DOI QR코드

DOI QR Code

Flexural behavior of post-tensioned precast concrete girder at negative moment region

  • Choi, Seung-Ho (Department of Architectural Engineering, University of Seoul) ;
  • Heo, Inwook (Department of Architectural Engineering, University of Seoul) ;
  • Kim, Jae Hyun (Department of Architectural Engineering, University of Seoul) ;
  • Jeong, Hoseong (Department of Architectural Engineering and Smart City Interdisciplinary Major Program, University of Seoul) ;
  • Lee, Jae-Yeon (Division of Architecture, Mokwon University) ;
  • Kim, Kang Su (Department of Architectural Engineering and Smart City Interdisciplinary Major Program, University of Seoul)
  • 투고 : 2022.02.06
  • 심사 : 2022.06.30
  • 발행 : 2022.07.25

초록

This study introduced a post-tensioned precast concrete system that was developed and designed to improve the performance of joints by post-tensioning. Full-scaled specimens were tested to investigate flexural performances at the negative moment region, where the test variables were the presence of slabs, tendon types, and post-tensioned lengths. A specimen with slabs exhibited significantly higher stiffness and strength values than a specimen without slabs. Thus, it would be reasonable to consider the effects of a slab on the flexural strength for an economical design. A specimen with unbonded mono-tendons had slightly lower initial stiffness and flexural strength values than a specimen with bonded multi-tendons but showed greater flexural strength than the value specified in the design codes. The post-tensioned length was found to have no significant impact on the flexural behavior of the proposed post-tensioned precast concrete system. In addition, a finite element analysis was conducted on the proposed post-tensioned precast concrete system, and the tests and analysis results were compared in detail.

키워드

과제정보

This research was supported by the Basic Science Research Program through the National Research Foundation of Korea (NRF) funded by the Ministry of Education (NRF-2021R1I1A3049928).

