DOI QR코드

DOI QR Code

Effect of Ice accretion on the aerodynamic characteristics of wind turbine blades

  • Sundaresan, Aakhash (Turbulence and Flow Control Lab, School of Mechanical Engineering, SASTRA Deemed University) ;
  • Arunvinthan, S. (Turbulence and Flow Control Lab, School of Mechanical Engineering, SASTRA Deemed University) ;
  • Pasha, A.A. (Department of Aerospace Engineering, King Abdulaziz University) ;
  • Pillai, S. Nadaraja (Turbulence and Flow Control Lab, School of Mechanical Engineering, SASTRA Deemed University)
  • 투고 : 2020.09.28
  • 심사 : 2021.01.21
  • 발행 : 2021.03.25

초록

Cold regions with high air density and wind speed attract wind energy producers across the globe exhibiting its potential for wind exploitation. However, exposure of wind turbine blades to such cold conditions bring about devastating impacts like aerodynamic degradation, production loss and blade failures etc. A series of wind tunnel tests were performed to investigate the effect of icing on the aerodynamic properties of wind turbine blades. A baseline clean wing configuration along with four different ice accretion geometries were considered in this study. Aerodynamic force coefficients were obtained from the surface pressure measurements made over the test model using MPS4264 Simultaneous pressure scanner. 3D printed Ice templates featuring different ice geometries based on Icing Research Tunnel data is utilized. Aerodynamic characteristics of both the clean wing configuration and Ice accreted geometries were analysed over a wide range of angles of attack (α) ranging from 0° to 24° with an increment of 3° for three different Reynolds number in the order of 105. Results show a decrease in aerodynamic characteristics of the iced aerofoil when compared against the baseline clean wing configuration. The key flow field features such as point of separation, reattachment and formation of Laminar Separation Bubble (LSB) for different icing geometries and its influence on the aerodynamic characteristics are addressed. Additionally, attempts were made to understand the influence of Reynolds number on the iced-aerofoil aerodynamics.

