DOI QR코드

DOI QR Code

Comparison of aerodynamic performances of various airfoils from different airfoil families using CFD

  • Kaya, Mehmet Numan (Department of Mechanical Engineering, Necmettin Erbakan University) ;
  • Kok, Ali Riza (Department of Mechanical Engineering, Necmettin Erbakan University) ;
  • Kurt, Huseyin (Department of Mechanical Engineering, Necmettin Erbakan University)
  • Received : 2020.12.15
  • Accepted : 2021.03.12
  • Published : 2021.03.25

Abstract

In this study, three airfoil families, NACA, FX and S, in each case three from each series with different shapes were investigated at different angles of attack using Computational Fluid Dynamics (CFD) method. To verify the CFD model, simulation results of the NACA 0012 airfoil was compared against the available experimental data and k-ω SST was used as the turbulence model. Lift coefficients, lift to drag ratios and pressure distributions around airfoils were obtained from the CFD simulations and compared each other. The simulations were performed at three Reynolds numbers, Re=2×105, 1×106and 2×106, and angle of attack was varied between -6 and 12 degrees. According to the results, similar lift coefficient values were obtained for symmetric airfoils reaching their maximum values at similar angles of attack. Maximum lift coefficients were obtained for FX 60-157 and S 4110 airfoils having lift coefficient values around 1.5 at Re=1×106 and 12 degrees of angle of attack. Flow separation occurred close to the leading edge of some airfoils at higher angles of attack, while some other airfoils were more successful in keeping the flow attached on the surface.

