Advances in environmental research

  • 제9권2호
  • /
  • Pages.135-150
  • /
  • 2020
  • /
  • 2234-1722(pISSN)
  • /
  • 2234-1730(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Preparation of chitosan, sunflower and nano-iron based core shell and its use in dye removal

  • Turgut, Esra (Faculty of Engineering, Department of Nano-Science and Nano-Engineering, Ataturk University) ;
  • Alayli, Azize (Faculty of Engineering, Department of Nano-Science and Nano-Engineering, Ataturk University) ;
  • Nadaroglu, Hayrunnisa (Faculty of Engineering, Department of Nano-Science and Nano-Engineering, Ataturk University)
  • 투고 : 2019.12.27
  • 심사 : 2020.06.01
  • 발행 : 2020.06.25
⟨ 이전 논문 다음 논문 ⟩

초록

Many industries, such as textiles, chemical refineries, leather, plastics and paper, use different dyes in various process steps. At the same time, these industrial sectors are responsible for discharging contaminants that are harmful and toxic to humans and microorganisms by introducing synthetic dyes into wastewater. Of these dyes, methylene blue dye, which is classified as basic dyes, is accepted as a model dye. For this reason, methylene blue dye was selected in the study and its removal from the water was studied. In this study, two efficient biosorbents were developed from chitosan and sunflower waste, an agro-industrial waste and modified using iron nanoparticles. The biosorption efficiency was evaluated for methylene blue (MB) dye removal from aqueous solution under various parameters such as treating agent, solution pH, biosorbent dosage, contact time, initial dye concentration and temperature. We investigated the kinetic properties of dye removal from water for Chitosan-Sunflower (CS), Chitosan-Sunflower-Nanoiron (CSN). When the wavelength of MB dye was spectrophotometrically scanned, the maximum absorbance was determined as 660 nm. For the core shell biosorbents we obtained, we found that the optimum time for removal of MB from wastewater was 60 min. The pH of the best pH was determined as 5 in the studied pH. The most suitable temperature for the experiment was determined as 30℃. SEM-EDAX, TEM, XRD, and FTIR techniques were used to characterize biosorbents produced and modified in the experimental stage and to monitor the change of biosorbent after dye removal. The interactions of the paint with the surface used for removal were explained by these techniques. It was calculated that 80% of CS and 88% of CSN removed MB in optimum conditions. Also, the absorption of MB dye onto the surface was investigated by Langmiur and Frendlinch isotherms and it was determined from the results that the removal was more compatible with Langmiur isotherm.

