DOI QR코드

DOI QR Code

Strength and abrasion resistance of roller compacted concrete incorporating GGBS and two types of coarse aggregates

  • Saluja, Sorabh (Department of Civil Engineering, Thapar Institute of Engineering and Technology) ;
  • Goyal, Shweta (Department of Civil Engineering, Thapar Institute of Engineering and Technology) ;
  • Bhattacharjee, Bishwajit (Department of Civil Engineering, Indian Institute of Technology)
  • Received : 2018.06.06
  • Accepted : 2019.05.10
  • Published : 2019.10.25

Abstract

Roller Compacted Concrete (RCC) is a zero slump concrete consisting of a mixture of cementitious materials, sand, dense graded aggregates and water. In this study, an attempt has been made to investigate the effect of aggregate type on strength and abrasion resistance of RCC made by using granulated blast furnace slag (GGBS) as partial replacement of cement. Mix proportions of RCC were finalized based upon the optimum water content achieved in compaction test. Two different series of RCC mixes were prepared with two different aggregates: crushed gravel and limestone aggregates. In both series, cement was partially replaced with GGBS at a replacement level of 20%, 40% and 60%. Strength Properties and abrasion resistance of the resultant mixes was investigated. Abrasion resistance becomes an essential parameter for understanding the acceptability of RCC for rigid pavements. Experimental results show that limestone aggregates, with optimum percentage of GGBS, perform better in compressive strength and abrasion resistance as compared to the use of crushed gravel aggregates. Observed results are further supported by stoichiometric analysis of the mixes by using basic stoichiometric equations for hydration of major cement compounds.

