DOI QR코드

DOI QR Code

온도에 따른 암석시편의 건조무게 특이점 분석

Dry Weight Singularity Analysis of Rock Specimen Depending on Temperature

  • Sukjoo Kim (Department of Civil Engineering, Gyeongbuk Provincial College)
  • 투고 : 2023.07.06
  • 심사 : 2023.08.10
  • 발행 : 2023.09.01

초록

한국산업표준(KS F)에는 건조된 흙과 암석의 무게를 측정하는 다양한 규정들이 있다. 그러나, 110±5℃ 또는 105±5℃로 건조 후 공기 중에서 건조무게를 측정하면 측정시간이 지속됨에 따라 무게가 감소 후 증가하는 무게 특이점이 나타난다. 본 연구에서는 울릉도 현무암질 암석을 40~110℃로 노건조 하였고, 0.0001g(0.1mg) 감도의 전자저울에 무게를 측정하여 무게 특이점을 찾았고, 나타난 무게 특이점을 이용하여 건조무게를 쉽게 결정할 수 있는 방법을 제시하였다. 온도에 따른 암석시편의 특이점을 다양하게 분석한 결과, 특이점은 40~110℃의 온도구간에서 모두 나타났고 가열온도가 높을수록 특이점의 무게가 작게 나타났다. 특별히, 무게 특이점이 지속되는 현상이 나타났고, 가열온도가 높을수록 특이점의 지속시간이 짧게 나타났다. 대류측정 실험의 결과에 의하면 특이점의 발생 원인은 가열된 암석이 공기와의 접촉에 의해 발생된 대류현상이 원인이라는 것을 알 수 있었다. 노건조된 암석의 무게 감소는 대류발생으로 인한 영향이 공기 중 수분 흡수의 영향보다 우세할 때 발생된다. 반대로 암석의 무게 증가는 공기 중 수분 흡수의 영향이 대류발생으로 인한 영향보다 우세할 때 발생된다.

The Korean Industrial Standards (KS F) have a various regulations for measuring the weight of dried soil and rock. However, if the dried weight is measured in air after drying at 110±5℃ or 105±5℃, a weight singularity occurs, in which the weight decreases and then increases as the measurement time continues. In this study, basaltic rock from Ulleung Island was oven dried at 40 to 110℃. The weight was measured on an electronic scale with a sensitivity of 0.0001g (0.1mg) to find weight singularities. A method to easily determine the dry weight using the weight singularities was presented. As a result of analyses of the singularity of rock specimen according to temperature, the singularities were appeared in the temperature range of 40 to 110℃, and the weight of the singularity was smaller as the heating temperature increased. In particular, the weight singularity duration appeared, and the duration of the singularity was shorter as the heating temperature increased. The results of the convection measurement experiment showed that the cause of the singularity is the convection phenomenon caused by the contact of the heated rock with the air. The weight decrease of oven dried rock occurs when the effect of convection is dominant over the effect of air moisture absorption. Conversely, the weight increase of rock occurs when the effect of air moisture absorption is dominant over the effect of convection.

키워드

참고문헌

  1. ASTM (2019), Standard test methods for laboratory determination of water (moisture) content of soil and rock by mass, D2216-19. ASTM International, West Conshohocken, PA, DOI:10.1520/D2216-19.
  2. Kim, S. J. (2022), A Experimental study of the weight increase of the oven dried weathered granite soil due to moisture absorbed during air exposure, The Journal of Engineering Geology, Vol. 32, No. 3, pp. 401~410 (In Korean). https://doi.org/10.9720/KSEG.2022.3.401
  3. Kim, S. J. (2023), Experimental study of the oven dried soil weight measurement using singularity analysis, Journal of the Korean Geo-Environmental Society, Vol. 24, No. 3, pp. 5~14 (In Korean). https://doi.org/10.26511/JKSET.24.5.9
  4. KS F 2104 (2018), Standard test method of organic matter contents in soils by ignition loss (In Korean).
  5. KS F 2301 (2020), Practice for preparing disturbed soil samples for soil testing (In Korean).
  6. KS F 2302 (2017), Standard test method for particle size distribution of soils (In Korean).
  7. KS F 2306 (2020), Standard test method for water content of soils (In Korean).
  8. KS F 2308 (2022), Test method for density of soil particles (In Korean).
  9. KS F 2324 (2022), Unified soil classification system (In Korean).
  10. KS F 2341 (2017), Standard method for wet preparation of soil samples for particle size analysis and determination of soil constants (In Korean).
  11. KS F 2503 (2019), Testing method for density and absorption of coarse aggregate (In Korean).
  12. KS F 2504 (2019), Testing method for density and absorption of fine aggregate (In Korean).
  13. KS F 2518 (2020), Standard test method for density and water absorption rate of natural stone (In Korean).
  14. KSRM (2006) Standard test method for absorption and bulk specific gravity of rock, Tunnel and Underground Space, Vol. 16, No. 2, pp. 99~100 (In Korean).
  15. Lee, S. K. and Lee, T. J. (2010), A new suggested method for determining solid weight of rock samples by weight monitoring during drying process, Journal of the Korean Society of Mineral and Energy Resources Engineers, Vol. 47, No. 2, pp. 183~190 (In Korean).