Advances in concrete construction

  • 제8권2호
  • /
  • Pages.145-154
  • /
  • 2019
  • /
  • 2287-5301(pISSN)
  • /
  • 2287-531X(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Experimental study on effect of EBRIG shear strengthening method on the behavior of RC beams

  • 투고 : 2018.05.09
  • 심사 : 2019.06.12
  • 발행 : 2019.10.25
⟨ 이전 논문 다음 논문 ⟩

초록

The present experimental study addresses the structural response of reinforced concrete (RC) beams strengthened in shear. Thirteen RC beams were divided into four different sets to investigate the effect of transverse and longitudinal steel reinforcement ratios, concrete compressive strength change and orientation for installing carbon fiber-reinforced polymer (CFRP) laminates. Then, we employed a shear strengthening solution through externally bonded reinforcement in grooves (EBRIG) and externally bonded reinforcement (EBR) techniques. In this regard, rectangular beams of $200{\times}300{\times}2000mm$ dimensions were subjected to the 4-point static loading condition and their load-displacement curves, load-carrying capacity and ductility changes were compared. The results revealed that using EBRIG method, the gain percentage augmented with the increase in the longitudinal reinforcement ratio. Also, in the RC beams with stirrups, the gain in shear strength decreased as transverse reinforcement ratio increased. The results also revealed that the shear resistance obtained by the experimental tests were in acceptable agreement with the design equations. Besides, the results of this research indicated that using the EBRIG system through vertical grooves in RC beams with and without stirrups caused the energy absorption to increase about 85% and 97%, respectively, relative to the control.

