DOI QR코드

DOI QR Code

An efficient approach for stability analysis of rock slopes subjected to a transient drawdown

  • Hu, Yining (School of Civil Engineering and Transportation, Hohai University) ;
  • Ding, Ying (School of Automotive and Transportation Engineering, Hefei University of Technology) ;
  • Sun, Zhibin (School of Automotive and Transportation Engineering, Hefei University of Technology)
  • Received : 2020.11.14
  • Accepted : 2021.10.05
  • Published : 2021.11.25

Abstract

Since the water drawdown in a reservoir easily triggers the instability of a nearby slope, chart research on slopes that are subjected to drawdown conditions has attracted extensive attention recently. However, most studies only consider the extreme 'rapid/slow' drawdown conditions and ignore the general 'transient' drawdown scenario. This paper proposes an efficient approach for stability analysis of rock slope subjected to a transient flow, and provide a chart study and a parametric analysis. To address the challenge of determining the bent phreatic surface in a transient flow and to employ the nonlinear Hoek-Brown criterion of rock masses, a phreatic equation was adopted in this paper, together with the discretization technique. In the framework of limit analysis, the external work rate and the internal energy dissipation rate were computed. A calculation flow was proposed for capturing the optimized factor of safety (FOS) based on the strength reduction technique. Then, following the evaluation of this approach, a set of stability charts and an application example were presented. A parametric analysis was conducted to evaluate the influences of the rock properties and the hydrodynamic parameters on the factor of safety.

