Steel and Composite Structures

  • 제53권4호
  • /
  • Pages.421-434
  • /
  • 2024
  • /
  • 1229-9367(pISSN)
  • /
  • 1598-6233(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Experimental study on seismic performance of damaged steel concrete special-shaped beam-column joints reinforced by manually compacted ultra-high performance concrete

  • Hu Aoxiang (School of construction engineering, Shenzhen Polytechnic University) ;
  • Du Jing (School of construction engineering, Shenzhen Polytechnic University) ;
  • Song Xiaofang (School of Architecture and Art Design, Henan Geology Mineral College) ;
  • Liao Xi (School of construction engineering, Shenzhen Polytechnic University)
  • 투고 : 2024.07.19
  • 심사 : 2024.11.04
  • 발행 : 2024.11.25
⟨ 이전 논문 다음 논문 ⟩

초록

In order to study the seismic performance of the damaged steel concrete special-shaped beam-column joints reinforced by manually compacted ultra-high performance concrete (UHPC), cyclic hysteresis loading tests were carried on two profiled concrete beam-column joint specimens before and after the reinforcement. The failure mode, load carrying capacity, deformation, hysteresis curves, skeleton curves, strength degradation, stiffness degradation, and energy dissipation capacity of the specimens were compared before and after reinforcement. The results show that the bonding performance between UHPC material and ordinary concrete was very good. After UHPC reinforcement, the bearing capacity of the damaged joints can be basically restored to the intact state, and the energy-consuming capacity increased, but the stiffness degradation was obvious. It is recommended that when using UHPC for joint reinforcement, the effect of forming ring wrap in the joint area is better. The research conclusion can provide reference for the design and popularization of UHPC and has certain theoretical and practical value.

키워드

과제정보

The research described in this paper was financially supported by District Project of Post-doctoral Later Foundation Project of Shenzhen Polytechnic (No. 6022271001K) and Youth Science and Technology Innovation Project of Shenzhen Polytechnic (No. 6022310024K).

참고문헌

  1. Bai, G., Zhao, J. and Du, N. (2018), "Experimental study on seismic performance of joints in profiled steel and concrete shapes and design suggestions", J. Build. Struct., 39(7), 33-45. https://doi.org/10.14006/j.jzjgxb.2018.07.005.
  2. Cao, Z., Li, A. and Wang, Y. (2006), "Experimental study on beam-column joints strengthened by high-strength stranded wire mesh-polymer mortar composite facings for seismic reinforcement", Eng. Seism. Reinf. Retro., 36(8), 92-94.
  3. Gergely, J., Pantelides, C.P. and Reaveley, L.D. (2000), "Shear strengthening of RCT-joint using CFRP composite", J. Compos. Construct., 2(4), 56-64. https://doi.org/10.1061/(ASCE)1090-0268(2000)4:2(56).
  4. Ghobarah, A. and Said A. (2002), "Shear strengthening of beam-column joints", Eng. Struct., 24(7), 881-888. https://doi.org/10.1016/S0141-0296(02)00026-3.
  5. Huo, L., LI, H. and Xiao, S. (2009), "Investigation of earthquake damage of reinforced concrete frame structures in Wenchuan earthquake and its implications", J. Dalian Univ. Tech., 49(5), 718-723.
  6. Kang, J.Y., Park, J.S., Jung, W.T. and Keum, M.S. (2014), "Evaluation of the shear strength of perfobond rib connectors in ultra high performance concrete", Eng., 06(13), 989-999. https://doi.org/10.4236/eng.2014.613089.
  7. Kevin, M. and Zmetra, E. (2015), "Repair of corrosion damaged steel bridge girder ends by encasement in ultra-high strength concrete", Ph.D. Dissertation, University of Connecticut, Connecticut.
  8. Kruszewski, D., Wille, K. and Zaghi, A.E. (2018), "Design considerations for headed shear studs embedded in ultra-high performance concrete as part of a novel bridge repair method", J. Construct. Steel Res., 149, 180-194. https://doi.org/10.1016/j.jcsr.2018.07.015.
  9. Mcmullen, K.F. and Zaghi, A.E. (2022), "An accelerated repair method for steel girders with severe end corrosion damage", Eng. Struct., 251, 113493. https://doi.org/10.1016/j.engstruct.2021.113493.
  10. Patel, C.C. and Jangid, R.S. (2014), "Dynamic response of identical adjacent structures connected by viscous damper", Struct. Control Health Monit., 21(2), 205-224. https://doi.org/10.1002/stc.1566.
  11. Rahmdel, J.M., Vahdattalab, F., Shafei, E. and Zirakian, T. (2021), "Seismic response assessment of high-strength concrete frames strengthened with carbon fiber reinforced polymers", Struct. Eng. Mech., 2021(6), 735-744. https://doi.org/10.12989/sem.2021.77.6.735.
  12. Sharma, R. and Bansal, P.P. (2022), "Experimental investigation of initially damaged beam column joint retrofitted with reinforced UHP-HFRC overlay", J. Build. Eng., 49, 103973. https://doi.org/10.1016/j.jobe.2021.103973.
  13. Soni, D.P., Mistry, B.B., Jangid, R.S. and Panchal, V.R. (2011), "Seismic response of the double variable frequency pendulum isolator", Struct. Control Health Monit., 18(4), 450-470. https://doi.org/10.1002/stc.384.
  14. Sun, Z., Wang, D. and LI, H. (2010), "Seismic damage of reinforced concrete frames in the Wenchuan earthquake and post-earthquake repair proposals", J. Nat. Haz., 19(4), 114-123. https://doi.org/123. 10.13577/j.jnd.2010.0418.
  15. Wang, T, Chen, J. and Lin, X. (2023), "Investigation and analysis of housing damage in the Mw7.8 earthquake in Turkey", Disaster Prevention Expo, 2, 10-17.
  16. Weng, D., Zhang, C. and Xia, J. (2013), "Experimental study on reinforcement of seismically damaged frame joints with external steel plates", J. Civil Eng., 46(04), 36-45. https://doi.org/10.15951/j.tmgcxb.2013.04.013.
  17. Wu, B. and Wang, W. (2005), "Experimental study on seismic performance of reinforced concrete frame joints reinforced with carbon fiber fabric", J. Civil Eng., 38(4), 60-65.
  18. Wu, W. and Zheng, J. (2013), "Experimental study on seismic performance of self-compacting mixed experimental study on seismic performance of solid frame joints", Eng. Mech., 30(4), 89-96.
  19. Xin, L., Wang, T. and Zhang, L. (2007), "Experimental and theoretical study on hysteretic return performance of damaged square steel pipe concrete frames after reinforcement", Eng. Mech., S2,185-190.
  20. Yang, X., Dong, Y., Liu, X., Qiu, T. and Zhou, J. (2024), "Seismic behavior of concrete beam-column joints reinforced with steel-jacketed grouting", Build., 14(10), 3239. https://doi.org/10.3390/buildings14103239.
  21. Yu, Q. and LI, S. (2005), "Experimental analysis of frame joints strengthened by column enlarged section method", Indus. Build., 35(4), 43-47.
  22. Zhao, J.Q. (2018), "Research on seismic performance and design method of shaped joints of section steel and concrete frame row frame for nuclear power plant", Ph.D. Dissertation, Xi'an University of Architecture and Technology, Xi'an China.