DOI QR코드

DOI QR Code

Behavior of GGBS concrete with pond ash as a partial replacement for sand

  • Maheswaran, J. (Department of Civil Engineering, St Xavier's Catholic College of Engineering Nagercoil) ;
  • Chellapandian, M. (Department of Civil Engineering, Mepco Schlenk Engineering College) ;
  • Kumar, V. (Thanthai Periyar Government Institute of Technology Vellore)
  • 투고 : 2020.07.01
  • 심사 : 2022.03.11
  • 발행 : 2022.03.25

초록

An attempt is made to develop an eco-friendly concrete with ground granulated blast furnace slag (GGBS) and pond ash as partial replacement materials for cement and fine aggregate, respectively without compromising the strength and durability. Sixteen concrete mixes were developed by replacing cement and fine aggregate by GGBS and pond ash, respectively in stages of 10%. The maximum replacement levels of cement and fine aggregates were 50% and 30% respectively. Experimental results revealed that the optimum percentage of GGBS and pond ash replacement levels were 30% and 20% respectively. The optimized mix was used further to study the flexural behavior and durability properties. Reinforced Concrete (RC) beams were cast and tested under a four-point bending configuration. Also, the specimens prepared from the optimized mix were subjected to alternate wet and dry cycles of acid (3.5% HCl and H2SO4) and sulphate (10% MgSO4) solutions. Results show that the optimized concrete mix with GGBS and pond ash had a negligible weight loss and strength reduction.

키워드

과제정보

The authors would like to thank the Department of Civil Engineering, Government College of Engineering Salem for providing necessary facilities and support to perform the experimental work.

