Geomechanics and Engineering

  • 제19권2호
  • /
  • Pages.105-114
  • /
  • 2019
  • /
  • 2005-307X(pISSN)
  • /
  • 2092-6219(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

Distribution and evolution of residual voids in longwall old goaf

  • Wang, Changxiang (College of Mining and Safety Engineering, Shandong University of Science and Technology) ;
  • Jiang, Ning (College of Mining and Safety Engineering, Shandong University of Science and Technology) ;
  • Shen, Baotang (College of Mining and Safety Engineering, Shandong University of Science and Technology) ;
  • Sun, Xizhen (College of Mining and Safety Engineering, Shandong University of Science and Technology) ;
  • Zhang, Buchu (College of Mining and Safety Engineering, Shandong University of Science and Technology) ;
  • Lu, Yao (College of Mining and Safety Engineering, Shandong University of Science and Technology) ;
  • Li, Yangyang (College of Mining and Safety Engineering, Shandong University of Science and Technology)
  • 투고 : 2018.11.01
  • 심사 : 2019.09.25
  • 발행 : 2019.10.10
⟨ 이전 논문 다음 논문 ⟩

초록

In this paper, simulation tests were conducted with similar materials to study the distribution of residual voids in longwall goaf. Short-time step loading was used to simulate the obvious deformation period in the later stage of arch breeding. Long-time constant loading was used to simulate the rheological stage of the arch forming. The results show that the irregular caving zone is the key area of old goaf for the subsidence control. The evolution process of the stress arch and fracture arch in stope can be divided into two stages: arch breeding stage and arch forming stage. In the arch breeding stage, broken rocks are initially caved and accumulated in the goaf, followed by the step deformation. Arch forming stage is the rheological deformation period of broken rocks. In addition, under the certain loads, the broken rock mass undergoes single sliding deformation and composite crushing deformation. The void of broken rock mass decreases gradually in short-time step loading stage. Under the water lubrication, a secondary sliding deformation occurs, leading to the acceleration of the broken rock mass deformation. Based on above research, the concept of equivalent height of residual voids was proposed, and whose calculation equations were developed. Finally, the conceptual model was verified by the field measurement data.

키워드

과제정보

연구 과제 주관 기관 : Shandong Provincial Natural Science Foundation, National Natural Science Foundation of China, Shandong University of Science and Technology

