DOI QR코드

DOI QR Code

Mechanical Characteristics of Basalt in Jeju Island with Relation to Moisture Condition

함수상태에 따른 제주도 현무암의 역학적 특성

  • Received : 2020.06.23
  • Accepted : 2020.07.09
  • Published : 2020.07.31

Abstract

In this study, various laboratory tests were conducted to evaluate the effect of the moisture conditions of Jeju basalt on the mechanical properties. Twenty specimens were produced respectively from basalts collected from Sangga-ri and Eoeum-ri in northwestern Jeju. The tests were performed under saturated and dry conditions, and the results of these tests were used to examine the relationship with the physical properties and the mechanical properties depending on the moisture conditions. As a result of analysis with the test results and references, it was found that the uniaxial compressive strength, Brazilian tensile strength and elastic modulus in the saturated condition decrease at a similar ratio as compared with the dry condition. Also, the Brazilian tensile strength and the uniaxial compressive strength were in a linear proportional relationship, and in the moisture conditions, this relationship was not significantly affected.

본 연구는 제주도 현무암의 함수상태가 역학적 특성에 미치는 영향을 평가하기 위하여 다양한 실내시험을 수행하였다. 시험편은 제주 북서부의 상가리와 어음리에서 채취한 현무암으로 각각 20개씩 제작하였다. 시험은 포화 및 건조상태로 구별하여 진행하였으며, 이를 바탕으로 함수상태에 따른 물성 및 역학적 특성간의 관계를 고찰하였다. 기존 연구결과들과 함께 분석한 결과, 포화상태의 경우 건조상태보다 일축압축강도, 압열인장강도 및 탄성계수가 비슷한 비율로 감소함을 알 수 있었다. 또한 압열인장강도와 일축압축강도는 선형비례관계에 있으며, 함수상태는 이 관계에 큰 영향을 주지 않았다.

