DOI QR코드

DOI QR Code

Comparative study on bearing characteristics of pervious concrete piles in silt and clay foundations

  • Cai, Jun (School of Transportation, Southeast University, Jiulong Lake Campus) ;
  • Du, Guangyin (Zhejiang Provincial Institute of Communications Planning, Design and Research) ;
  • Xia, Han (School of Transportation, Southeast University, Jiulong Lake Campus) ;
  • Sun, Changshen (Zhejiang Provincial Institute of Communications Planning, Design and Research)
  • 투고 : 2021.08.31
  • 심사 : 2021.11.10
  • 발행 : 2021.12.25

초록

With the advantages of high permeability and strength, pervious concrete piles can be suitable for ground improvement with high water content and low bearing capacity. By comparing the strength and permeability of pervious concrete with different aggregate sizes (3-5 mm and 4-6 mm) and porosities (20%, 25%, 30% and 35%), the recommended aggregate size (3-5 mm) and porosity (30%) can be achieved. The model tests of the pervious concrete piles in soft soil (silt and clay) foundations were conducted to evaluate the bearing characteristics, results show that, for the higher consolidation efficiency of the silty foundation, the bearing capacity of the silty foundation is 16% higher, and the pile-soil stress ratio is smaller. But when it is the ultimate load for the piles, they will penetrate into the underlying layer, which reduces the pile-soil stress ratios. With higher skin friction of the pile in the silty foundation, the pile penetration is smaller, so the decrease of the pile axial force can be less. For the difference in consolidation efficiency, the skin friction of pile in silt is more affected by the effective stress of soil, while the skin friction of pile in clay is more affected by the lateral stress. When the load reaches 4400 N, the skin friction of the pile in the silty foundation is about 35% higher than that of the clay foundation.