참고문헌

  1. Barbato, J., Hebblewhite, B., Mitra, R. and Mills, K., (2016), "Prediction of horizontal movement and strain at the surface due to longwall coal mining", Int. J. Rock Mech. Min. Sci., 84, 105-118. https://doi.org/10.1016/j.ijrmms.2016.02.006.
  2. Ghabraie, B., Ren, G., Zhang, X. and Smith, J. (2015), "Physical modelling of subsidence from sequential extraction of partially overlapping longwall panels and study of substrata movement characteristics", Int. J. Coal Geol., 140, 71-83. https://doi.org/10.1016/j.coal.2015.01.004.
  3. Guo, G. L., (2001). Deformation Mechanism and Control of Building Foundation over Old Goaf, China University of Mining and Technology Press, Xuzhou, China.
  4. Jaouhar, E.M., Li, L. and Aubertin, M. (2018), "An analytical solution for estimating the stresses in vertical backfilled stopes based on a circular arc distribution", Geomech. Eng., 15(3), 889-898. https://doi.org/10.12989/gae.2018.15.3.889.
  5. Jiang, N., Zhao, J., Sun, X., Bai, L. and Wang, C. (2017), "Use of fly-ash slurry in backfill grouting in coal mines", Heliyon, 3(11), e00470. https://doi.org/10.1016/j.heliyon.2017.e00470.
  6. Kim, S.M. and Choi, Y. (2018), "SIMPL: A simplified modelbased program for the analysis and visualization of groundwater rebound in abandoned mines to prevent contamination of water and soils by acid mine drainage", Int. J. Environ. Res. Public Health, 15(5), 951. https://doi.org/10.3390/ijerph15050951.
  7. Li, M., Zhang, J. and Gao, R. (2016), "Compression characteristics of solid wastes as backfill materials", Adv. Mater. Sci. Eng., http://dx.doi.org/10.1155/2016/2496194.
  8. Li, X.S. and Xu, J.L. (2009), "A model of void distribution in collapsed zone based on fractal theory", Procedia Earth Planet. Sci., 1(1), 203-210. https://doi.org/10.1016/j.proeps.2009.09.034.
  9. Li, Y., Zhang, S. and Zhang, X. (2018), "Classification and fractal characteristics of coal rock fragments under uniaxial cyclic loading conditions", Arab. J. Geosci., 11(9), 201-212. https://doi.org/10.1007/s12517-018-3534-2.
  10. Ma, D., Duan, H., Liu, J., Li, X. and Zhou, Z. (2019), "The role of gangue on the mitigation of mining-induced hazards and environmental pollution: An experimental investigation", Sci. Total Environ., 664, 436-448. https://doi.org/10.1016/j.scitotenv.2019.02.059.
  11. Ma, D., Rezania, M., Yu, H. and Bai, H. (2017), "Variations of hydraulic properties of granular sandstones during water inrush: Effect of small particle migration", Eng. Geol., 217, 61-70. https://doi.org/10.1016/j.enggeo.2016.12.006.
  12. Majdi, A., Hassani F.P. and Nasiri, M.Y. (2012), "Prediction of the height of destressed zone above the mined panel roof in longwall coal mining", Int. J. Coal Geol., 98, 62-72. https://doi.org/10.1016/j.coal.2012.04.005.
  13. Mondal, D., Roy, P.N.S. and Behera, P.K. (2017), "Use of correlation fractal dimension signatures for understanding the overlying strata dynamics in longwall coal mines", Int. J. Rock Mech. Min. Sci., 91, 210-221. https://doi.org/10.1016/j.ijrmms.2016.11.019.
  14. Poulsen, B., Adhikary A.D. and Guo, H. (2018), "Simulating mining-induced strata permeability changes", Eng. Geol., 237, 208-216. https://doi.org/10.1016/j.enggeo.2018.03.001.
  15. Rezaei, M., Hossaini, M.F. and Majdi, A. (2015), "A timeindependent energy model to determine the height of destressed zone above the mined panel in longwall coal mining", Tunn. Undergr. Sp. Technol., 47, 81-92. https://doi.org/10.1016/j.tust.2015.01.001.
  16. Salamon, M.D.G. (1990), "Mechanism of caving in longwall coal mining", Proceedings of the Rock Mechanics Contributions and Challenges: Proceedings of the 31st US Symposium on Rock Mechanics, Golden, Colorado, U.S.A., June.
  17. Salmi, E.F., Nazem, M. and Karakus, M., (2017), "Numerical analysis of a large landslide induced by coal mining subsidence", Eng. Geol., 217, 141-152. https://doi.org/10.1016/j.enggeo.2016.12.021.
  18. Sasaoka, T., Takamoto, H., Shimada, H., Oya, J., Hamanaka, A. and Matsui, K., (2015), "Surface subsidence due to underground mining operation under weak geological condition in Indonesia", J. Rock Mech. Geotech. Eng., 7(3), 337-344. https://doi.org/10.1016/j.jrmge.2015.01.007.
  19. Shen, B. and Barton, N. (2018), "Rock fracturing mechanisms around underground openings", Geomech. Eng., 16(1), 35-47. https://doi.org/10.12989/gae.2018.16.1.035.
  20. Shen, B., Poulsen, B., Luo, X., Qin, J., Thiruvenkatachari, R. and Duan, Y. (2017), "Remediation and monitoring of abandoned mines", Int. J. Min. Sci. Technol., 27(5), 803-811. https://doi.org/10.1016/j.ijmst.2017.07.026.
  21. Song, Z.Q. (1988), Practical Mining Pressure Control, China University of Mining and Technology Press, Xuzhou, China
  22. Sun, X., Yang, P. and Zhang, Z. (2017), "A study of earthquakes induced by water injection in the changning salt mine area, SW China", J. Asian Earth Sci., 136, 102-109. https://doi.org/10.1016/j.jseaes.2017.01.030.
  23. Talbot, A.N. and Richart, F.E. (1923), The Strength of Concrete-its Relation to the Cement, Aggregates and Water, University of Illinois at Urbana Champaign, Illinois, U.S.A.
  24. Wang, C., Lu, Y., Cui, B., Hao, G. and Zhang, X. (2018), "Stability evaluation of old goaf treated with grouting under building load", Geotech. Geol. Eng., 36(4), 2553-2564. https://doi.org/10.1007/s10706-018-0482-2.
  25. Wang, L., Xie, G.X. and Wang, J.A. (2015), "Numerical investigation on the influence of surrounding rock stress shell on fractured field", J. China Coal Soc., 40(9), 2009-2014.
  26. Wang, W. (2017), "A analytical model for cover stress reestablishment in the goaf after longwall caving mining", J. South. Afr. Inst. Min. Metall., 117(7), 670-683. https://doi.org/10.17159/2411-9717/2017/v117n7a9
  27. Xu, P., Mao, X., Zhang, M., Zhou, Y. and Yu, B. (2014), "Safety analysis of building foundations over old goaf under additional stress from building load and seismic actions", Int. J. Min. Sci. Technol., 24(5), 713-718. https://doi.org/10.1016/j.ijmst.2014.03.030.
  28. Xuan, D. and Xu, J. (2017), "Longwall surface subsidence control by technology of isolated overburden grout injection", Int. J. Min. Sci. Technol., 27(5), 813-818. https://doi.org/10.1016/j.ijmst.2017.07.014.
  29. Xuan, D., Xu, J., Wang, B. and Teng, H. (2015), "Borehole investigation of the effectiveness of grout injection technology on coal mine subsidence control", Rock Mech. Rock Eng., 48(6), 2435-2445. https://doi.org/10.1007/s00603-015-0710-5.
  30. Yavuz, H. (2004), "An estimation method for cover pressure reestablishment distance and pressure distribution in the goaf of longwall coal mines", Int. J. Rock Mech. Min. Sci., 41(2), 193-205. https://doi.org/10.1016/S1365-1609(03)00082-0.
  31. Zhang, S., Li, Y., Shen, B., Sun, X. and Gao, L. (2019), "Effective evaluation of pressure relief drilling for reducing rock bursts and its application in underground coal mines", Int. J. Rock Mech. Min. Sci., 114, 7-16. https://doi.org/10.1016/j.ijrmms.2018.12.010.