Journal of Power Electronics

  • 제22권6호
  • /
  • Pages.947-958
  • /
  • 2022
  • /
  • 1598-2092(pISSN)
  • /
  • 2093-4718(eISSN)
전력전자학회 (The Korean Institute of Power Electronics)
권호 표지
DOI QR코드

DOI QR Code

Fault detection and tolerant control for flying-capacitor modular multilevel converters feeding induction motor drives

  • 투고 : 2022.01.04
  • 심사 : 2022.03.29
  • 발행 : 2022.06.20
⟨ 이전 논문 다음 논문 ⟩

초록

In this paper, an IGBT open-circuit fault detection and fault-tolerant control strategy are proposed for a flying-capacitor modular multilevel converter (FC-MMC) feeding induction motor drives. Fault occurrence is detected by monitoring the sum of measured AC-circulating currents. In the fault case, the phase with the faulty device is identified through the errors between the measured and estimated output currents of the converter. In this phase, then, a localization of a faulty submodule (SM) is performed by investigating the SM capacitor voltages. Thereafter, the fault-tolerant control method is applied to reconfigure the converter structure, where the faulty SM is isolated and the converter can operate as normal. In addition, an SM capacitor voltage-balancing control scheme is proposed, where the number of current sensors is reduced to six from nine. Therefore, the system cost is lowered, and the communication burden is lightened. The viability of the proposed control scheme is confirmed by experimental results for an FC-MMC-fed induction motor drive system.

키워드

과제정보

This work was supported by the National Research Foundation of Korea (NRF) grant funded by the Korea government (MSIT) (No. 2021R1A2C2005996).

