DOI QR코드

DOI QR Code

Application of probabilistic method to determination of aerodynamic force coefficients on tall buildings

  • Yong Chul Kim (Department of Engineering, Tokyo Polytechnic University) ;
  • Shuyang Cao (State Key Laboratory for Disaster Reduction in Civil Engineering, Tongji University)
  • 투고 : 2022.12.16
  • 심사 : 2023.04.07
  • 발행 : 2023.04.25

초록

Aerodynamic force coefficients are generally prescribed by an ensemble average of ten and/or twenty 10-minute samples. However, this makes it difficult to identify the exact probability distribution and exceedance probability of the prescribed values. In this study, 12,600 10-minute samples on three tall buildings were measured, and the probability distributions were first identified and the aerodynamic force coefficients corresponding to the specific non-exceedance probabilities (cumulative probabilities) of wind load were then evaluated. It was found that the probability distributions of the mean and fluctuating aerodynamic force coefficients followed a normal distribution. The ratios of aerodynamic force coefficients corresponding to the specific non-exceedance probabilities (Cf,Non) to the ensemble average of 12,600 samples (Cf,Ens), which was defined as an adjusting factor (Cf,Non/Cf,Ens), were less than 2%. The effect of coefficient of variation of wind speed on the adjusting factor is larger than that of the annual non-exceedance probability of wind load. The non-exceedance probabilities of the aerodynamic force coefficient is between PC,nonex = 50% and 60% regardless of force components and aspect ratios. The adjusting factors from the Gumbel distribution were larger than those from the normal distribution.

키워드

과제정보

This research was supported by the State Key Laboratory of Disaster Reduction in Civil Engineering, Tongji University (Project No. SLDRCE21-05). The authors gratefully acknowledge this support.

참고문헌

  1. Aboutabikh, M., Elshaer, A. and Aboshosha, H. (2022), "A low-cost expandable multi-channel pressure system for wind tunnels", Wind Struct., 35(5), 297-307, https://doi.org/10.12989/was.2022.35.5.297.
  2. Architectural Institute of Japan (2015), Recommendations for Loads on Buildings (2015), Tokyo, Architectural Institute of Japan.
  3. Cook, N.J. and Mayne, J.R. (1979), "A novel working approach to the assessment of wind loads for equivalent static design", J. Wind Eng. Ind. Aerod., 4, 149-164, https://doi.org/10.1016/0167-6105(79)90043-6.
  4. Cook, N.J. and Mayne, J.R. (1980), "A refined working approach to the assessment of wind loads for equivalent static design", J. Wind Eng. Ind. Aerod., 6, 125-137, https://doi.org/10.1016/0167-6105(80)90026-4.
  5. Gringorten, I.I. (1963), "A plotting rule for extreme probability", J Geophys. Res., 68, 813-814, https://doi.org/10.1029/JZ068i003p00813.
  6. Irpanni, H., Katsuchi, H. and Yamada, H. (2022), "Direct identification of aeroelastic force coefficients using forced vibration method", Wind Struct., 35(5), 323-336, https://doi.org/10.12989/was.2022.35.5.323.
  7. Kasperski, M. (2003), "Specification of wind load based on wind tunnel experiments", J. Wind Eng. Ind. Aerod., 91, 527-541, https://doi.org/10.1016/S0167-6105(02)00407-5.
  8. Kasperski, M. (2004), "Reliability and code level", Wind Struct., 4, 295-307, https://doi.org/10.12989/was.2005.8.4.295.
  9. Kasperski, M. (2009), "Specification of the design wind load - a critical review of code concepts", J. Wind Eng. Ind. Aerod., 97, 335-357, https://doi.org/10.1016/j.jweia.2009.05.002.
  10. Kim, Y. and Kanda, J. (2010), "Effects of taper and setback on wind force and wind-induced response of tall buildings", Wind Struct., 13(6), 499-517, https://doi.org/10.12989/was.2010.13.6.499.
  11. Kim, Y.C. and Kinoshita, T. (2023), "Evaluation of peak pressure coefficients on low-rise building based on probabilistic theory", J. Struct. Constr. Eng., 88(805), 395-402, https://doi.org/10.3130/aijs.88.395.
  12. Lo, Y.L. and Tseng, Y.F. (2017), "Interference effects on tail characteristics of extreme pressure value distributions", J. Wind Eng. Ind. Aerod., 170, 28-45, https://doi.org/10.1016/j.jweia.2017.08.011.
  13. Nowak, A.S. and Collins, K. (2013), Reliability of Structures, New York, CRC Press.
  14. Pal, S., Meena, R.K., Raj, R. and Li, M. (2021), "Wind tunnel study of a fish-plan shape model under different isolated wind incidences", Wind Struct., 33(5), 353-366, https://doi.org/10.12989/was.2021.33.5.353.
  15. Sanyal, P., Banerjee, S. and Dalui, S.K. (2022), "Prognosis of aerodynamic coefficients of butterfly plan shaped tall building by surrogate modelling", Wind Struct., 34(4), 321-334, https://doi.org/10.12989/was.2022.34.4.321.
  16. Simiu, E. and Scanlan, R.H. (1996), Winds Effects on Structures: Fundamentals and Applications to Design, New York, John Wiley & Sons.
  17. Tse, K.T., Chen, Z.-S., Lee, D.-E. and Kim, B. (2021), "Effect of aerodynamic modifications on the surface pressure patterns of buildings using proper orthogonal decomposition", Wind Struct., 32(3), 227-238, https://doi.org/10.12989/was.2021.32.3.227.
  18. Yang, F. and Niu, H., (2022), "Wind tunnel tests on wind loads acting on steel tubular transmission towers under skewed wind", Wind Struct., 35(2), 93-108, https://doi.org/10.12989/was.2022.35.2.093.
  19. Zhang, A., Zhang, S., Xu, X., Hui Y. and Piccardo, G. (2022), "Characteristics, mathematical modeling and conditional simulation of cross-wind layer forces on square section high-rise buildings", Wind Struct., 35(6), 369-383, https://doi.org/10.12989/was.2022.35.6.369.