Advances in concrete construction

  • 제10권3호
  • /
  • Pages.237-245
  • /
  • 2020
  • /
  • 2287-5301(pISSN)
  • /
  • 2287-531X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Performance of eco-friendly mortar mixes against aggressive environments

  • Saha, Suman (Department of Civil Engineering, National Institute of Technology Calicut) ;
  • Rajasekaran, Chandrasekaran (Department of Civil Engineering, National Institute of Technology Karnataka) ;
  • Gupta, Prateek (Department of Civil Engineering, National Institute of Technology Karnataka)
  • 투고 : 2019.07.25
  • 심사 : 2020.08.13
  • 발행 : 2020.09.25
⟨ 이전 논문 다음 논문 ⟩

초록

Past research efforts already established geopolymer as an environment-friendly alternative binder system for ordinary Portland cement (OPC) and recycled aggregate is also one of the promising alternative for natural aggregates. In this study, an effort was made to produce eco-friendly mortar mixes using geopolymer as binder and recycled fine aggregate (RFA) partially and study the resistance ability of these mortar mixes against the aggressive environments. To form the geopolymer binder, 70% fly ash, 30% ground granulated blast furnace slag (GGBS) and alkaline solution comprising of sodium silicate solution and 14M sodium hydroxide solution with a ratio of 1.5 were used. The ratio of alkaline liquid to binder (AL/B) was also considered as 0.4 and 0.6. In order to determine the resistance ability against aggressive environmental conditions, acid attack test, sulphate attack test and rapid chloride permeability test were conducted. Change in mass, change in compressive strength of the specimens after the immersion in acid/sulphate solution for a period of 28, 56, 90 and 120 days has been presented and discussed in this study. Results indicated that the incorporation of RFA leads to the reduction in compressive strength. Even though strength reduction was observed, eco-friendly mortar mixes containing geopolymer as binder and RFA as fine aggregate performed better when it was produced with AL/B ratio of 0.6.