Keywords

References

  1. Aghabaglou, A.M. and Ramyar, K. (2013), "Mechanical properties of high volume fly ash roller compacted concrete designed by maximum density method", Constr. Build. Mater., 38, 356-364. https://doi.org/10.1016/j.conbuildmat.2012.07.109
  2. American Concrete Institute (1988), ACI 207.5R: Roller Compacted Mass Concrete, Tilte No. 85-M44, ACI Materials Journal Committee report, U.S.A.
  3. American Concrete Institute (2001), ACI 325.10R -95: Report on Roller-Compacted Concrete Pavements, USA.
  4. American Concrete Institute (2002), ACI 211.3R -02: Guide for Selecting Proportions for No- Slump Concrete, U.S.A.
  5. Ashish, D.K., Singh, B. and Verma, S.K. (2016), "The effect of attack of chloride and sulphate on ground granulated blast furnace slag concrete", Adv. Concrete Constr., 4(2), 101-121.
  6. ASTM C 1170/C1170M -08 (2008), Standard Test Method for Determining Consistency and Density of Roller Compacted Concrete using a Vibrating Table, American Society of Testing and Materials, West Conshohocken, U.S.A.
  7. ASTM C 1176/C1176 M -08 (2008), Standard Practice for Making Roller Compacted Concrete in Cylinder Molds using a Vibrating Table, American Society of Testing and Materials, West Conshohocken, U.S.A.
  8. ASTM D1557-09 (2009), Standard Test Methods for Laboratory Compaction Characteristics of Soil using Modified Effort (2.700 kN.m/$m^3$), American Society of Testing and Materials, West Conshohocken, U.S.A.
  9. Babu, G.K. and Kumar, V.S.R. (2000), "Efficiency of GGBS in concrete", Cement Concrete Res., 30, 1031-1036. https://doi.org/10.1016/S0008-8846(00)00271-4
  10. Beixing, L., Guoju, K. and Mingkai, Z. (2011), "Influence of manufactured sand characteristics on strength and abrasion resistance of pavement cement concrete", Constr. Build. Mater., 25, 3849-3853. https://doi.org/10.1016/j.conbuildmat.2011.04.004
  11. Beshr, H., Almusallam, A.A. and Maslehuddin M. (2003), "Effect of coarse aggregate quality on the mechanical properties of high strength concrete", Constr. Build. Mater., 17, 97-103. https://doi.org/10.1016/S0950-0618(02)00097-1
  12. BIS 12089 (1987), Indian Standard Specification for Granulated Slag for the Manufacture of Portland Slag Cement, Bureau of Indian Standards, New Delhi, India.
  13. BIS 1237 (1980), Indian Standard Method for Testing Abrasion Resistance of Concrete, Bureau of Indian Standards, New Delhi, India.
  14. BIS 383 (2002), Indian Standard Specification for Coarse and Fine Aggregates from Natural Sources for Concrete, Bureau of Indian Standards, New Delhi, India.
  15. BIS 516-1959 (Reconfirmed 2004), Indian Standard Methods of Tests for Strength of Concrete, Bureau of Indian Standards, New Delhi, India.
  16. BIS 8112 (1989), Indian Standard Specification for 43 Grade Ordinary Portland Cement, Bureau of Indian Standards, New Delhi, India.
  17. Cai, X., He, Z., Tang, S. and Chen, X. (2016), "Abrasion erosion characteristics of concrete made with moderate heat Portland cement, fly ash and silica fume using sandblasting test", Constr. Build. Mater., 127, 804-814. https://doi.org/10.1016/j.conbuildmat.2016.09.117
  18. Chidiac, S.E. and Panesar, D.K. (2008), "Evolution of mechanical properties of concrete containing ground granulated blast furnace slag and effects on the scaling resistance test at 28days", Cement Concrete Compos., 30, 63-71. https://doi.org/10.1016/j.cemconcomp.2007.09.003
  19. Hesami, S., Modarres, A., Soltaninejad, M. and Madani H. (2016), "Mechanical properties of roller compacted concrete pavement containing coal waste and lime stone powder as partial replacement of cement", Constr. Build. Mater., 111, 625-636. https://doi.org/10.1016/j.conbuildmat.2016.02.116
  20. Kilic, A., Atis, C.D., Teymen, A., Karahan, O., Ozcan, F., Bilim C. and Ozdemir, M. (2008), "The influence of aggregate type on the strength and abrasion resistance of high strength concrete", Cement Concrete Compos., 30, 290-296. https://doi.org/10.1016/j.cemconcomp.2007.05.011
  21. Kolani, B., Lacarriere, L.B., Sellier, A., Escadeillas, G., Boutillon, L. and Linger, L. (2012), "Hydration of slag blended cements", Cement Concrete Compos., 34(9), 1009-1018. https://doi.org/10.1016/j.cemconcomp.2012.05.007
  22. Kumar, G.B.R. and Sharma, U.K. (2014), "Abrasion resistance of concrete containing marginal aggregate", Constr. Build. Mater., 66, 712-722. https://doi.org/10.1016/j.conbuildmat.2014.05.084
  23. Li, G. and Zhao, X. (2003), "Properties of concrete incorporating fly ash and ground granulated blast-furnace slag", Cement Concrete Compos., 25, 293-299. https://doi.org/10.1016/S0958-9465(02)00058-6
