Steel and Composite Structures

  • 제41권1호
  • /
  • Pages.137-147
  • /
  • 2021
  • /
  • 1229-9367(pISSN)
  • /
  • 1598-6233(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Experimental research on free vibration of curved composite box-girders with corrugated steel webs

  • Li, Yunsheng (Department of Civil Engineering, Shijiazhuang Tiedao University) ;
  • Dai, Qingnian (State Key Laboratory for Health and Safety of Bridge Structures) ;
  • Liu, Chaoxing (China Railway Bridge & Tunnel Technology Co., Ltd.) ;
  • Zhang, Yanling (Department of Civil Engineering, Shijiazhuang Tiedao University)
  • 투고 : 2020.06.25
  • 심사 : 2021.08.30
  • 발행 : 2021.10.10
⟨ 이전 논문 다음 논문 ⟩

초록

The curved composite box-girders (CBGs) with corrugated steel webs (CSWs) have been used widely in bridges due to their great advantages and the demand of the road alignment, but the curvature makes both the static and dynamic behaviors more complex. To research the free vibration performance of the curved CBGs with CSWs, 5 simply-supported test girders were designed with the span-to-radius ratio (λ=L/R), the number of the cells of the box section, and the number of the diaphragms as parameters. The natural frequencies and mode shapes were measured in the experiment. The experimental results were compared with the numerical results using ANSYS software, and a satisfying agreement was obtained. The parametric analysis shows that for the curved CBG with CSWs, the vertical mode shapes are combined flexural and torsion, and the contribution of the torsional effects to the mode shapes and frequencies improve with the increase of λ, which leads to a decrease in the vertical and lateral frequencies and increase in the torsional frequency. The corrugated angle of the steel web has little effect on the natural frequencies of the curved CBGs with CSWs. Increasing the thickness of the steel web and the number of the diaphragms can improve the torsional rigidity of the curved CBG with CSWs effectively; while the deck width has a great contribution on the lateral rigidity.

키워드

과제정보

The research described in this paper was financially supported by the National Natural Science Foundation of China (51508348, 51778377) and the Graduate Innovation Funding Program of Shijiazhuang Tiedao University (YC2021084, YC2021017).

