Earthquakes and Structures

  • 제22권6호
  • /
  • Pages.625-635
  • /
  • 2022
  • /
  • 2092-7614(pISSN)
  • /
  • 2092-7622(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Mitigation of seismic pounding between RC twin high-rise buildings with piled raft foundation considering SSI

  • Farghaly, Ahmed Abdelraheem (Department of Civil and Architectural Constructions, Faculty of Technology and Education, Sohag University) ;
  • Kontoni, Denise-Penelope N. (Department of Civil Engineering, School of Engineering, University of the Peloponnese)
  • 투고 : 2018.05.10
  • 심사 : 2022.06.12
  • 발행 : 2022.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

High-rise buildings (HRBs) are considered one of the most common structures nowadays due to the population growth, especially in crowded towns. The lack of land in crowded cities has led to the convergence of the HRBs and the absence of any gaps between them, especially in lands with weak soil (e.g., liquefaction-prone soil), but then during earthquakes, these structures may be exposed to the risk of collision between them due to the large increase in the horizontal displacements, which may be destructive in some cases to the one or both of these adjacent buildings. To evaluate methods of reducing the risk of collision between adjacent twin HRBs, this research investigates three vibration control methods to reduce the risk of collision due to five different earthquakes for the case of two adjacent reinforced concrete (RC) twin high-rise buildings of 15 floors height without gap distance between them, founded on raft foundation supported on piles inside a liquefaction-prone soil. Contact pounding elements between the two buildings (distributed at all floor levels and at the raft foundation level) are used to make the impact strength between the two buildings realistic. The mitigation methods investigated are the base isolation, the tuned mass damper (TMD) method (using traditional TMDs), and the pounding tuned mass damper (PTMD) method (using PTMDs connected between the two buildings). The results show that the PTMD method between the two adjacent RC twin high-rise buildings is more efficient than the other two methods in mitigating the earthquake-induced pounding risk.

