Abstract
In complete denture fabrication, accurate preliminary impressions are crucial for obtaining an accurate final impression. However, it can be challenging in cases of atypical arch shapes. This case report compares diagnostic casts made with a stock tray and an intraoral scanner (IOS) in a patient with an atypical arch shape. A 58-year-old edentulous male patient with long, narrow, atypical arches was referred to the Oral and Maxillofacial Surgery department for complete denture fabrication. Compared to the diagnostic cast obtained using IOS with adequately captured anatomical parameters, the primary model obtained using a stock tray showed prominent overextended flanges on the labial and buccal sides of the maxillary arch and less prominent overextended flanges in the mandibular arch with pressure spots in the posterior palatal seal area. The custom tray fabricated from such a model required additional adjustment resulting in increased chair time during the final impression procedure.
총의치 제작 과정 중 정확한 최종인상을 얻기 위해서는 정확한 예비인상 채득이 선행되어야 한다. 본 증례에서는 비정형적인 악궁 형태를 가진 환자에서 기성 트레이 및 구강 스캐너로 채득하여 제작한 예비모형과 개인트레이를 비교하였다. 58세 남자 환자로 상, 하악 총의치 제작을 위해 본원 구강악안면외과에서 의뢰되었다. 상하악궁 모두 좁고 긴 형태로 비정형적인 형태를 보였다. 기성 트레이를 이용하여 채득한 예비모형은 구강 스캐너를 이용한 예비 모형에 비해 상악의 경우, 협측의 변연이 과연장되었고, 후방 구개 폐쇄 부위에서는 압박되어 있었다. 또한 하악에서도 과연장되었으나, 상악에 비하여 그 양이 많지 않았다. 그리고 구강 스캐너에 의해 채득된 예비모형은 기성 트레이로 채득된 예비 모형에 비해 저연장되었으나, 해부학적 지표는 충분히 인기되었다. 기성 트레이에 의해 제작된 개인 트레이는 IOS에 의해 제작된 개인 트레이에 비하여 구강 내 시적 시, 개인 트레이의 조정량이 많았고 진료 시간이 증가하였다. 본 증례를 통해 비정형적인 악궁을 가진 환자에게 3D 구강 스캐너로 인상을 채득하는 것이 대안이 될 수 있음을 보고하는 바이다.