DOI QR코드

DOI QR Code

Contribution of using geogrid under a shallow foundation on sand subjected to static and repeated loads: Laboratory testing and numerical simulations

  • Tolun, Mustafa (Department of Civil Engineering, Adana Alparslan Turkes Science and Technology University) ;
  • Epsileli, Sefer E. (6th Regional Directorate, Republic of Turkey General Directorate of Highways) ;
  • Emirler, Buse (Department of Civil Engineering, Cukurova University) ;
  • Yildiz, Abdulazim (Department of Civil Engineering, Cukurova University) ;
  • Tutumluer, Erol (Department of Civil and Environmental Engineering, University of Illinois at Urbana-Champaign)
  • 투고 : 2020.10.12
  • 심사 : 2021.10.07
  • 발행 : 2021.10.25

초록

This paper focuses on the use of a certain punched and drawn geogrid to increase the bearing capacity of a circular shallow foundation subjected to a combination of static and repeated loads. In the experiments, the foundation is first subjected to a prespecified static load, afterwards, a repeated load derived in different proportions of the applied static load is superimposed to that static load. The variables investigated in the tests are the number of geogrid layers, the amplitude of repeated load, and the number of load cycles. The effect of these variables is also investigated by a finite element numerical modeling approach verified with one-dimensional site response analysis, and as a consequence of this effort that refers to the innovation of the study, the consistency between the results obtained from both methods is observed. The test results show that the displacements of the shallow foundation increase rapidly in the first 100 load cycles in all cases. After that, the rate of increase is reduced until about 2000 load cycles and the displacements become negligible. From the experiments, 2 geogrid layers were found to be quite effective in reducing displacements due to both static and dynamic loading cases. In other respects, finite element simulations of the physical experiment have produced numerical results in good agreement with the test results. Plus, the main contribution of the numerical simulation is to indicate the deformed mesh outputs of the model including the geogrids for the foregoing variables.

키워드

과제정보

The authors would like to thank Republic of Turkey General Directorate of Highways and 5th Regional Directorate-Mersin for the supports which are required to be able to carry out the experimental part of the study.

