Geomechanics and Engineering

  • 제36권1호
  • /
  • Pages.71-81
  • /
  • 2024
  • /
  • 2005-307X(pISSN)
  • /
  • 2092-6219(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Assessment of pull-out behavior of tunnel-type anchorages under various joint conditions

  • Junyoung Ko (Department of Civil Engineering, Chungnam National University) ;
  • Hyunsung Lim (Department of Wind Power Business, Hanwha Corporation/E&C) ;
  • Seunghwan Seo (Department of Geotechnical Engineering Research, Korea Institute of Civil Engineering and Building Technology) ;
  • Moonkyung Chung (Department of Geotechnical Engineering Research, Korea Institute of Civil Engineering and Building Technology)
  • 투고 : 2023.05.15
  • 심사 : 2023.12.04
  • 발행 : 2024.01.10
⟨ 이전 논문 다음 논문 ⟩

초록

This study analyzes the pull-out behavior of tunnel-type anchorage under various joint conditions, including joint direction, spacing, and position, using a finite element analysis. The validity of the numerical model was evaluated by comparing the results with a small-scaled model test, and the results of the numerical analysis and the small-scaled model test agree very well. The parametric study evaluated the quantitative effects of each influencing factor, such as joint direction, spacing, and position, on the behavior of tunnel-type anchorage using pull-out resistance-displacement curves. The study found that joint direction had a significant effect on the behavior of tunnel-type anchorage, and the pull-out resistance decreased as the displacement level increased from 0.002L to 0.006L (L: anchorage length). It was confirmed that the reduction in pull-out resistance increased as the number of joints in contact with the anchorage body increased and the spacing between the joints decreased. The pull-out behavior of tunnel-type anchorage was thus shown to be significantly influenced by the position and spacing of the rock joints. In addition, it is found that the number of joints through which the anchorage passes, the wider the area where the plastic point occurs, which leads to a decrease in the resistance of the anchorage.

키워드

과제정보

This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIT) (No. NRF-2022R1C1C1011477). Also, this research was supported by a grant (21SCIP-B119947-06) from the Construction Technology Research Program funded by the Ministry of Land, Infrastructure and Transport of Korean government.