Keywords

References

  1. Abbott, I.H. and von Doenhoff, A.E. (1959), Theory of Wing Sections, Dover Publications, New York.
  2. Abinav, R., Nair, N.R., Sravan, P., Kumar, P. and Nagaraja, S.R. (2016), "CFD Analysis of co flow jet airfoil", Indian J. Sci. Technol., 9, 45. https://doi.org/10.17485/ijst/2016/v9i45/104686.
  3. Alonso-Estebanez, A., del Coz Diaz, J.J., Rabanal, F.P., lvarez Pascual-Munoz, P. and Nieto, P.J.G. (2018), "Numerical investigation of truck aerodynamics on several classes of infrastructures", Wind Struct., 26(1), 35-43. https://doi.org/10.12989/WAS.2018.26.1.035.
  4. Anitha, D., Shamili, G.K., Kumar, P.R. and Vihar, R.S. (2018), "Air foil shape optimization using CFD and parametrization methods", Mater. Today: Proc., 5(2), 5364-5373. https://doi.org/10.1016/j.matpr.2017.12.122.
  5. ANSYS Inc (2017), ANSYS Fluent 18.0 Theory Guide, Ansys.
  6. Aranake, A.C., Lakshminarayan, V.K. and Duraisamy, K. (2015), "Computational analysis of shrouded wind turbine configurations using a 3-dimensional RANS solver", Renew. Energy, 75, 818-832. https://doi.org/10.1016/j.renene.2014.10.049.
  7. Argyropoulos, C.D. and Markatos, N.C. (2015), "Recent advances on the numerical modelling of turbulent flows", Appl. Math. Model., 39(2), 693-732. https://doi.org/10.1016/j.apm.2014.07.001.
  8. Bansal, L., Chauhan, S., Kumar, C., Muzakkir, S.M. and Jafri, H.Z. (2017), "CFD Analysis of an aerofoil placed in uniform Flow", Int. J. Sci. Eng. Res, 8(7), 163-165.
  9. Basta, E., Ghommem, M., Romdhane, L. and Abdelkefi, A. (2020), "Modeling and experimental comparative analysis on the performance of small-scale wind turbines", Wind Struct., 30(3), 261-273. http://dx.doi.org/10.12989/was.2020.30.3.261.
  10. Cakmakcioglu, S.C., Sert, I.O., Tugluk, O. and Sezer-Uzol, N. (2014), "2-D and 3-D CFD investigation of NREL S826 airfoil at low Reynolds numbers", J. Phys. Conf. Ser., 524(1), IOP Publishing.
  11. Celik, Y., Ma, L., Ingham, D. and Pourkashanian, M. (2020), "Aerodynamic investigation of the start-up process of H-type vertical axis wind turbines using CFD", J. Wind. Eng. Ind. Aerod., 204, 104252. https://doi.org/10.1016/j.jweia.2020.104252.
  12. Eggert, C.A. and Rumsey, C.L. (2017), CFD study of NACA 0018 airfoil with flow control, NASA/TM-2017-219602.
  13. Elsakka, M.M., Ingham, D.B., Ma, L. and Pourkashanian, M. (2018), "Effects of turbulence modelling on the predictions of the pressure distribution around the wing of a small scale vertical axis wind turbine", The 7th European Conference on Computational Fluid Dynamics (ECFD 7), Glasgow, U.K.
  14. Gresho, P.M. (1991), "Some current CFD issues relevant to the incompressible Navier-Stokes equations", Comput. Methods Appl. Mech. Eng., 87(2-3), 201-252. https://doi.org/10.1016/0045-7825(91)90006-R.
  15. Ilhan, A., Bilgili, M. and Sahin, B. (2018), "Analysis of aerodynamic characteristics of 2 MW horizontal axis large wind turbine", Wind Struct., 27(3), 187-197. http://dx.doi.org/10.12989/was.2018.27.3.187.
  16. Kapsalis, P.C.S., Voutsinas, S. and Vlachos, N.S. (2016), "Comparing the effect of three transition models on the CFD predictions of a NACA0012 airfoil aerodynamics", J. Wind. Eng. Ind. Aerod., 157, 158-170. https://doi.org/10.1016/j.jweia.2016.07.007.
  17. Kaya, M.N., Kose, F., Ingham, D., Ma, L. and Pourkashanian, M. (2018), "Aerodynamic performance of a horizontal axis wind turbine with forward and backward swept blades", J. Wind. Eng. Ind. Aerod., 176, 166-173. https://doi.org/10.1016/j.jweia.2018.03.023.
  18. Kose, F. and Kaya, M.N. (2018), "Wind-hydro pumped storage power stations to meet the energy demands of irrigation: Feasibility, optimal design and simulation of a system," J. Chin. Soc. Mech. Eng., 39(2), 223-232. http://dx.doi.org/10.29979/JCSME.
  19. Li, X., Zhang, L., Song, J., Bian, F. and Yang, K. (2020), "Airfoil design for large horizontal axis wind turbines in low wind speed regions", Renew. Energy, 145, 2345-2357. https://doi.org/10.1016/j.renene.2019.07.163.
