Smart Structures and Systems

  • 제25권6호
  • /
  • Pages.657-668
  • /
  • 2020
  • /
  • 1738-1584(pISSN)
  • /
  • 1738-1991(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

A novel multistage approach for structural model updating based on sensitivity ranking

  • Jiang, Yufeng (Shandong Provincial Key Laboratory of Ocean Engineering, Ocean University of China) ;
  • Li, Yingchao (College of Civil Engineering, Ludong University) ;
  • Wang, Shuqing (Shandong Provincial Key Laboratory of Ocean Engineering, Ocean University of China) ;
  • Xu, Mingqiang (Shandong Provincial Key Laboratory of Ocean Engineering, Ocean University of China)
  • 투고 : 2019.04.19
  • 심사 : 2020.01.14
  • 발행 : 2020.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

A novel multistage approach is developed for structural model updating based on sensitivity ranking of the selected updating parameters. Modal energy-based sensitivities are formulated, and maximum-normalized indices are designed for sensitivity ranking. Based on the ranking strategy, a multistage approach is proposed, where these parameters to be corrected with similar sensitivity levels are updated simultaneously at the same stage, and the complete procedure continues sequentially at several stages, from large to small, according to the predefined levels of the updating parameters. At every single stage, a previously developed cross model cross mode (CMCM) method is used for structural model updating. The effectiveness and robustness of the multistage approach are investigated by implementing it on an offshore structure, and the performances are compared with non-multistage approach using numerical and experimental vibration information. These results demonstrate that the multistage approach is more effective for structural model updating of offshore platform structures even with limited information and measured noise. These findings serve as a preliminary strategy for structural model updating of an offshore platform in service.

키워드

과제정보

This work was supported by the National Science Fund for Distinguished Young Scholars (51625902), the National Key Research and Development Program of China (2019YFC0312404), the Major Scientific and Technological Innovation Project of Shandong Province (2019JZZY010820), the National Natural Science Foundation of China (51809134), the Natural Science Foundation of Shandong Province (ZR2017MEE007), and the Taishan Scholars Program of Shandong Province (TS201511016).

