DOI QR코드

DOI QR Code

Estimation Methods for the Roll Damping Ratio of Floating Structures

  • Hyun Jung Park (Department of Naval Architecture and Ocean Engineering, Pusan National University) ;
  • Yong Jae Jung (Department of Naval Architecture and Ocean Engineering, Pusan National University) ;
  • Kwang Hyo Jung (Department of Naval Architecture and Ocean Engineering, Pusan National University) ;
  • Sung Boo Park (Ship and Offshore Performance Research Center, Samsung Heavy Industries Co. Ltd) ;
  • Yong Ho Choi (Ship and Offshore Performance Research Center, Samsung Heavy Industries Co. Ltd) ;
  • Yun Suk Chung (Bureau Veritas Korea) ;
  • Seung Jae Lee (Division of Naval Architecture and Ocean Systems Engineering, Korea Maritime and Ocean University)
  • 투고 : 2024.10.04
  • 심사 : 2024.10.31
  • 발행 : 2024.12.31

초록

This study compares four estimation methods for determining the roll damping ratio using a series of free roll decay tests conducted in a two-dimensional wave tank. Numerous studies have been performed to estimate the roll damping ratio of floating structures while considering nonlinear effects. In this work, a floating structure was tested at four initial roll angles to investigate the nonlinear behavior at large roll motions. The roll natural periods were determined using the Fast Fourier Transform and the peak-to-peak method applied to the time series of the free roll decay test. At initial roll angles below 10°, the roll damping ratios derived from the four methods exhibited similar results. However, at initial roll angles exceeding 10°, the results varied significantly across the methods, likely due to differences in their treatment of nonlinear viscous effects. This study examines the applicability of these methods for various initial roll angles and recommends the minimum roll angle and the number of rolling period required for accurate calculations from free roll decay tests. Further studies are needed to evaluate roll damping ratios for motions exceeding 10° while accounting for nonlinear viscous damping effects.

키워드

과제정보

This work was supported by the Korea Institute of Energy Technology Evaluation and Planning (KETEP) grant funded by the Korea government (MOTIE) (Project Number:20213030020200, Project Name: Development of fully-coupled aero-hydro-servo-elastic-soil analysis program for offshore wind turbine system), Regional Innovation Strategy (RIS) through the National Research Foundation of Korea (NRF) funded by the Ministry of Education (MOE) (2023RIS-007), New Renewable Energy Core Technology Development Project (RS-2024-00450063) and the Global Advanced Engineer Education Program for Future Ocean Structures (P0012646) funded by the Ministry of Trade, Industry and Energy.

참고문헌

  1. Baniela, S. I. (2008). Roll motion of a ship and the roll stabilising effect of bilge keels. Journal of Navigation, 61(4), 667–686. https://doi.org/10.1017/S0373463308004931
  2. Bassler, C., Reed, A., & Brown, A. J. (2010, June). A method to model large amplitude ship roll damping. In Proceedings of the 11th International Ship Stability Workshop (pp. 217–224).
  3. Beurea Veritas (BV). (2011). HydroSTAR for experts user manual. 
  4. Bureau Veritas. Bhattacharya, R. (1978). Dynamics of marine vehicles. John Wiley & Sons Inc.
  5. Chakrabarti, S. (2001). Empirical calculation of roll damping for ships and barges. Ocean Engineering, 28(7), 915–932. https://doi.org/10.1016/S0029-8018(00)00036-6
  6. Choi, Y.R., Kim, J.H & Kim, Y.S. (2005). An analysis of rolling performance for a barge-type FPSO. Journal of Ocean Engineering and Technology, 19(3), 25–30.
  7. Gu, Y., Sandy, D., & Evangelos B. (2015). A Study on the effects of bilge keels on roll damping coefficient. In Proceedings of the 12th International Conference on the Stability of Ships and Ocean Vehicles.
  8. Ikeda, Y., Himeno, Y., & Tanaka, N. (1978). A prediction method for ship roll damping. Report of Department of Naval Architecture University of Osaka Prefecture (p. 00405). 
  9. Inman, D. J. (2013). Engineering vibration (4th ed.). Pearson. 
  10. International Towing Tank Conference (ITTC). (2021). Estimation of roll damping (7.5-02-07-04.5). Proceedings of the 29th ITTC quality manual Reconmmended procedures and Guideline.
  11. Jiang, Y., Ding, Y., Sun, Y., Shao, Y., & Sun, L. (2020). Influence of bilge-keel configuration on ship roll damping and roll response in waves. Ocean Engineering, 216, 107539. https://doi.org/10.1016/j.oceaneng.2020.107539
  12. Jung, K. H., Chang, K. A., & Jo, H. J. (2006) Viscous effect on the roll motion of a rectangular structure. Journal of engineering mechanics,132(2), 190–200. https://doi.org/10.1061/(ASCE)0733-9399(2006)132:2(190)
  13. Jung, K. H., Park, S. B., Park, H. J., & Mohamed, A. H. (2022). Hydrodynamic characteristics of rectangular structure in various water depth. Proceeding of the 15th International Symposium on Practical Design of Ships and Other Floating Structures (PRADS 2022).
  14. Kim, M., Jung, K. H., Park, S., Suh, S. B., Park, I. R., Kim, J., & Kim, K. S. (2019a). Experimental study on viscous effect in roll and heave motions of a rectangular structure. Ocean Engineering, 171, 250–258. https://doi.org/10.1016/j.oceaneng.2018.11.004
  15. Kim, M. G., Jung, K. H., Park, S. B., Lee, G. N., Park, I. R., & Suh, S. B. (2019b). Study on roll motion characteristics of a rectangular floating structure in regular waves. Journal of Ocean Engineering and Technology, 33(2), 131–138. https://doi.org/10.26748/KSOE.2019.009
  16. Kim, N., Kim, Y, J., & Ha, Y. (2015). Experimental study of the free roll decay test for the evaluation of roll damping coefficients. Journal of the Society of Naval Architects of Korea, 52(6), 460–470. https://doi.org/10.3744/SNAK.2015.52.6.460
  17. Kim, Y., & Park, M. J. (2015). Identification of the nonlinear roll damping and restoring moment of a FPSO using Hilbert transform. Ocean Engineering, 109, 381–388. https://doi.org/10.1016/j.oceaneng.2015.09.019
  18. Lyons, R. G. (1997). Understanding digital signal processing, 3/E. Pearson Education India. 
  19. Park, B., Jung, D. W., Jung, J., Park, I., Cho, S. K., & Sung, H. G. (2019). Experimental study on estimation of roll damping for various midship sections. Journal of Ocean Engineering and Technology, 33(4), 322–329. https://doi.org/10.26748/KSOE.2019.004
  20. Piehl, H. (2017). Ship roll damping analysis [Doctoral dissertation, University of Duisburg-Essen].
  21. Sun, J., & Shao, M. (2019). Estimation of nonlinear roll damping by analytical approximation of experimental free-decay amplitudes. Journal of Ocean University of China, 18, 812–822. https://doi.org/10.1007/s11802-019-3912-8
  22. Zeraatgar, H., Asghari, M., & Bakhtiari-Nejad, F. (2010). A study of the roll motion by means of a free decay test. Journal of Offshore Mechanics and Arctic Engineering, 132(3), 031303. https://doi.org/10.1115/1.4000393