Structural Monitoring and Maintenance

  • 제10권2호
  • /
  • Pages.155-174
  • /
  • 2023
  • /
  • 2288-6605(pISSN)
  • /
  • 2288-6613(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Monitoring of bridge overlay using shrinkage-modified high performance concrete based on strain and moisture evolution

  • Yifeng Ling (Department of Qilu Transportation, Shandong University) ;
  • Gilson Lomboy (Department of Civil and Environmental Engineering, Rowan University) ;
  • Zhi Ge (Department of Qilu Transportation, Shandong University) ;
  • Kejin Wang (Department of Civil, Construction and Environmental Engineering, Iowa State University)
  • 투고 : 2022.05.05
  • 심사 : 2023.06.07
  • 발행 : 2023.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

High performance concrete (HPC) has been extensively used in thin overlay for repair purpose due to its excellent strength and durability. This paper presents an experiment, where the sensor-instrumented HPC overlays have been followed by dynamic strain and moisture content monitoring for 1 year, under normal traffic. The vibrating wire and soil moisture sensors were embedded in overlay before construction. Four given HPC mixes (2 original mixes and their shrinkage-modified mixes) were used for overlays to contrast the strain and moisture results. A calibration method to accurately measure the moisture content for a given concrete mixture using soil moisture sensor was established. The monitoring results indicated that the modified mixes performed much better than the original mixes in shrinkage cracking control. Weather condition and concrete maturity at early age greatly affected the strain in concrete. The strain in HPC overlay was primarily in longitudinal direction, leading to transverse cracks. Additionally, the most moisture loss in concrete occurred at early age. Its rate was very dependent on weather. After one year, cracking survey was carried out by vision to verify the strain direction and no cracks observed in shrinkage modified mixes.

키워드

과제정보

The present study is a part of a research project, Investigation into Shrinkage of High-Performance Concrete Used for Iowa Bridge Decks and Overlays - Phase II Shrinkage Control and Field Investigation, sponsored by the Iowa Department of Transportation. (IHRB Project TR-690).