키워드

참고문헌

  1. Afzal, F. and Muhammad, S. Virk. (2018), "Review of icing effects on wind turbine in cold regions.", E3S Web of Conferences 72. https://doi.org/10.1051/e3sconf/20187201007.
  2. Akay, B., Ragni, D., Ferreira, C.S. and Van Bussel, G.J.W. (2013), "Investigation of the Root Flow in a Horizontal Axis", Wind Energy, 1-20. https://doi.org/10.1002/we.
  3. Akin I., Mehmet, B. and Besir, S. (2018), "Analysis of aerodynamic characteristics of 2 MW horizontal axis large wind turbine", Wind Struct., 27(3), 187-197. http://dx.doi.org/10.12989/was.2018.27.3.187.
  4. Bose, N. (1992), "Icing on a small horizontal-axis wind turbine-Part 1: Glaze ice profiles", J. Wind Eng. Ind. Aerod., 45(1), 75-85. https://doi.org/10.1016/0167-6105(92)90006-V.
  5. Bragg, M.B., Broeren, A.P. and Blumenthal, L.A. (2005), "Iced-airfoil aerodynamics", Progress Aeros. Sci., 41(5), 323-362. https://doi.org/10.1016/j.paerosci.2005.07.001.
  6. Bragg, M.B., Khodadoust, A. and Spring, S.A. (1992). "Measurements in a leading-edge separation bubble due to a simulated airfoil ice accretion", AIAA J., 30(6), 1462-1467. https://doi.org/10.2514/3.11087.
  7. Broeren, A., LaMarre, C., Bragg, M. and Lee, S. (2005), "Characteristics of SLD ice accretions on airfoils and their aerodynamic effects", In 43rd AIAA Aerospace Sciences Meeting and Exhibit.
  8. Cao, Y., Wenyuan T. and Zhenlong W. (2018), "Aircraft icing: An ongoing threat to aviation safety", Aeros. Sci. Technol. 75, 353-85. https://doi.org/10.1016/j.ast.2017.12.028.
  9. Cevahir T. and Ilker Y. (2019), "Numerical and experimental investigations of 14 different small wind turbine airfoils for 3 different Reynolds number condition", Wind Struct., 28(3), 141-153. http://dx.doi.org/10.12989/was.2019.28.3.141.
  10. Fakorede, O., Zoe F., Hussein I., Adrian I., Jean P. and Christian M. (2016), "Ice protection systems for wind turbines in cold climate: Characteristics, comparisons and analysis", Renew. Sustain. Energy Rev., https://doi.org/10.1016/j.rser.2016.06.080.
  11. Ferrer, E. and Munduate, X. (2007), "Wind turbine blade tip comparison using CFD", In Journal of Physics: Conference Series, https://doi.org/10.1088/1742-6596/75/1/012005.
  12. Fu, P. and Masoud F. (2010), "A CFD approach for modeling the rime-ice accretion process on a horizontal-axis wind turbine", J. Wind Eng. Ind. Aerod., 98(4-5), 181-188. https://doi.org/10.1016/j.jweia.2009.10.014.
  13. Han, Y., Jose P. and Sven S. (2012), "Scaled ice accretion experiments on a rotating wind turbine blade", J. Wind Eng. Ind. Aerod., 109, 55-67. https://doi.org/10.1016/j.jweia.2012.06.001.
  14. Han, Y., Jose P. and Sven, S. (2012), "Scaled ice accretion experiments on a rotating wind turbine blade", J. Wind Eng. Ind. Aerod., 109, 55-67. https://doi.org/10.1016/j.jweia.2012.06.001.
  15. Homola, M.C., Virk, M.S., Wallenius, T., Nicklasson, P.J. and Sundsbo, P.A. (2010), "Effect of atmospheric temperature and droplet size variation on ice accretion of wind turbine blades", J. Wind Eng. Ind. Aerod., 98(12), 724-729. https://doi.org/10.1016/j.jweia.2010.06.007.
  16. Howard R.J.A and Pereira J.C.F. (2006), "A study of wind turbine power generation and turbine/tower interaction using large eddy simulation", Wind Struct., 9(2), 95-108. http://dx.doi.org/10.12989/was.2006.9.2.095
  17. Hu, L., Xiaocheng Z., Jinge C., Xin, S. and Zhaohui, D. (2018), "Numerical simulation of rime ice on NREL phase VI blade", J. Wind Eng. Ind. Aerod., 178(May), 57-68. https://doi.org/10.1016/j.jweia.2018.05.007.
  18. Hudecz, A. (2014), "Icing problems of wind turbine blades in cold climates", Ph.D. Dissertation, Department of Wind Energy, Technical University of Denmark.
  19. Ibrahim, G.M., Pope, K. and Muzychka, Y.S. (2018), "Effects of blade design on ice accretion for horizontal axis wind turbines", J. Wind Eng. Ind. Aerod., 173, 39-52. https://doi.org/10.1016/j.jweia.2017.11.024.
  20. Jasinski, W.J., Noe, S.C., Selig, M.S. and Bragg, M.B. (1998), Wind Turbine Performance Under Icing Conditions.
