DOI QR코드

DOI QR Code

Special cases in fatigue analysis of wind turbines

  • Gunes, Onur (Department of Civil Engineering, Istanbul Technical University) ;
  • Altunsu, Elif (Department of Civil Engineering, Istanbul Technical University) ;
  • Sari, Ali (Department of Civil Engineering, Istanbul Technical University)
  • 투고 : 2020.11.12
  • 심사 : 2021.04.20
  • 발행 : 2021.05.25

초록

The turbine industry demands a reliable design with affordable cost. As technological advances begin to support turbines of huge sizes, and the increasing importance of wind turbines from day to day make design safety conditions more important. Wind turbines are exposed to environmental conditions that can affect their installation, durability, and operation. International Electrotechnical Commission (IEC) 61400-1 design load cases consist of analyses involving wind turbine operating conditions. This design load cases (DLC) is important for determining fatigue loads (i.e., forces and moments) that occur as a result of expected conditions throughout the life of the machine. With the help of FAST (Fatigue, Aerodynamics, Structures, and Turbulence), an open source software, the NREL 5MW land base wind turbine model was used. IEC 61400-1 wind turbine design standard procedures assessed turbine behavior and fatigue damage to the tower base of dynamic loads in different design conditions. Real characteristic wind speed distribution and multi-directional effect specific to the site were taken into consideration. The effect of these conditions on the economic service life of the turbine has been studied.

