Smart Structures and Systems

  • 제27권1호
  • /
  • Pages.53-60
  • /
  • 2021
  • /
  • 1738-1584(pISSN)
  • /
  • 1738-1991(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Experimental investigation of long-term effects on temperature reliability of exothermic coating for smart railway structures with self-heating surfaces

  • Kim, Heonyoung (Railroad Major Accident Research Team, Korea Railroad Research Institute) ;
  • Kang, Myeongcheol (Department of Mechatronics Engineering and LANL-JBNU Engineering Institute-Korea, Jeonbuk National University) ;
  • Hwang, Mun-Young (Department of Mechatronics Engineering and LANL-JBNU Engineering Institute-Korea, Jeonbuk National University) ;
  • Kang, Lae-Hyong (Department of Flexible and Printable Electronics Engineering, and LANL-JBNU Engineering Institute-Korea, Jeonbuk National University) ;
  • Joo, Chulmin (Department of Mechanical Engineering, Yonsei University) ;
  • Kang, Donghoon (Railroad Major Accident Research Team, Korea Railroad Research Institute)
  • 투고 : 2020.02.06
  • 심사 : 2020.11.18
  • 발행 : 2021.01.25
⟨ 이전 논문 다음 논문 ⟩

초록

Gravel scattering, which occurs from snow-ice that develops on trains during winter, is a major cause of damage to train parts. An exothermic technology that uses copper wires to solve the problem of gravel scattering is ineffective on the snow-ice produced on the surface of the trains. Therefore, studies have been conducted to overcome the weaknesses of the conventional methods and to develop a paint-type surface exothermic technology that can be efficiently applied to complicated structures. However, multi-layered paint-type coatings can lead to problems such as a delamination or exfoliation of the layers when used for a long period of time within an environment undergoing variations in temperature. Therefore, this study assesses the long-term effects of temperature on multi-layered exothermic coating technology based on nano-solutions for an application of self-heating function on railway infrastructures. To do so, we developed an exothermic coating test specimen using the paint applied to train cars and commercial nano-solutions. To conduct an experiment on accelerated aging, the specimen was subjected to regular changes in the temperature within a thermal chamber. The results revealed that there is a nonlinear decline in the performance as the specimen is worn out in comparison to the exothermic performance achieved during the early stages. Further, it is possible to identify the structural causes of the decline in performance from the specimen applied thermal load by analyzing the morphology. However, it is possible to observe a high stability from noninvasive overheating or short-circuits based on the structural changes to the coating, which are observed during the assessment of the exothermic uniformity. Therefore, it can be concluded that a multi-layer exothermic coating, which can be effectively applied as an exothermic technology based on self-heating surfaces, can be applied for a long period to prevent disasters from freezing or snow-ice in trains during winter.

키워드

과제정보

This research was supported by a grant from R&D Program of the Korea Railroad Research Institute, Republic of Korea.

