Wind and Structures

  • 제33권6호
  • /
  • Pages.463-470
  • /
  • 2021
  • /
  • 1226-6116(pISSN)
  • /
  • 1598-6225(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Effect of trailing-edge modification over aerodynamic characteristics of NACA 0020 airfoil

  • Ethiraj, Livya (Turbulence and Flow Control Lab, School of Mechanical Engineering, SASTRA Deemed University) ;
  • Pillai, Subramania Nadaraja (Turbulence and Flow Control Lab, School of Mechanical Engineering, SASTRA Deemed University)
  • 투고 : 2021.06.21
  • 심사 : 2021.12.07
  • 발행 : 2021.12.25
⟨ 이전 논문 다음 논문 ⟩

초록

This study investigates the aerodynamic characteristics of NACA series airfoil by altering the trailing edge in the form of extended and serrated sections. This contemporary advent examined NACA 0020 airfoil experimentally at the angle of attack ranging from 0° to 45° and for the Reynolds number of 2.46 × 105. To figure out the flow behaviour, the standard average pressure distribution over the airfoil surface is estimated with 50 pressure taps. The time series surface pressure is recorded for 700 Hz of sampling frequency. The extended trailing edge of 0.1 c, 0.2 c and 0.3 c are attached to the base airfoil. Further, the triangular serration is introduced with the base length of 2 cm, 4 cm and 6 cm. Each base length with three different amplitudes of 0.1 c, 0.2 c and 0.3 c were designed and equipped with the baseline case at the trailing edge and tested. The aerodynamic force coefficient, as well as pressure coefficient are presented. The obtained data advises that modification in the trailing edge will reflect the aerodynamic characteristics and the flow behaviour over the section of a wing. Resultantly, the extended trailing edge as a thin elongated surface attached to a base airfoil without revising the main airfoil favors good lift increment. The serrated trailing edge acts as a flow control device by altering the flow pattern results to delay the stall phenomenon. Besides it, improves lift co-efficient with less amount of additional drag. This extended and serrated trailing edge approach can support for designing the future smart airfoil.