참고문헌

  1. Lesnicar, A., Marquardt, R.: An innovative modular multilevel converter topology suitable for a wide power range. In: 2003 IEEE Bologna PowerTech, vol. 3, pp. 272-277 (2003)
  2. Allebrod, S., Hamerski, R., Marquardt, R.: New transformerless, scalable modular multilevel converters for HVDC-transmission. In: Proc. IEEE PESC, pp. 174-179 (2008)
  3. Xia, X., et al.: Modular multilevel converter predictive control strategy based on energy balance. J. Power Electron. 21(5), 757-767 (2021) https://doi.org/10.1007/s43236-021-00225-9
  4. Luo, W., Ma, Y., Zheng, C.: Selection-based capacitor voltage balancing control for modular multilevel converters. J. Power Electron. 21(10), 1427-1438 (2021) https://doi.org/10.1007/s43236-021-00288-8
  5. Peng, F.Z., Lai, J., Mckeever, J.W., Vancoevering, J.: A multilevel voltage-source inverter with separate DC sources for static var generation. IEEE Trans. Ind. Appl. 32(5), 1130-1138 (1996) https://doi.org/10.1109/28.536875
  6. Hiller, M., Krug, D., Sommer, R., Rohner, S.: A new highly modular medium voltage converter topology for industrial drive applications. In: Proc. IEEE EPE, pp. 1-10 (2009)
  7. Korn, A.J., Winkelnkemper, M., Steimer, P.: Low output frequency operation of the modular multi-level converter. In: Proc. IEEE ECCE, pp. 3993-3997 (2010)
  8. Hagiwara, M., Hasegawa, I., Akagi, H.: Start-up and low-speed operation of an electric motor driven by a modular multilevel cascade inverter. IEEE Trans. Ind. Appl. 49(4), 1473-1480 (2013)
  9. Antonopoulos, A., Angquist, L., Norrga, S., Ilves, K., Harnefors, L., Nee, H.P.: Modular multilevel converter AC motor drives with constant torque from zero to nominal speed. IEEE Trans. Ind. Appl. 50(3), 1982-1993 (2014) https://doi.org/10.1109/TIA.2013.2286217
  10. Zhao, F., Xiao, G., Zhu, T., Zheng, X., Wu, Z., Zhao, T.: A coordinated strategy of low-speed and start-up operation for medium-voltage variable-speed drives with a modular multilevel converter. IEEE Trans. Power Electron. 35(1), 709-724 (2020) https://doi.org/10.1109/tpel.2019.2913696
  11. Wang, L., Zhang, L., Xiong, Y., Ma, R.: Low-frequency suppression strategy based on predictive control model for modular multilevel converters. J. Power Electron. 21(10), 1407-1415 (2021) https://doi.org/10.1007/s43236-021-00286-w
  12. Du, S., Wu, B., Zargari, N.R., Cheng, Z.: A flying-capacitor modular multilevel converter for medium-voltage motor drive. IEEE Trans. Power Electron. 32(3), 2081-2089 (2017) https://doi.org/10.1109/TPEL.2016.2565510
  13. Le, D.D., Lee, D.-C.: Current stress reduction and voltage THD improvement of FC-MMCs for AC machine drive applications. IEEE Trans. Ind. Electron. 69(1), 90-100 (2022) https://doi.org/10.1109/TIE.2021.3050394
  14. Le, D.D., Lee, D.-C.: A modular multilevel converter topology with novel middle submodules to reduce capacitor voltage fluctuations. IEEE Trans. Power Electron. 37(1), 70-75 (2022) https://doi.org/10.1109/TPEL.2021.3101884
  15. Shao, S., Wheeler, P.W., Clare, J.C., Watson, A.J.: Fault detection for modular multilevel converters based on sliding mode observer. IEEE Trans. Power Electron. 28(11), 4867-4872 (2013) https://doi.org/10.1109/TPEL.2013.2242093
  16. Choi, U.-M., Blaabjerg, F., Lee, K.-B.: Study and handling methods of power IGBT module failures in power electronic converter systems. IEEE Trans. Power Electron. 30(5), 2517-2533 (2015) https://doi.org/10.1109/TPEL.2014.2373390
  17. Liu, C., et al.: Fault localization strategy for modular multilevel converters under submodule lower switch open-circuit fault. IEEE Trans. Power Electron. 35(5), 5190-5204 (2020) https://doi.org/10.1109/tpel.2019.2941129
  18. Zhang, J., Hu, X., Xu, S., Zhang, Y., Chen, Z.: Fault diagnosis and monitoring of modular multilevel converter with fast response of voltage sensors. IEEE Trans. Industr. Electron. 67(6), 5071-5080 (2020) https://doi.org/10.1109/tie.2019.2928248
  19. Deng, F., Chen, Z., Khan, M.R., Zhu, R.: Fault detection and localization method for modular multilevel converters. IEEE Trans. Power Electron. 30(5), 2721-2732 (2015) https://doi.org/10.1109/TPEL.2014.2348194
  20. Li, B., Shi, S., Wang, B., Wang, G., Wang, W., Xu, D.: Fault diagnosis and tolerant control of single IGBT open-circuit failure in modular multilevel converters. IEEE Trans. Power Electron. 31(4), 3165-3176 (2016) https://doi.org/10.1109/TPEL.2015.2454534
  21. Abdelsalam, M., Marei, M.I., Tennakoon, S.B.: An integrated control strategy with fault detection and tolerant control capability based on capacitor voltage estimation for MMCs. IEEE Trans. Ind. Appl. 53(3), 2840-2851 (2017) https://doi.org/10.1109/TIA.2016.2608940
  22. Li, B., Xu, Z., Ding, J., Xu, D.: Fault-tolerant control of medium-voltage modular multilevel converters with minimum performance degradation under submodule failures. IEEE Access 6, 11772-11781 (2018) https://doi.org/10.1109/access.2018.2811904
  23. Wang, J., Tang, Y.: A fault-tolerant operation method for medium voltage MMCs with phase-shifted carrier modulation. IEEE Trans. Power Electron. 34(10), 9459-9470 (2019) https://doi.org/10.1109/tpel.2018.2890536
  24. Li, K., Yuan, L., Zhao, Z., Lu, S., Zhang, Y.: Fault-tolerant control of MMC with hot reserved submodules based on carrier phase shift modulation. IEEE Trans. Power Electron. 32(9), 6778-6791 (2017) https://doi.org/10.1109/TPEL.2016.2628762
  25. Yang, S., Tang, Y., Wang, P.: Seamless fault-tolerant operation of a modular multilevel converter with switch open-circuit fault diagnosis in a distributed control architecture. IEEE Trans. Power Electron. 33(8), 7058-7070 (2018) https://doi.org/10.1109/TPEL.2017.2756849
  26. Lo, Y., Shi, X., Liu, B., Wang, F., Lei, W.: Maximum modulation index for modular multilevel converter with circulating current control. In: 2014 IEEE Energy Conversion Congress and Exposition (ECCE), pp. 491-498 (2014)
  27. Harnefors, L., Antonopoulos, A., Norrga, S., Angquist, L., Nee, H.P.: Dynamic analysis of modular multilevel converters. IEEE Trans. Ind. Electron. 60(7), 2526-2537 (2013) https://doi.org/10.1109/TIE.2012.2194974