참고문헌

  1. ACI Committee 318 (2019), Buildi ng Code Requirements for Structural Concrete and Commentary (ACI 318-19), American Concrete Institute, Farmington Hills, MI.
  2. Adibi, M., Talebkhah, R. and Yahyaabadi, A. (2019), "Simulation of cyclic response of precast concrete beam-column joints", Comput. Concrete, 24(3), 223-236. https://doi.org/10.12989/cac.2019.24.3.223.
  3. Al-Fakher, U., Manalo, A., Ferdous, W., Aravinthan, T., Zhuge, Y. and Bai, Y. (2021), "Bending behaviour of precast concrete slab with externally flanged hollow FRP tubes", Eng. Struct., 241(15), Article No. 112433. https://doi.org/10.1016/j.engstruct.2021.112433.
  4. Choi, S.H., Hwang, J.H., Han, S.J., Joo, H.E., Kim, J.H. and Kim, K.S. (2021), "Experimental study of punching shear in post-tensioned slabs with unbonded tendons", Struct. Eng. Mech., 79(4), 507-516. https://doi.org/10.12989/sem.2021.79.4.507.
  5. Choi, S.H., Lee, D.H., Oh, J.Y., Kim, K.S., Lee, J.Y. and Lee, K.S. (2017), "Unified equivalent frame method for post-tensioned flat plate slab structures", Comput. Concrete, 20(6), 663-670. https://doi.org/10.12989/cac.2017.20.6.663.
  6. Collins, M.P. and Mitchell, D. (1991), Prestressed Concrete Structures, Prentice Hill, 766.
  7. Eberhard, M.O., Stanton, J.F., Haraldsson, O.S., Finnsson, G., Davis, P.M. and Schoettler, M.J. (2014), "Development of a bridge bend system for rapid construction and enhanced seismic performance", 10th U.S. National Conf. on Earthquake Engineering, Earthquake Engineering Research Institute, Oakland, CA.
  8. Ertas, O., Ozden, S. and Ozturan, S. (2006), "Ductile connections in precast concrete moment resisting frames", PCI J., 51(3), 66-76. https://doi.org/10.15554/pcij.05012006.66.76.
  9. Esmaeili, J. and Ahooghalandary, N. (2019), "Introducing a precast moment resistant beam-to-column concrete connection comparable with in-situ one", Comput. Concrete, 24(3), 203-215. https://doi.org/10.12989/cac.2019.23.3.203.
  10. Ferdous, W., Manalo, A., Alajarmeh, O.S., Zhuge, Y., Mohammed, A.A., Bai, Y., Aravinthan, T. and Schubel, P. (2021), "Bending and shear behaviour of waste rubber concrete-filled FRP tubes with external flanges", Polym., 13(15), Article No. 2500. https://doi.org/10.3390/polym13152500.
  11. Gorgun, H. (2018), "An experimental study of the behaviour of double sided welded plate connections in precast concrete frames", Steel Compos. Struct., 29(1), 1-22. https://doi.org/10.12989/scs.2018.29.1.001.
  12. Han, S.J., Joo, H.E., Choi, S.H., Heo, I.W. and Kim, K.S. (2021), "Flexural behavior of prestressed hybrid wide flange beams with hollowed steel webs", Steel Compos. Struct., 38(6), 691-703. https://doi.org/10.12989/scs.2021.38.6.691.
  13. Hwang, J.H., Choi, S.H., Lee, D.H., Kim, K.S. and Kwon, O.S. (2021), "Seismic behaviour of post-tensioned precast concrete beam-column connections", Mag. Concrete Res., 73(9), 433-447. https://doi.org/10.1680/jmacr.19.00083.
  14. Jin, K., Kitayama, K., Song, S. and Kanemoto, K. (2016), "Shear capacity of precast prestressed concrete beam-column joint assembled by unbonded tendon", ACI Struct. J., 114(6), 51-61. https://doi.org/10.14359/51689148.
  15. Joshi, D.D., Patel, P.V., Rangwala, H.M. and Patoliya, B.G. (2020). "Experimental and numerical studies of precast connection under progressive collapse scenario", Adv. Concrete Constr., 9(3), 235-248. https://doi.org/10.12989/acc.2020.9.3.235.
  16. Kim, J.H., Choi, S.H., Hwang, J.H., Jeong, H.S., Han, S.J. and Kim, K.S. (2021), "Experimental study on lateral behavior of post-tensioned precast beam-column joints", Struct., 33, 841-854. https://doi.org/10.1016/j.istruc.2021.04.095.
  17. Kim, J.H., Jang, B.S., Choi, S.H., Lee, Y.J., Jeong, H.S. and Kim, K.S. (2021), "Experimental study on lateral behavior of precast wide beam-column joints", Earthq. Struct., 21(6), 653-667. https://doi.org/10.12989/eas.2021.21.6.653.
  18. Kmiecik, P. and Kaminski, M. (2011), "Modeling of reinforced concrete structures and composite structures with concrete strength degradation taken into consideration", Arch. Civil Mech. Eng., 11(3), 623-636. https://doi.org/10.1016/S1644-9665(12)60105-8.
  19. Kurosawa, R., Sakata, H., Qu, Z. and Suyama, T. (2019), "Precast prestressed concrete frames for seismically retrofitting existing RC frames", Eng. Struct., 184, 345-354. https://doi.org/10.1016/j.engstruct.2019.01.110.
  20. Smith, M. (2009), ABAQUS/Standard User's Manual, Version 6.9, Dassault Systemes Simulia Corp., Providence, RI, USA.
  21. Song, M., He. J., Liu, W., Zhang, H., Ge, C., Jin, Y., Liu, B., Huang, S. and Liu, Y. (2018), "Seismic behavior of three-story prestressed fabricated concrete frame under dynamic and low reversed cyclic loading", Adv. Civil Eng., 2018, Article ID: 7876908. https://doi.org/10.1155/2018/7876908.
  22. Tazarv, M. and Saiidi, M. (2015), "UHPC-filled duct connections for accelerated brige construction of RC columns in high seismic zones", Eng. Struct., 99(15), 413-422. https://doi.org/10.1016/j.engstruct.2015.05.018.
  23. Tong, C. and Li, C. (2021), "A novel precast concrete beam-to-column connection with replaceable energy-dissipation connector: Experimental investigation and theoretical analysis", Bull. Earthq. Eng., 19, 4911-4943. https://doi.org/10.1007/s10518-021-01144-7.
  24. Yu, Z., Lv, X., Ding, F. and Peng, X. (2019), "Seismic performance of precast concrete columns with improved U-type reinforcement ferrule connections", Int. J. Concrete Struct. Mater., 13, 1-18. https://doi.org/10.1186/s40069-019-0368-6.
  25. Zhang, D., Fleschman R.B. and Lee, D.H. (2020), "Effects of diaphragm flexibility on the seismic design acceleration of precast concrete diaphragms", Comput. Concrete, 25(3), 273-282. https://doi.org/10.12989/cac.2020.25.3.273.