DOI QR코드

DOI QR Code

A Study on Stress-Strain Behaviour of Geotube Structure Filled with Silty Sand Under Low Confining Pressure by Triaxial Compression Test

실트질 모래가 충진된 지오튜브 구조체의 저 등방조건에서 삼축압축시험에 의한 응력-변위 거동 연구

  • Hyeong-Joo, Kim (Department of Civil Engineering, Kunsan National University) ;
  • Tae-Woong, Park (Renewable Energy Research Institute, Kunsan National University) ;
  • Ki-Hong, Kim (Department of Civil & Environment Engineering, Kunsan National University)
  • Received : 2022.11.09
  • Accepted : 2022.12.15
  • Published : 2022.12.30

Abstract

Geotextile tubes are widely used to prevent erosion in coastal areas and to replace the backfill for shore slopes in the reclamation of land using dredged soil. In this study, The triaxial confining pressures were chosen as 10kPa, 50kPa, or 100kPa for the specimens reinforced with geotextile considering the condition in the site. The strain behavior under various compressive stresses was then identified. At strains 0% to 7%, the stress-strain behavior was the same due to the effect of initial strain hardening, in which the force was exerted according to the relaxation of the geotextile regardless of the confining pressure (≤100kPa). At strains of 7% or more, the specimen with the small confining pressure had smaller deformation under load, which increases the tensile resistance provided by the reinforcing geotextile. Brittle fracture was then observed due to strain softening and the deviator stress abruptly decreased. This is different from the phenomenon in which the shear strength increases as the confining pressure increases in general triaxial compression tests. In the geoxtile-confined tests, geotextiles are primarily subjected to tensile displacement. Thereafter, the modulus of elasticity increases rapidly, which exhibits the elastic behavior of the geotextile.

지오튜브 공법은 해안지역 해안선 침식방지와 준설토 매립 호안사면의 뒤채움 필터석 대체용으로도 널리 활용되고 있다. 본 연구는 지오텍스타일에 의해 보강되어 제작된 공시체를 현장 상태를 고려하여 등방 구속압력 10kPa, 50kPa, 100kPa 이하로 최소화하여 연직응력 재하 시 변형 거동을 파악하였다. 시험결과 공시체의 연직 변형율 7%까지는 구속압(≤100kPa)에 관계없이 지오텍스타일 조직의 이완에 따른 인장력이 발휘되는 초기 Strain Hardening 영향으로 응력-변위 거동은 동일하였다. 변형율 7%이상부터는 구속압력이 작은 공시체는 재하 시 변형이 커서 보강 지오텍스타일의 인장 저항력을 증가시키므로 Strain Hardening에 의해 파괴 시 축차응력은 상대적으로 증가하였다. 파괴 후는 급격하게 Strain Softening에 의해 취성파괴형태를 나타내면서 저하되었다. 이는 일반적인 삼축압축시험에서 셀 압이 증가되면서 전단응력도 크게 증가되는 현상과 다르다. 지오텍스타일 등방구속시험에서는 지오텍스타일의 인장변위가 일차적으로 영향을 받기 때문에 탄성계수를 급격하게 증가시키는 탄성 거동을 나타내고 있다.

Keywords

Acknowledgement

This research was supported by Basic Science Research Program through the National Research Foundation of Korea(NRF) funded by the Ministry of Education(NRF 2021R1A6A1A0304518511, NRF2020R1I1A3A04036506)

References

  1. Choi, Y. J., Nguyen, T. H. and Ahn, J. H. (2019), Resilient Modulus and Permanent Deformation of 40-mm OpenGraded Aggregates based on Repeated-Load Triaxial Tests, Journal of the Korean Society of Hazard Mitigation, Vol.19, No.7, pp.367-374. https://doi.org/10.9798/kosham.2019.19.7.367
  2. Kim, B. I., Yoo, W. K., Kim. Y. U. and Moon. I. J. (2013), An Experimental Study on the Behavior of Composite Ground Improved by SCP and GCP with Low Replacement Ratio, Journal of the Korea Academia-Industrial cooperation Society, Vol.14, No.2, pp.936-942. https://doi.org/10.5762/KAIS.2013.14.2.936
  3. Kim, H. J., Lee, K. H., Jo, S.K. and Jamin, J. C. (2014a), Stress and strain behavior investigation on a scale model geotextile tube for Saemangeum dike project, Ocean Systems Engineering, Vol.4, No.4, pp.309-325, doi: 10.12989/ose.2014.4.4.309.
  4. Kim, Y. S., Cho, D. S. and Lee. K. J. (2014b), A Study of Mechanical Behavior of Sand on Reinforcement of Non -Woven Geotextile, Journal of the Korean Geosynthetics Society, Vol.2014, No.11, pp.81-84.
  5. Kim, H. J., Won, M. S., Lee, K. H. and Jamin, J, C. (2016), Model Tests on Dredged Soil-Filled Geocontainers Used as Containment Dikes for the Saemangeum Reclamation Project in South Korea, Vol.16, No.2, pp.1-13.
  6. Kim, Y. S., Oh, S. W. and Cho, D. S. (2010), Effect of NonWoven Geotextile Reinforcement on Mechanical Behavior of Sand, Journal of the Korean Geosynthetics Society, Vol.9, No.4, pp.39-45.
  7. Lee, K. H. and Hyun. S. C. (2009), Development of Asphalt Concrete Rutting Model by Triaxial Compression Test, Journal of the Korean Society of Hazard Mitigation, Vol.9, No.1, pp.57-64.
  8. Nouri, S., Nechnech, A., Lamri, B. and Lurdes, L. M. (2016), Triaxial test of drained sand reinforced with plastic layers, Arabian Journal of Geosciences, Vol.9, No.1, pp.1-9. https://doi.org/10.1007/s12517-015-2098-7
  9. Wang, J. Q., Zhang, L. L., Chen, Y. J., and Shi, C. H. (2017), Mesoscopic analysis of reinforced sand triaxial test using PFC3D, Shuili Xuebao/Journal of Hydraulic Engineering, Vol. 48, No.4, pp.426-434 and 445.
  10. Won, M. S., Lee, J. B., Kim, K. J. and Kim, H. J. (2013), A Study of Geotextile Seam Strength, Geosynthetics Conference, Vol.2013, No.11, pp.53-56.