Advances in concrete construction

  • 제9권6호
  • /
  • Pages.537-545
  • /
  • 2020
  • /
  • 2287-5301(pISSN)
  • /
  • 2287-531X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

A new geopolymeric grout blended completely weathered granite with blast-furnace slag

  • Zhang, Jian (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Li, Shucai (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Li, Zhaofeng (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Li, Hengtian (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Du, Junqi (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Gao, Yifan (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Liu, Chao (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Qi, Yanhai (Geotechnical and Structural Engineering Research Center, Shandong University) ;
  • Wang, Wenlong (Geotechnical and Structural Engineering Research Center, Shandong University)
  • 투고 : 2019.04.12
  • 심사 : 2020.05.19
  • 발행 : 2020.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

In order to reduce the usage of cement slurry in grouting engineering and consume the tunnel excavation waste soil, a new geopolymeric grouting material (GGM) was prepared by combine completely weathered granite (CWG) and blast-furnace slag (BFS), which can be applied to in-situ grouting treatment of completely weathered granite strata. The results showed CWG could participate in the geopolymerization process, and GGM slurry has the characteristics of short setting time, high flowability, low viscosity, high stone rate and high mechanical strength, and a design method of grouting pressure based on viscosity evolution was proposed. By adjusted the content of completely weathered granite and alkali activator concentration, the setting time of GGM were ranged from 5 to 30 minutes, the flowability was more than 23.5 cm, the stone rate was higher than 90%, the compressive strength of 28 days were 7.8-16.9 MPa, the porosity were below 30%. This provides a novel grouting treatment and utilizing excavated soil of tunnels in the similar strata.

키워드

과제정보

This study was financially supported by the Major basic Project of Shandong Provincial Natural Science Foundation of China (Project Nos. ZR2017ZC0734), the Major Project of Chinese National Programs for Fundamental Research and Development (Project No. 2017YFC0703100), the Young Scientists Funds of National Natural Science Foundation of China (Grants Nos. 51709158), the China Postdoctoral Science Foundation Funded Project (No. 2018M632676).

