DOI QR코드

DOI QR Code

Monte Carlo analysis of the induced cracked zone by single-hole rock explosion

  • Shadabfar, Mahdi (Department of Civil Engineering, Sharif University of Technology) ;
  • Huang, Hongwei (Department of Geotechnical Engineering, Tongji University) ;
  • Wang, Yuan (Department of Geotechnical Engineering, Hohai University) ;
  • Wu, Chenglong (Department of Geotechnical Engineering, Hohai University)
  • 투고 : 2018.01.20
  • 심사 : 2020.03.23
  • 발행 : 2020.05.10

초록

Estimating the damage induced by an explosion around a blast hole has always been a challenging issue in geotechnical engineering. It is difficult to determine an exact dimension for damage zone since many parameters are involved in the formation of failures, and there are some uncertainties lying in these parameters. Thus, the present study adopted a probabilistic approach towards this problem. First, a reliability model of the problem was established and the failure probability of induced damage was calculated. Then, the corresponding exceedance risk curve was developed indicating the relation between the failure probability and the cracked zone radius. The obtained risk curve indicated that the failure probability drops dramatically by increasing the cracked zone radius so that the probability of exceedance for any crack length greater than 4.5 m is less than 5%. Moreover, the effect of each parameter involved in the probability of failure, including blast hole radius, explosive density, detonation velocity, and tensile strength of the rock, was evaluated by using a sensitivity analysis. Finally, the impact of the decoupling ratio on the reduction of failures was investigated and the location of its maximum influence was demonstrated around the blast point.

