DOI QR코드

DOI QR Code

Behavior of modified concrete based on crumb rubber: Experimental test and numerical investigation

  • Mezidi, Amar (Department of Civil Engineering, National Polytechnic School of Algiers) ;
  • Kettab, Ratiba Mitiche (Department of Civil Engineering, National Polytechnic School of Algiers) ;
  • Benzahar, Hamid Hamli (Department of Technology, Faculty of Sciences and Technology, University of Khemis Miliana) ;
  • Touhari, Mahfoud (Acoustic and Civil Engineering Laboratory LAGC, Faculty of Sciences and Technology, University of Khemis Miliana)
  • Received : 2020.06.09
  • Accepted : 2021.06.25
  • Published : 2021.08.25

Abstract

The Crumb rubber concrete is becoming a new interesting environmental material in the last two decades, which requires research studies on the recovery of local materials using industrial waste. The present paper is devoted to investigate the behavior of concrete made only with dunes sand and an ordinary concrete modified with various weight contents of crumb rubber. The mechanical and physical proporties such us the density, the compressive strength, the relative copmaction and the tension by bending strength of a dune sand concrete and an ordinary concrete modified with differents weight percentage of rubber crumb, 1%, 2%, 3%, 4% and 5% are investigated. The obtained results show that the optimal percentage of the crumb rubber is 3%. In addition, the results indicate that concrete made only with dunes sand has weaker elasticity modulus -54% approximately, and reduced compressive strength -63% compared to the modified ordinary concrete. Consequently, the ordinary concrete mix with crumb rubber and admixture incorporation has proven acceptable performances for the eventual use in the structural elements, however, the dunes sand only aggregate concrete modified by crumb rubber may limit its use in certain structural applications such us pavements borders. Finally, modified ordinary concrete and modified dunes sand are modeled by the finite element method and compared with the experimental results.