키워드

참고문헌

  1. ACI 522R (2010), Report on Pervious Concrete, American Concrete Institute, Farmington Hills, MI, USA.
  2. Ahn, J. and Kim, Y. (2012), "Consolidation behavior and stress concentration ratio of SCP composite ground", Mar. Georesour. Geotechnol., 30(1), 63-85. https://doi.org/10.1080/1064119X.2011.586011.
  3. Alamgir, M.N., Miura, H.B. Poorooshasb and Madhav, M.R. (1996), "Deformation analysis of soft ground reinforced by columnar inclusions", Comput. Geotech., 18(4), 267-299. https://doi.org/10.1016/0266-352X(95)00034-8
  4. Andreou, P., Frikha W., Frank R., Canou J., Papadopoulos V. and Dupla J.C. (2008), "Experimental study on sand and gravel columns in clay", Proc. Inst. Civ. Eng. Ground Improv., 161(4), 189-198. https://doi.org/10.1680/grim.2008.161.4.189
  5. ASTM. (1974), "Standard method of test for permeability of granular soils (constant head)", D2434-74.
  6. Baez, J.I. (1995), "A design model for the reduction of soil liquefaction by vibro-stone columns", Ph.D. dissertation, Univ. of Southern California, Los Angeles.
  7. Barksdale, R.D. and Bachus, R.C. (1983), "Design and construction of stone columns", FHWA/RD 83/026, Rep. No. 1, Vol. 1, Federal Highway Administration (FHWA), Washington, DC.
  8. Cao, W.P., Chen, Y.M. and Chen, R.P. (2008), "Analysis of soil arching in piled embankments considering coupled effect of embankment filling and soil consolidation", Chinese J. Rock Mech. Eng., 27(8), 1610-1617. https://doi.org/10.3321/j.issn:1000-6915.2008.08.010
  9. Chen, J. Sheng, Q. Liu, X.M. Zhu, Z.Q., Leng, X.L. Zhang, Y.H. and Chen, G.L. (2013), "An production method of solid model layered tamping for the pseudo-earth- quake shaking table test". Chinese patent No.201310154909.8, Institute of Rock and Soil Mechanics, Chinese Academy of Sciences, Wuhan, China.
  10. CJJ/T 135-2009 (2009), Technical specification for pervious cement concrete pavement, Ministry of housing and urban-rural development of the people's republic of China, China Architecture & Building Press, Beijing, China.
  11. Cui, X.Z., Wang, C., Zhou, Y.X., Zhang, N. and Gao, Z.J. (2012), "Anti-earthquake mechanism of pervious concrete pile composite foundation", J. Shandong Univ., Eng. Sci., 42(4), 86-91. https://doi.1672-3961(2012)04-0086-06.
  12. Cui, X.Z., Zhang, J., Chen, D.H., Li, S.C., Jin, Q., Zheng, Y.J. and Cui. S.Q. (2018), "Clogging of pervious concrete pile caused by soil piping an approximate experimental study", Can. Geotech. J., (55), 999-1015. https://doi.10.1139/cgj-2017-0238.
  13. Das, B.M. (2010), Principles of geotechnical engineering (7th Ed.), Wadsworth Inc., 683.
  14. Fattah, Mohammed Y., Al-Mosawi, Mosa J. and Al-Zayadi, Abbas A.O. (2013), "Time dependent behavior of piled raft foundation in clayey soil", Geomech. Eng., 5(1), 17-36. https://doi.org/10.12989/gae.2013.5.1.017.
  15. GB/T 50783-2012 (2012), Technical code for composite foundation, Ministry of housing and urban-rural development of the people's republic of China, China Planning Press, Beijing, China.
  16. Ghafoori, N. and Dutta, S. (1995), "Laboratory investigation of compacted no-fines concrete for paving materials", J. Mater. Civil Eng., 7(3), 183-191. https://doi.org/10.1061/(ASCE)0899-1561(1995)7:3(183)
  17. Han, J., Ye, S.L. and Zhang, D.S. (1993), "In-situ observations on back-pressures and pore water pressures in composite foundation with stone columns", Chinese J. Geotech. Eng., 15(5), 40-47.
  18. Housing and urban-rural development department of Shandong province (2018), "Technical code for composite foundation of pervious concrete pile", DB37/T 5214-2018, China Building Materials Press, Beijing, China.
  19. Huang, B.S., Wu, H., Shu, X. and Burdette, E.G. (2010), "Laboratory evaluation of permeability and strength of polymer-modified pervious concrete", Constr. Build. Mater., 24(5), 818-823. https://doi.10.1016/j.conbuildmat.2009.10.025.
  20. Ko, J., Cho, J. and Jeong, S. (2018), "Analysis of load sharing characteristics for a piled raft foundation", Geomech. Eng., 16(4), 449-461. https://doi.org/10.12989/gae.2018.16.4.449.
  21. Kwon, J., Kim, C., Im, J.C. and Yoo, J.W. (2018), "Effect of performance method of sand compaction piles on the mechanical behavior of reinforced soft clay", Geomech. Eng., 14(2), 175-185. https://doi.org/10.12989/gae.2018.14.2.175.