키워드

참고문헌

  1. Amiri, G.G., Shakouri, A., Veismoradi, S. and Namiranian, P. (2017), "Effect of seismic pounding on buildings isolated by triple friction pendulum bearing", Earthq. Struct., 12(1), 35-45. https://doi.org/10.12989/eas.2017.12.1.035.
  2. Ardeshiri-Lajimi, S., Yazdani, M. and Assadi-Langroudi, A. (2016) "A study on the liquefaction risk in seismic design of foundations", Geom. Eng., 11(6), 805-820. https://doi.org/10.12989/gae.2016.11.6.805.
  3. Bhatt, G., Paul, D.K. and Bhowmick, S. (2018) "Design of base isolation system for buildings", Chapter 4 in Design and Optimization of Mechanical Engineering Products, 67-82. IGI Global.
  4. Chou, J.C. and Lin, D.G. (2020), "Incorporating ground motion effects into Sasaki and Tamura prediction equations of liquefaction-induced uplift of underground structures", Geom. Eng., 22(1), 25-33. https://doi.org/10.12989/gae.2020.22.1.025.
  5. Faizan, A.A. and Kirtel, O. (2021), "Non-linear soil-structure interaction analysis of Railway Bridge subjected to earthquake ground motions considering different types of soil", Arab. J. Geosci., 14(6), 509, 1-11. https://doi.org/10.1007/s12517-021-06834-9.
  6. Farghaly, A.A. (2017), "Seismic analysis of adjacent buildings subjected to double pounding considering soil-structure interaction", Int. J. Adv. Struct. Eng., 9(1), 51-62. https://doi.org/10.1007/s40091-017-0148-y.
  7. Folhento, P., Barros, R. and Braz-Cesar, M. (2020), "Mitigation of earthquake-induced structural pounding between adjoining buildings - state-of-the-art", Proceedings of the 14th APCA International Conference on Automatic Control and Soft Computing - CONTROLO 2020, Braganca, Portugal, July. Goncalves J.A., Braz-Cesar M., Coelho J.P. (eds), CONTROLO 2020, Lecture Notes in Electrical Engineering, 695, 752-776. Springer, Cham. https://doi.org/10.1007/978-3-030-58653-9_72.
  8. Fukasawa, S. and Kanno, Y. (2020), "Numerical simulation of base-isolated buildings in collisions with surrounding moat walls during earthquakes: a non-smooth mechanics approach", Optim. Eng., 21(4), 1423-1457. https://doi.org/10.1007/s11081-019-09481-y.
  9. Jaradat, Y. and Far, H. (2021), "Optimum stiffness values for impact element models to determine pounding forces between adjacent buildings", Struct. Eng. Mech., 77(2), 293-304. https://dx.doi.org/10.12989/sem.2021.77.2.293.
  10. Kanbir, Z., Ozdemir, G. and Alhan, C. (2018), "Modeling of Lead Rubber Bearings via 3DBASIS, SAP2000, and OpenSees Considering Lead Core Heating Modeling Capabilities", Int. J. Struct. Civil Eng. Res., 7(4), 294-301. https://dx.doi.org/10.18178/ijscer.7.4.294-301.
  11. Kang, B.S., Li, L. and Ku, T.W. (2009), "Dynamic response characteristics of seismic isolation systems for building structures", J. Mech. Sci. Tech., 23, 2179-2192. https://doi.org/10.1007/s12206-009-0437-x.
  12. Karabork, T. and Aydin, E. (2019), "Optimum design of viscous dampers to prevent pounding of adjacent structures", Earthq. Struct., 16(4), 437-453. https://dx.doi.org/10.12989/eas.2019.16.4.437.
  13. Kontoni, D.-P.N. and Farghaly, A.A. (2018), "Seismic Response of Adjacent Unequal Buildings Subjected to Double Pounding Considering Soil-Structure Interaction", Computation, 6(1), 10, 1-18. https://doi.org/10.3390/computation6010010.
  14. Kontoni, D.-P.N. and Farghaly, A.A. (2019a), "Mitigation of the seismic response of a cable-stayed bridge with soil-structure-interaction effect using tuned mass dampers", Struct. Eng. Mech., 69(6), 699-712. https://doi.org/10.12989/sem.2019.69.6.699.
  15. Kontoni, D.-P.N. and Farghaly, A.A. (2019b), "The effect of base isolation and tuned mass dampers on the seismic response of RC high-rise buildings considering soil-structure interaction", Earthq. Struct., 17(4), 425-434. https://doi.org/10.12989/eas.2019.17.4.425.
  16. Kontoni, D.-P.N. and Farghaly, A.A. (2020), "TMD effectiveness for steel high-rise building subjected to wind or earthquake including soil-structure interaction", Wind Struct., 30(4), 423-432. https://doi.org/10.12989/was.2020.30.4.423.
  17. Lin, W., Lin, Y., Song, G. and Li, J. (2016), "Multiple pounding Tuned Mass Damper (MPTMD) control on benchmark tower subjected to earthquake excitations", Earthq. Struct., 11(6), 1123-1141. https://doi.org/10.12989/eas.2016.11.6.1123.
