Geomechanics and Engineering

  • 제28권6호
  • /
  • Pages.585-598
  • /
  • 2022
  • /
  • 2005-307X(pISSN)
  • /
  • 2092-6219(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Simulation of monopile-wheel hybrid foundations under eccentric lateral load in sand-over-clay

  • Zou, Xinjun (College of Civil Engineering, Key Laboratory of Building Safety and Energy Efficiency of Ministry of Education, Hunan University) ;
  • Wang, Yikang (College of Civil Engineering, Key Laboratory of Building Safety and Energy Efficiency of Ministry of Education, Hunan University) ;
  • Zhou, Mi (School of Marine Science and Engineering, State key laboratory of subtropical building science, South China University of Technology) ;
  • Zhang, Xihong (School of Civil and Mechanical Engineering, Curtin University)
  • 투고 : 2021.01.09
  • 심사 : 2022.02.12
  • 발행 : 2022.03.25
⟨ 이전 논문 다음 논문 ⟩

초록

The monopile-friction wheel hybrid foundation is an innovative solution for offshore structures which are mainly subjected to large lateral eccentric load induced by winds, waves, and currents during their service life. This paper presents an extensive numerical analysis to investigate the lateral load and moment bearing performances of hybrid foundation, considering various potential influencing factors in sand-overlaying-clay soil deposits, with the complex lateral loads being simplified into a resultant lateral load acting at a certain height above the mudline. Finite element models are generated and validated against experimental data where very good agreements are obtained. The failure mechanisms of hybrid foundations under lateral loading are illustrated to demonstrate the effect of the friction wheel in the hybrid system. Parametric study shows that the load bearing performances of the hybrid foundation is significantly dependent of wheel diameter, pile embedment depth, internal friction angle of sand, loading eccentricity (distance from the load application point to the ground level), and the thickness of upper sandy layer. Simplified empirical formulae is proposed based on the numerical results to predict the corresponding lateral load and moment bearing capacities of the hybrid foundation for design application.

키워드

과제정보

The first three authors of this paper were financially supported by the National Natural Science Foundation of China (Grant No. 52178329, 51578231 & 42176224), Guangdong Basic and Applied Basic Research Foundation (2021A1515010828) and Guangdong Provincial Key Laboratory of Modern Civil Engineering Technology (2021B1212040003).