키워드

참고문헌

  1. Ahmad, A., Mohd-Setapar, S.H., Chuong, C.S., Khatoon, A., Wani W.A., Kumar, R. and Rafatullah., M. (2015), "Recent advances in new generation dye removal technologies: Novel search for approaches to reprocess wastewater", RSC Adv., 5(39), 30801-30818. https://doi.org10.1039/C4RA16959J.
  2. Ahmad, T., Danish, M., Rafatullah, M., Ghazali, A., Sulaiman, O., Hashim, R., Nasir, M. and Ibrahim, M. (2012), "The use of date palm as a potential adsorbent for wastewater treatment: A review", Environ. Sci. Pollut. Res., 19(5), 1464-1484. https://doi.org10.1007/s11356-011-0709-8.
  3. Ahmad, T., Rafatullah, M., Ghazali, A., Sulaiman, O. and Hashim, R. (2011), "Oil palm biomass-based adsorbents for the removal of water pollutants-a review", J. Environ. Sci. Health Part C, 29(3), 177-222. https://doi.org10.1080/10590501.2011.601847.
  4. Aksoy, O. (2012), "Evaluation of pomegranate paste as a new adsorptor for removal of some dyestuffs and copper metal from the aqueous solution", Master Thesis, Dicle University, Diyarbakir, Turkey.
  5. Basibuyuk, M. and Forster, C.F. (1997), "An examination of the treatability of a simulated textile wastewater containing maxilon red", Process Biochem., 32(6), 523-527. https://doi.org/10.1016/S0032-9592(97)00007-1.
  6. Cao, Y.L., Pan, Z.H., Shi, Q.X. and Yu, J.Y. (2018), "Modification of chitin with high adsorption capacity for methylene blue removal", Int. J. Biol. Macromolecul., 114, 392-399. https://doi.org/10.1016/j.ijbiomac.2018.03.138 .
  7. Dakikiy, M., Khamis, M., Manassra, A. and Mer'eb, M. (2002), "Selective adsorption of chromium (VI) in industrial wastewater using low-cost abundantly available adsorbents", Adv. Environ. Res., 6(4), 533-540. https://doi.org/10.1016/S1093-0191(01)00079-X.
  8. Dipa, G. and Bhattacharyya, K.G. (2002), "Adsorption of methylene blue on kaolinite", Appl. Clay Sci., 20(6), 295-300. https://doi.org/10.1016/S0169-1317 01)00081-3.
  9. Dotto, G.L. and Pinto, L.A.A. (2011), "Adsorption of food dyes acid blue 9 and food yellow 3 onto chitosan: Stirring rate effect in kinetics and mechanism", J. Hazard. Mater., 187, 164-170. https://doi.org/10.1016/j.jhazmat.2011.01.016.
  10. Fang, L. and Ding, C. (2011), "Adsorption of reactive black m-2r on different deacetylation degree chitosan", J. Eng. Fibers Fabrics, 6(3), 155892501100600303. https://doi.org/10.1177/155892501100600303.
  11. Gungor, A.A., Celebi, N. and Nadaroglu H. (2015), "Removal of basic red 9 in wastewater using green fenton reaction", Fresenius Environ. Bull., 24(5B), 1947-1957.
  12. Iqbal, J., Wattoo, F.H., Muhammad, H.S., Malik, R., Tirmizi, S.A., Imran, M. and Ghangro, A.B. (2010), "Adsorption of acid yellow dye on flakes of chitosan prepared from fishery wastes", Arab. J. Chem., 4(4), 389-395. https://doi.org/10.1016/J.Arabjc.2010.07.007.
  13. Ismail, B., Hussain, S.T. and Akram, S. (2013), "Adsorption of methylene blue onto spinel magnesium aluminate nanoparticles: adsorption isotherms, kinetic and thermodynamic studies", Chem. Eng. J., 219, 395-402. https://doi.org/10.1016/j.cej.2013.01.034.
  14. Karaduman, I., Gungor, A.A., Nadaroglu, H., Altundas, A. and Acar S. (2017), "Green synthesis of y-fe2o3 nanoparticles for methane gas sensing", J. Mater. Sci. Mater. Electron., 28(21), 16094-16105. https://doi.org/10.1007/s10854-017-7510-5.
  15. Kaya, Y. (2016), Sunflower, in Breeding Oilseed Crops for Sustainable Production, Academic Press, 55-88.