  24. Menendez, G., Bonavetti, V. and Irassar, E.F. (2003), "Strength development of ternary blended cement with limestone filler and blast furnace slag", Cement Concrete Compos., 25, 61-67. https://doi.org/10.1016/S0958-9465(01)00056-7
  25. Naik, T.R., Ramme, B.W. and Tews, J.H. (1995), "Pavement construction with high volume class C and class F fly ash concrete", ACI Mater. J., 92(2), 200-211.
  26. Neville, A.M. (2012), Properties of Concrete, 4th Edition, Dorling Kindersley Publishing, India.
  27. Neville, A.M. and Brooks, J.J. (2010), Concrete Technology, 2nd Edition, Pearson Education Limited, England.
  28. Patra, R.K. and Mukharjee, B.B. (2017), "Properties of concrete incorporating granulated blast furnace slag as fine aggregate", Adv. Concrete Constr., 5(5), 437-450. https://doi.org/10.12989/acc.2017.5.5.437
  29. Patra, R.K. and Mukharjee, B.B (2016), "Fresh and hardened properties of concrete incorporating ground granulated blast furnace slag- A review", Adv. Concrete Constr., 4(4), 283-303. https://doi.org/10.12989/acc.2016.4.4.283
  30. Piotr, P. and Piotrowski, T. (2016), "Bound water content measurement in cement pastes by Stoichiometric and gravimetris analysis", J. Build. Chem., 1, 18-25.
  31. Poitevin, P. (1999), "Limestone aggregate concrete, usefulness and durability", Cement Concrete Compos., 21, 89-97. https://doi.org/10.1016/S0958-9465(98)00047-X
  32. Rao, S.K., Sravana, P. and Rao, T.C. (2016), "Abrasion resistance and mechanical properties of roller compacted concrete with GGBS", Constr. Build. Mater., 114, 925-933. https://doi.org/10.1016/j.conbuildmat.2016.04.004
  33. Rao, S.K., Sravana, P. and Rao, T.C. (2016a), "Investigating the effect of M-sand on abrasion resistance of fly ash roller compacted concrete", Constr. Build. Mater., 118, 352-363. https://doi.org/10.1016/j.conbuildmat.2016.05.017
  34. Rao, S.K., Sravana, P. and Rao, T.C. (2016b), "Investigating the effect of M-sand on abrasion resistance of roller compacted concrete containing GGBS", Constr. Build. Mater., 112, 191-201. https://doi.org/10.1016/j.conbuildmat.2016.02.216
  35. Rashad, A.M., Seleem, H.E.D.H and Shaheen, A.F. (2014), "Effect of silica fume and slag on compressive strength and abrasion resistance of HVFA concrete", Int. J. Concrete Struct. Mater., 8(1), 69-81. https://doi.org/10.1007/s40069-013-0051-2
  36. Siddique, R. (2013), "Compressive strength, water absorption, sorptivity, abrasion resistance and permeability of self compacting concrete containing coal bottom ash", Constr. Build. Mater., 47, 1444-1450. https://doi.org/10.1016/j.conbuildmat.2013.06.081
  37. Siddique, R. and Khatib, J.M. (2010), "Abrasion resistance and mechanical properties of high volume fly ash concrete", Mater. Struct., 43, 709-718. https://doi.org/10.1617/s11527-009-9523-x
  38. Singh, M. and Siddique R. (2014), "Strength properties and microstructural properties of concrete containing coal bottom ash as partial replacement of fine aggregate", Constr. Build. Mater., 50, 246-256. https://doi.org/10.1016/j.conbuildmat.2013.09.026
  39. Stephant, S., Chomat, L., Nonat, A. and Charpentier, T. (2015), "Influence of the slag content on the hydration of blended cement", 14th International Congress on the Chemistry of Cement, Beijing, October.
  40. Vahedifard, F., Nili, M. and Meehan, C.L. (2010), "Assessing the effect of supplementary cementitious materials on the performance of low-cement roller compacted concrete pavement", Constr. Build. Mater., 24, 2528-2535. https://doi.org/10.1016/j.conbuildmat.2010.06.003
  41. Wu, C.H., Yen, T., Liu, Y.W. and Hsu T.H. (1994), "The abrasion erosion resistance of concrete containing blast furnace slag", Taiwan Power Co. Report, http://citeseerx.ist.psu.edu/viewdoc/summary.
  42. Yazici, S., Tuyan, M., Mardani-Aghabaglou, A. and Ute, A.A (2015), "Mechanical properties and impact resistance of roller compacted concrete containing polypropylene fibre", Mag. Concr. Res., 67(16), 867-875. https://doi.org/10.1680/macr.14.00242

Cited by

  1. Waste glass powder and its effect on the fresh and mechanical properties of concrete: A state of the art review vol.10, pp.5, 2019, https://doi.org/10.12989/acc.2020.10.5.417
  2. Laboratory evaluation of roller compacted concrete containing RAP vol.10, pp.6, 2019, https://doi.org/10.12989/acc.2020.10.6.489
  3. Effect of cement as mineral filler on the performance development of emulsified asphalt concrete vol.10, pp.6, 2019, https://doi.org/10.12989/acc.2020.10.6.515
  4. Effect of sulfate activators on mechanical property of high replacement low-calcium ultrafine fly ash blended cement paste vol.11, pp.3, 2019, https://doi.org/10.12989/acc.2021.11.3.183