Keywords

References

  1. Abdeldjalil, B., Djaffar, S.B. and Kheireddine, A. (2019), "Influence of tire rubber aggregates on the physico-mechanical properties of cement mortars", Int. J. Sust. Build. Tech. Urban Develop., 10(1), 2-14. https://doi.org/10.22712/susb.20190002.
  2. Benaissa, A., Morlier, P. and Viguier, C. (2000), "Microstructure du Beton de Sable", Cement. Concret. Res., 30(5), 703-711. https://doi.org/10.1016/0008-8846(93)90017-4.
  3. Benbellil, B., Kebdani, S., Mitiche Kettab, R. and Benbouras, M.A. (2018), "Comparative modelling of seismic performance of l-shaped reinforced concrete shear walls", Urban. Arch. Constr., 10(1), 29-46.
  4. Benouadah, A., Beddar, M. and Meddah, A. (2017), "Physical And mechanical behaviour of a roller compacted concrete reinforced with polypropylene fiber", J. Fund. Appl. Sci., 9(2), 623-635. https://doi.org/10.4314/jfas.v9i2.1.
  5. Benzahar, H.H. (2019), "Theoretical and numerical analysis of stress and stress intensity factor in bi-material", Int. J. Struct. Integ., 10(1), 76-84. https://doi.org/10.1108/IJSI-08-2018-0048.
  6. Bravo, M. and Brito, J. (2012), "Concrete made with used tyre aggregate: durability related performance", J. Clean. Prod., 25, 42-50. https://doi.org/10.1016/j.jclepro.2011.11.066.
  7. Festa, J. (1998), Nouveau Guide du Beton et de Ses Constituants, Eyrolles Huitieme Edition, Paris, France.
  8. Hilal, N.N. (2017), "Hardened properties of self-compacting concrete with different crumb rubber size and content", Int. J. Sust. Built Envir., 6(1), 191-206. https://doi.org/10.1016/j.ijsbe.2017.03.001.
  9. Hosseinpour, F. and Abbasnia, R. (2014), "Experimental investigation of the stress-strain behavior of FRP confined concrete prisms", Adv. Concret Constr., 2(3), 177. https://doi.org/10.12989/acc.2014.2.3.177.
  10. Karakurt, C. (2015), "Microstructure properties of waste tire rubber composites: An overview", J. Mater. Cycl. Waste Manage., 17, 422-433. https://doi.org/10.1007/s10163-014-0263-9.
  11. Kettab, R., Bali, A. and Fleureau, J.M. (2004), "Modified bituminous concrete", International Conference Sustainable Waste Management and Recycling Challenge and Opportunities, Londres.
  12. Kettab, R., Bali, A. and Alliche, A. (2007), "Rubber modified sand concrete for waste management", Int. J. Nucl. Energ. Sci. Technol., 3(1), 63-75. https://doi.org/10.1504/IJNEST.2007.012441.
  13. Khaloo, A.R., Dehestani, P. and Rahmatabadi P. (2008), "Mechanical properties of concrete containing a high volume of tire-rubber particles", J. Wast. Manag. 28, 2472-2482. https://doi.org/10.1016/j.wasman.2008.01.015.
  14. Kromoser, B. and Huber, P. (2016), "Pneumatic formwork systems in structural engineering", Adv. Mater. Sci. Eng., 2016, Article ID 4724036. https://doi.org/10.1155/2016/4724036.
  15. Lyacia, S., Ratiba, M.K. and Djaffar, S.B. (2019), "Evaluation of the workability, marshall parameters, and the stiffness modulus of rubber modified bituminous concrete", Int. J. Sust. Build. Tech. Urban Develop., 10(2), 43-55. https://doi.org/10.22712/susb.20190006.
  16. Marzec, I., Bobinski, J. and Tejchman, J. (2007), "Simulations of spacing of localized zones in reinforced concrete beams using elasto-plasticity and damage mechanics with non-local softening", Comput. Concrete, 4(5), 377-402. https://doi.org/10.12989/cac.2007.4.5.377.
  17. Meddah, A., Bensaci, H. and Bali, A. (2017), "Study of effects of mechanical and chemical treatment of rubber on the performance of rubberized roller-compacted concrete pavement", Innov. Infrastr. Solut., 2(1), 17. https://doi.org/10.1007/s41062-017-0068-5.
  18. Sablocrete (1994), Beton de Sable, Presse de L'Ecole Nationale des Ponts Et Chaussees, Paris, France.
  19. Segre, N. and Joekes, I. (2000), "Use of tire rubber particles as addition to cement paste", J. Cement Concret Res., 30, 1421-1425. https://doi.org/10.1016/j.wasman.
  20. Tayeh, A.I. (2013), "Effect of replacement of sand by waste fine crumb rubber on concrete beam subject to impact load: experiment and simulation", Civil Eng. Res., 3(13), 165-172.
  21. Topcu, I.B. and Bilir, T. (2009), "Experimental investigation of some fresh and hardened properties of rubberized self-compacting concrete", Mater. Des., 30(8), 3056-3065. https://doi.org/10.1016/j.matdes.2008.12.011.
  22. Xu, J., Fu, Z., Han, Q., Lacidogna, G. and Carpinteri, A. (2018), "Micro-cracking monitoring and fracture evaluation for crumb rubber concrete based on acoustic emission techniques", Struct. Hlth. Monit., 17(4), 1-13. https://doi.org/10.1177/1475921717730538.
  23. Yahiaoui, W., Kenai, S., Menadi, B. and Kadri, E. (2017), "Durability of self compacted concrete containing slag in hot climate", Adv. Concrete Constr., 5(3), 271-288. https://doi.org/10.12989/acc.2017.5.3.271.
  24. Youssf, O., Mills, J.E. and Hassanli, R. (2016), "Assessment of the mechanical performance of crumb rubber concrete", Constr. Build. Mater., 125, 175-183. https://doi.org/10.1016/j.conbuildmat.2016.08.040.
  25. Yung, W.H., Yung, L.C and Hua, L.H (2013), "A study of the durability properties of waste tire rubber applied to self-compacting concrete", Constr. Build. Mater, 41, 665-672. https://doi.org/10.1016/j.conbuildmat.2012.11.019.