Geomechanics and Engineering

  • 제33권1호
  • /
  • Pages.101-112
  • /
  • 2023
  • /
  • 2005-307X(pISSN)
  • /
  • 2092-6219(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Dynamic behavior of submerged floating tunnels at the shore connection considering the use of flexible joints

  • Seok-Jun Kang (Department of Civil and Environmental Engineering, Korea Institute of Science and Technology) ;
  • Minhyeong Lee (Disposal Performance Demonstration Research Division, Korea Atomic Energy Research Institute) ;
  • Jun-Beom An (Department of Civil and Environmental Engineering, Korea Institute of Science and Technology) ;
  • Dong-Hyuk Lee (Department of Civil and Environmental Engineering, Korea Institute of Science and Technology) ;
  • Gye-Chun Cho (Department of Civil and Environmental Engineering, Korea Institute of Science and Technology)
  • 투고 : 2022.10.27
  • 심사 : 2023.03.15
  • 발행 : 2023.04.25
⟨ 이전 논문 다음 논문 ⟩

초록

When a submerged floating tunnel is connected to the ground, there is a risk of stress concentration at the shore connection owing to the displacement imbalance caused by low confinement pressures in water and high confinement pressures in the ground. Here, the effects of the boundary condition and stiffness of the joints installed at the shore connection on the behaviors of a submerged floating tunnel and its shore connection were analyzed using a numerical method. The analysis results obtained with fixed and ground boundaries were similar due to the high stiffness of the ground boundary. However, the stability of the shore connection was found to be improved with the ground boundary as a small displacement was allowed at the boundary. The effect of the joint stiffness was evaluated by investigating the dynamic behavior of the submerged floating tunnel, the magnitude of the load acting on the bored tunnel, and the stress distribution at the shore connection. A lower joint stiffness was found to correspond to more effective relief of the stress concentration at the shore connection. However, it was confirmed that joints with low stiffness also increase the submerged floating tunnel displacement and decrease the frequency of the dynamic behavior, causing a risk of increased resonance when wave loads with low frequency are applied. Therefore, it is necessary to derive the optimal joint stiffness that can achieve both stress concentration relief and resonance prevention during the design of shore connections to secure their dynamic stability.

키워드

과제정보

The research described in this paper was financially supported by a National Research Foundation of Korea (NRF) grant funded by the Korean government (MSIT) (No. 2017R1A5A1014883).

