DOI QR코드

DOI QR Code

Numerical and experimental study on hydrodynamic performance of multi-level OWEC

  • Jungrungruengtaworn, Sirirat (Department of Maritime Engineering, Faculty of International Maritime Studies, Kasetsart University) ;
  • Reabroy, Ratthakrit (Department of Maritime Engineering, Faculty of International Maritime Studies, Kasetsart University) ;
  • Thaweewat, Nonthipat (Department of Maritime Engineering, Faculty of International Maritime Studies, Kasetsart University) ;
  • Hyun, Beom-Soo (Department of Naval Architecture and Ocean Systems Engineering, Korea Maritime and Ocean University)
  • 투고 : 2020.05.30
  • 심사 : 2020.10.19
  • 발행 : 2020.12.25

초록

The performance of a multi-level overtopping wave energy converter (OWEC) has been numerically and experimentally investigated in a two-dimensional wave tank in order to study the effects of opening width of additional reservoirs. The device is a fixed OWEC consisting of an inclined ramp together with several reservoirs at different levels. A particle-based numerical simulation utilizing the Lattice Boltzmann Method (LBM) is used to simulate the flow behavior around the OWEC. Additionally, an experimental model is also built and tested in a small wave flume in order to validate the numerical results. A comparison in energy captured performance between single-level and multi-level devices has been proposed using the hydraulic efficiency. The enhancement of power capture performance is accomplished by increasing an overtopping flow rate captured by the extra reservoirs. However, a noticeably large opening of the extra reservoirs can result in a reduction in the power efficiency. The overtopping flow behavior into the reservoirs is also presented and discussed. Moreover, the results of hydrodynamic performance are compared with a similar study, of which a similar tendency is achieved. Nevertheless, the LBM simulations consume less computational time in both pre-processing and calculating phases.

키워드

과제정보

The authors would like to acknowledge Norawat Chareonthanavit, Patipan Boonchan, Wasuta Pannaphop, Setthawut Sukuma and Tanakorn Sa-nguansook for their contribution and generous supply of numerical and experimental data.

