Wind and Structures

  • 제33권1호
  • /
  • Pages.87-101
  • /
  • 2021
  • /
  • 1226-6116(pISSN)
  • /
  • 1598-6225(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Investigation of aerodynamic performance of pitch-control wind turbine with polygonal towers

  • Kim, Y.C. (Department of Architecture, Tokyo Polytechnic University) ;
  • Tamura, Y. (Department of Civil Engineering, Chongqing University)
  • 투고 : 2021.02.22
  • 심사 : 2021.06.15
  • 발행 : 2021.07.25
⟨ 이전 논문 다음 논문 ⟩

초록

Wind turbines are commonly used power generation systems around the world and their application is becoming increasingly widespread. Traditionally, they have been mounted on circular towers, but their recent upsizing has exposed weaknesses of these structures, including problems related to manufacturing and insufficient strength. Thus, the concept of site-assembled modular towers with polygonal cross-sections has been proposed, but their aerodynamic performances have not been properly investigated. In the present study, the aerodynamic performances of a wind turbine with seven polygonal towers were investigated. Wind tunnel tests have shown that the forces on the upper structure (rotor and nacelle) are larger than those on the tower, which makes the effect of cross-sectional shape of tower relatively small. Drag forces decrease with increasing number of sides of the tower, and lift forces on the square helical tower are quite small. For the power spectra, there are peaks in high reduced frequency for oblique wind directions at azimuth angles of 60° and 90°, which were considered to result from vortices that were formed and shed behind the blade in front of the tower.

키워드

과제정보

This work was supported by JSPS KAKENHI Grant Number19H02291.