참고문헌

  1. Chen, X., Chen, Z., Cai, S., Xu, W., Zhuo, X., Lv, J. and Zhao, J. (2020), "Numerical investigation of dynamic responses and mooring forces of submerged floating tunnel driven by surface waves", Sci. Rep. 10(1), 1-19. https://doi.org/10.1038/s41598-020-75907-8. 
  2. Cifuentes, C., Kim, S., Kim, M. and Park, W. (2015), "Numerical simulation of the coupled dynamic response of a submerged floating tunnel with mooring lines in regular waves", Ocean Syst. Eng., 5(2), 109-123. https://doi.org/10.12989/ose.2015.5.2.109. 
  3. Grant, A. (1986), "A submerged floating tunnel solution to a crossing for the Strait of Messina", Symposium on Strait Crossings, 353, 365. 
  4. Hardin, B.O. and Drnevich, V.P. (1972), "Shear modulus and damping in soils: design equations and curves", J. Soil Mech. Found. Div., 98(7), 667-692. https://doi.org/10.1061/jsfeaq.0001760. 
  5. Itasca, F.D. (2013), Fast lagrangian analysis of continua in 3 dimensions.
  6. Jakobsen, B. (2010), "Design of the submerged floating tunnel operating under various conditions", Procedia Eng., 4 71-79. https://doi.org/10.1016/j.proeng.2010.08.009. 
  7. Jiang, B., Liang, B. and Wu, S. (2018), "Feasibility study on the submerged floating tunnel in Qiongzhou strait, China", Pol. Marit. Res., https://doi.org/10.2478/pomr-2018-0066. 
  8. Jin, C. and Kim, M. (2017), "Dynamic and structural responses of a submerged floating tunnel under extreme wave conditions", Ocean Syst. Eng., 7(4), 413-433. https://doi.org/10.12989/ose.2017.7.4.413. 
  9. Jin, C. and Kim, M. (2021), "The effect of key design parameters on the global performance of submerged floating tunnel under target wave and earthquake excitations", Comput. Model. Eng. Sci., 128(1), 315-337. https://doi.org/10.32604/cmes.2021.016494. 
  10. Jin, R., Gou, Y., Geng, B., Zhang, H. and Liu, Y. (2020), "Coupled dynamic analysis for wave action on a tension leg-type submerged floating tunnel in time domain", Ocean Eng., 212, 107600. https://doi.org/10.1016/j.oceaneng.2020.107600. 
  11. Kang, S.J., Kim, J.T. and Cho, G.C. (2020), "Preliminary study on the ground behavior at shore connection of submerged floating tunnel using numerical analysis", Geomech. Eng., 21(2), 133-142. https://doi.org/10.12989/gae.2020.21.2.133. 
  12. Karabork, T., Deneme, I.O. and Bilgehan, R.P. (2014), "A comparison of the effect of SSI on base isolation systems and fixed-base structures for soft soil", Geomech. Eng., 7(1), 87-103. https://doi.org/ 10.12989/gae.2014.7.1.087. 
  13. Kuhlemeyer, R.L. and Lysmer, J. (1973), "Finite element method accuracy for wave propagation problems", J. Soil Mech. Found. Div., 99(5), 421-427. https://doi.org/10.1061/JSFEAQ.0001885. 
  14. Liang, P., Gao, Y., Zhou, Y., Zhu, C. and Sun, Y. (2020), "Solution for surrounding rock of strain-softening considering confining pressure-dependent Young's modulus and nonlinear dilatancy", Geomech. Eng., 22(4), 277-290. https://doi.org/10.12989/gae.2020.22.4.277. 
  15. Long, X., Ge, F. and Hong, Y. (2015), "Feasibility study on buoyancy-weight ratios of a submerged floating tunnel prototype subjected to hydrodynamic loads", Acta Mech. Sin., 31(5), 750-761. https://doi.org/10.1007/s10409-009-0233-y. 
  16. Long, X., Ge, F., Wang, L. and Hong, Y. (2009), "Effects of fundamental structure parameters on dynamic responses of submerged floating tunnel under hydrodynamic loads", Acta Mech. Sin., 25(3), 335-344. https://doi.org/10.1007/s10409-009-0233-y. 
  17. Martinelli, L., Barbella, G. and Feriani, A. (2010), "Modeling of Qiandao Lake submerged floating tunnel subject to multi-support seismic input", Procedia Eng., 4, 311-318.  https://doi.org/10.1016/j.proeng.2010.08.035
  18. Martire, G. (2010), The development of Submerged Floating Tunnels as an innovative solution for waterway crossings, Universita degli Studi di Napoli Federico II, Italy. 
  19. Mazzolani, F., Faggiano, B. and Martire, G. (2010), "Design aspects of the AB prototype in the Qiandao lake", Procedia Eng., 4, 21-33. https://doi.org/10.1016/j.proeng.2010.08.005. 
  20. Mazzolani, F.M., Landolfo, R., Faggiano, B. and Esposto, M. (2007), "A submerged floating tunnel (Archimedes bridge) prototype in the Qiandao lake (PR of China): research development and basic design", Costr. Met., 5, 45-63. 
  21. NPRA (2016), Bjornafjord Submerged Floating Tube Bridge: K3/K4 Technical Report. 
  22. Park, J., Kang, S.J., Hwang, H.J. and Cho, G.C. (2022), "Numerical study on the resonance behavior of submerged floating tunnels with elastic joint", Geomech. Eng., 29(3), 207-218. https://doi.org/10.12989/gae.2022.29.3.207. 
  23. Seed, H.B., Wong, R.T., Idriss, I. and Tokimatsu, K. (1986), "Moduli and damping factors for dynamic analyses of cohesionless soils, J. Geotech. Eng., 112(11), 1016-1032. https://doi.org/10.1061/(asce)0733-9410(1986)112:11(1016). 
  24. Won, D. and Kim, S. (2018), "Feasibility study of submerged floating tunnels moored by an inclined tendon system", Int. J. Steel Struct., 18(4), 1191-1199. https://doi.org/10.1007/s13296-018-0102-2. 
  25. Xiao, J. and Huang, G. (2010), "Transverse earthquake response and design analysis of submerged floating tunnels with various shore connections", Procedia Eng., 4, 233-242. https://doi.org/10.1016/j.proeng.2010.08.027. 
  26. Youshi, H. and Fei, G. (2010), "Dynamic response and structural integrity of submerged floating tunnel due to hydrodynamic load and accidental load", Procedia Eng., 4, 35-50. https://doi.org/10.1016/j.proeng.2010.08.006.