DOI QR코드

DOI QR Code

Specification optimization and sensitivity analysis of Si3N4/SiO2 slot and ridge-slot optical waveguides for integrated-optical biochemical sensors

집적광학 바이오케미컬 센서에 적합한 Si3N4/SiO2 슬롯 및 릿지-슬롯 광 도파로 제원 최적화 및 감지도 해석

  • Jang, Jaesik (Dept. of Electronics and Computer Engineering, Graduate School, Hongik Unversity) ;
  • Jung, Hongsik (Dept. of Electronics and Computer Engineering, Graduate School, Hongik Unversity)
  • 장재식 (홍익대학교 대학원 전자전산공학과) ;
  • 정홍식 (홍익대학교 대학원 전자전산공학과)
  • Received : 2021.04.21
  • Accepted : 2021.05.11
  • Published : 2021.05.31

Abstract

Numerical analysis was performed using FIMMWAVE to optimize the specifications of Si3N4/SiO2 slot and ridge-slot optical waveguides based on confinement factor and effective mode area. The optimized specifications were confirmed based on sensitivity in terms of the refractive index of the analyte. The specifications of the slot optical waveguide, i.e., the width of the slot and the width and height of the rails, were optimized to 0.2 ㎛, 0.46 ㎛, and 0.5 ㎛ respectively. When the wavelength was 1.55 ㎛ and the refractive index of the slot was 1.3, the confinement factor and effective mode area of 0.2024 and 2.04 ㎛2, respectively, were obtained based on the optimized specifications. The thickness of the ridge and the refractive index of the slot were set to 0.04 ㎛ and 1.1, respectively, to optimize the ridge-slot optical waveguide, and the confinement factor and effective mode area were calculated as 0.1393 and 2.90 ㎛2, respectively. When the confinement coefficient and detection degree of the two structures were compared in the range of 1 to 1.3 of the analyte index, it was observed that the confinement coefficient and sensitivity were higher in the ridge-slot optical waveguide in the region with a refractive index less than 1.133, but the reverse situation occurred in the other region. Therefore, in the implementation of the integrated optical biochemical sensor, it is possible to propose a selection criterion for the two parameters depending on the value of the refractive index of the analyte.

Keywords

Acknowledgement

이 논문은 한국연구재단 이공학개인기초연구(2018-R1D1A1B07049908) 연구비 지원으로 수행되었습니다.

References

  1. P. Lambeck, "Integrated optical sensors for the chemical domain", Meas. Sci. Technol., Vol. 17, No. 8, pp. 93-116, 2006. https://doi.org/10.1088/0957-0233/17/8/R01
  2. P. Damborsky, J. Svitel, and J. Katrlik, "Optical biosensor", Essays Biochem., Vol. 60, No. 1, pp. 91-100, 2016. https://doi.org/10.1042/EBC20150010
  3. J. Hodgkinson and R. P. Tatam, "Optical gas sensing : a review", Meas. Sci. Technol., Vol. 24, No. 1, pp. 1-59, 2013.
  4. A. P. Timbo, P. V. F. Pinto, H. A. Pinho, L. P. de Moura, J. B. Chretien, F. W. Viana, and G. de Freitas Guimaraes, "pH optical sensor based on thin films of sol-gel with bromocresol purple", Sens. Actuators B Chem., Vol. 223, No. C, pp. 406-410, 2016. https://doi.org/10.1016/j.snb.2015.09.066
  5. C. A. Barrios, K. B. Gylfason, B. Sanchez, A. Griol, H. Sohlstrom, M. Holgado, and R. Casquel, "Slot-waveguide biochemical sensor", Opt. Lett., Vol. 32, No. 21, pp. 3080-3082, 2007. https://doi.org/10.1364/OL.32.003080
  6. T. Fujisawa and M. Koshiba, "Polarization-independent optical directional coupler based on slot waveguides," Opt. Lett., Vol. 31, No. 1, pp. 56-58, 2006. https://doi.org/10.1364/OL.31.000056
  7. C. A. Barrios, "Analysis and modeling of a silicon nitride slot-waveguide microring resonator biochemical sensor", Proc. SPIE., Vol. 7356, Prague, Czech Republic, 2009.
  8. X. Wang, S. Grist, J. Flueckiger, N. A. G. Jaerger, and L. Chrostowski, "Silicon photonis slot waveguide bragg gratings and resonators", Opt. Express, Vol. 21, pp. 19029-19039, 2013. https://doi.org/10.1364/OE.21.019029
  9. A. kargar and C. Y. Chao, "Design and optimization of waveguide sensitivity in slot microring sensor", J. Opt. Soc. Am. A. Op.t Image. Sci. Vis., Vol. 28, No. 4, pp. 596-603, 2011. https://doi.org/10.1364/JOSAA.28.000596
  10. T. Dar, J. Homola, B. M. A. Rahman, and M. Rajarajan, "Label-free slot-waveguide biosensor for the detection of DNA hybridization", Appl. Opt., Vol. 51, No. 34, pp. 8195-8202, 2012 https://doi.org/10.1364/AO.51.008195
  11. V. R. Almeida, Q. Xu, C. A. Barrios, and M. Lipson, "Guiding and confining light in void nanostructure", Opt. Lett., Vol. 29, No. 11, pp. 1209-1211, 2004. https://doi.org/10.1364/OL.29.001209
  12. Q. Xu, V. R. Almeida, R. R. Panepucci, and M. Lipson, "Experimental demonstration of guiding and confining light in nanometer-size low-refractive-index material," Opt. Lett., Vol. 29, No. 14, pp. 1626-1628, 2004. https://doi.org/10.1364/OL.29.001626
  13. Y. Fang, C. Bao, Z. Wang, Y. Liu, L. Zhang, H. Huang, Y. Ren, Z. Pan, and Y. Yue, "Polarization beam splitter based on Si3N4/SiO2 horizontal slot waveguides for On-chip highpower applications", Sensors, Vol. 20, No. 10, pp. 1-13, 2020. https://doi.org/10.1109/JSEN.2019.2959158
  14. C. A. Barrios, B. Sanchez, K. B. Gylfason, A. Griol, H. Sohlstrom, M. Holgado, and R. Casquel, "Demonstration of slot-waveguide structures on silicon nitride/silicon oxide platform", Opt. Express, Vol. 15, No. 11, pp. 6846-6856, 2007. https://doi.org/10.1364/OE.15.006846
  15. H. Zengzhi, Y. Zhang, C. Zeng, D. Li, M. S. Nisar, J. Yu, and J. Xia, "High confinement Factor ridge slot waveguide for optical sensing", IEEE Photonics Tech nol. Lett., Vol. 27, No. 22, pp. 2395-2398, 2015. https://doi.org/10.1109/LPT.2015.2466595
  16. M. Kong, Y. Liu, Y. Jiang, C. Liu, and Y. Wang, "Transverse magnetic modes in planar slot waveguides", J. Opt. Soc. Am. B, Vol. 32, No. 10, pp. 2052-2060, 2015. https://doi.org/10.1364/JOSAB.32.002052
  17. M. Kong, Y. Liu, and Y. Jiang, "Transverse electric modes in planar slot waveguides", J. Mod. Opt., Vol. 65, No. 1, pp. 111-118, 2017. https://doi.org/10.1080/09500340.2017.1377307
  18. https://www.rp-photonics.com/effective_mode_area (retrived on Mar. 6, 2006)