키워드

참고문헌

  1. Barrera, C., Battistella, T., Guanche, R. and Losada, I.J. (2020), "Mooring system fatigue analysis of a floating offshore wind turbine", Ocean Eng., 195, 106670. https://doi.org/10.1016/j.oceaneng.2019.106670.
  2. Chou, J.S. and Tu, W.T., (2011), "Failure analysis and risk management of a collapsed large wind turbine tower", Eng. Failure Analysis, 18, 295-313. https://doi.org/10.1016/j.engfailanal.2010.09.008.
  3. DNV-RP-C203 (2010), Fatigue Design of Offshore Steel Structures
  4. Do, T.Q., Mahmoud, H. and van de Lindt, J.W. (2015), "Fatigue life of wind turbine tower bases throughout Colorado", J. Perform. Construct. Facilities, 29(4), 04014109. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000612.
  5. Gao, Q., Liu, S., Fan, J. and Shen, Z. (2019), "Wind-induced fatigue analysis of wind turbine steel tower", Earth Environment. Sci., 310(3), 032007. https://doi.org/10.1016/j.engstruct.2015.07.038.
  6. Gunes, O., Altunsu, E. and Sari, A. (2019), "Yorulma Etkisideki Ruzgar Turbinlerinin Yasam O murlerinin Degerlendirilmesi", 2019 3rd International Symposium on Multidisciplinary Studies and Innovative Technologies (ISMSIT), Ankara, Turkey, October. https://doi.org/10.1109/ISMSIT.2019.8932844.
  7. Gupta, N. (2015), "Loads Analysis of the NREL 5-MW Reference Turbine for an Onshore Site", Master's Internship at Fraunhofer Institute for Wind Energy and Energy System Technology (IWES), Bremerhaven, Germany.
  8. GWEC (2019), "Global Wind Report 2018", Global Wind Energy Council, Brussels, Belgium.
  9. Ilhan, A., Bilgili, M. and Sahin, B. (2018), "Analysis of aerodynamic characteristics of 2 MW horizontal axis large wind turbine", Wind Struct., 27(3), 187-197." https://doi.org/10.12989/was.2018.27.3.187.
  10. International Electrotechnical Commission (2005), IEC 61400-1 Wind Turbines - Part 1: Design requirements. Wind Turbines - Part 1: Design Requirements, 1-92. https://doi.org/10.1055/s2007-985912.
  11. Jonkman, B.J. and Buhl, M.L., Jr. (2007), "TurbSim User's Guide", NREL/EL-500-41136, Golden, CO: National Renewable Energy Laboratory.
  12. Jonkman, J.M. (2007), "Dynamics Modeling and Loads Analysis of an Offshore Floating Wind Turbine", National Renewable Energy Laboratory NREL/TP-500-41958, 68(November), 233. http://www.nrel.gov/docs/fy08osti/41958.pdf
  13. Jonkman, J., Butterfield, S., Musial, W. and Scott, G. (2009), Definition of a 5-MW Reference Wind Turbine for Offshore System Development. Contract, February, 1-75. http://tethys-development.pnnl.gov/sites/default/files/publications/Jonkman_et_al_2009.pdf
  14. Jonkman, J.M. and Buhl Jr, M.L. (2005), "FAST User's Guide", National Renewable Energy Laboratory, Golden, CO, Technical Report No. NREL/EL-500-38230.
  15. Kaimal, J.C., Wyngaard, J.C., Haugen, D.A., Cote, O.R. and Izumi, Y. (1976), "Turbulence structure in the convective boundary layer", J. Atmosph. Sci., 33(417), 2152-2169. https://doi.org/10.1175/15200469(1976)033<2152:TSITCB>2.0.CO;2.
  16. Kaimal, J.C., Wyngaard, J.C., Izumi, Y. and Cote, O.R. (1972), "Spectral Characteristics of Surface-layer Turbulence", J. Roy. Meteorol. Soc., 98(417), 563-589. https://doi.org/10.1002/qj.49709841707.
  17. Kanbur, F.A. (2014), "500 KW Enerji Kapasiteli Bir Ruzgar Turbinin C elik Kule Tasarimi", Master Thesis, Istanbul Technical University, Turkey.
  18. Ke, S.T., Wang, X.H., and Ge, Y.J. (2019), "Wind load and wind-induced effect of the large wind turbine tower-blade system considering blade yaw and interference", Wind Struct., 28(2), 71-87. http://dx.doi.org/10.12989/was.2019.28.2.071.
  19. Li, H., Hu, Z., Wang, J. and Meng, X., (2018), "Short-term fatigue analysis for tower base of a spar-type wind turbine under stochastic wind-wave loads", Int. J. Naval Architect. Ocean Eng., 10(1), 9-20. https://doi.org/10.1016/j.ijnaoe.2017.05.003.
  20. Manwell, J.F., Mcgowan, J.G. and Rogers, A.L. (2010), "Wind Energy Explained-Theory, Design and Application", Royal academic of engineering, Wiley, Chichester, U.K.
  21. Matha, D., Fischer, T., Kuhn, M. and Jonkman, J. (2010), "Model development and loads analysis of a wind turbine on a floating offshore tension leg platform", (No. NREL/CP-500-46725). National Renewable Energy Lab. (NREL), Golden, CO (United States).
  22. Miner, M.A. (1945), "Cumulative damage in fatigue", J. Appl. Mech., 12(3), 159-164. https://doi.org/10.1115/1.4009458
  23. Nunez-Casado, C., Lopez-Garcia, O., de las Heras, E.G., Cuerva-Tejero, A. and Gallego-Castillo, C. (2017), "Assembly strategies of wind turbine towers for minimum fatigue damage", Wind Struct., 25(6), 569-588. https://doi.org/10.12989/WAS.2017.25.6.569.
  24. Olsen, T. and Preus, R. (2015), "Small wind site assessment guidelines", National Renewable Energy Laboratory NREL/TP-5000-63696, 1-51.
  25. Palmgren, A. (1924), "Die lebensdauer von kugellagern". Zeitschrift des Vereinesdeutscher Ingenierure, 68(14), 339-341.
  26. Sahin S. (2016), "Wind Turbine Tower Structures Analysis According to Wind Load in Terms of Cost", Master. Thesis, University of Liege, Szczecin, Poland.
  27. Sahin, M. (2018), "Dynamic Modeling, Control and Adaptive Envelope Protection System for Horizontal Axis Wind Turbines", Ph.D. Dissertation, Middle East Technical University, Turkey
  28. Slot, R.M.M., Svenningsen, L., Sorensen, J.D. and Thogersen, M. L. (2018), "Directional fatigue accumulation in wind turbine steel towers", J. Phys.: Conference Series, 1102, 012017. https://dx.doi.org/10.1088/1742-6596/1102/1/012017.
  29. Udoh, I.E. and Zou, J. (2019), "Wind spectral characteristics on fatigue responses of towerbase and moorings of a floating offshore wind turbine", Ocean Syst. Eng., 9(2), 191-218. https://doi.org/10.12989/ose.2019.9.2.191.
  30. Van der Tempel, J. (2006), Design of Support Structures for Offshore Wind Turbines, Report no. 2006.029, Delft University Wind Energy Research Institute (DUWIND).
  31. Yeter, B., Garbatov, Y. and Soares, C.G. (2015), "Fatigue damage assessment of fixed offshore wind turbine tripod support structures", Eng. Struct., 101, 518-528. https://doi.org/10.1016/j.engstruct.2015.07.038.
  32. Zhu, Y. and huang, M. (2020), "Influence of non-Gaussian characteristics of wind load on fatigue damage of wind turbine", Wind Struct., 31(3), 217-227. https://doi.org/10.12989/was.2020.31.3.217.