참고문헌

  1. Adams, M.T. and Collin, J.G. (1997), "Large model spread footing load tests on geosynthetic reinforced soil foundations", J. Geotech. Geoenviron. Eng., 123(1), 66-72. https://doi.org/10.1061/(ASCE)1090-0241(1997)123:1(66).
  2. Ahmad, H., Mahboubi, A. and Noorzad, A. (2020), "Scale effect study on the modulus of subgrade reaction of geogrid-reinforced soil", SN Appl. Sci., 2(3), 1-22.. https://doi.org/10.1007/s42452-020-2150-4.
  3. Alam, M.J.I., Gnanendran, C.T. and Lo, S.R. (2018), "Experimental and numerical investigations of the behavior of footing on geosynthetic reinforced fill slope under cyclic loading", Geotext. Geomembranes, 46(6), 848-859. https://doi.org/10.1016/j.geotexmem.2018.08.001.
  4. Alamshahi, S. and Hataf, N. (2009), "Bearing capacity of strip footings on sand slopes reinforced with geogrid and grid-anchor", Geotext. Geomembranes, 27(3), 217-226. https://doi.org/10.1016/j.geotexmem.2008.11.011.
  5. Al-rkaby, A.H., Chegenizadeh, A. and Nikraz, H.R. (2017), "Cyclic behavior of reinforced sand under principal stress rotation", J. Rock Mech. Geotech. Eng., 9(4), 585-598. https://doi.org/10.1016/j.jrmge.2017.03.010.
  6. Asakereh, A., Ghazavi, M. and Moghaddas Tafreshi, S.N. (2013), "Cyclic response of footing on geogrid-reinforced sand with void", Soils Found., 53(3), 363-374. https://doi.org/10.1016/j.sandf.2013.02.008.
  7. ASTM D2487-11 (2011), Standard practice for classification of soils for engineering purposes (Unified soil classification system), ASTM International, West Conshohocken, Pennsylvania, U.S.A.
  8. Badakhshan, E. and Noorzad, A. (2015), "Load eccentricity effects on behavior of circular footings reinforced with geogrid sheets", J. Rock Mech. Geotech. Eng., 7(6), 691-699. https://doi.org/10.1016/j.jrmge.2015.08.006.
  9. Biswas, S. and Mittal, S. (2017), "Square footing on geocell reinforced cohesionless soils", Geomech. Eng., 13(4), 641-651. https://doi.org/10.12989/gae.2017.13.4.641.
  10. Cakir, T. (2013), "Evaluation of the effect of earthquake frequency content on seismic behavior of cantilever retaining wall including soil-structure interaction", Soil Dyn. Earthq. Eng., 45, 96-111. https://doi.org/10.1016/j.soildyn.2012.11.008.
  11. Chen, J.F., Guo, X.P., Xue, J.F. and Guo, P.H. (2019), "Load behavior of model strip footings on reinforced transparent soils", Geosynth. Int., 26(3), 251-260. https://doi.org/10.1680/jgein.19.00003.
  12. Coduto, D.P. (2001), Foundation Design: Principles and Practices, Prentice Hall, New Jersey, U.S.A.
  13. Dal, K., Cansiz, O.F., Ornek, M. and Turedi, Y. (2019), "Prediction of footing settlements with geogrid reinforcement and eccentricity", Geosynth. Int., 26(3), 297-308. https://doi.org/10.1680/jgein.19.00008.
  14. Das, B.M. (2016), "Use of geogrid in the construction of railroads", Innov. Infrastruct. Solutions, 1(1), 15. https://doi.org/10.1007/s41062-016-0017-8.
  15. Das, B.M. (2017), Shallow Foundations: Bearing Capacity and Settlement, CRC Press, Boca Raton, Florida, U.S.A.
  16. El Sawwaf, M. and Nazir, A.K. (2010), "Behavior of repeatedly loaded rectangular footings resting on reinforced sand", Alexandria Eng. J., 49(4), 349-356. https://doi.org/10.1016/j.aej.2010.07.002.
  17. Fragaszy, R.J. and Lawton, E. (1984), "Bearing capacity of reinforced sand subgrades", J. Geotech. Eng., 110(10), 1500-1507. https://doi.org/10.1061/(ASCE)0733-9410(1984)110:10(1500).
  18. Ghazavi, M. and Lavasan, A.A. (2008), "Interference effect of shallow foundations constructed on sand reinforced with geosynthetics", Geotext. Geomembranes, 26(5), 404-415. https://doi.org/10.1016/j.geotexmem.2008.02.003.
  19. Hashash, Y.M.A., Musgrove, M.I., Harmon, J.A., Groholski, D.R., Phillips, C.A. and Park, D. (2015), DEEPSOIL 6.1 User Manual, University of Illinois at Urbana-Champaign, Illinois, U.S.A.
  20. Hataf, N., Boushehrian, A.H. and Ghahramani, A. (2010), "Experimental and numerical behavior of shallow foundations on sand reinforced with geogrid and grid anchor under cyclic loading", Scientia Iranica Trans. A Civ. Eng., 17(1), 1-10.
