Structural Monitoring and Maintenance

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Continuously inhomogeneous beam structure with creep: a longitudinal crack study

  • Rizov, Victor I. (Department of Technical Mechanics, University of Architecture, Civil Engineering and Geodesy)
  • Received : 2020.08.06
  • Accepted : 2021.01.08
  • Published : 2021.03.25
⟨ Previous Next ⟩

Abstract

The main purpose of the present paper is to evaluate the influence of increase of the coefficient of viscosity with time on the strain energy release rate for a longitudinal crack in a continuously inhomogeneous beam configuration under linear creep. The beam exhibits continuous material inhomogeneity along the width, thickness and length. The creep behavior is studied analytically by a viscoelastic model structured by one dashpot and three springs. The coefficient of viscosity of the dashpot and the modulii of elasticity of the springs are distributed continuously in the width, thickness and length directions of the beam. Besides, the coefficient of viscosity increases with time. Time-dependent solutions to the strain energy release are derived by considering the balance of the energy and by applying the compliance method. The results obtained by the two solutions are identical which proves the correctness of the analysis performed. The solutions take into account the creep behavior and the increase of the coefficient of viscosity with time. A parametric study of the strain energy release rate is carried-out by using the solutions derived. It is found that the strain energy release rate decreases with increasing of the coefficient of viscosity with time.