참고문헌

  1. Alvares, A.C. and Fernandez, D.C. (2016), Conceptual Design and FE Analysis of a CLT Wind Turbine Tower, Master's Thesis, Chalmers University of Technology, Gothenburg, Sweden.
  2. Architectural Institute of Japan (2015), Recommendations for Loads on Buildings (2015), Architectural Institute of Japan, Tokyo, Japan.
  3. Barthelmie, R., Hansen, O., Enevoldsen, K., Hojstrup, J., Larsen, S., Frandsen, S., Pryor, S., Motta, M. and Sanderhoff, P. (2005), "Ten years of meteorological measurements for offshore wind farms", J. Solar Energy Eng., 127, 170-176. https://doi.org/10.1115/1.1850489.
  4. Choi, B.H. and Kim, J.W. (2016), "Compressive strength evaluation of longitudinally stiffened octangular-section modular shell towers", J. Korea Academia-Ind. Cooperat. Soc., 17(1), 135-140. https://doi.org/10.5762/KAIS.2016.17.1.135.
  5. Choi, B.H., Park, S.M. and Hwang, M.O. (2013), "Local buckling strength of modular hexagon-section shell wind-turbine towers", J. Korea Soc. Hazard Mitigat., 13(1), 81-87. https://doi.org/10.9798/KOSHAM.2013.13.1.081.
  6. Dimitrov, N., Natarajan, A. and Kelly, M. (2015), "Model of wind shear conditional on turbulence and its impact on wind turbine loads", Wind Energy, 18, 1917-1931. https://doi.org/10.1002/we.1797.
  7. Faccio, C.F., Cardozo, A.C.P., Monteiro, V. and Neto, A.G. (2019), "Modeling wind turbine blades by geometrically-exact beam and shell elements: A comparative approach", Eng. Struct., 180, 357-378. https://doi.org/10.1016/j.engstruct.2018.09.032.
  8. Hu, H., Yang, Z. and Sarkar, P. (2012), "Dynamic wind loads and wake characteristics of a wind turbine model in an atmospheric boundary layer wind", Experiment. Fluids, 52, 1277-1294. https://doi.org/10.1007/s00348-011-1253-5.
  9. Huo, T. and Tong, L. (2020), "Wind-induced response analysis of wind turbine tubular towers with consideration of rotating effect of blades", Advan. Struct. Eng., 23(2), 289-306. https://doi.org/10.1177/1369433219865815.
  10. Japan Society of Civil Engineers (2010), Guidelines for design of wind turbine support structures and foundations, Japan Society of Civil Engineers, Tokyo, Japan.
  11. Jonkman, J., Butterfield, S., Musial, W. and Scott, G. (2009), Definition of a 5-MW Reference Wind Turbine for Offshore System Development, Technical Report NREL/TP-500-38060, National Renewable Energy Laboratory, Golden, Colorado.
  12. Kawai, H., Michishita, K. and Deguchi, A. (2008), "Design wind loads on a wind turbine for strong wind", Int. Colloquium on Bluff Bodies Aerodynamics & Applications VI, Milano, Italy, July.
  13. Kim, Y. and Kanda, J. (2010), "Characteristics of aerodynamic forces and pressures on square plan buildings with height variations", J. Wind Eng. Ind. Aerod., 98(8-9), 449-465. https://doi.org/10.1016/j.jweia.2010.02.004.
  14. Kim, Y.C., Bandi, E.K., Yoshida, A. and Tamura, Y. (2015), "Response characteristics of super-tall buildings - Effects of number of sides and helical angle", J. Wind Eng. Ind. Aerod., 145, 252-262. https://doi.org/10.1016/j.jweia.2015.07.001.
  15. Kono, T., Nebucho, S., Kogaki, T., Kiwata, T., Kimura, S. and Komatsu, N. (2016), "Numerical analysis of the effects of a wind turbine's rotating blades on the aerodynamics forces on the tower", 1st International Symposium on Flutter and its Application, Tokyo, Japan, May.
  16. Moriarty, P.J., Holley, W.E. and Butterfield, S.P. (2004), Extrapolation of Extreme and Fatigue Loads Using Probabilistic Methods, Technical Report NREL/TP-500-34421, National Renewable Energy Laboratory, Golden, Colorado.
  17. Okubo, K., Yamamoto, M., Fukumoto, Y. and Ishihara, T. (2016), "Wind loads on a bottom-mounted offshore wind turbine tower", 1st International Symposium on Flutter and its Application, Tokyo, Japan, May.
  18. Shourangiz-Haghighi, A., Haghnegahdar, M.A., Wang, L., Mussetta, M., Kolios, A. and Lander, M. (2019), "State of the art in the optimisation of wind turbine performance using CFD", Archiv. Comput. Methods Eng., 27, 413-431. https://doi.org/10.1007/s11831-019-09316-0.
  19. SIEMENS GAMESA (2011), https://pdf.archiexpo.com/pdf/siemens-gamesa/bolted-steelshell-toweer/88089-134503.html.
  20. Sun, C, Jahangiri, V. and Sun, H. (2019), "Performance of a 3D pendulum tuned mass damper in offshore wind turbines under multiple hazards and system variations", Smart Struct. Syst., 24(1), 53-65. http://dx.doi.org/10.12989/sss.2019.24.1.053.
  21. Tanaka, H., Tamura, T., Ohtake, K., Nakai, M. and Kim, Y.C. (2012), "Experimental investigation of aerodynamic forces and wind pressures acting on tall buildings with various unconventional configurations", J. Wind Eng. Ind. Aerod., 107-108, 179-191. https://doi.org/10.1016/j.jweia.2012.04.014.
  22. Tian, W., Ozbay, A. and Hu, H. (2019), "A wind tunnel study of wind loads on a model wind turbine in atmospheric boundary layer winds", J. Fluids Struct., 85, 17-26. https://doi.org/10.1016/j.jfluidstructs.2018.12.003.
  23. Tossas, L.A.M. and Leonardi, S. (2013), Wind Turbine modeling for computational fluid dynamics, Subcontract Report NREL/SR-5000-55054, National Renewable Energy Laboratory, Golden, Colorado.
  24. Totsuka, Y., Imamura, H. and Yde, A. (2016), "Dynamic behavior of parked wind turbine at extreme wind speed", 1st International Symposium on Flutter and its Application, Tokyo, Japan, May.
  25. WWEA (2019), Wind power capacity worldwide reaches 597 GW, 50, 1 GW added in 2018. https://wwindea.org/blog/2019/02/25/wind-power-capacityworldwide-reaches-600-gw-539-gw-added-in-2018/.
  26. Xu, N. and Ishihara, T. (2014), "Analytical formulae for wind turbine tower loading in the parked condition by using quasisteady analysis", Wind Eng., 38(3), 171-189. https://doi.org/10.1260/0309-524X.38.3.291.
  27. Zhao, Y., Pan, J., Huang, Z., Miao, Y., Jiang, J. and Wang, Z. (2020), "Analysis of vibration monitoring data of an onshore wind turbine under different operational conditions", Eng. Struct., 205, 110071. https://doi.org/10.1016/j.engstruct.2019.110071.