  20. Lin, Y.T. and Chiu, P.H. (2020), "Influence of leading-edge protuberances of fx63 airfoil for horizontal-axis wind turbine on power performance", Sustain. Energy Technol. Assess., 38, 100675. https://doi.org/10.1016/j.seta.2020.100675.
  21. Manwell, J.F., McGowan, J.G. and Rogers, A.L. (2010), Wind energy explained: theory, design and application, John Wiley & Sons.
  22. Matyushenko, A.A., Kotov, E.V. and Garbaruk, A.V. (2017), "Calculations of flow around airfoils using two-dimensional RANS: an analysis of the reduction in accuracy", St. Petersburg Polytech. Univ. J.: Phys Math., 3(1), 15-21. https://doi.org/10.1016/j.spjpm.2017.03.004.
  23. Menter F.R. (1992), "Influence of freestream values on k-omega turbulence model predictions", AIAA J. 30, 1657-1659. http://dx.doi.org/10.2514/3.11115.
  24. Menter F.R. (1994), "Two-equation eddy-viscosity turbulence models for engineering applications", AIAA J. 32, 1598-1605. http://dx.doi.org/10.2514/3.12149.
  25. Morgado, J., Vizinho, R., Silvestre, M.A.R. and Páscoa, J.C. (2016), "XFOIL vs CFD performance predictions for high lift low Reynolds number airfoils", Aerosp. Sci. Technol., 52, 207-214. https://doi.org/10.1016/j.ast.2016.02.031.
  26. Patel, K.S., Patel, S.B., Patel, U.B. and Ahuja, A.P. (2014), "CFD Analysis of an eerofoil", Int. J. Eng. Res., 3(3), 154-158. https://doi.org/10.17950/ijer/v3s3/305
  27. Rostami, M.V., Saghafian, M., Sedaghat, A. and Miansari, M. (2011), "Numerical investigation of turbulent flow over a stationary and oscillatory NACA0012 airfoil using overset grids method'', Int. J. Numer. Methods Fluids, 67, 135-154. https://doi.org/10.1002/fld.2332.
  28. Shantanu, S., Bhat, R. and Govardhan, N. (2013), "Stall flutter of NACA 0012 airfoil at low Reynolds numbers'', J. Fluids Struct., 41, 166-174. https://doi.org/10.1016/j.jfluidstructs.2013.04.001.
  29. Siauw, W.L., Bonnet, J.P., Tensi, J., Cordier L., Noack B.R. and Cattafesta, L. (2010), "Transient dynamics of the flow around a NACA 0015 airfoil using fluidic vortex generators," Int. J. Heat Fluid Flow, 31(3), 450-459. https://doi.org/10.1016/j.ijheatfluidflow.2010.02.028.
  30. Spurthy, S., Sumukha, G.D., Prathik, B.V., Naveen, R., Srikanth, H.V. and Sridhar, K. (2016), "Study on effect of surface modification on aerodynamic characteristics of Eppler 387 airfoil", AIP Conf. Proc., 2204(1), AIP Publishing LLC. https://doi.org/10.1063/1.5141573.
  31. Sreejith B.K. and Sathyabhama, A. (2018), ''Numerical study on effect of boundary layer trips on aerodynamic performance of E216 airfoil'', Eng. Sci. Technol. Int. J., 21, 77-88. https://doi.org/10.1016/j.jestch.2018.02.005.
  32. Srinath, D.N. and Mittal, S. (2009), "Optimal airfoil shapes for low Reynolds number flows", Int. J. Numer. Methods Fluids, 61(4), 355-381. https://doi.org/10.1002/fld.1960.
  33. Tarhan, C. and Yilmaz, I. (2019), "Numerical and experimental investigations of 14 different small wind turbine airfoils for 3 different reynolds number conditions", Wind Struct., 28(3), 141-153. https://doi.org/10.12989/was.2019.28.3.141.
  34. Tasci, M.O., Karasu, I., Sahin, B. and Akilli, H. (2020), "Investigation of crossflow features of a slender delta wing", Wind Struct., 31(3), 229-240. http://dx.doi.org/10.12989/was.2020.31.3.229.
  35. Troolin, D.R., Longmire, E.K. and Lai, W.T. (2006), "Time resolved PIV analysis of flow over a NACA 0015 airfoil with Gurney flap", Exp. Fluids, 41, https://doi.org/10.1007/s00348-006-0143-8.
  36. Tu, J., Yeoh, G.H. and Liu, C. (2018), Computational Fluid Dynamics: A practical approach, Butterworth-Heinemann.
  37. Younsi, A., zamree bin abd Rahim, S. and Rezoug, T. (2019), "Aerodynamic investigation of an airfoil under two hovering modes considering ground effect", J. Fluids Struct., 91, 102759. https://doi.org/10.1016/j.jfluidstructs.2019.102759.
  38. Zamani, M., Maghrebi, M.J. and Moshizi, S.A. (2016), "Numerical study of airfoil thickness effects on the performance of J-shaped straight blade vertical axis wind turbine", Wind Struct., 22(5), 595-616. https://doi.org/10.12989/WAS.2016.22.5.595.

Cited by

  1. Experimental study of a micro-scale sloped solar chimney power plant vol.35, pp.12, 2021, https://doi.org/10.1007/s12206-021-1146-3