Keywords

References

  1. Burshtein, L. (1969), "Effect of Moisture on the Strength and Deformability of Sandstone", J. of Mining Science, Vol.5, No.5, pp.573-576.
  2. Choi, S., Lee, S., and Jeon, S. (2018), "Experimental Study on the Change of Rock Properties due to Water Saturation", Tunnel & Underground Space, Vol.28, No.5, pp.476-492 (in Korean). https://doi.org/10.7474/TUS.2018.28.5.476
  3. Cho, T., Lee, S., Hwang, T., and Won, K. (2009), "Variations of Mechnical Properties of Hallasan Trachyte with Respect to the Degree of Weathering", Tunnel and Underground Space, Vol.19, No.4, pp.287-303 (in Korean).
  4. Eum, K. (2002), "Study on the Mechanical Properties of Volcanic Rocks in Chejudo", Master thesis, Yonsei University, p.63 (in Korean).
  5. GK Engineering, JPM Inc., and Jeju National Univ. (2013), Midway Report of the Leading Industry of Jeju Economic Region (in Korean).
  6. Hawkins, A. and McConnell, B. (1992), "Sensitivity of Sandstone Strength and Deformability to Changes in Moisure Content", Quarterly Journal of Engineering Geology and Hydrogeology, Vol.25, No.2, pp.115-130. https://doi.org/10.1144/gsl.qjeg.1992.025.02.05
  7. Hoek, E. and Brown, E.T. (1997), "Practical Estimates of Rock Mass Strength", International Journal of Rock Mechanics and Mining Sciences, Vol.34, No.8, pp.1165-1186. https://doi.org/10.1016/S1365-1609(97)80069-X
  8. Kim, J. (2007), "A Study on the Mechanical Characteristics and the Strength in Pyoseonri Basalt", Master thesis, Jeju National University, p.93 (in Korean).
  9. Kim, Y. and Choi, O. (1991), "Engineering Geological Characteristics of Volcanic Rocks of the Northwestern Cheju Island, Korea", The Journal of Engineering Geology, Vol.1, No.1, pp.19-37 (in Korean).
  10. Lee, I. (2013), "Principal of Rock Mechanics, 2nd Ed.", CIR, p.398 (in Korean).
  11. Moon, K., Park, S., Kim, Y., and Yang, S. (2014), "Mechanical Properties of Basalt in Jeju Island with Respect to Porosity", Journal of the Korean Society of Civil Engineering, Vol.34, No.4, pp. 1215-1225 (in Korean). https://doi.org/10.12652/Ksce.2014.34.4.1215
  12. Moon, K. and Yang, S. (2020), "Cohesion and Internal Friction Angle Estimated from Brazilian Tensile Strength and Unconfined Compressive Strength of Volcanic Rocks in Jeju Island", Journal of the Korean Geotechnical Society, Vol.36, No.2, pp.17-28 (in Korean).
  13. Multiplatform GEOscience Information System (MGEO), Korea Institute of Geoscience and Mineral Resources (KIGAM), mgeo.kigam.re.kr
  14. Nam, J., Yun, J., Song, Y., and Kim, J. (2008a), "Analysis of Engineering Properties to Basalt in Cheju Island", Journal of Korean Geosynthetics Society, Vol.7, No.1, pp.12-21 (in Korean).
  15. Nam, J., Yun, J., Song, Y., and Kim, J. (2008b), "Analysis of Influence Factors to Compressive and Tensile Strength of Basalt in Cheju Island", The Journal of Engineering Geology, Vol.18, No.2, pp.215-225 (in Korean).
  16. Nam, J., Yun, J., and Song, Y. (2009), "Estimation to the Strength of Basalt in Jeju Island according to Rock Failure Criterions", The Journal of Engineering Geology, Vol.19, No.2, pp.153-163 (in Korean).
  17. Toror, A. and Vasarhelyi, B. (2010), "The Influence of Fabric and Water Content on Selected Rock Mechanical Parameters of Travertine, Examples from Hungary", Engineering Geology, Vol.115, No.3, pp.237-245. https://doi.org/10.1016/j.enggeo.2010.01.005
  18. Van Eeckhout, E.M. (1976), "The Mechanisms of Strength Reduction Due to Moisture in Coal Mine Shales", International Journal of Rock Mechanics and Mining Sciences and Geomechanics Abstracts, Vol.13, No.2, pp.61-67. https://doi.org/10.1016/0148-9062(76)90705-1
  19. Van Eeckhout, E.M. and Peng, S.S. (1975), "The Effect of Humidity on the Compliances of Coal Mine Shales", International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, Vol.12, No.11, pp.335-340. https://doi.org/10.1016/0148-9062(75)90166-7
  20. Vasarhelyi, B. (2002), "Influence of the Water Saturation on the Strength of Volcanic Tuffs", EUROCK 2002, Proceedings of Workshop on Volcanic Rocks, pp.89-96.
  21. Vasarhelyi, B. (2003), "Some Observations Regarding the Strength and Deformability of Sandstone in Dry and Saturated Conditions", Bulletin of Engineering Geology and the Environment, Vo.62, No.3, pp.245-249. https://doi.org/10.1007/s10064-002-0186-x
  22. Vasarhelyi, B. (2005), "Statistical Analyisis of the Influence of Water Content on the Strength of the Miocene Limestone", Rock Mechanics and Rock Engineering, Vol.38, No.1, pp.69-76. https://doi.org/10.1007/s00603-004-0034-3
  23. Vasarhelyi, B. and Ledniczky, K. (1999), "Influence of Watersaturation and Weathering on Mechanical Properties of Sivac Marble", Proc. of 9th ISRM Congress, ISRM, pp.691-693.
  24. Yang, S. (2014), "Comparative Study on Physical and Mechanical Characteristics of Volcanic Rocks in Jeju Island", Journal of the Korean Geotechnical Society, Vol.30, No.11, pp.39-49 (in Korean). https://doi.org/10.7843/kgs.2014.30.11.39
  25. Yang, S. (2015a), "Physical and Mechanical Characteristics of Basalts in Northwestern and Southeastern Jeju Island", Journal of the Korean Geotechnical Society, Vol.31, No.7, pp.41-52 (in Korean). https://doi.org/10.7843/kgs.2015.31.7.41
  26. Yang, S. (2015b), "Cohesion and Internal Friction Angle of Basalts in Jeju Island", Journal of the Korean Geotechnical Society, Vol.31, No.11, pp.33-40 (in Korean). https://doi.org/10.7843/kgs.2015.31.11.33
  27. Yang, S. (2016), "Strength Parameters of Basalts in Jeju Island according to Rock Failure Criterions", Journal of the Korean Geotechnical Society, Vol.32, No.3, pp.15-27 (in Korean). https://doi.org/10.7843/kgs.2016.32.3.15
  28. Yang, S. and Boo, S. (2019), "Estimation of Deformation Modulus of Basaltic Rock Masses in Northeastern and Northwestern Jeju Island", Journal of the Korean Geotechnical Society, Vol.35, No.1, pp.5-15 (in Korean). https://doi.org/10.7843/KGS.2019.35.1.5
  29. Yoon, S. and Ko, K. (2011), "Topography, Geology and Underground Water in Jeju Island", Nae Ha Publishing Company, p.130 (in Korean).
  30. Yu, Y., Yin, J., and Zhang, Z. (2006), "Shape Effects in the Brazilian Tensile Strength Test and a 3D FEM Correction", International Journal of Rock Mechanics and Mining Sciences, Vol.43, pp. 623-627. https://doi.org/10.1016/j.ijrmms.2005.09.005