참고문헌

  1. ACI 318. (2015), Building Code Requirements for Structural Concrete and Commentary, Terminology of Building Conservation Industry, Division of Building Research, NRC Canada.
  2. Al-Rawi, S. and Taysi, N. (2018), "Performance of self-compacting geopolymer concrete with and without GGBFS and steel fiber", Adv. Concrete Constr., 6(4), 323-344. https://doi.org/10.12989/acc.2018.6.4.323.
  3. Annadurai, S., Rathinam, K. and Kanagarajan, V. (2020), "Development of eco-friendly concrete produced with rice husk ash (RHA) based geopolymer", Adv. Concrete Constr., 9(2), 139-147. https://doi.org/10.12989/acc.2020.9.2.139.
  4. Benyamina, S., Menadi, B., Bernard, S.K. and Kenai, S. (2020), "Performance of self-compacting concrete with manufactured crushed sand", Adv. Concrete Constr., 7(2), 87-96. https://doi.org/10.12989/acc.2019.7.2.087.
  5. Deja, J., Uliasz-Bochenczyk, A. and Mokrzycki, E. (2010), "CO2 emissions from Polish cement industry", Int. J. Greenhouse Gas Control., 4(4), 583-588. https://doi.org/10.1016/j.ijggc.2010.02.002.
  6. Flower, D.J.M., Sanjayan, J.G. and Baweja, D. (2005), "Environmental impacts of concrete production and construction", Concrete Institute of Australia-Biennial Conference, Concrete Institute of Australia.
  7. Hosseini. (2020), "Application of various types of recycled waste materials in concrete constructions", Adv. Concrete Constr., 9(5), 479-489. https://doi.org/10.12989/acc.2020.9.5.479.
  8. Indian Standards 10262. (2019), Recommended guidelines for concrete mix design, Bureau of Indian Standards, New Delhi, India.
  9. Indian Standards 1199 (1959), Method of Sampling and Analysis of Concrete, Bureau of Indian Standards, New Delhi, India.
  10. Indian Standards 12269 (2013), Indian Standard: Specification for 53 Grade Ordinary Portland Cement, Bureau of Indian standards, New Delhi, India.
  11. Indian Standards 383 (2016), Specification for Coarse and Fine Aggregates from Natural Sources for Concrete, Bureau of Indian Standards, New Delhi, India.
  12. Indian Standards 456 (2000), Plain and Reinforced Concrete Code of Practice, Bureau of Indian Standards, New Delhi, India.
  13. Indian Standards 516 (1959), Methods of Test for Strength of Concrete, Bureau of Indian Standards, New Delhi, India.
  14. Kalgal, M.R., Pranesh, R.N. and Ravishankar, S. (2007), "Strength and durability of concrete with pond ash as fine aggregate", Ind. Concrete J., 8(3), 7-11.
  15. Kim, H.K. and Lee, H.K. (2011), "Use of power plant bottom ash as fine and coarse aggregate in high strength concrete", Constrete Build. Mater., 25, 1115-1122. https://doi.org/10.1016/j.conbuildmat.2010.06.065.
  16. Kondraivendhan, B., Sairam, V. and Nandagopal, K. (1999), "Influence of pond ash as fine aggregate on strength and durability of concrete", Ind. Concrete J., 85(10), 27-36.
  17. Kumar, V. (2004), "Compaction and permeability study of pond ash", J. Inst. Eng., 85, 31-35.
  18. Kumar, V.P., Gunasekaran, K. and Shyamala, T. (2019), "Characterization study on coconut shell concrete with partial replacement of cement by GGBS", J. Build. Eng., 26, 100830. https://doi.org/10.1016/j.jobe.2019.100830.
  19. Li, Q., Yuan, G., Xu, Z. and Dou, T. (2014), "Effect of elevated temperature on the mechanical properties of high-volume GGBS concrete", Mag. Concrete Res., 66(24), 1277-1285. https://doi.org/10.1680/macr.14.00142.
  20. Nadiger, A. and Madhavan, M.K. (2019), "Influence of mineral admixtures and fibers on the workability and mechanical properties of reactive powder concrete", ASCE J. Mater. Civil Eng., 04018394.
  21. Nanthagopalan, P. and Santhanam, M. (2011), "Fresh and hardened properties of self-compacting concrete produced with manufactured sand", Cement Concrete Compos., 33, 353-358. https://doi.org/10.1016/j.cemconcomp.2010.11.005.
  22. Oner, A. and Akyuz, S. (2007), "An experimental study on optimum usage of GGBS for the compressive strength of concrete", Cement Concrete Compos., 29, 505-514. https://doi.org/10.1016/j.cemconcomp.2007.01.001.
  23. Ortega-Lopez, V., Garcia-Llona, A., Revilla-Cuesta, V., Santamaria, A. and San-Jose, J.T. (2021), "Fiber-reinforcement and its effects on the mechanical properties of high- workability concretes manufactured with slag as aggregate and binder", J. Build. Eng., 43, 102548. https://doi.org/10.1016/j.jobe.2021.102548.
  24. Park, R. and Paulay, T. (1975), Reinforced Concrete Structures, Wiley Publications.
  25. Prabhu, G.G., Hyun, J.H. and Kim, Y.Y. (2014), "Effects of foundry sand as a fine aggregate in concrete production", Constr. Build. Mater., 70, 514-21. https://doi.org/10.1016/j.conbuildmat.2014.07.070.
  26. Raman, S.K., Ngo, T., Mendis, P. and Mahmud, H.B. (2011), "High strength rice husk ash concrete incorporating quarry dust as a partial substitute for sand", Constr. Build. Mater., 25, 3123-3130. https://doi.org/10.1016/j.conbuildmat.2010.12.026.
  27. Ranganath, R.V., Bhattacharjee, B. and Krishnamoorthy, S. (1999), "Reproportioning of aggregate mixes for optimal workability with pond ash as fine aggregate in concrete", Ind. Concrete J., 7(3), 441-49.
  28. Revilla-Cuesta, V., Ortega-Lopez, V., Skaf, M. and Manso, J.M. (2020), "Effect of fine recycled concrete aggregate on the mechanical behavior of self-compacting concrete", Constr. Build. Mater., 263, 120671. https://doi.org/10.1016/j.conbuildmat.2020.120671.
  29. Revilla-Cuesta, V., Skaf, M., Espinosa, A.B. and Ortega-Lopez, V. (2021), "Multi-criteria feasibility of real use of self-compacting concrete with sustainable aggregate, binder and powder", J. Clean. Prod., 325, 129327. https://doi.org/10.1016/j.jclepro.2021.129327.
  30. Revilla-Cuesta, V., Skaf, M., Serrano-Lopez, R. and Ortega-Lopez, V. (2021), "Models for compressive strength estimation through non-destructive testing of highly self-compacting concrete containing recycled concrete aggregate and slag-based binder", Constr. Build. Mater., 280, 122454. https://doi.org/10.1016/j.conbuildmat.2021.122454.
  31. Shafigh, P., Jumaat, M.Z., Mahmud, H.B. and Alengaram, V.J. (2013), "Oil palm shell light weight concrete containing high volume ground granulated blast furnace slag", Constr. Build. Mater., 40, 231-238. https://doi.org/10.1016/j.conbuildmat.2012.10.007.
  32. Singh, M. and Siddique, R. (2015), "Effect of low-calcium coal bottom ash as fine aggregate on microstructure and properties of concrete", ACI Mater. J., 112(5), 693-703.
  33. Song, H. and Saraswathy, V. (2006), "Studies on the corrosion resistance of reinforced steel in concrete with ground granulated blast-furnace slag-An overview", J. Hazard Mater., 138, 226-233. https://doi.org/10.1016/j.jhazmat.2006.07.022.
  34. Teng, S., Lim, T.Y.D. and Divsholi, B.S. (2013), "Durability and mechanical properties of high strength concrete incorporating ultra-fine ground granulated blast-furnace slag", Constr. Build. Mater., 40(3), 875-881. https://doi.org/10.1016/j.conbuildmat.2012.11.052.
  35. Uyral, M., Yilmaz, K. and Ipek, M. (2012), "The effect of mineral admixtures on mechanical properties, chloride ion permeability and impermeability of self-compacting concrete", Constr. Build. Mater., 27, 263-70. https://doi.org/10.1016/j.conbuildmat.2011.07.049.
  36. Vasugi, K. and Ramamurthy, K. (2014), "Identification of admixtures for pelletization and strength enhancement of sintered coal pond ash aggregate through statistically designed experiments", Mater. Des., 60, 563-575. https://doi.org/10.1016/j.matdes.2014.04.023.
  37. Venkatesan, R.P. and Pazhani, K.C. (2015), "Strength and durability of geopolymer concrete made with GGBS and black rice husk ash", KSCE J. Civil Eng., 20, 2384-2391. https://doi.org/10.1007/s12205-015-0564-0.
  38. Wan, H. and Shui, Z. (2004), "Analysis of geometric characteristics of GGBS particles and their influences on cement properties", Cement Concrete Res., 34(1), 133-37. https://doi.org/10.1016/S0008-8846(03)00252-7.
  39. Yeau, K.Y. and Kim, E.K. (2005), "An experimental study on corrosion resistance of concrete with ground granulate blast-furnace slag", Cement Concrete Res., 35, 1391-1399. https://doi.org/10.1016/j.cemconres.2004.11.010.
  40. Zhao, Y., Bi, J., Sun, Y., Wang, Z., Huo, L. and Duan, Y. (2021), "Synergetic effect of ground granulated blast-furnace slag and hooked-end steel fibers on various properties of steel fiber reinforced self-compacting concrete", Struct. Concrete, 23(1), 268-284. https://doi.org/10.1002/suco.202000722.