대한토목학회논문집 (KSCE Journal of Civil and Environmental Engineering Research)

  • 제41권4호
  • /
  • Pages.377-386
  • /
  • 2021
  • /
  • 1015-6348(pISSN)
  • /
  • 2799-9629(eISSN)
대한토목학회 (Korean Society of Civil Engeneers)
권호 표지
DOI QR코드

DOI QR Code

도로 흐름폭 변화에 따른 차집유량 분석

Analysis of Intercepted Flow according to Change of Flow Width in Gutter

  • 주동원 (경기대학교 대학원 토목공학과) ;
  • 김정수 (부천대학교 토목과)
  • 투고 : 2020.05.28
  • 심사 : 2020.12.01
  • 발행 : 2021.08.01
PDF 다운로드
⟨ 이전 논문 다음 논문 ⟩

초록

밀집이 심한 도시는 불투수 면적이 많아 흘러나온 빗물이 빠르게 도로를 타고 한쪽으로 모이게 된다. 이는 도로에 설치된 빗물받이로 차집이 되지 못한 많은 노면 유출수로 인해 측구에서의 흐름 폭이 넓어져 정체 노면수를 증가시켜 교통체증과 미끄러움으로 인한 사고를 유발한다. 이에 본 연구에서는 차집유량 산정식을 제시하기 위해서 간선도로와 고속도로의 최대 종경사를 반영하여 2~10 %의 도로 조건을 반영하였고, 측구 횡경사는 일반도로 횡경사인 2 %를 선정하였다. 도로 차선조건은 중앙차선과 보도를 경계를 2, 3, 4 차선을 선정하였으며, 실험유량은 설계 빈도 상황을 고려하여 실제 도로 조건의 5년, 10년, 20년, 30년의 설계빈도 유수유출량을 실험유량으로 환산한 결과 1.36 l/s~3.96 l/s의 유량을 10개로 나누어 수리실험을 진행하였다. 또한, 측구로 들어오는 유입유속과, 흐름 폭을 고려한 식을 제시하였다. 실험 결과 종경사 증가에 따라 흐름 폭은 증가하고, 차집율은 감소하는 경향을 보였다. 이에 본 연구에서는 IBM SPSS Statistics 24 프로그램으로 회귀분석하여 설계빈도에 따른 우수 유출량, 도로의 종경사를 반영한 흐름 폭과 유입유속의 빗물받이 차집유량 산정식을 도출하였다. 산정된 도출식은 도로에서의 빗물받이 설계에 기초자료로 활용될 것으로 판단된다.

In dense cities, which are covered by many impermeable areas, rainwater flows quickly along the roads and collects in certain areas. The surface runoff that fails to get intercepted by the roadside rain gutters results in a wider flow of water along the sides, which in turn increases the amount of water on the road and causes traffic congestion as well as accidents due to slippage. Based on these issues, this study was carried out in order to propose an intercepted flow calculation formula. To this end, the maximum longitudinal slopes of arterial roads and expressways were reflected to depict a road condition of 2~10 %, while a general traverse slope of 2 % was selected for the traverse slope on the side. As for the road lane condition, two, three, and four lanes were chosen for the area from the centerline to the sidewalk. As for the experimental flow rate, the rainwater runoffs at the actual design frequency of 5, 10, 20, and 30 years for road conditions were converted into experimental flow rates, and as a result, flow rates ranging from 1.36 l/s to 3.96 l/s were divided into ten flow rates for a hydraulic experiment. Also, an equation taking into consideration the inflow velocity and flow width along the roadsides was proposed. The results of the experiment showed an increase in flow width and a decrease in interception rate. Also, the inflow velocity at a traverse slope of 2 % was measured, while increasing the longitudinal slope. Accordingly, an equation for calculating the flow intercepted by rain gutters at a flow width reflecting the longitudinal slope of the road and rainwater runoff, according to the design frequency, was derived by performing a regression analysis using IBM SPSS Statistics 24. It is deemed that the equation derived in this study will be useful in designing rain gutters for roads.

키워드

과제정보

본 연구는 2017년도 정부(교육부)의 재원으로 한국연구재단 지원을 받아 수행된 기초연구사업(No.2017 R1D1A1B03035823)입니다.