  22. Madhav, M.R. and Sharma, J.K. (2009), "Settlement of and load distribution in a granular piled raft", Geomech. Eng., 1(1), 97-112. https://doi.org/10.12989/gae.2009.1.1.097.
  23. Malaiskiene, J., Kizinievic, O and Sarkauskas, A (2020), "The impact of coarse aggregate content on infiltration rate, structure and other physical & mechanical properties of pervious concrete", Eur. J. Environ. Civ. Eng., 24(5), 569-582. https://doi.10.1080/19648189.2017.1410231.
  24. Mitchell, J. K. (1981), "State-of-the-art report, session 12", Proc., 10th Int. Conf. on Soil Mechanics and Foundation Engineering, Balkema, Rotterdam, Netherlands, 506-565.
  25. Neithalath, N., Sumanasooriya, M.S. and Deo, O. (2010), "Characterizing pore volume, sizes, and connectivity in pervious concretes for permeability prediction", Mater. Charact., 61(8), 802-813. https://doi.10.1016/j.matchar.2010.05.004.
  26. Nguyen, D.H., Sebaibi, N., Boutouil, M., Leleyter, L. and Baraud, F. (2014), "A modified method for the design of pervious concrete mix", Constr. Build. Mater., 73, 271-282. https://doi.10.1016/j.conbuildmat.2014.09.088.
  27. Ni, L.S., Suleiman, M.T. and Raich, A. (2016), "Behavior and soil-structure interaction of pervious concrete ground-improvement piles under lateral loading", J. Geotech. Geoenviron. Eng., 142(2), 04015071. https://doi.10.1061/(ASCE)GT.1943-5606.0001393.
  28. Okamura, M., Ishihara, M. and Tamura, K. (2006). "Degree of saturation and liquefaction resistances of sand improved with sand compaction pile", J. Geotech. Geoenviron. Eng., 132(2), 258-264. https://doi.10.1061/(ASCE)1090-0241(2006)132:2(258).
  29. Qin, Y.H., Liang, J., Yang, H.F. and Deng, Z.H. (2016), "Gas permeability of pervious concrete and its implications on the application of pervious pavements", Measurement, 78, 104-110. https://doi.org/10.1016/j.measurement.2015.09.055
  30. Schokker, A. J. (2010), "The sustainable concrete guide: strategies and examples", US Green Concrete Council.
  31. Suleiman, M.T., Ni, L.S. and Raich, A. (2014), "Development of pervious concrete pile ground-improvement alternative and behavior under vertical loading", J. Geotech. Geoenviron. Eng., 140(7), 04014035. https://doi.10.1061/(ASCE)GT.1943-5606.0001135.
  32. Tao, Z.H. (2006), "Research on material design and performance of porous cement concrete pavement", Ph.D. Dissertation, Southeast University. Nanjing
  33. Tennis, P.D., Leming, M.L. and Akers, D.J. (2004), "Pervious Concrete Pavements (No. PCA Serial No. 2828)", Portland Cement Association, Skokie, Illinois
  34. Wu, Y.D., Liu, J. and Chen, R. (2015). "An analytical analysis of a single axially-loaded pile using a nonlinear softening model". Geomech. Eng., 8(6), 769-781. https://doi.org/10.12989/gae.2015.8.6.769.
  35. Yahia, A. and Kabagire, K.D. (2014), "New approach to proportion pervious concrete", Constr. Build. Mater., 62, 38-46. https://doi.10.1016/j.conbuildmat.2014.03.025
  36. Yu, Y., Wang, Z. and Sun, H.Y. (2020) "Optimal design of stone columns reinforced soft clay foundation considering design robustness", Geomech. Eng., 22(4), 305-318. https://doi.org/10.12989/gae.2020.22.4.305.
  37. Zhang, J., Cui, X.Z., Huang, D., Jin, Q., Lou, J.J. and Tang, W.Z. (2016), "Numerical simulation of consolidation settlement of pervious concrete pile composite foundation under road embankment", Int. J. Geomech., 16(1), B4015006. https://doi.10.1061/(ASCE)GM.1943-5622.0000542.
  38. Zhang, N., Cui, X.Z., Zhang, J., Zhou, Y.X., Gao, Z.J. and Sui, W. (2013), "Settlement-controlling and pressure-reduction effect of pervious concrete pile under the action of embankment load", J. Shandong Univ., Eng. Sci., 43(4), 80-86. https://doi.10.6040/j.issn.1672-3961.0.2013.088.
  39. Zhang, X.F., Li, Q.N., Ma, Y., Zhang, X.J. and Yang, S.Z. (2014), "Large-scale pilot test study on bearing capacity of sea-crossing bridge main pier pile foundations", Geomech. Eng., 7(2), 201-212. https://doi.org/10.12989/gae.2014.7.2.201.
  40. Zhao, F., Hu, H.S., Yang, G.S. and Hou, M.X. (2017), "Development of the model box design and soil sample preparation technology for pile-soil model test", Low Temperature Architect. Technol., 39(7), 66-70.