DOI QR코드

DOI QR Code

Coagulant bath medium effect towards polylactic acid membranes structure and methylene blue dye removal

  • Amira M. Nasib (Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis) ;
  • Stephen Simon (Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis) ;
  • Syahmie M. Rasidi (Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis) ;
  • Siti Kartini E. Ab. Rahim (Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis) ;
  • Hoo Peng Yong (Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis) ;
  • Ng Qi Hwa (Faculty of Chemical Engineering & Technology, Universiti Malaysia Perlis) ;
  • Khairiraihanna Johari (Department of Chemical Engineering, Universiti Teknologi PETRONAS)
  • 투고 : 2023.08.18
  • 심사 : 2024.01.04
  • 발행 : 2024.06.25

초록

The asymmetric polylactic acid (PLA) membrane was prepared via phase inversion method using non-solvent induced separation (NIPS) technique. This study aims to synthesized as well as to characterize the PLA membrane and evaluating the membrane performance on water flux and permeability. In addition, this research also studied the removal performance of methylene blue dye. The polymer solution has been prepared using 12 wt.% of PLA and dissolved in 88 wt.% of Dimethylacetamide (DMAc) as a solvent. Then, the cast film was immersed in different ratio of coagulant bath medium (distilled water: methanol: ethanol) ranging from 100:0:0, 75:25:0, 75:0:25 and 75:12.5:12.5, respectively). Several characterizations were performed which include, membrane contact angle and membrane porosity. Performance PLA membranes were determined in terms of water flux and permeability at 1 bar transmembrane pressure using dead-end permeation cell. Finally, methylene blue (MB) removal efficiency was tested at the same transmembrane pressure. The findings revealed that the increase of alcohol concentration in coagulant bath resulted in higher porosity and lower contact angle. In short, MB dye rejection efficiency is also closely related to the amount of alcohol ratio used in coagulant baths. Increases in concentration of methanol and ethanol in coagulant bath medium increases the membrane porosity thus increased in efficiency of methylene blue rejection.

키워드

과제정보

The authors would like to acknowledge Frontiers Material Research, Centre of Excellence (FRONMATE), Faculty of Chemical Engineering Technology and Research, Management Centre (RMC) of Universiti Malaysia Perlis.

참고문헌

  1. Buahom, P. (2018), Measuring the Contact Angle Using ImageJ with Contact Angle Plug-In.
  2. Chequer, F.M.D., De Oliveira, G.A.R., Ferraz, E.R.A., Cardoso, J.N., Zanoni, M.V.B. and De Oliveira, D.P. (2013), Textile Dyes: Dyeing Process and Environmental Impact, TechOpen Limited, London, UK.
  3. Edokpayi, J.N., Odiyo, J.O. and Durowoju, O.S. (2017), "Impact of wastewater on surface water quality in developing countries: A case study of South Africa", Water Quality, 10(66561), 10-5772. https://doi.org/10.5772/66561.
  4. Hegab, H.M. and Zou, L. (2015), "Graphene oxide-assisted membranes: Fabrication and potential applications in desalination and water purification", J. Membr. Sci., 484, 95-106. https://doi.org/10.1016/j.memsci.2015.03.011.
  5. Hommel, J., Coltman, E. and Class, H. (2018), "Porosity-permeability relations for evolving pore space: A review with a focus on (Bio-) geochemically altered porous media", Transp. Porous Media, 124(2), 589-629. https://doi.org/10.1007/s11242-018-1086-2.
  6. Katheresan, V., Kansedo, J. and Yon Lau, S. (2018), "Efficiency of various recent wastewater dye removal methods: A review", J. Environ. Chem. Eng., 6(4), 4676-4697. https://doi.org/10.1016/j.jece.2018.06.060.
  7. Nasib, A.M., Hatim, I., Jullok, N. and Alamery, H.R. (2017), "Morphological properties of poly (vinylidene fluoride-co-tetrafluoroethylene membrane): Effect of solvents and polymer concentrations", Malay. J. Anal. Sci., 21(2), 356-364. https://doi.org/10.17576/mjas-2017-2102-10.
  8. Nikooe, N. and Saljoughi, E. (2017), "Preparation and characterization of novel PVDF nanofiltration membranes with hydrophilic property for filtration of dye aqueous solution", Appl. Surf. Sci., 413, 41-49. https://doi.org/10.1016/j.apsusc.2017.04.029.
  9. Nqombolo, A., Mpupa, A., Moutloali, R.M. and Nomngongo, P. (2018), "Wastewater treatment using membrane technology", TechOpen Limited, London, UK.
  10. Tang, Y., Sun, J., Li, S., Ran, Z. and Xiang, Y. (2019), "Effect of ethanol in the coagulation bath on the structure and performance of PVDF-g-PEGMA/PVDF membrane", J. Appl. Polym. Sci., 136(17), 47380. https://doi.org/10.1002/app.47380.
  11. Thurmer, M.B., Poletto, P., Marcolin, M., Duarte, J. and Zeni, M. (2012), "Effect of non-solvents used in the coagulation bath on morphology of PVDF membranes", Mater. Res., 15, 884-890. https://doi.org/10.1590/S1516-14392012005000115.
  12. Van Tran, T.T., Kumar, S.R. and Lue, S.J. (2019), "Separation mechanisms of binary dye mixtures using a PVDF ultrafiltration membrane: Donnan effect and intermolecular interaction", J. Membr. Sci., 575, 38-49. https://doi.org/10.1016/j.memsci.2018.12.070.
  13. Yaseen, D.A. and Scholz, M. (2019), "Textile dye wastewater characteristics and constituents of synthetic effluents: A critical review", Int. J. Environ. Sci. Technol., 16(2), 1193-1226. https://doi.org/10.1007/s13762-018-2130-z.
  14. Yu, H., Shangguan, S., Yang, H., Rong, H. and Qu, F. (2023), "Chemical cleaning and membrane aging of poly (vinylidene fluoride) (PVDF) membranes fabricated via non-solvent induced phase separation (NIPS) and thermally induced phase separation (TIPS)", Separ. Purif. Technol., 313, 123488. https://doi.org/10.1016/j.seppur.2023.123488.
  15. Zhu, L.J., Liu, F., Yu, X.M., Gao, A.L. and Xue, L.X. (2015), "Surface zwitterionization of hemocompatible poly (lactic acid) membranes for hemodiafiltration", J. Membr. Sci., 475, 469-479. https://doi.org/10.1016/j.memsci.2014.11.004.