키워드

참고문헌

  1. Apoorva, S., Saha, S. and Rajasekaran, C. (2016), "Experimental study on water absorption and accelerated curing properties of recycled aggregates in concrete", Proceedings of 5th International Engineering Symposium (IES 2016), Kumamoto University, Japan, March.
  2. ASTM C1202-18, Standard Test Method for Electrical Indication of Concrete's Ability to Resist Chloride Ion Penetration, ASTM International. https://doi.org/10.1520/C1202-18.
  3. Chindaprasirt, P., De Silva P., Sagoe-Crentsil, K. and Hanjitsuwan, S. (2012), "Effect of $ SiO_{2}$ and $Al_{2}O_{3}$ on the setting and hardening of high calcium fly ash-based geopolymer systems", J. Mater. Sci., 47, 4876-4883. https://doi.org/10.1007/s10853-012-6353-y
  4. Chore, H.S. and Joshi, M.P. (2015), "Strength evaluation of concrete with fly ash and GGBFS as cement replacing materials", Adv. Concrete Constr., 3(3), 223-236. http://dx.doi.org/10.12989/acc.2015.3.3.223.
  5. Davidovits, J. (1991), "Geopolymers: inorganic polymeric new materials", J. Therm. Anal., 37, 1633-1656. https://doi.org/10.1007/BF01912193
  6. Davidovits, J. (2002), "30 years of successes and failures in geopolymer applications. Market trends and potential breakthroughs", Geopolymer 2002 Conference, Melbourne, Australia, October.
  7. Deepa, R.S. and Bhoopesh, J. (2017), "Strength and behaviour of recycled aggregate geopolymer concrete beams", Adv. Concrete Constr., 5(2), 145-154. https://doi.org/10.12989/acc.2017.5.2.145.
  8. Gorhan, G. and Kurklu, G. (2014), "The influence of the NaOH solution on the properties of the fly ash based geopolymer mortar cured at different temperatures", Compos.: Part B, 58, 371- 377. https://doi.org/10.1016/j.compositesb.2013.10.082
  9. IS: 2386-1963, Methods of Test for Aggregates for Concrete, Bureau of Indian Standards, New Delhi.
  10. IS: 383-1970, Specifications for Coarse and Fine Aggregates from Natural Sources of Concrete, Bureau of Indian Standards, New Delhi.
  11. IS: 4031 (Part 6)-1988, Method of Physical Tests for Hydraulic Cements (Part 1: Determination of Compressive Strength of Hydraulic Cement other than Masonry Cement), Bureau of Indian Standards, New Delhi.
  12. Kagadgar, S.A., Saha, S. and Rajasekaran, C. (2017), "Mechanical and durability properties of fly ash based concrete exposed to marine environment", SSP-J. Civil Eng., 12(1), 7-18. https://doi.org/10.1515/sspjce-2017-0001.
  13. Lim, N.H.A.S., Mohammadhosseini, H., Md. Tahir, M., Samadi, M. and Sam, A.R.M. (2018), "Microstructure and strength properties of mortar containing waste ceramic nanoparticles", Arab. J. Sci. Eng., 43, 5305-5313. https://doi.org/10.1007/s13369018-3154-x.
  14. Mohammadhosseini, H. and Md.Tahir, M. (2018), "Durability performance of concrete incorporating waste metalized plastic fibres and palm oil fuel ash", Constr. Build. Mater., 180, 92-102. https://doi.org/10.1016/j.conbuildmat.2018.05.282.
  15. Mohammadhosseini, H., Lim, N.H.A.S., Md. Tahir, M., Alyousef, R., Alabduljabbar, H. and Samadi, M. (2019), "Enhanced performance of green mortar comprising high volume of ceramic waste in aggressive environments", Constr. Build. Mater., 212, 607-617. https://doi.org/10.1016/j.conbuildmat.2019.04.024.
  16. Mohammadhosseini, H., Md. Tahir, M., Sam, A.R.M., Lim, N.H.A.S. and Samadi, M. (2018), "Enhanced performance for aggressive environments of green concrete composites reinforced with waste carpet fibers and palm oil fuel ash", J. Clean. Prod., 185, 252-265. https://doi.org/10.1016/j.jclepro.2018.03.051.
  17. Mohammadhosseini, H., Yatim, J.M., Sam, A.R.M. and Abdul Awal, A.S.M. (2017), "Durability performance of green concrete composites containing waste carpet fibers and palm oil fuel ash", J. Clean. Prod., 144, 448-458. http://dx.doi.org/10.1016/j.jclepro.2016.12.151.
  18. Mukharjee, B.B. and Barai, S.V. (2015), "Characteristics of sustainable concrete incorporating recycled coarse aggregates and colloidal nano-silica", Adv. Concrete Constr., 3(3), 187-202. http://dx.doi.org/10.12989/acc.2015.3.3.187.
  19. Patra, R.K. and Mukharjee, B.B. (2018), "Influence of granulated blast furnace slag as fine aggregate on properties of cement mortar", Adv. Concrete Constr., 6(6), 611-629. https://doi.org/10.12989/acc.2018.6.6.611.
  20. Pattanapong, T., Chindaprasirt, P. and Sata, V. (2015), "Setting time, strength, and bond of high-calcium fly ash geopolymer concrete", J. Mater. Civil Eng., 27(7), 04014198. https://doi.org/10.1061/(ASCE)MT.1943-5533.0001157