키워드

참고문헌

  1. Ash, R.L. (1963), "The mechanics of rock breakage (part 2), standards for blasting design", Pit Quarry, 56(3), 118-122.
  2. Ash, R.L. (1963), "The mechanics of the rock breakage (part 1)", Pit Quarry, 56(2), 98-100.
  3. BakhshandehAmnieh, H. and Bahadori, M. (2012), "Numerical and field analysis of single-hole blasting mechanism in conglomerate rock mass of Gotvand Olya Dam", Energy Eng. Manage., 2(1), 22-31.
  4. Blasting Accessories (2010), Blasting and Explosives Quick Reference Guide, Dyno Nobel. https://www.yumpu.com/en/document/view/4652050/blasting-and-explosives-quick-reference-guide-2010-dyno-nobel.
  5. Britton, R.R. (1987), "Effect of decoupling ratio on explosive-generated energy release", Ph.D. Dissertation, The Ohio State University, Columbus, Ohio, U.S.A.
  6. Cardoso, J.B., de Almeida, J.R., Dias, J.M. and Coelho, P.G. (2008), "Structural reliability analysis using Monte Carlo simulation and neural networks", Adv. Eng. Softw., 39(6), 505-513. https://doi.org/10.1016/j.advengsoft.2007.03.015.
  7. Donze, F.V., Bouchez, J. and Magnier, S.A. (1997), "Modeling fractures in rock blasting", Int. J. Rock Mech. Min. Sci., 34(8), 1153-1163. https://doi.org/10.1016/S1365-1609(97)80068-8.
  8. Drukovanyi, M.F., Komir, V.M., Myachina, N.I., Rodak, S.N. and Semenyuk, E.A. (1973), "Effect of the charge diameter and type of explosive on the size of the overcrushing zone during an explosion", J. Min. Sci., 9(5), 500-506. https://doi.org/10.1007/BF02501378.
  9. Emsley, S., Olsson, O., Stenberg, L., Alheid, H.J. and Falls, S. (1997), "ZEDEX - A study of damage and disturbance from tunnel excavation by blasting and tunnel boring", No. SKB-TR-97-30, Swedish Nuclear Fuel and Waste Management Co., Stockholm, Sweden.
  10. Esen, S., Onederra, I. and Bilgin, H.A. (2003), "Modelling the size of the crushed zone around a blast hole", Int. J. Rock Mech. Min. Sci., 40(4), 485-495. https://doi.org/10.1016/S1365-1609(03)00018-2.
  11. Hu, Y., Lu, W., Chen, M., Yan, P. and Yang, J. (2013), "Comparison of blast-induced damage between presplit and smooth blasting of high rock slope", Rock Mech. Rock Eng., 47(4), 1307-1320. https://doi.org/10.1007/s00603-013-0475-7.
  12. Hustrulid, W. (2010), "Some comments regarding development drifting practices with special emphasis on caving applications", Min. Technol., 119(3), 113-131. https://doi.org/10.1179/174328610X12820409992219.
  13. Hustrulid, W. and Johnson, J. (2008), "A gas pressure-based drift round blast design methodology", Proceedings of the 5th International Conference and Exhibition on Mass Mining, Lulea, Sweden, June.
  14. Iverson, S.R., Hustrulid, W.A. and Johnson, J.C. (2013), "A new perimeter control blast design concept for underground metal/nonmetal drifting applications", Technical Report, National Institute for Occupational Safety and Health, Office of Mine Safety and Health Research.
  15. Kostic, S., Perc, M., Vasovic, N. and Trajkovic, S. (2013), "Predictions of experimentally observed stochastic ground vibrations induced by blasting", PLoS ONE, 8(12), 1-13. https://dx.doi.org/10.1371%2Fjournal.pone.0082056b.
  16. Liang, W.M., Liu, H.Y. and Zhou, F.J. (2012), "Influence of air-decoupling charge on rock blasting", Trans. Beijing Inst. Technol., 32(12), 1215-1218.
  17. Liu, C.Y., Yang, J.X. and Yu, B. (2017), "Rock-breaking mechanism and experimental analysis of confined blasting of borehole surrounding rock", Int. J. Min. Sci. Technol., 27(5), 795-801. https://doi.org/10.1016/j.ijmst.2017.07.016.
  18. Lu, W., Leng, Z., Chen, M., Yan, P. and Hu, Y. (2016), "A modified model to calculate the size of the crushed zone around a blast-hole", J. South. Afr. Inst. Min. Metall., 116(5), 413-422. http://dx.doi.org/10.17159/2411-9717/2016/v116n5a7.
  19. Ma, G.W., Hao, H. and Wang, F. (2011), "Simulations of explosion-induced damage to underground rock chambers", J. Rock Mech. Geotech. Eng., 3(1), 19-29. https://doi.org/10.3724/SP.J.1235.2011.00019.
  20. Nagy, N., Mohamed, M. and Boot, J.C. (2010), "Nonlinear numerical modelling for the effects of surface explosions on buried reinforced concrete structures", Geomech. Eng., 2(1), 1-18. http://doi.org/10.12989/gae.2010.2.1.001.
  21. Nie, S. (1999), "Measurement of borehole pressure history in blast holes in rock blocks", Fragblast 1999.
  22. Nikolaidis, E., Ghiocel, D.M. and Singhal, S. (2005), Engineering Design Reliability, CRC Press, Taylor and Francis.
  23. Nowak, A.S. and Collins, K.R. (2013), Reliability of Structures, CRC Press, Taylor and Francis.
  24. Perras, M.A. and Diederichs, M.S. (2014), "Predicting excavation damage zone depths in brittle rocks", J. Rock Mech. Geotech. Eng., 8(1), 60-74. https://doi.org/10.1016/j.jrmge.2015.11.004.
  25. Senuk, V.M. (1979), "The impulse from an explosion, and conditions for its greater utilization in crushing hard rock masses in blasting", Soviet Min. Sci., 15(1), 22-27. https://doi.org/10.1007/BF02499637.
  26. Sharafisafa, M., Aliabadian, Z., Alizadeh, R. and Mortazavi, A. (2014), "Distinct element modelling of fracture plan control in continuum and jointed rock mass in presplitting method of surface mining", Int. J. Min. Sci. Technol., 24(6), 871-881. https://doi.org/10.1016/j.ijmst.2014.10.022.
  27. Sun, C. (2013), "Damage zone prediction for rock blasting", Ph.D. Dissertation, The University of Utah, Salt Lake City, Utah, U.S.A.
  28. Talhi, K. and Bensaker, B. (2003), "Design of a model blasting system to measure peak p-wave stress", Soil Dyn. Earthq. Eng., 23(6), 513-519. https://doi.org/10.1016/S0267-7261(03)00018-6.
  29. Torbica, S. and Lapcevic, V. (2016), "Fragmenting of cylindrical rock specimens under explosive load: Comparison between model and laboratory results", Min. Metall. Inst. Bor, 1, 103-114. https://doi.org/10.5937/mmeb1601103T
  30. Tripathy, G.R., Shirke, R.R. and Kudale, M.D. (2016), "Safety of engineered structures against blast vibrations: A case study", J. Rock Mech. Geotech. Eng., 8(2), 248-255. https://doi.org/10.1016/j.jrmge.2015.10.007.
  31. Trivino, L.F. and Mohanty, B. (2015), "Assessment of crack initiation and propagation in rock from explosion-induced stress waves and gas expansion by cross-hole seismometry and FEMDEM method", Int. J. Rock Mech. Min. Sci., 77, 287-299. https://doi.org/10.1016/j.ijrmms.2015.03.036.
  32. Wang, Y. (2017), "Study of the dynamic fracture effect using slotted cartridge decoupling charge blasting", Int. J. Rock Mech. Min. Sci., 96, 34-46. https://doi.org/10.1016/j.ijrmms.2017.04.015.
  33. Xie, L.X., Lu, W.B., Zhang, Q.B., Jiang, Q.H., Wang, G.H. and Zhao, J. (2016), "Damage evolution mechanisms of rock in deep tunnels induced by cut blasting", Tunn. Undergr. Sp. Technol., 58, 257-270. https://doi.org/10.1016/j.tust.2016.06.004.
  34. Xu, G.Y., Duan, L.Z., Gu, D.S. and Yan, C.B. (2004), "Radial explosion strain and its fracture effect from confined explosion with charge of cyclonite", J. Central South Univ. Technol., 11(4), 429-433. https://doi.org/10.1007/s11771-004-0089-z.
  35. Yilmaz, O. and Unlu, T. (2013), "Three dimensional numerical rock damage analysis under blasting load", Tunn. Undergr. Sp. Technol., 38, 266-278. https://doi.org/10.1016/j.tust.2013.07.007.
  36. Zhang, Z.X. (2016), Chapter 10 - Single-Hole Blasting, in Rock Fracture and Blasting, Theory and Applications, Elsevier, Butterworth-Heinemann.
  37. Zhu, Z., Mohanty, B. and Xie, H. (2007), "Numerical investigation of blasting-induced crack initiation and propagation in rocks", Int. J. Rock Mech. Min. Sci., 44(3), 412-424. https://doi.org/10.1016/j.ijrmms.2006.09.002.

피인용 문헌

  1. Explosion wave and crack field of an eccentric decoupled charge vol.60, pp.33, 2020, https://doi.org/10.1364/ao.438530
  2. Estimation of Damage Induced by Single-Hole Rock Blasting: A Review on Analytical, Numerical, and Experimental Solutions vol.14, pp.1, 2020, https://doi.org/10.3390/en14010029