  21. Hegde, A. and Sitharam, T.G. (2016), "Behavior of geocell reinforced soft clay bed subjected to incremental cyclic loading", Geomech. Eng., 10(4), 405-422. https://doi.org/10.12989/gae.2016.10.4.405.
  22. Laman, M. and Yildiz, A. (2003), "Model studies of ring foundations on geogrid-reinforced sand", Geosynth. Int., 10(5), 142-152. https://doi.org/10.1680/gein.2003.10.5.142.
  23. Lee, K.M. and Manjunath, V.R. (2000), "Experimental and numerical studies of geosynthetic-reinforced sand slopes loaded with a footing", Can. Geotech. J., 37(4), 828-842. https://doi.org/10.1139/t00-016.
  24. Liu, F.Y., Wang, P., Geng, X., Wang, J. and Lin, X. (2016), "Cyclic and post-cyclic behavior from sand-geogrid interface large-scale direct shear tests", Geosynth. Int., 23(2), 129-139. https://doi.org/10.1680/jgein.15.00037.
  25. Liu, Y. and Glass, G. (2013), "Effects of mesh density on finite element analysis", SAE Int., 2013-01-1375. https://doi.org/10.4271/2013-01-1375.
  26. Mehrpazhouh, A., Moghaddas Tafreshi, S.N. and Mirzababaei, M. (2019), "Impact of repeated loading on mechanical response of a reinforced sand", J. Rock Mech. Geotech. Eng., 11(4), 804-814. https://doi.org/10.1016/j.jrmge.2018.12.013.
  27. Moghaddas Tafreshi, S.N. and Dawson, A.R. (2010). "Behavior of footings on reinforced sand subjected to repeated loading-Comparing use of 3D and planar geotextile", Geotext. Geomembranes, 28(5), 434-447. https://doi.org/10.1016/j.geotexmem.2009.12.007.
  28. Moghaddas Tafreshi, S.N. and Dawson, A.R. (2012). "A comparison of static and cyclic loading responses of foundations on geocell-reinforced sand", Geotext. Geomembranes, 32, 55-68. https://doi.org/10.1016/j.geotexmem.2011.12.003.
  29. Moradi, G., Abdolmaleki, A., Soltani, P. and Ahmadvand, M. (2018), "A laboratory and numerical study on the effect of geogrid-box method on bearing capacity of rock-soil slopes", Geomech. Eng., 14(4), 345-354. https://doi.org/10.12989/gae.2018.14.4.345.
  30. Musgrove, M., Harmon, J., Hashash, Y.M.A. and Rathje, E. (2017), "Evaluation of the DEEPSOIL software on the DesignSafe cyberinfrastructure", J. Geotech. Geoenviron. Eng., 143(9), 02817005. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001755.
  31. Ordu, E. and Ozkan, M.T. (2006), "Three-dimensional finite element analysis of the seismic behavior of pile foundations", ITU Dergisi/d, 5(2), 27-34. (in Turkish).
  32. PLAXIS 2D (2015), Geotechnical Finite Element Software Delft, The Netherlands. https://www.bentley.com/en/products/productline/geotechnical-engineering-software/plaxis-2d.
  33. Shin, E.C., Kim, D.H. and Das, B.M. (2002), "Geogrid-reinforced railroad bed settlement due to cyclic load", Geotech. Geol. Eng., 20(3), 261-271. https://doi.org/10.1023/A:1016040414725.
  34. Useche-Infante, D., Aiassa Martinez, G., Arrua, P. and Eberhardt, M. (2019), "Experimental study of behavior of circular footing on geogrid-reinforced sand", Geomech. Geoeng., 1-19. https://doi.org/10.1080/17486025.2019.1683621.
  35. Vijaya, S. and Gangadhara, S. (2010), "Experimental study on the performance of reinforced sand beds under repeated loads in presence of water", Proceedings of the 5th International Conference on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics, San Diego, California, U.S.A., May.
  36. Wang, J.Q., Zhang, L.L., Xue, J.F. and Tang, Y. (2018), "Load-settlement response of shallow square footings on geogrid-reinforced sand under cyclic loading", Geotext. Geomembranes, 46(5), 586-596. https://doi.org/10.1016/j.geotexmem.2018.04.009.
  37. Yeo, B., Yen, S.C., Puri, V.K., Das, B.M. and Wright, M.A. (1993), "A laboratory investigation into the settlement of a foundation on geogrid-reinforced sand due to cyclic load", Geotech. Geol. Eng., 11(1), 1-14. https://doi.org/10.1007/BF00452917.
  38. Yetimoglu, T., Wu, J.T.H. and Saglamer, A. (1994). "Bearing capacity of rectangular footings on geogrid-reinforced sand", J. Geotech. Eng., 120(12), 2083-2099. https://doi.org/10.1061/(ASCE)0733-9410(1994)120:12(2083).
  39. Yoon, Y.W., Cheon, S.H. and Kang, D.S. (2004), "Bearing capacity and settlement of tire-reinforced sands", Geotext. Geomembranes, 22(5), 439-453. https://doi.org/10.1016/j.geotexmem.2003.12.002.