  18. Lin, W., Wang, Q., Li, J., Chen, S. and Qi, A., (2017), "Shaking table test of pounding tuned mass damper (PTMD) on a frame structure under earthquake excitation", Comput. Concrete, 20(5), 545-553. https://doi.org/10.12989/cac.2017.20.5.545.
  19. Liu, M., Yang, W., Chen, W. and Li, H., (2019), "Experimental investigation on multi-mode vortex-induced vibration control of stay cable installed with pounding tuned mass dampers", Smart Struct. Sys., 23(6), 579-587. https://doi.org/10.12989/sss.2019.23.6.579.
  20. Mavronicola, E.A., Polycarpou, P.C. and Komodromo,s P. (2020), "Effect of ground motion directionality on the seismic response of base isolated buildings pounding against adjacent structures", Eng. Struct., 207, 110202, 1-12. https://doi.org/10.1016/j.engstruct.2020.110202.
  21. Miari, M., Choong, K.K. and Jankowski, R. (2019), "Seismic pounding between adjacent buildings: Identification of parameters, soil interaction issues and mitigation measures", Soil Dyn. Earthq. Eng., 121, 135-150. https://doi.org/10.1016/j.soildyn.2019.02.024.
  22. Molina-Gomez, F., Caicedo, B. and Viana da Fonseca, A. (2019), "Physical modelling of soil liquefaction in a novel micro shaking table", Geom. Eng., 19(3), 229-240. https://doi.org/10.12989/gae.2019.19.3.229.
  23. Naderpour, H., Naji, N., Burkacki, D. and Jankowski, R. (2019), "Seismic Response of High-Rise Buildings Equipped with Base Isolation and Non-Traditional Tuned Mass Dampers", Applied Sciences, 9(6), 1201, 1-22. https://doi.org/10.3390/app9061201.
  24. Newmark, N.M. and Rosenblueth, E. (1971), Fundamentals of Earthquake Engineering, Prentice-Hall, Englewood Cliffs, New Jersey, U.S.A.
  25. Panchal, V.R. and Jangid, R.S. (2009), "Seismic response of structures with variable friction pendulum system", J. Earthq. Eng., 13(2), 193-216, https://doi.org/10.1080/13632460802597786.
  26. Raheem, S.E.A., Alazrak, T., AbdelShafy, A.G., Ahmed, M.M. and Gamal, Y.A. (2021), "Seismic pounding between adjacent buildings considering soil-structure interaction", Earthq. Struct., 20(1), 55-70. https://dx.doi.org/10.12989/eas.2021.20.1.055.
  27. Rahimi, S. and Soltani, M., (2017), "Expected extreme value of pounding force between two adjacent buildings", Struct. Eng. Mech., 61(2), 183-192. https://doi.org/10.12989/sem.2017.61.2.183.
  28. Rayegani, A. and Nouri, G. (2020), "Application of Smart Dampers for Prevention of Seismic Pounding in Isolated Structures Subjected to Near-fault Earthquakes", J. Earthq. Eng., 1822230, 1-16. https://doi.org/10.1080/13632469.2020.1822230.
  29. Rupakhety, R., Elias, S. and Olafsson, S. (2020), "Shared Tuned Mass Dampers for Mitigation of Seismic Pounding", Appl. Sci., 10(6), 1918, 1-13. https://doi.org/10.3390/app10061918.
  30. SAP2000® Version 17 (2015), Integrated Software for Structural Analysis and Design; Computers and Structures, Inc., Walnut Creek, CA and New York, NY, U.S.A.
  31. Shakouri, A., Amiri, G.G., Miri, Z.S. and Lak, H.R., (2021), "Seismic poundings of multi-story buildings isolated by TFPB against moat walls", Earthq. Struct., 20(3), 295-307. https://dx.doi.org/10.12989/eas.2021.20.3.295.
  32. Soni, D.P., Mistry, B.B., Jangid, R.S. and Panchal, V.R. (2011), "Seismic response of the double variable frequency pendulum isolator", Struct. Control and Health Monitoring, 18(4), 450-470. https://doi.org/10.1002/stc.384.
  33. Sudevan, P.B., Boominathan, A. and Banerjee, S., (2020), "Mitigation of liquefaction-induced uplift of underground structures by soil replacement methods", Geom. Eng., 23(4), 365-379. https://dx.doi.org/10.12989/gae.2020.23.4.365.
  34. Varma, V., Reddy, G.R., Vaze, K.K. and Kushwaha, H.S., (2003), "Base Isolation Strategies for Structures and Components", BARC2003E023; Bhabha Atomic Research Centre, Mumbai, India. https://inis.iaea.org/collection/NCLCollectionStore/_Public/39/004/39004707.pdf.
  35. Yabana, S. and Matsuda, A. (2000), "Mechanical properties of laminated rubber bearings for three-dimensional seismic isolation", Proceedings of the 12th World Conference on Earthquake Engineering, Auckland, New Zealand, January. 2452, 1-8. https://www.iitk.ac.in/nicee/wcee/article/2452.pdf.