참고문헌

  1. Arun, D.I., Chakravarthy, P., Girish, B.S., Kumar, K.S. and Santhosh, B. (2019), "Experimental and Monte Carlo simulation studies on percolation behaviour of a shape memory polyurethane carbon black nanocomposite", Smart Mater. Struct., 28(5), 055010. https://doi.org/10.1088/1361-665X/ab083b
  2. Bhattacharyya, A., Dervishi, E., Berry, B., Viswanathan, T., Bourdo, S., Kim, H., Sproles, R. and Hudson, M.K. (2007), "Energy efficient graphite-polyurethane electrically conductive coatings for thermally actuated smart materials", Smart Mater. Struct., 16(1), S187. https://doi.org/10.1088/0964-1726/16/1/S19
  3. Du, C., Dutta, S., Kurup, P., Yu, T. and Wang, X. (2019), "A Review of Railway Infrastructure Monitoring using Fiber Optic Sensors", Sensors Actuat. A: Phys., 111728. https://doi.org/10.1016/j.sna.2019.111728
  4. Guo, L. and Li, Q.Z. (2013), "Research on On-line Anti-icing Technology for Carenary along Electrified Railway", Adv. Mater. Res., 676, 321-324. https://doi.org/10.4028/www.scientific.net/AMR.676.321
  5. Hu, R., Ma, A. and Wang, Y. (2018), "Transient hot wire measures thermophysical properties of organic foam thermal insulation materials", Experim. Thermal Fluid Sci., 98, 674-682. https://doi.org/10.1016/j.expthermflusci.2018.07.005
  6. Ikeya, Y., Orlu, R., Fukagata, K. and Alfredsson, P.H. (2017), "Towards a theoretical model of heat transfer for hot-wire anemometry close to solid walls", Int. J. Heat Fluid Flow, 68, 248-256. https://doi.org/10.1016/j.ijheatfluidflow.2017.09.002
  7. Jayathilake, D.S.Y., Sagu, J.S. and Wijayantha, K.G.U. (2019), "Transparent heater based on Al, Ga co-doped ZnO thin films", Mater. Lett., 237, 249-252. https://doi.org/10.1016/j.matlet.2018.11.092
  8. Kim, M.S. and Cho, K.H. (2017), "Proposal for Specification of Counter-measurement in Frost-Heave System in Railway Underpass Box Structures in North Korea Considering Climate Condition", J. Kor. Soc. Railway, 20(1), 99-110. https://doi.org/10.7782/JKSR.2017.20.1.99
  9. Kim, H., Kang, D. and Kim, D.H. (2017), "Mechanical strength of FBG sensor exposed to cyclic thermal load for structural health monitoring", Smart Struct. Syst., Int. J., 19(3), 335-340. https://doi.org/10.12989/sss.2017.19.3.335
  10. Kim, H., Kang, D. and Choi, K. (2019), "Evaluation on Heating Performance and Resistance Characteristics of Paint-Type Exothermic Coating for Application to Railway Vehicle", J. Kor. Soc. Nondestruct. Test., 39, 300-306. https://doi.org/10.7779/JKSNT.2019.39.5.300
  11. Kumar, S.K., Ganguli, R. and Harursampath, D. (2017), "Detecting width-wise partial delamination in the composite beam using generalized fractal dimension", Smart Struct. Syst., Int. J., 19(1), 91-103. https://doi.org/10.12989/sss.2017.20.4.451
  12. Lee, H., Kang, D., Kim, J., Choi, K. and Chung, W. (2019), "Void detection of cementitious grout composite using single-walled and multi-walled carbon nanotubes", Cement Concrete Compos., 95, 237-246. https://doi.org/10.1016/j.cemconcomp.2018.10.003
  13. Li, K. and Wang, S. (2018), "A network accident causation model for monitoring railway safety", Safety Sci., 109, 398-402. https://doi.org/10.1016/j.ssci.2018.06.008
  14. Li, W., Cho, Y. and Achenbach, J.D. (2012), "Detection of thermal fatigue in composites by second harmonic Lamb waves", Smart Mater. Struct., 21(8), 085019. https://doi.org/10.1088/0964-1726/21/8/085019.
  15. Liu, X., Markine, V.L., Wang, H. and Shevtsov, I.Y. (2018), "Experimental tools for railway crossing condition monitoring (crossing condition monitoring tools)", Measurement, 129, 424-435. https://doi.org/10.1016/j.measurement.2018.07.062
  16. Miyamoto, A. and Motoshita, M. (2017), "An Intelligent bridge with an advanced monitoring system and smart control techniques", Smart Struct. Syst., Int. J., 19(6), 587-599. https://doi.org/10.12989/sss.2017.19.6.587
  17. Nilsson, F., Moyassari, A., Bautista, A., Castro, A., Arbeloa, I., Jarn, M., Lundgren, U., Welinder, J. and Johansson, K. (2019), "Modelling anti-icing of railway overhead catenary wires by resistive heating", Int. J. Heat Mass Transfer, 143, 118505. https://doi.org/10.1016/j.ijheatmasstransfer.2019.118505
  18. Onder, A. and Robinson, M. (2018), "Harmonised method for impact resistance requirements of E-glass fibre/unsaturated polyester resin composite railway car bodies", Thin-Wall. Struct., 131, 151-164. https://doi.org/10.1016/j.tws.2018.06.041
  19. Park, G.W., Lee, J.K. and Lee, H.K. (2019), "Ice Melting Capacity Evaluation of Applicable Materials of De-icing Fluid for High Speed Railway Rolling Stock", Appl. Chem. Eng., 30(3), 384-388. https://doi.org/10.14478/ace.2019.1026
  20. Redondo, O., Prolongo, S.G., Campo, M., Sbarufatti, C. and Giglio, M. (2018), "Anti-icing and de-icing coatings based Joule's heating of graphene nanoplatelets", Compos. Sci. Technol., 164, 65-73. https://doi.org/10.1016/j.compscitech.2018.05.031
  21. Wang, J., Zhang, J., Xie, F., Zhang, Y. and Gao, G. (2018), "A study of snow accumulating on the bogie and the effects of deflectors on the de-icing performance in the bogie region of a high-speed train", Cold Regions Sci. Technol., 148, 121-130. https://doi.org/10.1016/j.coldregions.2018.01.010
  22. Yang, K., Cho, K., Im, K. and Kim, S. (2016), "Temperature Maintenance of an ITO Nanoparticle Film Heater", J. IKEEE, 20(2), 171-173. https://doi.org/10.7471/ikeee.2016.20.2.171
  23. Yang, H., Bai, S., Guo, X. and Wang, H. (2019), "Robust and smooth UV-curable layer overcoated AgNW flexible transparent conductor for EMI shielding and film heater", Appl. Surface Sci., 483, 888-894. https://doi.org/10.1016/j.apsusc.2019.04.034