequate communication models. In this paper, we propose a CORBA-based middleware design for CAN-based distributed embedded control systems. Our design goal is to minimize its resource need and make it support group communication without losing the IDL (interface definition language) level compliance to the OMG standards. To achieve this, we develop a transport protocol on the CAN and a group communication scheme based on the well-known publisher/subscriber model. The protocol effectively realizes subject-based addressing and supports anonymous publisher/subscriber communication. We also customize the method invocation and message passing protocol, referred to as the general inter-ORB protocol (GIOP), of CORBA so that CORBA method invocations are efficiently serviced on a low-bandwidth network such as the CAN. This customization includes packed data encoding and variable-length integer encoding for compact representation of IDL data types. We have implemented our CORBA-based middleware on the mArx real-time operating system we have developed at Seoul National University. Our experiments clearly demonstrate that it is feasible to use CORBA in developing distributed embedded control systems possessing severe resource limitations. Our design clearly demonstrates that it is feasible to use a CORBA-based middleware in developing distributed embedded systems on real-time networks possessing severe resource limitations.

The advance of computer, network, and Internet technology enables the control systems to process the massive data in the distributed computing environments. To implement and maintain the software in distributed environment, the component-based methodology is widely used. This paper proposes the middleware architecture for the distributed computer control system. With the proposed middleware services, it is relatively easy to maintain compatibility between products and to implement a portable control application. To achieve the compatibility between heterogeneous systems, the proposed architecture provides the communication protocols based on the XML with lightweight event-based service.

Quick evaluations of two in-plane orbit maneuvers using small sets of real-time GPS navigation solutions were performed for the KOMPSAT-1 spacecraft operation. Real-time GPS navigation solutions of the KOMPSAT-1 were collected during the Korean Ground Station(KGS) pass. Only a few sets of position and velocity data after completion of the thruster firing were used for the quick maneuver evaluations. The results were used for antenna pointing data predictions for the next station contact. Normal orbit maneuver evaluations using large sets of playback GPS navigation solutions were also performed and the result were compared with the quick evaluation results.