키워드

참고문헌

  1. Abbas, E., Majid, H. and Kamran, G. (2018), "Experimental study of stall control over an airfoil with dual excitation of separated shear layers", Aeros. Sci. Technol., 82, 402-411. http://doi.org/10.1016/j.ast.2018.09.027.
  2. Akash S., Arunvinthan, S., Pasha, A.A. and Nadaraja Pillai, S. (2021), "Effect of ice acceleration on the aerodynamic characteristics of wind turbine blades", Wind Struct., 32(3), 205-217. https://doi.org/10.12989/was.2021.32.3.205.
  3. Alawadhi, H.A., Alex, A.G. and Kim, Y.H. (2014), "CFD analysis of wing trailing edge vortex generator using serrations", EPJ Web Conferences, 67, 1-12. https://doi.org/10.1051/epjconf/20146702002.
  4. Arivoli, D. and Ishan, S. (2016), "Self-adaptive flaps on low aspect ratio wings at low Reynolds numbers", Aeros. Sci. Techno., 59, 78-93. http://dx.doi.org/10.1016/j.ast.2016.10.006.
  5. Arturo, A., Jesus, A.F.S.P. and Juan, C.J. (2021), "A novel high performance diffuser design for small DAWT's by using blunt trailing edge airfoil", Wind Struct., 32(1), 47-53. http://dx.doi.org/10.12989/was.2021.32.1.047.
  6. Arunvinthan, S. and Nadaraja pillai, S. (2019), "Aerodynamic characteristics of unsymmetrical aerofoil at various turbulence intensities", Chinese J. Aeronaut., 32(11), 2395-2407. https://doi.org/10.1016/j.cja.2019.05.014
  7. Arunvinthan, S., Nadaraja pillai, S. and Shuyang, C. (2020), "Aerodynamic characteristics of variously modified leading-edge protuberanced (LED) wind turbine blades under various turbulent intensities", J. Wind Eng. Ind. Aerod., 202, 1-18. https://doi.org/10.1016/j.jweia.2020.104188.
  8. Catalano, F.M. and Santana, L.D. (2012), "Airfoil self-noise reduction by application of different types of trailing edge serrations", 28th Int. Congress Aeronaut. Sci., Yokohama, Japan.
  9. Deepesh, D., Dhurba, A., Kishan, R.P. and Kshitiz, B. (2019), Performance Analysis of Airfoil Using Biomimicry: Serrated Trailing Edge and Denticles Inspired Surface, Report No. B-04-BME-2015/2019. Department of Mechanical Engineering, Tribhuvan University, Lalitpur, Nepal.
  10. He-Yong, X., Qing-Li, D., Cheng-Liang, Q. and Zheng-Yin, H. (2018), "Flow control over the blunt trailing edge of wind turbine airfoils using circulation control", Energies, 619(11), 1-26. http://doi.org/10.3390/en11030619.
  11. Justin, W., Hikaru, O., Bharath, G. and Inderjit, C. (2018), "Basic understanding of airfoil characteristics at low Reynolds numbers (104-105)", J. Aircraft, 55(3), 1050-1061. https://doi.org/10.2514/1.C034415.
  12. Li, Q.S. and Melbourne, W.H. (1999), "Turbulence effects on surface pressures of rectangular cylinders", Wind Struct., 2(4), 253-226. http://dx.doi.org/10.12989/was.1999.2.4.253.
  13. Li, Y.C., Wang, J.J. and Hua, J. (2006), "Experimental investigations on the effects of divergent trailing edge and gurney flaps on a supercritical airfoil", Aeros. Sci. Technol., 11, 91-99. https://doi.org/10.1016/j.ast.2006.01.006.
  14. Muraleekrishnan, M., Fernando, P., Xiao, S. and Qingli, D. (2016), "Aerodynamic analysis of flow-control devices for wind turbine application based on the trailing-edge slotted flap concept", J. Aeros. Eng., 29(5). 1-12. https://doi.org/10.0161/(ASCE)AS.1943-5525.0000623.
  15. Gall, P.D. (2010), A Numerical and Experimental Study of the Effects of Dynamic Roughness on Leading Edge Separation, Master Thesis, Dissertations and Problem Reports. 2984.
  16. Sameh, E. (2020), "Flow-conditioning of a subsonic wind tunnel to model boundary layer flows", Wind Struct., 30(4), 339-366. http://dx.doi.org/10.12989/was.2020.30.4.339.
  17. Akansu, S.O., Akansu, Y.E., Dagdevir, T., Daldaban, F. and Yavas, F. (2015), "Experimental and numerical aerodynamic investigation of a prototype vehicle", Wind Struct., 20(6), 811-827. http://dx.doi.org/10.12989/was.2015.20.6.811.
  18. Tianshu, L., Montefort, J., Liou. W. and Pantula. S.R. (2007), "Lift Enhancement by static extended trailing edge", J. Aircraft, 44(6), 1939-1947. http://doi.org/10.2514/1.31995.
  19. Usama, H., Saif Ul, M., Burhan, S. and Ozaif, A. (2017), "Effect of trailing edge serration on the lift and drag characteristics of NACA 0012 airfoil wing", 35th AIAA Appl. Aerod. Confer., Colorado. https://doi.org/10.2514/6.2017-4470.
  20. Xi, X. and Kamran. M. (2016), "Unsteady aerodynamics and trailing-edge vortex sheet of an airfoil", 54th AIAA Aeros. Sci. Meeting, Califonia, U.S.A.
  21. Xiao, L., Syamir, A.S.A., Mahdi, A. and Yannick, M. (2019), "Aeroacoustics and aerodynamic study of trailing-edge serrated airfoils in tandem configuration", Proceedings of the 23rd Int. Congress Acoust., Aachen, Germany.
  22. Yagebai, Z., Xiaolong, D., Hongfu, Z. D. and Zhiwen, L. (2021), "Effects of vortex generators on the wind load of a flat roof: A computational study", Wind Struct., 32(1), 1-9. http://dx.doi.org/10.12989/was.2021.32.10012.
  23. Yeongmin, J., Seongim, C., Zientarski, L.A. and James, J.J. (2016), "Aerodynamic characteristics and shape optimization techniques of a variable camber compliant wing", 34th AIAA Appl. Aerod. Confer., Washington, D.C.
  24. Wang, Y., Zhao, K., Lu, X.Y., Song, Y.B. and Bennett, G.J. (2019), "Bio-inspired aerodynamic noise control: a bibliographic review", Appl. Sci., 9(11), 2224. http://dx.doi.org/10.3390/app9112224.
  25. Zhu, Z.W., Chen, Z.Q. and Gu, M. (2009), "CFD based simulations of flutter characteristics of ideal thin plates with and without central slot", Wind Struct., 12(1), 1-19. http://dx.doi.org/10.12989/was.2009.12.1.001.