참고문헌

  1. Afroughsabet, V. and Teng, S. (2020), "Experiments on drying shrinkage and creep of high performance hybrid-fiber-reinforced concrete", Cement Concrete Compos., 106. https://doi.org/10.1016/j.cemconcomp.2019.103481.
  2. Asbahan, R.E. (2009), "Effects of the built-in construction gradient and environmental conditions on jointed plain concrete pavements", Ph.D. thesis, University of Pittsburgh.
  3. ASTM (2017), Standard test method for length change of hardened hydraulic-cement mortar and concrete. ASTM C157. West Conshohocken, PA: ASTM.
  4. ASTM (2018), Standard test method for compressive strength of cylindrical concrete specimens. ASTM C39. West Conshohocken, PA: ASTM.
  5. ASTM (2019), Standard specification for chemical admixtures for concrete. ASTM C494. West Conshohocken, PA: ASTM.
  6. Bahrani, N., Blanc, J., Hornych, P. and Menant, F. (2020), "Alternate method of pavement assessment using geophones and accelerometers for measuring the pavement response", Infrastructures, 5(3), 25. https://doi.org/10.3390/infrastructures5030025.
  7. Barroca, N., Borges, L., Velez, F., Monteriro, F., Gorski, M. and Castro-Gomes, J. (2013), "Wireless sensor networks for temperature and humidity monitoring within concrete structures", Constr. Build. Mater., 40, 1156-1166. https://doi.org/10.1016/j.conbuildmat.2012.11.087.
  8. Buenfeld, N., Davis, R., Karmini, A. and Gilbertson, A. (2008), Intelligent monitoring of concrete structures, UK: CIRIA.
  9. Chung, H.W., Subgranon, T. and Tia, M. (2020), "Reducing cementitious paste volume of slipformed pavement concrete by blending aggregates", Int. J. Pavement Res. Technol., 13, 679-685. https://doi.org/10.1007/s42947-020-6002-9.
  10. Dong, W., Zhao, X., Zhou, X. and Yuan, W. (2019), "Effects of moisture gradient of concrete on fracture process in restrained concrete rings: Experimental and numerical", Eng. Fract. Mech., 208, 189-208. https://doi.org/10.1016/j.engfracmech.2019.01.011.
  11. Ghafoori, E., Hosseini, A., Al-Mahaidi, R., Zhao, X.L. and Motavalli, M. (2018), "Prestressed CFRP-strengthening and long-term wireless monitoring of an old roadway metallic bridge", Eng. Struct., 176, 585-605. https://doi.org/10.1016/j.engstruct.2018.09.042.
  12. Hansen, W. and Wei, Y. (2008), PCC pavement acceptance criteria for new construction when built-in curling exists. Research Report RC-1481. Michigan Department of Transportation, Lansing, MI.
  13. James, J. and John, E. (2020), The effectiveness of shrinkage reducing admixture and fly ash on plastic shrinkage of concrete, UK: CRC Press.
  14. Klausen, A. and Kanstad, T. (2021), "The effect of shrinkage reducing admixtures on drying shrinkage, autogenous deformation, and early age stress development of concrete", Struct. Concrete, 22, 596-606. https://doi.org/10.1002/suco.201900583.
  15. Ma, L., Zhao, Y. and Gong, J. (2018), "Restrained early-age shrinkage cracking properties of high-performance concrete containing fly ash and ground granulated blast-furnace slag", Constr. Build. Mater., 191, 1-12. https://doi.org/10.1016/j.conbuildmat.2018.09.154.
  16. Mccarter, W. aand Vennesland, O. (2004), "Sensor systems for use in reinforced concrete structures", Constr. Build. Mater., 18(6), 351-358. https://doi.org/10.1016/j.conbuildmat.2004.03.008.
  17. Min, H., Zhang, W. and Gu, X. (2018), "Effects of load damage on moisture transport and relative humidity response in concrete", Constr. Build. Mater., 169, 59-68. https://doi.org/10.1016/j.conbuildmat.2018.02.203.
  18. Nassiri, S. (2011), "Establishing permanent curl/warp temperature gradient in jointed plain concrete pavements", Ph.D. thesis, University of Pittsburgh.
  19. Ni, Y.Q., Hua, X.G., Fan, K.Q. and Ko, J.M. (2005), "Correlating modal properties with temperature using long-term monitoring data and support vector machine technique", Eng. Struct., 27(12), 1762-1773. https://doi.org/10.1016/j.engstruct.2005.02.020.
  20. Norris, A., Saafi, M. and Romine, P. (2008), "Temperature and moisture monitoring in concrete structures using embedded nanotechnology/microelectromechanical systems (MEMS) sensors", Constr. Build. Mater., 22(2), 111-120. https://doi.org/10.1016/j.conbuildmat.2006.05.047.
  21. Qin, Y. (2011), "Numerical study on the curling and warping of hardened rigid pavement slabs", Ph.D. thesis, Michigan Technological University.
  22. Rao, S. and Roesler, J. (2005), Characterization of effective built-in curling and concrete pavement cracking on the palmdale test sections. Pavement Research Center, Institute of Transportation Studies, University of California, Berkeley, CA.
  23. Ray, I., Gong, Z., Davalos, J.F. and Kar, A. (2012), "Shrinkage and cracking studies of high performance concrete for bridge decks", Constr. Build. Mater., 28(1), 244-254. https://doi.org/10.1016/j.conbuildmat.2011.08.066.
  24. Rice, J. (2014), Optimization of a pavement instrumentation plan for a full-scale test road: evaluation. Final report, Florida Department of Transportation, FL, BDV31-977-04.
  25. Shen, D., Jiang, J., Zhang, M. and Yao, P. (2018), "Tensile creep and cracking potential of high performance concrete internally cured with super absorbent polymers at early age", Constr. Build. Mater., 165, 451-461. https://doi.org/10.1016/j.conbuildmat.2017.12.136.
  26. Shen, D.J., Wang, W.T., Liu, J.W., Zhao, X.G. and Jiang, G.Q. (2018), "Influence of Barchip fiber on early-age cracking potential of high performance concrete under restrained condition", Constr. Build. Mater., 187, 118-130. https://doi.org/10.1016/j.conbuildmat.2018.07.121.
  27. Wang, K., Schlorholtz, S., Sritharan, S., Seneviratne, H., Wang, X. and Hou, Q. (2013), "Investigation into shrinkage of high-performance concrete used for iowa bridge decks and overlays", In Trans Project Reports, 22.
  28. Wei, Y. and Hansen, W. (2011), "Characterization of moisture transport and its effect on deformations in jointed plain concrete pavement", Transportation Research Record: J. Transport. Res. Board, 2240(1), 9-15. https://doi.org/10.3141/2240-02.
  29. Wells, S. (2005), "Early age response of jointed plain concrete pavements to environmental loads", Master. Thesis, University of Pittsburgh, PA.
  30. Wu, L., Farzadnia, N., Shi, C., Zhang, Z. and Wang, H. (2017), "Autogenous shrinkage of high performance concrete: A review", Constr. Build. Mater., 149, 62-75. https://doi.org/10.1016/j.conbuildmat.2017.05.064.
  31. Wu, X., Dong, Z., Sun, L. and Jia, T. (2022), "Experimental study of the volume drying shrinkage characteristics of lignite under low temperatures", ACS Omega, 7, 12. https://doi.org/10.1021/acsomega.1c05575.
  32. Yang, S., Shen, K., Ceylan, H., Kim, S., Qiao, d. and Gopalakrishnan, K. (2015), "Integration of a prototype wireless communication system with micro-electromechanical temperature and humidity sensor for concrete pavement health monitoring", Cogent Eng., 2, 1014278 http://dx.doi.org/10.1080/23311916.2015.1014278.
  33. Yuan, T.F., Kim, S.K., Koh, K.T. and Yoon, Y.S. (2018), "Synergistic benefits of using expansive and shrinkage reducing admixture on high-performance concrete", Materials, 11(12). https://doi.org/10.3390/ma11122514.