Keywords

References

  1. Avcar, M. and Mohammed, W.K.M. (2018), "Free vibration of functionally graded beams resting on Winkler-Pasternak foundation", Arab. J. Geosci., 11, 232. http://doi.org/10.1007/s12517-018-3579-2
  2. Butcher, R.J., Rousseau, C.E. and Tippur, H.V. (1999), "A functionally graded particulate composite: Measurements and Failure Analysis", Acta. Mater., 47(2), 259-268. https://doi.org/10.1016/S1359-6454(98)00305-X
  3. Callioglu, H., Sayer, M. and Demir, E. (2011), "Stress analysis of functionally graded discs under mechanical and thermal loads", Indian J. Eng. Mater. Sci., 18(2), 111-118.
  4. Callioglu, H., Sayer, M. and Demir, E. (2015), "Elastic-plastic stress analysis of rotating functionally graded discs", Thin-Wall. Struct., 94, 38-44. https://doi.org/10.1016/j.tws.2015.03.016
  5. Demir, E., Callioglu, H. and Sayer, M. (2013), "Free vibration of symmetric FG sandwich Timoshenko beam with simply supported edges", Indian J. Eng. Mater. Sci., 20(6), 515-521.
  6. Erdogan, F. (1995), "Fracture mechanics of functionally graded materials", Computat. Eng., 5(1), 753-770. https://doi.org/10.1016/0961-9526(95)00029-M
  7. Gasik, M.M. (2010), "Functionally graded materials: bulk processing techniques", Int. J. Mater. Product Technol., 39(1-2), 20-29. https://doi.org/10.1504/IJMPT.2010.034257
  8. Han, X., Xu, Y.G. and Lam, K.Y. (2001), "Material characterization of functionally graded material by means of elastic waves and a progressive-learning neural network", Compos. Sci. Technol., 61(10), 1401-1411. https://doi.org/10.1016/S0266-3538(01)00033-1
  9. Hedia, H.S., Aldousari, S.M., Abdellatif, A.K. and Fouda, N.A. (2014), "New design of cemented stem using functionally graded materials (FGM)", Biomed. Mater. Eng., 24(3), 1575-1588. https://doi.org/10.3233/BME-140962
  10. Hirai, T. and Chen, L. (1999), "Recent and prospective development of functionally graded materials in Japan", Mater Sci. Forum, 308(4), 509-514. https://doi.org/10.4028/www.scientific.net/MSF.308-311.509
  11. Mahamood, R.M. and Akinlabi, E.T. (2017), Functionally Graded Materials, Springer.
  12. Markworth, A.J., Ramesh, K.S. and Parks, Jr.W.P. (1995), "Review: modeling studies applied to functionally graded materials", J. Mater. Sci., 30(3), 2183-2193. https://doi.org/10.1007/BF01184560
  13. Miyamoto, Y., Kaysser, W.A., Rabin, B.H., Kawasaki, A. and Ford, R.G. (1999), Functionally Graded Materials: Design, Processing and Applications, Kluwer Academic Publishers, Dordrecht/London/Boston.
  14. Nemat-Allal, M.M., Ata, M.H., Bayoumi, M.R. and Khair-Eldeen, W. (2011), "Powder metallurgical fabrication and microstructural investigations of Aluminum/Steel functionally graded material", Mater. Sci. Appl., 2(5), 1708-1718. https://doi.org/10.4236/msa.2011.212228
  15. Panigrahi, B. and Pohit, G. (2016), "Nonlinear modelling and dynamic analysis of cracked Timoshenko functionally graded beams based on neutral surface approach", Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 230(9), 1468-1497. http://doi.org/10.1177/0954406215576560
  16. Rizov, V.I. (2017), "Analysis of longitudinal cracked two-dimensional functionally graded beams exhibiting material non-linearity", Frattura ed Integrita Strutturale, 41, 498-510. https://doi.org/10.3221/IGF-ESIS.41.61
  17. Rizov, V.I. (2018a), "Non-linear fracture in bi-directional graded shafts in torsion", Multidiscipl. Model. Mater. Struct., 15(1), 156-169. https://doi.org/10.1108/MMMS-12-2017-0163
  18. Rizov, V.I. (2018b), "Analysis of cylindrical delamination cracks in multilayered functionally graded nonlinear elastic circular shafts under combined loads", Frattura ed Integrita Strutturale, 46, 158-17. https://doi.org/10.3221/IGF-ESIS.46.16
  19. Rizov, V.I. (2019), "Influence of material inhomogeneity and non-linear mechanical behavior of the material on delamination in multilayered beams", Frattura ed Integrita Strutturale, 47, 468-481. https://doi.org/10.3221/IGF-ESIS.47.37
  20. Rizov, V.I. (2020), "Longitudinal fracture analysis of inhomogeneous beams with continuously changing radius of cross-section along the beam length", Strength Fract. Complexity: Int. J., 13, 31-43. https://doi.org/10.3233/SFC-200250
  21. Rizov, V. and Altenbach, H. (2020), "Longitudinal fracture analysis of inhomogeneous beams with continuously varying sizes of the cross-section along the beam length", Frattura ed Integrita Strutturale, 53, 38-50. https://doi.org/10.3221/IGF-ESIS.53.04
  22. Saiyathibrahim, A., Subramaniyan, R. and Dhanapl, P. (2016), "Centrefugally cast functionally graded materials - review", Proceedings of International Conference on Systems, Science, Control, Communications, Engineering and Technology, pp. 68-73.
  23. Sofiyev, A.H. and Avcar, M. (2010), "The stability of cylindrical shells containing an FGM layer subjected to axial load on the Pasternak foundation", Engineering, 2, 228-236. https://doi.org/10.4236/eng.2010.24033
  24. Sofiyev, A.H., Alizada, A.N., Akin, O. Valiyev, A., Avcar, M. and Adiguzel, S. (2012), "On the stability of FGM shells subjected to combined loads with different edge conditions and resting on elastic foundations", Acta Mech., 223, 189-204. https://doi.org/10.1007/s00707-011-0548-1
  25. Udupa, G., Rao, S.S. and Gangadharan, K.V. (2014), "Functionally graded composite materials: an overview", Procedia Mater. Sci., 5(1), 1291-1299. https://doi.org/10.1016/j.mspro.2014.07.442
  26. Uslu Uysal, M. (2015), "Buckling of functional graded polymeric sandwich panel under different load cases", Compos. Struct., 121, 182-196. https://doi.org/10.1016/j.compstruct.2014.11.012
  27. Uslu Uysal, M. (2016), "Buckling behaviours of functionally graded polymeric thin-walled hemispherical shells", Steel Compos. Struct., Int. J., 21(1), 849-862. https://doi.org/10.12989/scs.2016.21.4.849
  28. Uslu Uysal, M. and Guven, U. (2016), "A bonded plate having orthotropic inclusion in the adhesive layer under in-plane shear loading", J. Adhes., 92, 214-235. https://doi.org/10.1080/00218464.2015.1019064
  29. Uslu Uysal, M. and Kremzer, M. (2015), "Buckling behaviour of short cylindrical functionally gradient polymeric materials", Acta Physica Polonica, A127, 1355-1357. https://doi.org/10.12693/APhysPolA.127.1355
  30. Wei, D., Liu, Y. and Xiang, Z. (2012), "An analytical method for free vibration analysis of functionally graded beams with edge cracks", J. Sound Vib., 331(7), 1686-1700. https://doi.org/10.1016/j.jsv.2011.11.020
  31. Wu, X.L., Jiang, P., Chen, L., Zhang, J.F., Yuan, F.P. and Zhu, Y.T. (2014), "Synergetic strengthening by gradient structure", Mater. Res. Lett., 2(1), 185-191. https://doi.org/10.1080/21663831.2014.935821
  32. Yang, J. and Chen, Y. (2008), "Free vibration and buckling analyses of functionally graded beams with edge cracks", Compos. Struct., 83(1), 48-60. https://doi.org/10.1016/j.compstruct.2007.03.006