Keywords

References

  1. Bandini, P., Salgado, R. and Loukidis, D. (2003), "Stability of seismically loaded slopes using limit analysis", Geotechnique, 53(5), 463-480. https://doi.org/10.1680/geot.2003.53.5.463.
  2. Berilgen, M.M. (2006), "Investigation of stability of slopes under drawdown conditions", Comput. Geotech., 34(2), 81-91. https://doi.org/10.1016/j.compgeo.2006.10.004.
  3. Carranza-Torres, C. and Fairhurst, C. (1999), "The elasto-plastic response of underground excavations in rock masses that satisfy the Hoek-Brown failure criterion", J. Rock Mech. Mining Sci., 36(6), 777-809. https://doi.org/10.1016/s0148-9062(99)00047-9.
  4. Chehade, H.A., Dias, D., Sadek, M., Jenck, O. and Chehade, F. H. (2019), "Seismic analysis of geosynthetic-reinforced retaining wall in cohesive soils", Geotextiles Geomembr., 47(3), 315-326. https://doi.org/10.1016/j.geotexmem.2019.02.003.
  5. Gaziev, E.G. (2001), "Stability analysis of the rock slope in the zimapan arch dam reservoir, Mexico", Bulletin Eng. Geology Environ., 60(2), 135-137. https://doi.org/10.1007/s100640000095.
  6. Hoek, E., Carranza-Torres, C. and Corkum, B. (2002) "Hoek-Brown failure criterion-2002 edition", Proceedings of the Fifth North American Rock Mechanics, Toronto, Canada, July.
  7. Huang, F. and Yang, X.L. (2010), "Upper bound solutions for the face stability of shallow circular tunnels subjected to nonlinear failure criterion", Geoshanghai International Conference, Shanghai, China, May.
  8. Karray, M., Hussien, M.N., Delisle, M.C. and Ledoux, C. (2018), "Framework to assess pseudo-static approach for seismic stability of clayey slopes", Canadian Geotech. J., 55(4), 1860-1876. https://doi.org/10.1139/cgj-2017-0383.
  9. Khorasani, E., Amini, M., Hossaini, M.F. and Medley, E. (2019), "Evaluating the effects of the inclinations of rock blocks on the stability of bimrock slopes", Geomech. Eng., 17(3), 281-287. https://doi.org/10.12989/gae.2019.17.3.281.
  10. Lane, P.A. and Griffiths, D.V. (2000). "Assessment of stability of slopes under drawdown conditions", J. Geotech. Geoenviron. Eng., 126(5), 443-450. https://doi.org/10.1061/(ASCE)1090-0241(2000)126:5(443).
  11. Leshchinsky, B. and Ambauen, S. (2015), "Limit equilibrium and limit analysis: comparison of benchmark slope stability problems", J. Geotech. Geoenviron. Eng., 141(10). https://doi.org/10.1061/(ASCE)GT.1943-5606.0001347.
  12. Li, A.J., Lyamin, A.V. and Merifield, R.S. (2008). "Seismic rock slope stability charts based on limit analysis methods", Comput. Geotech., 36(1-2), 135-148. https://doi.org/10.1016/j.compgeo.2008.01.004.
  13. Lu, C.P., Shu, L.C., Chen, X.H. and Cheng, C. (2011). "Parameter estimation for a karst aquifer with unknown thickness using the genetic algorithm method", Environ. Earth Sciences, 63(4), 797-807. https://doi.org/10.1007/s12665-010-0751-8.
  14. Lysandros, P., Elias, G. and Konstantinos-Paraskevas, G. (2020), "Stability assessment of soil slopes in three dimensions: The effect of the width of failure and of tension crack", Geomech. Eng., 22(4), 319-328. https://doi.org/10.12989/gae.2020.22.4.319.
  15. Merifield, R.S., Lyamin, A.V. and Sloan, S.W. (2006). "Limit analysis solutions for the bearing capacity of rock masses using the generalised hoek-brown criterion", J. Rock Mech. Mining Sci., 43(6), 920-937. https://doi.org/10.1016/j.ijrmms.2006.02.001.
  16. Mollon, G., Phoon, K.K., Dias, D. and Soubra, A.H. (2011), "Validation of a new 2D failure mechanism for the stability analysis of a pressurized tunnel face in a spatially varying sand", J. Eng. Mech., 137(1), 8-21. https://doi.org/10.1061/(ASCE)EM.1943-7889.0000196.
  17. Nadukuru, S.S. and Michalowski, R.L. (2013). "Three-dimensional displacement analysis of slopes subjected to seismic loads", Canadian Geotech. J., 50(6), 650-661. https://doi.org/10.1139/cgj-2012-0223.
  18. Rutqvist, J., Stephansson, O. (2003). "The role of hydromechanical coupling in fractured rock engineering", Hydrogeology Journal, 11(1), 7-40. https://doi.org/10.1007/s10040-002-0241-5.
  19. Saada, Z., Maghous, S. and Garnier, D. (2012). "Stability analysis of rock slopes subjected to seepage forces using the modified hoek-brown criterion", J. Rock Mech. Mining Sci., 55, 45-54. https://doi.org/10.1016/j.ijrmms.2012.06.010.
  20. Sahoo, P.P. and Shukla, S.K. (2019), "Taylor's slope stability chart for combined effects of horizontal and vertical seismic coefficients", Geotechnique, 69(4), 344-354. https://doi.org/10.1680/jgeot.17.p.222.
  21. Sun, Z.B., Li, J.F., Pan, Q.J., Dias, D., Li, S.Q. and Hou, C.Q. (2018), "Discrete kinematic mechanism for nonhomogeneous slopes and its application", J. Geomech., 18(12), 04018171. https://doi.org/10.1061/(ASCE)GM.1943-5622.0001303.
  22. Tiwari, G. and Latha, G.M. (2017), "Reliability analysis of jointed rock slope considering uncertainty in peak and residual strength parameters", Bulletin Eng. Geology Environ., 78, 913-930 https://doi.org/10.1007/s10064-017-1141-1.
  23. Ukritchon, B. and Keawsawasvong, S. (2018), "Stability of unlined square tunnels in hoek-brown rock masses based on lower bound analysis", Comput. Geotech., 105(1), 249-264. https://doi.org/10.1016/j.compgeo.2018.10.006.
  24. Viratjandr, C. and Michalowski, R.L. (2006), "Limit analysis of submerged slopes subjected to water drawdown", Canadian Geotech. J., 43(8), 802-814. https://doi.org/10.1139/T06-042.
  25. Yang, X.L. and Zou, Z.F. (2006). "Stability factors for rock slopes subjected to pore water pressure based on the Hoek-Brown failure criterion", J. Rock Mech. Mining Sci., 43(7), 1146-1152. https://doi.org/10.1016/j.ijrmms.2006.03.010.
  26. Younger, P.L. and Elliot, T. (1995), "Chalk fracture system characteristics: implications for flow and solute transport", Quarterly J. Eng. Geology Hydrogeology, 28(Supplement 1), S39-S50. https://doi.org/10.1144/gsl.qjegh.1995.028.s1.04.
  27. Zheng, Y.R., Shi, W.M. and Kong, W.X. (2004). "Calculation of seepage forces and phreatic surface under drawdown conditions", Chinese J. Rock Mech. Eng., 66(21), 2524-2533. https://doi.org/1000-6915(2004)18-3203-08. https://doi.org/10.00-6915(2004)18-3203-08