참고문헌

  1. Androus, A., Afefy, H.M. and Sennah, K. (2017), "Investigation of free vibration and ultimate behavior of composite twin-box girder bridges", J. Constr. Steel. Res., 130, 177-192. http://doi.org/10.1016/j.jcsr.2016.12.017.
  2. Cao, L., Liu, J.P. and Chen, Y.F. (2018), "Theoretical and numerical study on the natural frequencies of bridges with corrugated steel webs", Structures, 15, 224-231. https://doi.org/10.1016/j.istruc.2018.07.005.
  3. China Association for Standardization of Engineering Construction (2011), "Technical specification for steel structures with corrugated webs" CECS 291: 2011, China Planning Publishing House, Beijing, China.
  4. Correa, R.M., Arndt, M. and Machado, R.D. (2021), "Free inplane vibration analysis of curved beams by the generalized/extended finite element method", Eur. J. Mech. A-Solid, 88, 1-12. https://doi.org/10.1016/j.euromechsol.2021.104244.
  5. De Rosa, M.A. and Lippiello, M. (2021), "Closed-form solutions for vibrations analysis of cracked Timoshenko beams on elastic medium: An analytically approach", Eng. Struct., 236, 1-9. https://doi.org/10.1016/j.engstruct.2021.111946.
  6. Duan, H.J. (2008), "Nonlinear free vibration analysis of asymmetric thin-walled circularly curved beams with open cross section", Thin. Wall. Struct., 46, 1107-1112. https://doi.org/10.1016/j.tws.2008.01.002.
  7. Hafiz, A. and Schumacher, T. (2019), "Effects of elastic supports and flexural cracking on low and high order modal properties of a reinforced concrete girder", Eng. Struct., 178, 573-585. https://doi.org/10.1016/j.engstruct.2018.10.041.
  8. He, J., Liu, Y., Chen, A. and Yoda, T. (2012), "Mechanical behavior and analysis of composite bridges with corrugated steel webs: state-of-the-art", Int. J. Steel. Struct., 12(3), 321-338. https://doi.org/10.1007/s13296-012-3003-9.
  9. Ji, W., Lu D., Liu, S.Z. and Lin, P.Z. (2016), "Study of vertical bending vibration behavior of continuous prestressed concrete box girders with corrugated steel webs", Adv. Struct. Eng., 19(6), 953-965. https://doi.org/10.1177/1369433216630461.
  10. Jiang, R.J., Au, K.F.T. and Xiao, Y.F. (2015), "Prestressed concrete girder bridges with corrugated steel webs: review", J. Struct. Eng., 141(2), 04014108-1-04014108-9. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001040.
  11. Kashefi, K., Sheikh A.H., Griffith, M.C., Ali, M.M. and Tateishi, K. (2017), "Static and vibration characteristics of thin-walled box beams: An experimental investigation", Adv. Struct. Eng., 1-20. https://doi.org/10.1177/1369433216687565.
  12. Lee, J.K. and Jeong, S. (2016), "Flexural and torsional free vibrations of horizontally curved girders on Pasternak foundations", Appl. Math. Model., 40, 2242-2256. http://dx.doi.org/10.1016/j.apm.2015.09.024.
  13. Lu, P.Z. and Shao, C.Y. (2014), "Dynamic characteristics analysis of composite curved box girders", P. I. Civil. Eng-Bri., 167(2), 81-91. http://dx.doi.org/10.1680/bren.11.00053.
  14. Milos, J., Gligor, R., Marija, N.D. and Matthias, B. (2019), "Free vibration analysis of spatial Bernoulli-Euler and Rayleigh curved beams using isogeometric approach", Appl. Math. Model., 71, 152-172. https://doi.org/10.1016/j.apm.2019.02.002.
  15. Mohseni, I., Ahn, Y. and Kang, J. (2019), "Development of improved frequency expressions for composite horizontally curved bridges with high-performance steel girders", Arab. J. Sci. Eng., 44, 4151-4160. https://doi.org/10.1007/s13369-018-3356-2.
  16. Rodrigo, N. (2020), "On the natural frequencies of simply supported beams curved in mode shapes", J Sound Vib, 485, 1-14. https://doi.org/10.1016/j.jsv.2020.115597.
  17. Samaan, M., Kennedy, J.B. and Sennah, K. (2007), "Dynamic analysis of curved continuous multiple-box girder bridges", J. Bridge Eng., 12(2), 184-193. https://doi.org/10.1061/(ASCE)1084-0702(2007) 12:2(184).
  18. Wodzinowski, R., Sennah, K. and Afefy, H.M. (2018), "Free vibration analysis of horizontally curved composite concrete-steel I-girder bridges", J. Constr. Steel. Res., 140, 47-61. https://doi.org/10.1016/j.jcsr.2017.10.011.
  19. Wong, M.Y., Shanmugam, N.E. and Osman, S.A. (2010), "Free vibration characteristics of horizontally curved composite plate girder bridges", Steel. Compos. Struct., 10(4), 297-315. https://doi.org/10.12989/scs.2010.10.4.297
  20. Ye, S.Q., Mao, X.Y., Ding, H., Ji, J.C. and Chen, L.Q. (2020), "Nonlinear vibrations of a slightly curved beam with nonlinear boundary conditions", Int. J. Mech. Sci., 168, 1-10. https://doi.org/10.1016/j.ijmecsci.2019.105294.
  21. Zhang, L., Zhu, Z.C., Shen, G. and Cao, G.H. (2015), "Free vibration of curved thin-walled rectangular beams", P. I. Civil. Eng-Str. B., 168(12), 943-957. https://doi.org/10.1680/stbu.14.00112.