참고문헌

  1. Bakharev, T. (2005), "Durability of geopolymer materials in sodium and magnesium sulfate solutions", Cement Concrete Res., 35(6), 1233-1246. https://doi.org/10.1016/j.cemconres.2004.09.002.
  2. Chen, C., Habert, G., Bouzidi, Y. and Jullien, A. (2010), "Environmental impact of cement production: detail of the different processes and cement plant variability evaluation", Clean. Prod., 18(5), 478-485. https://doi.org/10.1016/j.jclepro.2009.12.014.
  3. Chiu, C.F. and Ng, C.W. (2014), "Relationships between chemical weathering indices and physical and mechanical properties of decomposed granite", Eng. Geol., 179(10), 76-89. https://doi.org/10.1016/j.enggeo.2014.06.021.
  4. Davidovits, J. (1991), "Geopolym", J. Therm. Anal. Calorim., 37, 1633-1656. https://doi.org/10.1007/BF01912193
  5. Duan, P., Yan, C., Zhou, W. and Ren, D. (2016), "Fresh properties, compressive strength and microstructure of fly ash geopolymer paste blended with iron ore tailing under thermal cycle", Constr. Build. Mater., 118, 76-88. https://doi.org/10.1016/j.conbuildmat.2016.05.059.
  6. Duxson, P., Fernandez-Jimenez, A., Provis, J.L., Lukey, G.C., Palomo, A. and van Deventer, J.S. (2007), "Geopolymer technology: the current state of the art", J. Mater. Sci., 42, 2917-2933. https://doi.org/10.1007/s10853-006-0637-z.
  7. El-Naggar, M.R. and El-Dessouky, M.I. (2017), "Re-use of waste glass in improving properties of metakaolin-based geopolymers: Mechanical and microstructure examinations", Constr. Build. Mater., 132, 543-555. https://doi.org/10.1016/j.conbuildmat.2016.12.023.
  8. Guo, X. and Shi, H. (2015), "Metakaolin-, fly ash- and calcium hydroxide-based geopolymers: effects of calcium on performance", Adv. Cement Res., 27(10), 559-566. https://doi.org/10.1680/jadcr.14.00081.
  9. Guo, X., Shi, H. and Hu, W. (2016), "Setting time and rheological properties of solid waste-based composite geopolymers", J. Tongji Univ. (Nat. Sci.), 44(7), 1066-1071.
  10. Hong, K. (2017), "Typical underwater tunnels in the mainland of China and related tunneling", Technol. Eng., 3(6), 871-879. https://doi.org/10.1016/j.eng.2017.12.007.
  11. Jindal, B.B., Singhal, D., Sharma, S.K. and Ashish, D.K. (2017), "Improving compressive strength of low calcium fly ash geopolymer concrete with alccofine", Adv. Concrete Constr., 5(1), 17-29. https://doi.org/10.12989/acc.2017.19.2.017.
  12. Kurtoglu, A.E., Alzeebaree, R., Aljumaili, O., Nis, A., Gulsan, M.E., Humur, G. and Cevik, A. (2018), "Mechanical and durability properties of fly ash and slag based geopolymer concrete", Adv. Concrete Constr., 6(4), 365-362. https://doi.org/10.12989/acc.2018.6.4.345.
  13. Li, C., Zhang, T. and Wang, L. (2014), "Mechanical properties and microstructure of alkali activated Pisha sandstone geopolymer composites", Constr. Build. Mater., 68, 233-239. https://doi.org/10.1016/j.conbuildmat.2014.06.051.
  14. Li, S., Liu, R., Zhang, Q. and Zhang, X. (2016), "Protection against water or mud inrush in tunnels by grouting", J. Rock Mech. Geotech. Eng., 8(5), 753-766. https://doi.org/10.1016/j.jrmge.2016.05.002.
  15. Mehta, A. and Siddique, R. (2016), "An overview of geopolymers derived from industrial by-products", Constr. Build. Mater., 127, 183-198. https://doi.org/10.1016/j.conbuildmat.2016.09.136.
  16. Ng, C., Alengaram, U.J., Wong, L.S., Mo, K.H., Jumaat, M.Z. and Ramesh, S. (2018), "A review on microstructural study and compressive strength of geopolymer mortar, paste and concrete", Constr. Build. Mater., 186, 550-576. https://doi.org/10.1016/j.conbuildmat.2018.07.075.
  17. Owie, S. and Walton, G. (2018), "The effect of mineralogical parameters on the mechanical properties of granitic rocks", Eng. Geol., 5(24), 204-225. https://doi.org/10.1016/j.enggeo.2018.04.021.
  18. Panias, D., Giannopoulou, I.P. and Perraki, T. (2007), "Effect of synthesis parameters on the mechanical properties of fly ash-based geopolymers", Coll. Surf. A: Physicochem. Eng. Aspect., 301(1-3), 246-254. https://doi.org/10.1016/j.colsurfa.2006.12.064.
  19. Puertas, F., Fernandez-Jimenez, A. and Blanco-Varela, M.T. (2004), "Blanco-Varela MT. Pore solution in alkali activated slag cement pastes. Relation to the composition and structure of calcium silicate hydrate", Cement Concrete Res., 34, 139-148. https://doi.org/10.1016/S0008-8846(03)00254-0.
  20. Schneider, M., Romer, M., Tschudin, M. and Bolio, H. (2011), "Sustainable cement production-present and future", Cement Concrete Res., 41(7), 642-650. https://doi.org/10.1016/j.cemconres.2011.03.019.
  21. Shi, Y., Yang, J. and Wang, S. (2014), "Sub-horizontal reinforcement of weathered granite before tunneling beneath a spillway", Int. J. Rock Mech. Min. Sci., 72(72), 283-293. https://doi.org/10.1016/j.ijrmms.2014.08.005.
  22. Tchadjie, L.N. and Ekolu, S.O. (2018), "Enhancing the reactivity of aluminosilicate materials toward geopolymer synthesis", J. Mater. Sci., 53, 4709-4733. https://doi.org/10.1007/s10853-017-1907-7.
  23. Wang, K., Li, S., Yang, L., Zhang, Q., Li, Z. and Yuan, J. (2017), "Grouting simulation experiment on reinforcement characteristics of completely decomposed granite", J. Tianjin Univ. (Sci. Technol.), 50(11), 1199-1209.
  24. Yang, T., Yao, X. and Zhang, Z. (2014), "Geopolymer prepared with high-magnesium nickel slag: Characterization of properties and microstructure", Constr. Build. Mater., 59, 188-194. https://doi.org/10.1016/j.conbuildmat.2014.01.038.
  25. Zhang, Y.C. (2012), Cementation Technology, Coal Industry publishing House, Beijing, CHINA.