  16. Low, L.W., Teng, T.T., Rafatullah, M., Morad, N. and Azahari, B. (2013), "Adsorption studies of methylene blue and malachite green from aqueous solutions by pre-treated lignocellulosic materials", Sep. Sci. Technol., 48(11), 1688-1698. https://doi.org/10.1080/01496395.2012.756912.
  17. Mahmoodi, N.M., Salehi, R., Arami, M. and Bahrami, H. (2011), "Dye removal from colored textile wastewater using chitosan in binary systems", Desalination, 267, 64-72. https://doi.org/10.1016/j.desal.2010.09.007.
  18. Markovi, S., Stankovi, A., Lopicic, Z., Lazarevi, S., Stojanovi, M. and Uskokovi, D. (2015), "Application of raw peach shell particles for removal of methylene blue", J. Environ. Chem. Eng., 3(2), 716-724. https://doi.org/10.1016/j.jece.2015.04.002.
  19. Nadaroglu H., Gungor A.A. and Celebi N. (2015), "Removal of basic red 9 (BR9) in aqueous solution by using silica with nano-magnetite by enzymatic with fenton process", Int. J. Environ. Res., 9(3), 991-1000. https://doi.org 10.22059/IJER.2015.987.
  20. Nadaroglu, H., Alayli Gungor, A. and Ince, S. (2017). "Synthesis of nanoparticles by green synthesis method", Int. J. Innov. Res. Rev., 1(1), 6-9.
  21. Nadaroglu, H., Lesani, A., Soleimani, S.S., Babagil, A. and Gungor, A.A. (2018), "Efficient solar photocatalyst based on $TiO_2$ /corn silk NPs composite for removal of a textile azo-dye from aqueous solution", IIOAB J., 9(4), 20-27.
  22. Nollet, H., Roels, M., Lutgen, P., An Der Meeren, P. and Verstraete, W. (2003), "Removal of pcbs from wastewater using fly ash", Chemosphere, 53, 655-665. https://doi.org/10.1016/S0045-6535(03)00517-4.
  23. Piccin, J.S., Dotto, G.L. and Pinto, L.A.A. (2011), "Adsorption isotherms and thermochemical data of fd&c red no 40 binding by chitosan", Braz. J. Chem. Eng., 28(2), 295-304. https://doi.org/10.1590/S0104-66322011000200014.
  24. Rafatullah, M., Sulaiman, O., Hashim, R. and Ahmad, A. (2009), "Adsorption of methylene blue on low-cost adsorbents: A review", J. Hazard. Mater., 177(1-3), 70-80. https://doi.org 10.1016/J.Jhazmat.2009.12.047.
  25. Saha, T.K., Bhoumik, N.C., Karmaker, S., Ahmed, M.G., Ichikawa, H. and Fukumori, Y. (2010), "Adsorption of methyl orange onto chitosan from aqueous solution", J. Water Resour. Protect., 2, 898-906. https://doi.org 10.4236/jwarp.2010.210107.
  26. Salimi, F., Rahimi, H. and Karami, C. (2019), "Removal of methylene blue from water solution by modified nanogoethite by Cu", Desalination Water Treatment, 137, 334-344. https://doi.org10.5004/dwt.2019.22922.
  27. Simonetti, E.A.N., Cividanes, L.D.S., Campos, T.M.B., Menezes, B.R.C.D., Brito, F.S. and Thim, G.P. (2016), "Carbon and $TiO_2$ synergistic effect on methylene blue adsorption", Mater. Chem. Phys., 177, 330-338. https://doi.org/10.1016/j.matchemphys.2016.04.035.
  28. Sulfath, T.S., Bhanu, K.M., Koneru, V., Aparna, R.M. and Ann, V.K. (2019), "Case report on methylene blue induced hemolytic anemia", Int. J. Med. Res. Health Sci., 8(5), 83-85.
  29. Turgut, E. (2019), "Chitosan, nanoparticle and sunflower plant based biosorbent material production and investigation of usability for dye removal", Master Thesis, Ataturk University Nanoscience and Nano Engineering, Erzurum, Turkey.
  30. Uddin, M.T., Islam, M.A., Mahmud, S. and Rukanuzzaman M. (2009), "Adsorptive removal of methylene blue by tea waste", J. Hazard. Mater., 164(1), 53-60. https://doi.org10.1016/j.jhazmat.2008.07.131.
  31. Vakili, M., Mohd, R., Babak, S., Ahmad, Z.A., Mahamad, H.I., Kok, B.T., Zahra, G. and Parisa, A. (2014), "Application of chitosan and its derivatives as adsorbents for dye removal from water and wastewater: A review", Carbohyd. Polym., 13, 115-130. https://doi.org10.1016/j.carbpol.2014.07.007.