DOI QR코드

DOI QR Code

Numerical investigation of turbulence models with emphasis on turbulent intensity at low Reynolds number flows

  • Musavir Bashir (School of Aerospace Engineering, Universiti Sains Malaysia, Engineering Campus) ;
  • Parvathy Rajendran (School of Aerospace Engineering, Universiti Sains Malaysia, Engineering Campus) ;
  • Ambareen Khan (School of Aerospace Engineering, Universiti Sains Malaysia, Engineering Campus) ;
  • Vijayanandh Raja (Department of Aeronautical Engineering, Kumaraguru College of Technology) ;
  • Sher Afghan Khan (Department of Mechanical Engineering, Faculty of Engineering, International Islamic University)
  • 투고 : 2022.06.22
  • 심사 : 2023.08.07
  • 발행 : 2023.07.25

초록

The primary goal of this research is to investigate flow separation phenomena using various turbulence models. Also investigated are the effects of free-stream turbulence intensity on the flow over a NACA 0018 airfoil. The flow field around a NACA 0018 airfoil has been numerically simulated using RANS at Reynolds numbers ranging from 100,000 to 200,000 and angles of attack (AoA) ranging from 0° to 18° with various inflow conditions. A parametric study is conducted over a range of chord Reynolds numbers for free-stream turbulence intensities from 0.1 % to 0.5 % to understand the effects of each parameter on the suction side laminar separation bubble. The results showed that increasing the free-stream turbulence intensity reduces the length of the separation bubble formed over the suction side of the airfoil, as well as the flow prediction accuracy of each model. These models were used to compare the modeling accuracy and processing time improvements. The K- SST performs well in this simulation for estimating lift coefficients, with only small deviations at larger angles of attack. However, a stall was not predicted by the transition k-kl-omega. When predicting the location of flow reattachment over the airfoil, the transition k-kl-omega model also made some over-predictions. The Cp plots showed that the model generated results more in line with the experimental findings.

키워드

과제정보

This research was funded by Universiti Sains Malaysia Bridging GRA Grant (304/PAERO/6316608). The authors confirm that the data supporting the findings of this study are available within the article. The authors declare no conflict of interest.

