DOI QR코드

DOI QR Code

Analysis and Experiment Verification of Heat Generation Factor of High Power 18650 Lithium-ion Cell

고출력 18650 리튬이온 배터리의 발열인자 해석 및 실험적 검증

  • Kang, Taewoo (Department of Electrical Engineering, Chungnam National University) ;
  • Yoo, Kisoo (Department of Electrical Engineering, Chungnam National University) ;
  • Kim, Jonghoon (Department of Mechanical Engineering, Yeungnam University)
  • Received : 2019.03.12
  • Accepted : 2019.05.14
  • Published : 2019.10.20

Abstract

This study shows the feasibility of the parameter of the 1st RC parallel equivalent circuit as a factor of the heat generation of lithium-ion cell. The internal resistance of a lithium-ion cell consists of ohmic and polarization resistances. The internal resistances at various SOCs of the lithium-ion cell are obtained via an electrical characteristic test. The internal resistance is inversely obtained through the amount of heat generated during the experiment. By comparing the resistances obtained using the two methods, the summation of ohmic and polarization resistances is identified as the heating factor of lithium-ion battery. Finally, the amounts of heat generated from the 2C, 3C, and 4C-rate discharge experiments and the COMSOL multiphysics simulation using the summation of ohmic and polarization resistances as the heating parameter are compared. The comparison shows the feasibility of the electrical parameters of the 1st RC parallel equivalent circuit as the heating factor.

Keywords

Acknowledgement

Supported by : 충남대학교

References

  1. M. Densing, H. Turton, and G. Bauml, "Conditions for the successful deployment of electric vehicles-A global energy system perspective," Journal of Energy, Vol. 47, pp. 137-149, 2012. https://doi.org/10.1016/j.energy.2012.09.011
  2. K. Hedegaard, H. Ravn, N. Juul, and P. Meibom, "Effects of electric vehicles on power systems in northern Europe," Jounal of Energy, Vol. 48, pp. 356-638, 2012. https://doi.org/10.1016/j.energy.2012.06.012
  3. X. Hu, L. Chaudhari, S. H. Lin, S. Stanton, S. Asgari, and W. Y. Lian, "A state space thermal model for HEV/EV battery using vector fitting," in Proc. IEEE ITEC, pp. 1-8, 2012.
  4. L. H. Saw, Y. Ye, and A. A. O. Tay, "Electrochemical-thermal analysis of 18650 lithium iron phosphate cell," Journal of Energy Conversion and Management, Vol. 75, pp. 162-174, 2013. https://doi.org/10.1016/j.enconman.2013.05.040
  5. X. Lin, H. E. Perez, S. Mohan, J. B Siegel, A. G. Stefanopoulou, Y. Ding, and M. P. Castanier "A lumped-parameter electro-thermal model for cylindrical batteries," Journal of Power Sources, Vol. 257, pp. 1-11, 2014. https://doi.org/10.1016/j.jpowsour.2014.01.097
  6. Q. Wang, P. Ping, and X. Zhao, "Thermal runaway caused fire and explosion of lithium ion battery," Journal of Power Sources, Vol. 208, pp. 210-224, 2012. https://doi.org/10.1016/j.jpowsour.2012.02.038
  7. X. S. Hu, S. B. Li, H. Peng, "A comparative study of equivalent circuit models for li-ion batteries," Journal of Power Sources, Vol. 198, pp. 359-367, 2012. https://doi.org/10.1016/j.jpowsour.2011.10.013
  8. D. Bernardi, "A general energy balance for battery systems," Journal of the Electrochemical Society, 1985.
  9. G. Liu, M. Ouyang, L. Lu, and L. Jianqiu, "Analysis of the heat generation of lithium-ion battery during charging and discharging considering influencing factors," Journal of Thermal Analysis and Calorimetry, Vol. 116, pp. 1001-1010, 2014. https://doi.org/10.1007/s10973-013-3599-9
  10. L. P. Gregory, Battery management systems: Battery modeling, Boston: Artech House, 2015.
  11. H. G. Schweiger, "Comparison of several methods for determining the internal resistance of lithium ion cells," Journal of Sensors and Sensor Systems, Vol. 10, pp. 5604-5625, 2010.
  12. K. K. Parsons, "Design and simulation of passive thermal management system for lithium-ion battery packs on an unmanned ground vehicle," M.S. thesis, Dept. Mech, California Univ, California, USA, 2012.
  13. F. P. Incropera, Principles of Heat and Mass Transfer, WILEY, 2014
  14. J. P. Holman, Heat Transfer, 10th ed., McGraw Hill Book Company, New York, 2009
  15. R. R. Richardson, P. T. Ireland, and D. A. Howey, "Battery internal temperature estimation by combined impedance and surface temperature measurement," Journal of Power Sources, Vol. 265, pp. 254-261, 2014. https://doi.org/10.1016/j.jpowsour.2014.04.129
  16. C. Forgez, D. V. Do, G. Friedrich, M. Morcrette, and C. Delacourt, "Thermal modeling of a cylinderical LiFePO4 /graphite lithium-ion battery," Journal of Power Sources, Vol. 195, pp. 2961-2968, 2010. https://doi.org/10.1016/j.jpowsour.2009.10.105