  21. Praveen Kumar, V.V. and Ravi Prasad, D. (2019), "Influence of supplementary cementitious materials on strength and durability characteristics of concrete", Adv. Concrete Constr., 7(1), 75-85. https://doi.org/10.12989/acc.2019.7.2.075.
  22. Rahim, A., Rosniza, H., Khairun, A.A., Zakaria, M., Rahmiati, T. and Lukman, I. (2014), "Effect of solid to liquid ratio on the nechanical and physical properties of fly ash geopolymer without sodium silicate", Appl. Mech. Mater., 625, 46-49. https://doi.org/10.4028/www.scientific.net/AMM.625.46
  23. Rahmiati, T., Khairun, A.A., Zakaria, M., Lukman, I. and Muhd, F.N. (2014), "Effect of solid/liquid ratio during curing time fly ash based geopolymer on mechanical property", Mater. Sci. Forum, 803, 120-124. https://doi.org/10.4028/www.scientific.net/MSF.803.120.
  24. Saha, S. and Rajasekaran, C. (2016), "Mechanical properties of recycled aggregate concrete produced with portland pozzolana cement", Adv. Concrete Constr., 4(1), 27-35. https://doi.org/10.12989/acc.2016.4.1.027.
  25. Saha, S. and Rajasekaran, C. (2016), "Strength characteristics of recycled aggregate concrete produced with portland slag cement", J. Constr. Eng., Technol. Manage., 6(1), 70-77.
  26. Saha, S. and Rajasekaran, C. (2017), "Effects of alkaline solution on the properties of slag based geopolymer", Appl. Mech. Mater., 877, 193-199. https://doi.org/10.4028/www.scientific.net/AMM.877.193.
  27. Saha, S. and Rajasekaran, C. (2017), "Enhancement of the properties of fly ash based geopolymer paste by incorporating ground granulated blast furnace slag", Constr. Build. Mater., 146, 615-620. http://dx.doi.org/10.1016/j.conbuildmat.2017.04.139.
  28. Saha, S. and Rajasekaran, C. (2019), "An experimental investigation to determine the properties of fly ash based geopolymers as per Indian standards", Recent Advances in Structural Engineering, 1, Lecture Notes in Civil Engineering, 11, Springer Singapore, 657-668.
  29. Saha, S., Rajasekaran, C. and More, A.P. (2019), "Use of foundry sand as partial replacement of natural fine aggregate for the production of concrete", Sustainable Construction and Building Materials, Lecture Notes in Civil Engineering, 25, Springer Singapore, 61-71.
  30. Saha, S., Rajasekaran, C. and Pai, V.T. (2015) "Use of recycled coarse aggregates as an alternative in construction industry-A review", Proceedings of 4th International Engineering Symposium (IES 2015), Kumamoto University, Japan, March.
  31. Saha, S., Rajasekaran, C. and Vinay, K. (2019), "Use of concrete wastes as the partial replacement of natural fine aggregates in the production of concrete", GCEC 2017. GCEC 2017, Lecture Notes in Civil Engineering, 9, Springer Singapore, 407-416.
  32. Saha., S. and Rajasekaran, C. (2019), "Investigation on the potential use of recycled fine aggregate to produce geopolymer mortar mix", Adv. Civil Eng. Mater., 8(1), 207-223. https://doi.org/10.1520/ACEM20180084.
  33. Saha., S. and Rajasekaran, C. (2020). "Strength and shrinkage properties of heat-cured fly ash-based geopolymer mortars containing fine recycled concrete aggregate", J. Test. Eval., https://doi.org/10.1520/JTE20180799.
  34. Saha., S., Shaik, N. and Rajasekaran, C. (2020). "Volume change characteristics of eco-friendly mortar mixes produced with geopolymeric binder and recycled fine aggregate", J. Test. Eval., 48(1), 692-710. https://doi.org/10.1520/JTE20180316.
  35. Shaikh, F., Kerai, S. and Kerai, S. (2015), "Effect of micro-silica on mechanical and durability properties of high volume fly ash recycled aggregate concretes (HVFA-RAC)", Adv. Concrete Constr., 3(4), 317-331. http://dx.doi.org/10.12989/acc.2015.3.4.317.
  36. Sunil, B.M., Manjunatha, L.S. and Yaragal, S.C. (2017), "Durability studies on concrete with partial replacement of cement and fine aggregates by fly ash and tailing material", Adv. Concrete Constr., 5(6), 671-683. https://doi.org/10.12989/acc.2017.5.6.671.
  37. Thete, S., Arpitha, D., Saha, S. and Rajasekaran, C. (2017), "Suitability of quarry dust as a partial replacement of fine aggregate in self compacting concrete", Appl. Mech. Mater., 877, 248-253. https://doi.org/10.4028/www.scientific.net/AMM.877.248.
  38. Thomas, J., Thaickavil, N.N. and Abraham, M.P. (2018), "Copper or ferrous slag as substitutes for fine aggregates in concrete", Adv. Concrete Constr., 6(5), 545-560. https://doi.org/10.12989/acc.2018.6.5.545.