참고문헌

  1. Aftab, S.M.A., Mohd Rafie, A.S., Razak, N.A. and Ahmad, K.A. (2016), "Turbulence model selection for low reynolds number flows", PloS one, 11(4), e0153755. https://doi.org/10.1371/journal.pone.0153755. 
  2. Carmichael, B.H. (1981), Low Reynolds Number Airfoil Survey, Volume 1 (No. NASA-CR-165803-VOL1). 
  3. Choudhry, A., Arjomandi, M. and Kelso, R. (2015), "A study of long separation bubble on thick airfoils and its consequent effects", Int. J. Heat Fluid Flow, 52, 84-96. https://doi.org/10.1016/j.ijheatfluidflow.2014.12.001. 
  4. Drela, M. (1989), "XFOIL: An analysis and design system for low Reynolds number airfoils", Low Reynolds Number Aerodynamics, Springer. 
  5. Ferrero, A., Larocca, F. and Bernaschek, V. (2017), "Unstructured discretisation of a non-local transition model for turbomachinery flows", Adv. Aircraft Spacecraft Sci., 4(5), 555. https://doi.org/10.12989/aas.2017.4.5.555. 
  6. Gerakopulos, R., Boutilier, M.S. and Yarusevych, S. (2010), "Aerodynamic characterisation of a NACA 0018 airfoil at low Reynolds numbers", AIAA, 4629. https://doi.org/10.2514/6.2010-4629. 
  7. Ghasemi, E., McEligot, D.M., Nolan, K.P., Crepeau, J., Tokuhiro, A. and Budwig, R.S. (2013), "Entropy generation in a transitional boundary layer region under the influence of free-stream turbulence using transitional RANS models and DNS", Int. Commun. Heat Mass Transf., 41, 10-16. https://doi.org/10.1016/j.icheatmasstransfer.2012.11.005. 
  8. Herbert-Acero, J.F., Probst, O., Rivera-Solorio, C.I., Castillo-Villar, K.K. and Mendez-Diaz, S. (2015), "An extended assessment of fluid flow models for the prediction of two-dimensional steady-state airfoil aerodynamics", Math. Prob. Eng., 2015, Article ID 854308. https://doi.org/10.1155/2015/854308. 
  9. Istvan, M., Kurelek, J. and Yarusevych, S. (2016), "Effects of free-stream turbulence intensity on laminar separation bubbles", 46th AIAA Fluid Dynamics Conference, Washington D.C., June. 
  10. Jones, G., Santer, M. and Papadakis, G. (2018), "Control of low Reynolds number flow around an airfoil using periodic surface morphing: A numerical study", J. Fluid. Struct., 76, 95-115. https://doi.org/10.1016/j.jfluidstructs.2017.09.009. 
  11. Kamada, Y., Maeda, T., Murata, J. and Nishida, Y. (2016), "Effect of turbulent inflows on airfoil performance for a Horizontal Axis Wind Turbine at low Reynolds numbers (Part II: Dynamic pressure measurement)", Energy, 112, 574-587. https://doi.org/10.1016/j.energy.2016.06.126. 
  12. Kojima, R., Nonomura, T., Oyama, A. and Fujii, K. (2013), "Large-eddy simulation of low-Reynolds-number flow over thick and thin NACA airfoils", J. Aircraft, 50(1), 187-196. https://doi.org/10.2514/1.C031849. 
  13. Lachenal, X., Daynes, S. and Weaver, P.M. (2013), "Review of morphing concepts and materials for wind turbine blade applications", Wind Energy, 16(2), 283-307. https://doi.org/10.1002/we.531. 
  14. Menter, F.R., Kuntz, M. and Langtry, R. (2003), "Ten years of industrial experience with the SST turbulence model", Turbul. Heat Mass Transf., 4(1), 625-632. 
  15. Mueller, T.J. and DeLaurier, J.D. (2003), "Aerodynamics of small vehicles", Ann. Rev. Fluid Mech., 35(1), 89-111. https://doi.org/10.1146/annurev.fluid.35.101101.161102. 
  16. O'meara, M. and Mueller, T. (1987), "Laminar separation bubble characteristics on an airfoil at low Reynolds number", AIAA J., 25(8), 1033-1041. https://doi.org/10.2514/3.9739. 
  17. Rogowski, K., Hansen, M.O. and Maronski, R. (2018), "Steady and unsteady analysis of NACA 0018 airfoil in vertical-axis wind turbine", J. Theor. Appl. Mech., 56(1), 203-212. https://doi.org/10.15632/jtam-pl.56.1.203. 
  18. Rogowski, K., Krolak, G. and Bangga, G. (2021), "Numerical study on the aerodynamic characteristics of the NACA 0018 airfoil at low Reynolds number for darrieus wind turbines using the transition SST model", Proc., 9(3), 477. https://doi.org/10.3390/pr9030477. 
  19. Shen, X., Avital, E., Paul, G., Rezaienia, M.A., Wen, P. and Korakianitis, T. (2016), "Experimental study of surface curvature effects on aerodynamic performance of a low Reynolds number airfoil for use in small wind turbines", J. Renew. Sustain. Energy, 8(5), 053303. https://doi.org/10.1063/1.4963236. 
  20. Theofilis, V. and Sherwin, S.J. (2001), "Global instabilities in trailing-edge laminar separated flow on a NACA 0012 Airfoil", 15th ISABE (International Symposium on Airbreathing Engines), Bangalore, India, September. 
  21. Yarusevych, S., Sullivan, P.E. and Kawall, J.G. (2006), "Coherent structures in an airfoil boundary layer and wake at low Reynolds numbers", Phys. Fluid., 18(4), 044101. https://doi.org/10.1063/1.2187069. 
  22. Zhou, W., Ning, Z., Li, H. and Hu, H. (2017), "An experimental investigation on rotor-to-rotor interactions of small UAV", 35th AIAA Applied Aerodynamics Conference, Denver, Colorado, June.