Acknowledgement
This research was supported by the MSIT(Ministry of Science and ICT), Korea, under the ITRC(Information Technology Research Center) support program(IITP-2022-2018-0-01426) supervised by the IITP(Institute for Information & Communications Technology Planning & Evaluation) This research was supported by the Bio & Medical Technology Development Program of the NRF funded by the Korean government, MSIP(NRF-2017M3A9E2063260) This research was supproted by a grant of Korea Health Technology R&D Project through the Korea Health Industry Development Institute(KHIDI), funded by the Ministry of Health & Welfare, Republic of Korea(HJ22C0003)
References
- Linda Paterno, "Sockets for Limb Prostheses: A Review of Existing Technologies and Open Challenges," IEEE Transactions on Biomedical Engineering, Vol.65, Issue.9, 2018. DOI: 10.1109/TBME.2017.2775100
- Rene Fluit, "A Comparison of Control Strategies in Commercial and Research Knee Prostheses," IEEE Transactions on Biomedical Engineering, Vol.67, No.1, 2020. DOI: 10.1109/TBME.2019.2912466
- M. Goldfarb, "Realizing the promise of robotic leg prostheses," Sci. Tranlational Med., Vol.5, No. 210, 2013. DOI: 10.1126/scitranslmed.3007312
- Qinjian Li, "Neural-Dynamics Optimization and Repetitive Learning Control for Robotic Leg Prostheses," IEEE/ASME Transactions on Mechatronics, Vol.27, No.2, 2022. DOI: 10.1109/TMECH.2021.3071936
- Lin Du, "Toward Design of an Environment Aware Adaptive Locomotion-Mode-Recognition System," IEEE Transactions on Biomedical Engineering, Vol.59, No.10, 2012. DOI: 10.1109/TBME.2012.2208641
- Gholamreza Khademi, "Toward Minimal-Sensing Locomotion Mode Recognition for a Powered Knee-Ankle Prosthesis," IEEE Transactions on Biomedical Engineering, Vol.68, No.3, 2021. DOI: 10.1109/TBME.2020.3016129
- Richard B. Woodward, "Real-Time Adaptation of an Artificial Neural Network for Transfemoral Amputees Using a Powered Prosthesis," IEEE Transactions on Biomedical Engineering, Vol.69, No.3, 2022. DOI: 10.1109/TBME.2021.3120616
- S. R. Fairhurst, "Sensor based control of a bimodal ankle-foot prosthesis with a smart phone interface," J. Med. Devices, vol.9, no.3, pp.030907, 2015. https://doi.org/10.1115/1.4030545
- Aaron J. Young, "A Training Method for Locomotion Mode Prediction Using Powered Lower Limb Prostheses," IEEE Transactions on Neural systems and Rehabilitation Engineering, Vol.22, No.3, 2014. DOI: 10.1109/TNSRE.2013.2285101
- Stephanie Huang, "Locomotor Adaptation by Transtibial Amputees Walking With an Experimental Powered Prosthesis Under Continuous Myoelectric Control," IEEE Transactions on Neural Systems and Rehabilitation Engineering, Vol.24, No.5, 2016. DOI: 10.1109/TNSRE.2015.2441061
- Fan Zhang, "Source Selection for Real-Time User Intent Recognition Toward Volitional Control of Artificial Legs," IEEE Journal of Bilmedical and Health Informatics, Vol.17, No.5, 2013. DOI: 10.1109/JBHI.2012.2236563
- Seong Ho Yeon, "Acquisition of Surface EMG Using Flexible and Low-Profile Electrodes for Lower Extremity Neuroprosthetic Control," IEEE Transactions on Medical Robotics and Bionics, Vol.21, No.5, 2016. DOI: 10.1109/TMRB.2021.3098952
- Farahiyah Jasni, "In-Socket Sensory System for Transfemoral Amputees Using Piezoelectric Sensors: An Efficacy Study," IEEE/ASME Transactions on Mechatronics, Vol.21, No.5, 2016. DOI: 10.1109/TMECH.2016.2578679
- Zuojun Liu, "Intent Pattern Recognition of Lower-limb Motion Based on Mechanical Sensors," IEEE/CAA Journal of Automatica Sinica, Vol.4, No.4, 2017. DOI: 10.1109/JAS.2017.7510619
- Enhao Zheng, "A Noncontact Capacitive Sensing System for Recognizing Locomotion Modes of Transtibial Amputees," IEEE Transactions on Biomedical Engineering, Vol.61, No.12, 2014. DOI: 10.1109/TBME.2014.2334316.
- Jordan Tabor, "Textile-Based Pressure Sensors for Monitoring Prosthetic-Socket Interfaces," IEEE Sensors Journal, Vol.21, NO.7, 2021. DOI: 10.1109/JSEN.2021.3053434
- Haiying Huang, "A Stacked Dual-Frequency Microstrip Patch Antenna for Simultaneous Shear and Pressure Displacement Sensing," IEEE Sensors Journal, Vol.17, No.24, 2017. DOI: 10.1109/JSEN.2017.2765893
- Armando Ferreira, "Piezoresistive Polymer Based Materials for Real-Time Assessment of the Stump/Socket Interface Pressure in Lower Limb Amputees," IEEE Sensors Journal, Vol.17, No.7, 2017. DOI: 10.1109/JSEN.2017.2667717
- Matthew Hopkins "Examination of the Performance Characteristics of Velostat as an In-Socket Pressure Sensor," IEEE Sensors Journal, Vol.20, No.13, 2020. DOI: 10.1109/JSEN.2020.2978431
- Peng Dou, "Pressure distribution at the stump/socket interface in transtibial amputees during walking on stairs, slope and non-flat road," Clinical Biomechanics, 2006. DOI: 10.1016/j.clinbiomech.2006.06.004
- T. Dumbleton, "Dynamic interface pressure distributions of two transtibial prosthetic socket concepts," J. Rehabil. Res. Develop., vol.46, no.3, pp.405-415, 2009. DOI: 10.1682/JRRD.2008.01.0015
- T. L. Beil, "Interface pressures during ambulation using suction and vacuum assisted prosthetic sockets," J. Rehabil. Res. Develop., vol.39, no.6, pp.693-700, 2002.
- Roberto de Fazio, "Development of a Self-Powered Piezo-Resistive Smart Insole Equipped with Low-Power BLE Connectivity for Remote Gait Monitoring," Sensors Journal, Vol.21, Issue.13, 2021. DOI: 10.3390/s21134539
- Liangqi Yuan, "Velostat Sensor Array for Object Recognition," IEEE Sensors Journal, Vol.22, No.2, 2022. DOI: 10.1109/JSEN.2021.3132793
- Andrius Dzedzickis, "Polyethylene-Carbon Composite (Velostat®) Based Tactile Sensor," Polymers Journal, Vol.12, Issue.12, 2020. DOI: 10.3390/polym12122905
- Anis Fatema, "A Low-Cost Pressure Sensor Matrix for Activity Monitoring in Stroke Patients Using Artificial Intelligence," IEEE Sensors Journal, Vol.21, No.7, 2021. DOI: 10.1109/JSEN.2021.3054406