참고문헌

  1. Buccino, M., Daliri, M., Dentale, F. and Calabrese, M. (2019a), "CFD experiments on a low crested sloping top caisson breakwater. Part 2. Analysis of plume impact", Ocean Eng., 173, 345-357. https://doi.org/10.1016/j.oceaneng.2018.12.065.
  2. Buccino, M., Daliri, M., Dentale, F., Leo, A.D. and Calabrese, M. (2019b), "CFD experiments on a low crested sloping top caisson breakwater. Part 1. Nature of loadings and global stability", Ocean Eng., 182, 259-282. https://doi.org/10.1016/j.oceaneng.2019.04.017.
  3. Cho, I. and Kim, M. (2013), "Enhancement of wave-energy-conversion efficiency of a single power buoy with inner dynamic system by intentional mismatching strategy", Ocean Syst. Eng., 3(3), 203-217. https://doi.org/10.12989/ose.2013.3.3.203.
  4. Cho, I., Kim, M. and Kweon, H. (2012), "Wave energy converter by using relative heave motion between buoy and inner dynamic system", Ocean Syst. Eng., 2(4), 297-314. https://doi.org/10.12989/ose.2012.2.4.297.
  5. Chumchan, C. and Rattanadecho, P. (2020), "Experimental and numerical investigation of dam break flow propagation passed through complex obstacles using LES model based on FVM and LBM.", Songklanakarin J. Sci. Technol., 42(3), 564-572. https://doi.org/10.14456/sjst-psu.2020.71.
  6. Cui, Y. and Hyun, B.S. (2016), "Numerical study on Wells turbine with penetrating blade tip treatments for wave energy conversion", Int. J. Naval Architect. Ocean Eng., 8(5), 456-465. https://doi.org/10.1016/j.ijnaoe.2016.05.009.
  7. Cui, Y., Hyun, B.S. and Kim, K. (2017), "Numerical study on air turbines with enhanced techniques for OWC wave energy conversion", China Ocean Eng., 31(5), 517-527. https://doi.org/10.1007/s13344-017-0060-z.
  8. de Andres, A., Medina-Lopez, E., Crooks, D., Roberts, O. and Jeffrey, H. (2017), "On the reversed LCOE calculation: Design constraints for wave energy commercialization", Int. J. Marine Energy, 18, 88-108. https://doi.org/10.1016/j.ijome.2017.03.008.
  9. Drew, B., Plummer, A. and Sahinkaya, M.N. (2009), "A review of wave energy converter technology", Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 223(8), 887-902. https://doi.org/10.1243/09576509jpe782
  10. Evans, D.V. and Antonio, F.d.O. (2012), Hydrodynamics of Ocean Wave-Energy Utilization: IUTAM Symposium Lisbon/Portugal 1985, Springer Science & Business Media.
  11. Han, Z., Liu, Z. and Shi, H. (2018), "Numerical study on overtopping performance of a multi-level breakwater for wave energy conversion", Ocean Eng., 150, 94-101. https://doi.org/10.1016/j.oceaneng.2017.12.058.
  12. Jungrungruengtaworn, S. and Hyun, B.S. (2017), "Influence of slot width on the performance of multi-stage overtopping wave energy converters", Int. J. Naval Architect. Ocean Eng., 9(6), 668-676. https://doi.org/10.1016/j.ijnaoe.2017.02.005.
  13. Jungrungruengtaworn, S. and Hyun, B.S. (2018), "Numerical Investigation of Design Strategy on Overtopping Performance of Multi-Stage OWEC", Proceedings of the 2018 OCEANS - MTS/IEEE Kobe Techno-Oceans (OTO), IEEE. https://doi.org/10.1109/oceanskobe.2018.8558884.
  14. Kim, J., Cho, I.H. and Kim, M.H. (2019), "Numerical calculation and experiment of a heaving-buoy wave energy converter with a latching control", Ocean Syst. Eng., 9(1), 1-19. https://doi.org/10.12989/ose.2019.9.1.001.
  15. Kofoed, J. and Frigaard, P. (1999), "Evaluation of hydraulic response of the Wave Dragon", Test Report.
  16. Kofoed, J.P., Frigaard, P., Friis-Madsen, E. and Sorensen, H.C. (2006), "Prototype testing of the wave energy converter wave dragon", Renew. Energy, 31(2), 181-189. https://doi.org/10.1016/j.renene.2005.09.005.
  17. Kofoed, J.P. and Osaland, E. (2005), "Crest level optimization of the multi level overtopping based wave energy converter seawave slot-cone generator", Proceedings of the 6th European Wave and Tidal Energy Conference, 243-250.
  18. Koo, W. and Kim, M.H. (2012), "A time-domain simulation of an oscillating water column with irregular waves", Ocean Systems Engineering, 2(2), 147-158. https://doi.org/10.12989/ose.2012.2.2.147.
  19. Lallemand, P. and Luo, L.S. (2000), "Theory of the lattice Boltzmann method: Dispersion, dissipation, isotropy, Galilean invariance, and stability", Physical Review E, 61(6), 6546. https://doi.org/10.1103/PhysRevE.61.6546
  20. Lallemand, P. and Luo, L.S. (2003), "Lattice Boltzmann method for moving boundaries", J. Comput. Phys., 184(2), 406-421. https://doi.org/10.1016/s0021-9991(02)00022-0.
  21. Liu, Z., Han, Z., Shi, H. and Yang, W. (2018), "Experimental study on multi-level overtopping wave energy convertor under regular wave conditions", Int. J. Naval Architect. Ocean Eng., 10(5), 651-659. https://doi.org/10.1016/j.ijnaoe.2017.10.004.
  22. Lopez, I., Andreu, J., Ceballos, S., de Alegria, I.M. and Kortabarria, I. (2013), "Review of wave energy technologies and the necessary power-equipment", Renew. Sust. Energy, 27, 413-434. https://doi.org/10.1016/j.rser.2013.07.009.
  23. Margheritini, L., Vicinanza, D. and Frigaard, P. (2009), "SSG wave energy converter: Design, reliability and hydraulic performance of an innovative overtopping device", Renew. Energy, 34(5), 1371-1380. https://doi.org/10.1016/j.renene.2008.09.009.
  24. Maroufi, A. and Aghanajafi, C. (2013), "Analysis of conduction-radiation heat transfer during phase change process of semitransparent materials using lattice Boltzmann method", J. Quantitative Spectroscopy Radiative Transfer, 116, 145-155. https://doi.org/10.1016/j.jqsrt.2012.10.019.
  25. Melikoglu, M. (2018), "Current status and future of ocean energy sources: A global review", Ocean Eng., 148, 563-573. https://doi.org/10.1016/j.oceaneng.2017.11.045.
  26. Mustapa, M., Yaakob, O., Ahmed, Y.M., Rheem, C.K., Koh, K. and Adnan, F.A. (2017), "Wave energy device and breakwater integration: A review", Renew. Sust. Energy Review, 77, 43-58. https://doi.org/10.1016/j.rser.2017.03.110.
  27. Parmeggiani, S., Chozas, J.F., Pecher, A., Friis-Madsen, E., Sorensen, H. and Kofoed, J.P. (2011), "Perfor mance assessment of the wave dragon wave energy converter based on the EquiMar methodology", Proceedings of the 9th European Wave and Tidal Energy Conference (EWTEC), 9.
  28. Shadman, M., Silva, C., Faller, D., Wu, Z., de Freitas Assad, L., Landau, L., Levi, C. and Estefen, S. (2019), "Ocean renewable energy potential, technology, and deployments: A case study of Brazil", Energies, 12(19), 3658. https://doi.org/10.3390/en12193658.
  29. Sorensen, H., Hansen, R., Friis-Madsen, E., Panhauser, W., Mackie, G., Hansen, H., Frigaard, P., Hald, T., Knapp, W., Keller, J., Holmen, E., Holmes, B., Thomas, G. and Rasmussen, P. (2000), "The Wave Dragon: now ready for tests in real seas", Proceedings of the 4th European Wave Energy Conference, Aalborg, Denmark.
  30. Tedd, J. and Kofoed, J.P. (2009), "Measurements of overtopping flow time series on the Wave Dragon, wave energy converter", Renew. Energy, 34(3), 711-717. https://doi.org/10.1016/j.renene.2008.04.036.
  31. Vicinanza, D., Dentale, F., Salerno, D., Buccino, M. et al. (2015), "Structural response of seawave slot-cone generator (SSG) from random wave CFD simulations", Proceedings of the 25th International Ocean and Polar Engineering Conference, International Society of Offshore and Polar Engineers.
  32. Xie, J. and Zuo, L. (2013), "Dynamics and control of ocean wave energy converters", Int. J. Dynam. Control, 1(3), 262-276. https://doi.org/10.1007/s40435-013-0025-x.