  21. Jin, J.Y. and Virk, M.S. (2018), "Study of ice accretion along symmetric and asymmetric airfoils", J. Wind Eng. Ind. Aerod., 179(March), 240-249. https://doi.org/10.1016/j.jweia.2018.06.004.
  22. Jin, J.Y. and Virk, M.S. (2020), "Experimental study of ice accretion on S826 & S832 wind turbine blade profiles", Cold Regions Sci. Technol., 169, 102913. https://doi.org/10.1016/j.coldregions.2019.102913.
  23. Lamraoui, F., Guy F., Robert, B., Jean, P. and Christian, M. (2014), "Atmospheric icing impact on wind turbine production", Cold Regions Sci. Technol., https://doi.org/10.1016/j.coldregions.2013.12.008.
  24. Maissan, J.F. (2001), "Wind power development in sub-arctic conditions with severe rime icing", Northern Review, 24, 174-183.
  25. Parent, O. and Adrian, I. (2011), "Anti-icing and de-icing techniques for wind turbines: Critical review", Cold Regions Sci. Technol., https://doi.org/10.1016/j.coldregions.2010.01.005.
  26. Politovich, M.K. (2014), "Aviation meteorology: Aircraft icing", Encyclopedia Atmos. Sci., 1. https://doi.org/10.1016/B978-0-12-382225-3.00055-4.
  27. Pouryoussefi, S.G., Mirzaei, M., Nazemi, M.M., Fouladi, M. and Doostmahmoudi, A. (2016), "Experimental study of ice accretion effects on aerodynamic performance of an NACA 23012 airfoil", Chinese J. Aeronaut., 29(3), 585-595. https://doi.org/10.1016/j.cja.2016.03.002.
  28. Pryor, S.C. and Barthelmie, R.J. (2010), "Climate change impacts on wind energy: A review", Renew. Sustain. Energy Rev., 14(1), 430-437. https://doi.org/10.1016/j.rser.2009.07.028.
  29. Raj, L.P., Lee, J.W. and Myong, R.S. (2019), "Ice accretion and aerodynamic effects on a multi-element airfoil under SLD icing conditions", Aeros. Sci. Technol., 85, 320-333. https://doi.org/10.1016/j.ast.2018.12.017.
  30. Rodriguez, I., Lehmkuhl, O., Borrell, R. and Oliva, A. (2015), Flow past a NACA0012 airfoil: From laminar separation bubbles to fully stalled regime", In Direct and Large-Eddy Simulation IX, 225-231, Springer, Cham. https://doi.org/10.1007/978-3-319-14448-1_28.
  31. Shin, J., Berkowitz, B., Chen, H.H. and Cebeci, T. (1994), "Prediction of ice shapes and their effect on airfoil drag", J. Aircraft, 31(2), 263-270. https://doi.org/10.2514/3.46483.
  32. Shu, L., Hantao, L., Qin, H., Xingliang, J., Gang, Q., Ghyslaine, M. and Hang, Y. (2018), "Study of ice accretion feature and power characteristics of wind turbines at natural icing environment", Cold Regions Sci. Technol., https://doi.org/10.1016/j.coldregions.2018.01.006.
  33. Somers, D.M. (1997), Design and Experimental Results for the S809 Airfoil, No. NREL/SR-440-6918. National Renewable Energy Lab., Golden.
  34. Tsai Hsiang, C. and Van Tan, T. (2015), "Prospects of wind energy on Penghu Island, Taiwan", Wind Struct. 20(1), 1-13. http://dx.doi.org/10.12989/was.2015.20.1.001.
  35. Tsao, J.C. and Anderson, D. (2004), "Additional study of MVD effects on ice shapes", In 42nd AIAA Aerospace Sciences Meeting and Exhibit.
  36. Virk, M.S., Homola, M.C. and Nicklasson, P.J. (2010), "Effect of rime ice accretion on aerodynamic characteristics of wind turbine blade profiles", Wind Eng., 34(2), 207-218. https://doi.org/10.1260/0309-524X.34.2.207.
  37. Virk, M.S., Homola, M.C. and Nicklasson, P.J. (2012), "Atmospheric icing on large wind turbine blades", Int. J. Energy Environ, 3(1), 1-8. https://doi.org/10.1186/2251-6832-3-1
  38. World Wind Energy Association (2019), World Wind Energy Association-Wind Power Capacity Worldwide Reaches 600 GW, 53, 9 GW added in 2018. Press ReleasesStatistics.
  39. Yirtici, O., Tuncer, I.H. and Ozgen, S. (2016), "Ice accretion prediction on wind turbines and consequent power losses", In J. Phys. Conference Series, 753(2), 022022, IOP Publishing. https://doi.org/10.1088/1742-6596/753/2/022022.
  40. Zhang, C. and Liu, H. (2016), "Effect of drop size on the impact thermodynamics for supercooled large droplet in aircraft icing", Phys. Fluids, 28(6), 062107. https://doi.org/10.1063/1.4953411.