참고문헌

  1. Anastasopoulos, I. and Theofilou, M. (2016), "Hybrid foundation for offshore wind turbines: Environmental and seismic loading", Soil. Dyn. Earthq. Eng., 80, 192-209. https://doi.org/10.1016/j.soildyn.2015.10.015.
  2. API (American Petroleum Institute). (2014). ANSI/API recommended practice, 2GEO, 1st Ed., Part 4, 499 Washington, DC.
  3. Arshi, S. (2016), "Physical and Numerical Modelling of Hybrid Monopiled-Footing Foundation Systems", Ph.D. Dissertation; University of Brighton, Brighton, England.
  4. Bandyopadhyay, S., Sengupta, A. and Parulekar, Y.M. (2020), "Behavior of a combined piled raft foundation in a multi-layered soil subjected to vertical loading", Geomech. Eng., 21(4), 379-390. https://doi.org/10.12989/gae.2020.21.4.379.
  5. Chen, D., Gao, P., Huang, S.S., Li, C.S. and Yu, X.G. (2020), "Static and dynamic loading behavior of a hybrid foundation for offshore wind turbines", Mar. Struct., 71, 102727. https://doi.org/10.1016/j.marstruc.2020.102727.
  6. Chong, S.H., Shin, H.S. and Cho, G.C. (2019), "Numerical analysis of offshore monopile during repetitive lateral loading", Geomech. Eng., 19(1), 79-91. https://doi.org/10.12989/gae.2019.19.1.079.
  7. Dassault Systemes. Abaqus analysis user's manual. Simulia Corp 2016.
  8. DNV (Det Norske Veritas). (2019). Offshore soil mechanics and geotechnical engineering, DNV GL-RP-C212. Hovik, Norway: DNV.
  9. El-Marassi, M. (2011), "Investigation of Hybrid Monopile-footing Foundation Systems Subjected to Combined Loading", Ph.D. Dissertation, The University of Western Ontario, Ontario, Canada.
  10. Fatahi, B., Basack, S., Ryan, P., Zhou, W.H. and Khabbaz, H. (2014), "Performance of laterally loaded piles considering soil and interface parameters", Geomech. Eng., 7(5), 495-524. https://doi.org/10.12989/gae.2014.7.5.495.
  11. Feng, X., Randolph, M.F., Gourvenec, S. and Wallerand, R. (2014), "Design approach for rectangular mudmats under fully threedimensional loading", Geotechnique, 64(1), 51-63. https://doi.org/10.1680/geot.13.P.051.
  12. Gourvenec, S.M and Barnett, S. (2011). "Undrained failure envelope for skirted foundations under general loading", Geotechnique, 61(3), 263-270. https://doi.org/10.1680/geot.9.T.027.
  13. Gourvenec, S.M. and Mana, D. (2011), "Undrained vertical bearing capacity factors for shallow foundations", Geotechnique Lett., 1(4), 101-108. https://doi.org/10.1680/geolett.11.00026.
  14. Hossain, M.S., Hu, P., Cassidy, M.J., Menzies, D. and Wingate, A. (2019), "Measured and calculated spudcan penetration profiles for case histories in sand-over-clay", Appl. Ocean Res., 82, 447-457. https://doi.org/10.1016/j.apor.2018.10.027.
  15. Lehane, B.M., Pedram, B., Doherty, J.A. and Powrie, W. (2014), "Improved performance of monopiles when combined with footings for tower foundations in sand", J. Geotech. Geoenviron. Eng., 140(7), 04014027. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001109.
  16. Liu, F., Yi, JT., Cheng, P. and Yao, K. (2020), "Numerical simulation of set-up around shaft of XCC pile in clay", Geomech. Eng., 21(5), 489-501. https://doi.org/10.12989/gae.2020.21.5.489.
  17. Li, D.Y., Feng, L.Y. and Zhang, Y.K. (2014), "Model tests of modified suction caissons in marine sand under monotonic lateral combined loading", Appl. Ocean Res., 48, 137-147. https://doi.org/10.1016/j.apor.2014.08.005.
  18. Li, X.Y, Zeng, X.W. and Wang X.F. (2020), "Feasibility study of monopile-friction wheel-bucket hybrid foundation for offshore wind turbine", Ocean Eng., 204, 107276. https://doi.org/10.1016/j.oceaneng.2020.107276.
  19. Li, X., Hu, Y. and White, D. (2013), "A large deformation finite element analysis solution for modelling dense sand", In Proceedings of the 18th International Conference on Soil Mechanics and Geotechnical Engineering: Challenges and Innovations in Geotechnics, Presses des Ponts. (1), 2359-2362. http://eprints.soton.ac.uk/id/eprint/419746.
  20. Malhotra, S. (2011), Selection, design and construction of offshore wind turbine foundations. In Wind turbines, ed. I. Al-Bahadly. Rijeka, Croatia: InTech.
  21. Meyerhof, G.G. and Hanna, A.M (1978), "Ultimate bearing capacity of foundations on layered soils under inclined load", Can. Geotech. J., 15(4), 565-572. https://doi.org/10.1139/t78-060.
  22. Pedram, B. (2018), "Behaviour of Hybrid Piled Footing Structures in Sands", Geotech Geol. Eng., 36(4), 2273-2292. https://doi.org/10.1007/s10706-018-0461-7.
  23. Raj, D., Singh, Y. and Kaynia, A.M. (2019), "Behavior and critical failure modes of strip foundations on slopes under seismic and structural loading", Int. J. Geomech., 19(6), 04019047. https://doi.org/10.1061/(ASCE)GM.1943-5622.0001427.
  24. Stone, K.J., Arshi, H.S. and Zdravkovi, L. (2018), "Use of a bearing plate to enhance the lateral capacity of monopiles in sand", J. Geotech. Geoenviron. Eng., 144(8), 04018051. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001913.
  25. Trojnar, K. (2019), "Multi scale studies of the new hybrid foundations for offshore wind turbines", Ocean Eng., 192, 106506. https://doi.org/10.1016/j.oceaneng.2019.106506.
  26. Wang, L.Z., Wang, H., Zhu, B. and Hong, Y. (2018b), "Comparison of monotonic and cyclic lateral response between monopod and tripod bucket foundations in medium dense sand", Ocean Eng., 155, 88-105. https://doi.org/10.1016/j.oceaneng.2017.12.006.
  27. Wang, X.F., Zeng, X.W., Yang, X. and Li, J.L. (2018a), "Feasibility study of offshore wind turbines with hybrid monopile foundation based on centrifuge modeling", Appl. Energy, 209(1), 127-139. https://doi.org/10.1016/j.apenergy.2017.10.107.
  28. Xu, C.J., Ding, H.B., Luo, W.J.,Tong, L., Chen, Q.S. and Deng, J.L.(2020) "Experimental and numerical study on performance of long-short combined retaining piles", Geomech. Eng., 20(3), 255-265. https://doi.org/10.12989/gae.2020.20.3.255.
  29. Yang, X., Wang, X.F. and Zeng X.W. (2017), "Numerical Simulation of the Lateral Loading Capacity of a Bucket Foundation", Geotechnical Special Publication, 279, 112-121.
  30. Yang, X., Zeng, X.W., Wang, X.F. and Yu, H. (2018), "Performance of monopile-friction wheel foundations under lateral loading for offshore wind turbines", Appl. Ocean Res., 78, 14-24. https://doi.org/10.1016/j.apor.2018.06.005.
  31. Zhou, M., Hossain, M.S., Hu, Y.X. and Liu, H. (2016), "Scale issues and interpretation of ball penetration in stratified deposits in centrifuge testing", J. Geotech. Geoenviron. Eng., 142(5) 04015103. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001442.
  32. Zheng, G., Zhao, J.P., Zhou, H.Z. and Zhang, T.Q. (2018), "Ultimate Bearing Capacity of Strip Footings on Sand Overlying Clay Under Inclined Loading", Comput. Geotech., 106, 266-273. https://doi.org/10.1016/j.compgeo.2018.11.003.
  33. Zou, X.J., Hu, Y.X., Hossain, M. and Zhou, M. (2018), "Capacity of skirted foundations in sand-over-clay under combined V-H-M loading", Ocean Eng., 159(1), 201-218. https://doi.org/10.1016/j.oceaneng.2018.04.007.