키워드

참고문헌

  1. Abdel-Karim, A.A. (2014), "Shear strengthening of reinforced concrete beams with rectangular web openings by FRP composites", Adv. Concrete Constr., 2(4), 281-300. https://doi.org/10.12989/acc.2014.2.4.281
  2. Abdul, A.A., Ali, S.N. and Mohamad, N. (2017), "Shear strengthening and shear repair of 2-span continuous RC beams with CFRP strips", J. Compos. Constr., 21(3), 401- 412.
  3. ACI 318R-4 (2014), Building Code Requirements for Structural Concrete and Commentary, American Concrete Institute; Farmington Hills, Michigan, USA.
  4. ACI 440.2R-08 (2008), Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete MI, USA.
  5. Al-Tersawy, S.H. (2013), "Effect of fiber parameters and concrete strength on shear behavior of strengthened RC beams", Constr. Build. Mater., 44, 15-24. https://doi.org/10.1016/j.conbuildmat.2013.03.007
  6. ASTM C 39/C 39M-04a (2005), Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens, ASTM International, West Conshohocken, PA.
  7. Belarbi, A. and Acun, B. (2013), "FRP systems in shear strengthening of reinforced concrete structures", Procedia Eng., 57, 2-8. https://doi.org/10.1016/j.proeng.2013.04.004
  8. Chen, J.F. and Teng, J.G. (2003), "Shear capacity of FRP strengthened RC beam: FRP de-bonding", Constr. Build. Mater., 17(1), 27-41. https://doi.org/10.1016/S0950-0618(02)00091-0
  9. De Lorenzis, L. and Rizzo, A. (2009), "Behavior and capacity of RC beams strengthened in shear with NSM FRP Reinforcement", Constr. Build. Mater., 23, 1555-1567. https://doi.org/10.1016/j.conbuildmat.2007.08.014
  10. De Lorenzis, L. and Teng, J.G. (2007), "Near-surface mounted FRP reinforcement: an emerging technique for strengthening structures", Compos. Part B Eng., 38(2), 119-143. https://doi.org/10.1016/j.compositesb.2006.08.003
  11. Galal, K. and Mofidi, A. (2010), "Shear strengthening of RC Tbeams using mechanically anchored un-bonded dry carbon fiber sheets", J. Perform. Constr. Facil., 24(1), 31-39. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000067
  12. Grande, E., Imbimb, M. and Rasulo, A. (2009), "Effect of transverse steel on the response of RC beams strengthened in shear by FRP-experimental study", J. Compos. Constr., 13(5), 405-414. https://doi.org/10.1061/(ASCE)1090-0268(2009)13:5(405)
  13. Gunes, O., Lau, D., Tuakta, C. and Buyukozturk, O. (2013), "Ductility of FRP- concrete systems: investigations at different length scales", Constr. Build. Mater., 49, 915-925. https://doi.org/10.1016/j.conbuildmat.2012.10.017
  14. Hosen, M.A., Jumaat, M.Z., Saiful Islam, A.B.M., Kamruzzaman, M., Nazmul Huda, M.D. and Rahman Soeb, M. (2015), "Eliminating concrete cover separation of NSM strengthened beam by CFRP end anchorage", Struct. Eng. Mech., 56(6), 899-916. https://doi.org/10.12989/sem.2015.56.6.899
  15. Kuntal, V.S., Chellapandian, M. and Prakash, S.S. (2017), "Efficient near surface mounted CFRP shear strengthening of high strength pre-stressed concrete beams-An experimental study", Compos. Struct., 180, 16-28. https://doi.org/10.1016/j.compstruct.2017.07.095
  16. Mesbah, H.A. and Benzaid, R. (2017), "Damage-based stressstrain model of RC cylinders wrapped with CFRP composites", Adv. Concrete Constr., 5(5), 539-561. https://doi.org/10.12989/acc.2017.5.5.539
  17. Mofidi, A. and Chaallal, O. (2014), "Effect of steel stirrups on shear resistance gain due to externally bonded fiber sheets", ACI Struct. J., 111(2), 353-362.
  18. Mofidi, A., Chaallal, O. and Cheng, L. (2016), "Investigation of near surface-mounted method for shear rehabilitation of reinforced concrete beams using fiber reinforced-polymer composites". J. Compos. Constr., 20(2), 201-214.
  19. Mostofinejad, D. and Mahmoudabadi, E. (2010), "Grooving as an alternative of surface preparation to postpone de-bonding of FRP lamination in concrete beams", J. Compos. Constr., 14(6), 804-811. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000117
  20. Mostofinejad, D. and Moshiri, N. (2014), "Compressive strength of CFRP composites used for strengthening of RC columns: Comparative evaluation of EBR and grooving methods", J. Compos. Constr., 19, 04014079. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000545
  21. Mostofinejad, D. and Shameli, S.M. (2013), "Externally bonded reinforcement in grooves (EBRIG) technique to postpone debonding of FRP sheets in strengthened concrete beams", Constr. Build. Mater., 38, 751-758. https://doi.org/10.1016/j.conbuildmat.2012.09.030
  22. Mostofinejad, D. and Tabatabaei Kashani, A. (2013), "Experimental study on effect of EBR and EBROG methods on de-bonding of FRP sheets used for shear strengthening of RC beams", Compos. Part B Eng., 45, 1704-1713. https://doi.org/10.1016/j.compositesb.2012.09.081
  23. Mostofinejad, D. and Torabian, A. (2015), "Experimental study of circular RC columns strengthened with longitudinal CFRP composites under eccentric loading: Comparative evaluation of EBR and EBROG methods on effect of EBR and EBROG methods", J. Compos. Constr., 20(2), 04015055. https://doi.org/10.1061/(ASCE)CC.1943-5614.0000618
  24. Mostofinejad, D., Esfahani, M.R. and Shomali, A. (2019), "Experimental and numerical study of the RC beams shearstrengthened with NSM technique", J. Compos. Mater., 0021998319830777.
  25. Mostofinejad, D., Hosseini, S.A. and Razavi, S.B. (2016), "Influence of different bonding and wrapping techniques on performance of beams strengthened in shear using CFRP reinforcement", Constr. Build. Mater., 116, 310-320. https://doi.org/10.1016/j.conbuildmat.2016.04.113
  26. Rita, S.Y., Wong, F. and Vecchio, J. (2003), "Towards modeling of reinforced concrete members with externally bonded fiber reinforced polymer composites", ACI Struct. J., 100(1), 47-55.
  27. Saljoughian, A. and Mostofinejad, D. (2018), "Grooving methods in square RC columns strengthened with longitudinal CFRP under cyclic axial compression", Eng. Struct., 174, 724-735. https://doi.org/10.1016/j.engstruct.2018.08.007
  28. Satish Kumar, C.N., Krishna, P.V. and Kumar, D.R. (2017), "Effect of fiber and aggregate size on mode-I fracture parameters of high strength concrete", Adv. Concrete Constr., 5(6), 613-624. https://doi.org/10.12989/ACC.2017.5.6.613
  29. Shomali, A., Mostofinejad, D. and Esfahani, M.R. (2019), "Shear strengthening of RC beams using EBRIG CFRP strips: A comparative study", Eur. J. Environ. Civil Eng., 5(6), 625-638.
  30. Sumathi, A. and Arun Vignesh, S. (2017), "Study on behavior of RCC beams with externally bonded FRP members in flexure", Adv. Concrete Constr., 5(6), 625-638. https://doi.org/10.12989/ACC.2017.5.6.625
  31. Teng, J.G., Chen, J.F., Smith, S.T. and Lam, L. (2002), FRP Strengthened RC Structures, John Wiley & Sons, USA.
  32. Zhou, C., Ren, D. and Cheng, X. 2017, "Shear-strengthening of RC continuous T-beams with spliced CFRP U-strips around bars against flange top", Struct. Eng. Mech., 64(1), 135-143. https://doi.org/10.12989/sem.2017.64.1.135