참고문헌

  1. Alawneh, A.S., Malkawi, A.I.H. and Al-Deeky, H. (1999), "Tension tests on smooth and rough model piles in dry sand", Can. Geotech. J., 36, 746-753. https://doi.org/10.1139/t98-104
  2. ASCE (1979), "Long span of suspension bridge: history and performance", Proceedings of the ASCE National Conventions, Boston, MA, USA.
  3. Aydan, O., Ebisu, S. and Komura, S. (1993) "Pull-out tests of rock anchors and their failure modes", In Assessment and Prevention of Failure Phenomena in Rock Engineering; CRC Press: Boca Raton, FL, USA.
  4. Dakeuchi, K.O. and Yoshida, Y.T. (1984), "Tunnel type anchorage", Construction report of Honshousikoku connection bridge, Research Report No. 22(11).
  5. Das, S., Halder, K. and Chakraborty, D. (2022), "Seismic bearing capacity of shallow embedded strip footing on rock slopes", Geomech. Eng., 30(2), 123-138. https://doi.org/10.12989/gae.2022.30.2.123.
  6. Deng, Y., Li, A., Chen, S. and Feng, D. (2018). "Serviceability assessment for long-span suspension bridge based on deflection measurements", Struct. Control Health Monit., 25(11), 1-23. https://doi.org/10.1002/stc.2254.
  7. Gwon, S.G. and Choi, D.H. (2018). "Static and dynamic analyses of a suspension bridge with three-dimensionally curved main cables using a continuum model", Eng. Struct., 161, 250-264, 2018. https:/doi.org/10.1016/j.engstruct.2018.01.062.
  8. Han, Y., Liu, X., Wei, N., Li, D., Deng, Z., Wu, X. and Liu, D. (2019). "A comprehensive review of the mechanical behavior of suspension bridge tunnel-type anchorage", Adv. Mater. Sci. Eng., 2019, 1-9. https://doi.org/10.1155/2019/3829281.
  9. Hong, E.S., Cho, G.C., Baak, S.H., Park, J.-H., Chung, M. and Lee, S.-W. (2014), "A numerical study on pull-out behavior of cavern-type rock anchorages", J. Korean Tunn. Undergr. Sp. Association, 16(6), 521-531. https://doi.org/10.9711/KTAJ.2014.16.6.521.
  10. Ilamparuthi, K., Dickin, E.A. and Muthukrisnaiah, K. (2002) "Experimental investigation of the uplift behaviour of circular plate anchors embedded in sand", Can. Geotech. J., 39, 648-664. https://doi.org/10.1139/t02-005
  11. Jaiswal, A. and Kumar, R. (2022), "Finite element analysis of granular column for various encasement conditions subjected to shear load", Geomech. Eng., 29(6), 645-655. https://doi.org/10.12989/gae.2022.29.6.645.
  12. Kanemitsu, H., Omachi, T. and Higuchi, K. (1980), "Calculation method of ultimated resisting pull strength of tunnel type of anchorage for suspension bridge", Honsi Technical Report, 5(16), 15-20.
  13. Karira, H., Kumar, A., Ali, T.H., Mangnejo, D.A. and Mangi, N. (2022), "A parametric study of settlement and load transfer mechanism of piled raft due to adjacent excavation using 3D finite element analysis", Geomech. Eng., 30(2), 169-185. https://doi.org/10.12989/gae.2022.30.2.169.
  14. Lei, J.Q., Zheng, M.Z. and Xu G.Y. (2012). Suspension Bridge Design, China Communication Press, Beijing, China.
  15. Lekidis, V., Tsakiri, M., Makra, K., Karakostas, C., Klimis, N. and Sous, I. (2005). "Evaluation of dynamic response and local soil effects of the Evripos cable-stayed bridge using multi-sensor monitoring systems", Eng. Geol., 79(1-2), 43-59. https://doi.org/10.1016/j.enggeo.2004.10.015.
  16. Li, J.P. and Li, Y.S. (2006). "Research on displacement of anchorage of suspension bridge", Ground Modification and Seismic Mitigation, Proceedings of the GeoShanghai Conference, Shanghai, China, June, GSP 152, 207-214.
  17. Lim, H., Seo, S., Lee, S. and Chung, M. (2020). "Analysis of the passive earth pressure on a gravity-type anchorage for a suspension bridge", Int. J. Geo. Eng., 11, 1-7. https://doi.org/10.1186/s40703-020-00120-5.
  18. Lim, H., Seo, S., Ko, J. and Chung, M. (2021). "Effect of joint characteristics and geometries on tunnel-type anchorage for suspension bridge", Appl. Sci., 11(24), 11688. https://doi.org/10.3390/app112411688.
  19. Lim, H., Seo, S., Ko, J. and Chung, M. (2022). "Influence of geometric factors on pull-out resistance of gravity-type anchorage for suspension bridge". Geomech. Eng., 31(6), 573-582. https://doi.org/10.12989/gae.2022.31.6.573.
  20. Park, J.W., Chung, S.T. and Cho, J.H. (2009), "The design of tunnel type anchorage in Ulsan Grand Bridge", Yooshin technical report, 16, 328-336
  21. Park, C.S., Park, J.H., Chung, M.K. and Oh, I.K. (2013), "A study for improvement of suspension bridge's tunnel anchorage design", Proceedings of Korean Society of Civil Engineering Annual Conference, City, Month.
  22. Park, C.S., Park, J.H. and Chung, M.K. (2014), "Recent study for improving the calculation method of ultimate pull-out resistance of tunnel anchorage", Proceedings of the Korean Geotechnical Society Spring National Conference, City, 3.
  23. PLAXIS. PLAXIS 3D Reference Manual; Bentley: Exton, PA, USA, 2022.
  24. Seo, S., Park, J., Lee, S. and Chung, M. (2018). "Analysis of pull-out behavior of tunnel-type anchorage for suspended bridge using 2-D model tests and numerical analysis", J. Korean Geotech. Soc., 34(10), 61-74. https://doi.org/10.7843/kgs.2018.34.10.61.
  25. Seo, S., Lim, H. and Chung, M. (2021). "Evaluation of failure mode of tunnel-type anchorage for a suspension bridge via scaled model tests and image processing", Geomech. Eng., 24(5), 457-470. https://doi.org/10.12989/gae.2021.24.5.457.
  26. Shanker, K., Basudhar, P.K. and Patra, N.R. (2007), "Uplift capacity of single piles: Predictions and performance", Geotech. Geol. Eng., 25, 151-161. https://doi.org/10.1007/s10706-006-9000-z.
  27. Yooshin Co., Ltd., (2009), Ulsan Grand Bridge and Access Road Private Proposal Project: Basic Design Report.
  28. Zhang, Q., Li, Y.J., Yu, M. W., Hu, H.H. and Hu, J.H. (2015), "Study of the rock foundation stability of the Aizhai suspension bridge over a deep canyon area in China", Eng. Geol., 198, 65-77. https://doi.org/10.1016/j.enggeo.2015.09.012.