참고문헌

  1. Burgi, P. H. and Gober, D. E. (1977). Bicycle-safe grate inlet study, vol.1-hydraulic and safety characteristics of selected grate inlets on continuous grades, Report No. FHWA-RD-77-24, Federal Highway Administration, Washington, D.C., USA.
  2. Federal Highway Administration (1996). Urban drainage design manual, HEC 22, FHWA-SA-96-078, Federal Highway Administration, Washington, D.C., USA.
  3. Federal Highway Administration (2001). Urban drainage design manual, HEC 22, FHWA -NHI-01-021, Federal Highway Administration, Washington, D.C., USA.
  4. Guo, J. C. Y. (2000). "Design of grate inlets with a clogging factor." Advances in Environmental Research, Vol. 4, No. 3, pp. 181-186. https://doi.org/10.1016/S1093-0191(00)00013-7
  5. Guo, J. C. Y. (2009). "Street storm water conveyance capacity." Journal of Irrigation and Drainage Engineering, Vol. 126, No. 2, pp. 119-123. https://doi.org/10.1061/(ASCE)0733-9437(2000)126:2(119)
  6. Gwak, S. H., Kim, J. S. and Yoon, S. E. (2016). "Intercepted flow equation at grate inlet on road." Journal of Korea Water Resources Association, KWRA, Vol. 49, No. 6, pp. 537-549 (in Korean). https://doi.org/10.3741/JKWRA.2016.49.6.537
  7. Izzard, C. F. (1947). "Hydraulics of runoff from developed surfaces." Highway Research Board Proceedings, Washington, D.C., USA, Vol. 26, pp. 129-150.
  8. Yi, S. K. and Cho, W. C. (2002). "Effective carrying capacity on road drainage inlets." Proceedings of KSCE Conference 2002, Korean Society of Civil Engineers, pp. 490-493 (in Korean).
  9. Kemper, S. and Schlenkhoff, A. (2015). "Determination of the hydraulic efficiency of intake structures like grate inlets and screens in supercritical flow." In E-proceedings of the 36th IAHR World Congress, Hague, Netherlands.
  10. Kim, J. S., Kwon, I. S., Yoon, S. E. and Lee, J. T. (2006). "An experimental study for clogging factors estimation of grate inlets in urban area." Journal of the Korean Society of Civil Engineers, KSCE, Vol. 26, No. 2B, pp. 179-186 (in Korean).
  11. Lee, J. T., Yoon, S. E., Kim, K. S., Kim, Y. R. and Ryu, T. H. (2003). "An analysis of interception capability of storm water grate inlet in road." Journal of the Korean Society of Civil Engineers, KSCE, Vol. 36, No.3, pp. 465-480 (in Korean).
  12. Linsely, R. K., Franzini, J. B., Freyberg, D. L. and Tchobanoglous, G. (1992). Water-resources engineering 4th edition, McGRAW-Hill, New York, USA.
  13. Ministry of Environment (MOE) (2018). Design criteria of sewer facilities (in Korean).
  14. Ministry of Land, Transport and Maritime Affairs (MLTM) (2003). The guideline of design and maintenance management for drainage facilities of road (in Korean).
  15. Ministry of Land, Transport and Maritime Affairs (MLTM) (2011). The report of improvement and supplement of probability rainfall (in Korean).
  16. Ministry of Land, Transport and Maritime Affairs (MLTM) (2012). Design manual of road (in Korean).
  17. Pugh, C. A. (1980). Bicycle-safe grate inlet study, vol. 4-hydraulic characteristics of slotted inlets, Report No. FHWA-RD-79-106, Federal Highway Administration, Washington, D.C., USA.
  18. Russo, B., Gomez, M. and Martinez, P. (2006). "A simple hydrological approach to design inlet systems in urban areas according to risk criteria." Proceedings of the 7th International Conference on Hydro Science and Engineering, Philadelphia, USA, pp. 1-15.
  19. Whiffin, A. C. and Young, C. P. (1973). Drainage of level or nearly level roads, Laboratory Report No. 602, Crowthorne, Berkshire: Transport and Road Research Laboratory, Berkshire, United Kingdom.
  20. Wong, T. S. W. (1994). "Kinematic wave method for determination of road drainage inlet spacing." Advanced in Water Resources, Vol. 17, No. 6, pp. 329-336. https://doi.org/10.1016/0309-1708(94)90009-4