참고문헌

  1. Banan, M.R. and Huelmstad, K.D. (1994), "Parameter estimation of structures from static response. I: computational aspects", J. Struct. Eng., 120(11), 3243-3258. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:11(3243)
  2. Bayraktar, A., Altunisik, A.C., Sevim, B. and Turker, T. (2010), "Finite element model updating of Komurhan highway bridge based on experimental measurements", Smart. Struct. Syst., Int. J., 6(4), 373-388. https://doi.org/10.12989/sss.2010.6.4.373
  3. Cheng, L., Xie, H.C., Spencer, B.F.J. and Giles, R.K. (2009), "Optimized finite element model updating method for damage detection using limited sensor information", Smart. Struct. Syst., Int. J., 5(6), 681-697. https://doi.org/10.12989/sss.2009.5.6.681
  4. Chung, T.T., Cho, S., Yun, C.B. and Sohn, H. (2012), "Finite element model updating of Canton Tower using regularization technique", Smart. Struct. Syst., Int. J., 10(4-5), 459-470. https://doi.org/10.12989/sss.2012.10.4_5.459
  5. Doebling, S.W., Farrar, C.R., Prime, M.B. and Shevitz, D.W. (1998), "A summary review of damage identification methods that examine changes in dynamic properties", Shock Vib. Digest, 30(2), 91-105. https://doi.org/10.1177/058310249803000201
  6. Ewins, D.J. (2000), Modal Testing: Theory, Practice and Application, (2nd Edition), Research Studies Press, London, UK.
  7. Fan, W. and Qiao, P.Z. (2011), "Vibration-based damage identification methods: a review and comparative study", Struct. Health. Monit., 10(1), 83-111. https://doi.org/10.1177/1475921710365419
  8. Fox, R. and Kapoor, M. (1968), "Rate of change of eigenvalues and eigenvectors", AIAA. J., 6(12), 2426-2429. https://doi.org/10.2514/3.5008
  9. Friswell, M.I. and Mottershead, J.E. (1995), Finite element model updating in structural dynamics, Kluwer Academic, Norwell, MA, USA.
  10. Hu, S.L.J. and Li, H.J. (2007), "Simultaneous mass, damping, and stiffness updating for dynamic systems", AIAA. J., 45(10), 2529-2537. https://doi.org/10.2514/1.28605
  11. Hu, S.L.J., Li, H.J. and Wang, S.Q. (2006), "Cross-modal strain energy method for estimating damage severity", J. Eng. Mech., 132(4), 429-437. https://doi.org/10.1061/(ASCE)0733-9399(2006)132:4(429)
  12. Hu, S.L.J., Li, H.J. and Wang S.Q. (2007), "Cross model cross mode method for model updating", Mech. Syst. Signal. Pr., 21(4), 1690-1703. https://doi.org/10.1016/j.ymssp.2006.07.012
  13. Li, H.J., Fang, H. and Hu, S.L.J. (2007), "Damage localization and severity estimate for three-dimensional frame structures", J. Sound. Vib., 301(3-5), 481-494. https://doi.org/10.1016/j.jsv.2006.08.042
  14. Li, H.J., Wang, J.R. and Hu, S.L.J. (2008), "Using incomplete modal data for damage detection in offshore jacket structures", Ocean. Eng., 35, 1793-1799. https://doi.org/10.1016/j.oceaneng.2008.08.020
  15. Li, Y.C, Wang, S.Q., Zhang, M. and Zheng, C.M. (2016), "An improved modal strain energy method for damage detection in offshore platform structures", J. Marine. Sci. Appl., 15(2), 182-192. https://doi.org/10.1007/s11804-016-1350-1
  16. Liang, Y.B., Feng, Q., Li, H. and Jiang, J. (2019), "Damage detection of shear buildings using frequency-change-ratio and model updating algorithm", Smart. Struct. Syst., Int. J., 23(2), 107-122. https://doi.org/10.12989/sss.2019.23.2.107
  17. Liu, K., Yan, R.J. and Guedes Soares, C. (2018), "An improved model updating technique based on modal data", Ocean. Eng., 154, 277-287. https://doi.org/10.1016/j.oceaneng.2018.02.011
  18. Messina, A., Williams, E.J. and Contursi, T. (1998), "Structural damage detection by a sensitivity and statistical-based method", J. Sound. Vib., 216(5), 791-808. https://doi.org/10.1006/jsvi.1998.1728
  19. Modak, S.V., Kundra, T.K. and Nakra, B.C. (2002), "Comparative study of model updating methods using simulated experimental data", Comput. Struct., 80(5-6), 437-447. https://doi.org/10.1016/s0045-7949(02)00017-2
  20. Ni, P.H. and Ye, X.W. (2019), "Nonlinear finite element model updating with a decentralized approach", Smart. Struct. Syst., Int. J., 24(6), 683-692. https://doi.org/10.12989/sss.2019.24.6.683
  21. Oliveira, G., Magalhaes, F., Alvaro, C. and Caetano, E. (2018), "Vibration-based damage detection in a wind turbine using 1 year of data", Struct. Control. Health. Monit., 25(11), e2238. https://doi.org/10.1002/stc.2238
  22. Perera, R. and Ruiz, A. (2008), "A multistage FE updating procedure for damage identification in large-scale structures based on multiobjective evolutionary optimization", Mech. Syst. Signal. Pr., 22, 970-991. https://doi.org/10.1016/j.ymssp.2008.06.010
  23. Perez, J.E.R., Rodriguez, R. and Vazquez-Hernandez, A.O. (2017), "Damage detection in offshore jacket platforms with limited modal information using the damage sub-matrices method", Mar. Struct., 55, 78-103. https://doi.org/10.1016/j.marstruc.2017.05.004
  24. Song, W., Hayati, S. and Zhou, S.L. (2017), "Real-time model updating for magnetorheological damper identification: an experimental study", Smart. Struct. Syst., Int. J., 20(5), 619-636. https://doi.org/10.12989/sss.2017.20.5.619
  25. Viero, P.F. and Roitman, N. (1999), "Application of some damage identification methods in offshore platforms", Mar. Struct., 12(2), 107-126. https://doi.org/10.1016/s0951-8339(99)00007-6
  26. Villalba, J.D. and Laier, J.E. (2012), "Localizing and quantifying damage by means of a multi-chromosome genetic algorithm", Adv. Eng. Softw., 50(1), 150-157. https://doi.org/10.1016/j.advengsoft.2012.02.002
  27. Wang, S.Q. (2014), "Model updating and parameters estimation incorporating flexible joints and boundary conditions", Inverse. Probl. Sci. En., 22(5), 727-745. https://doi.org/10.1080/17415977.2013.823413
  28. Wang, S.Q. and Liu, F.S. (2010), "New accuracy indicator to quantify the true and false modes for eigensystem realization algorithm", Struct. Eng. Mech., 34(5), 625-634. https://doi.org/10.12989/sem.2010.34.5.625
  29. Wang, T. and Wu, B. (2014), "Model updating with constrained unscented Kalman filter for hybrid testing", Smart. Struct. Syst., Int. J., 14(6), 1105-1129. https://doi.org/10.12989/sss.2014.14.6.1105
  30. Wang, S.Q., Li, Y.C. and Li, H.J. (2015), "Structural model updating of an offshore platform using cross model cross mode method: an experimental study", Ocean. Eng., 97, 57-64. https://doi.org/10.1016/j.oceaneng.2015.01.007
  31. Xu, M.Q., Wang, S.Q. and Jiang, Y.F. (2019), "Iterative two-stage approach for identifying structural damage by combining the modal strain energy decomposition method with the multiobjective particle swarm optimization algorithm", Struct. Control. Health. Monit., 26(2), stc-2301. https://doi.org/10.1002/stc.2301
  32. Yuan, Z.X., Liang, P., Silva, T., Yu, K.P. and Mottershead, J.E. (2019), "Parameter selection for model updating with global sensitivity", Mech. Syst. Signal. Pr., 115, 483-496. https://doi.org/10.1016/j.ymssp.2018.05.048
  33. Zhang, D.W. and Wei, F.S. (1999), Model Updating and Damage Detection, Science Press, Beijing, China.