Structural Engineering and Mechanics

Techno-Press (테크노프레스)
권호 표지
DOI QR코드

DOI QR Code

Spectral element method in the analysis of vibrations of overhead transmission line in damping environment

  • Dutkiewicz, Maciej (Faculty of Civil, Environmental Engineering and Architecture, University of Science and Technology) ;
  • Machado, Marcela (Department of Mechanical Engineering, University of Brasilia)
  • Received : 2019.01.18
  • Accepted : 2019.04.03
  • Published : 2019.08.10
⟨ Previous Next ⟩

Abstract

In the paper the analysis of natural vibrations of the transmission line with use of spectral elements and the laboratory experiments is performed. The purpose of the investigation is to analyze the natural vibrations of the transmission line and compare with the results obtained in the numerical simulations. Particular attention is paid to the hysteretic and aerodynamic damping analysis. Sensitivity of the wave number is performed for changing of the tension force, as well as for the different damping parameters. The numerical model is made using the Spectral Element Method. In the spectral model, for various parameters of stiffness, damping and tension force, the system response is checked and compared with the results of the accelerations obtained in the measurements. A frequency response functions (FRF) are calculated. The credibility of the model is assessed through a validation process carried out by comparing graphical plots of FRF and time history analysis and numerical values expressing differences in acceleration amplitude (MSG), phase angle differences (PSG) and differences in acceleration and phase angle total (CSG) values. The next aspect constituting the purpose of this paper is to present the wide possibilities of modelling and simulation of slender conductors using the Spectral Element Method. The obtained results show good accuracy in the range of both experimental measurements as well as simulation analysis. The paper emphasizes the ease with which the sensitivity of the conductor and its response to changes in density of spectral mesh division, tensile strength or material damping can be studied.

Keywords

References

  1. Aeschliman, D.P., Oberkampf, W.L. and Blottner, F.G. (1995), "A proposed methodology for CFD code verification, calibration, and validation", 95-CH3482-7; 16th International Congress on Instrumentation for Aerospace Simulation Facilities, Dayton, OH, USA.
  2. Aeschliman, D.P. and Oberkampf, W.L. (1998), "Experimental methodology for computational fluid dynamics code validation", AIAA J., 36(5), 733-741. https://doi.org/10.2514/2.461.
  3. American Institute of Aeronautics and Astronautics (AIAA) (1998), "Guide for the verification and validation of computational fluid dynamics simulations", AIAA-G-077-1998; American Institute of Aeronautics and Astronautics, Reston, VA, USA.
  4. American Society of Mechanical Engineers (ASME) (2006), "Guide for the verification and validation in computational solid mechanics", ASME VV 10-2006, ASME; New York, NY, USA.
  5. Barber, T.J. (1998), "Role of code validation and certification in the design environment", AIAA J., 36(5), 752-758. https://doi.org/10.2514/2.433.
  6. Benek, J.A., Kraft, E.M. and Lauer, R.F. (1998), "Validation issues for engine - Airframe integration", AIAA J., 36(5), 759-764. https://doi.org/10.2514/2.434.
  7. Bertin, J.J., Martellucci, A., Neumann, R.D. and Stetson, K.F. (1993), "Developing a data Bbase 94 for the calibration and validation of hypersonic CFD codes - Sharp cones", the 24th AIAA Fluid Dynamics Conference, Orlando, FL, USA, July. https://doi.org/10.2514/6.1993-3044.
  8. Boseop, J., Taehyun, K. and Usik, L. (2018), "Vibration analysis of a multi-span beam subjected to a moving point force using spectral element method", Struct. Eng. Mech., 65(3), 263-274. https://doi.org/10.12989/sem.2018.65.3.263.
  9. Bradley, R.G. (1988), "CFD validation philosophy, AGARD-CP-437", Fluid Dynamics Panel Symposium: Validation of Computational Fluid Dynamics, Lisbon, Portugal, May.
  10. Clough, R. and Penzien, J. (1993), Dynamics of Structures, McGraw Hill, New York, USA.
  11. Coleman, H.W. and Stern, F. (1997), "Uncertainties and CFD code validation", J. Fluids Eng., 119, 795-803. https://doi.org/10.1115/1.2819500.
  12. Den Hartog, J.P. (1932), "Transmission line vibration due to sleet", Transactions of the American Institute of Electrical Engineers, 51(4), 1074-1086. https://doi.org/10.1109/TAIEE.1932.5056223.
  13. Doyle, J.F. (1997), Wave Propagation in Structures: Spectral Analysis Using Fast Discrete Fourier Transforms, 2nd Edition, Springer-Verlag, New York, USA.
  14. Dutkiewicz, M. (2017a), "Experimental measurements of dynamical wind load acting on the overhead transmission line", Anul XXIV, 1, 88-100.
  15. Dutkiewicz, M. (2017b), "Interaction of bridge cables and wake behind in the vortex induced vibrations", 14th International Conference Dynamical Systems - Theory and Applications, Lodz, Poland, December.
  16. Dutkiewicz, M., Machado, M.R. (2019a), "Spectral approach in vibrations of overhead transmission lines", IOP Conference Series: Materials Science and Engineering 471. https://doi.org/10.1088/1757-899X/471/5/052029.
  17. Dutkiewicz, M. and Machado, M.R. (2019b), "Dynamical response of overhead transmission line in turbulent wind flow with application of the spectral element method", IOP Conference Series: Materials Science and Engineering 471. https://doi.org/10.1088/1757-899X/471/5/052031.
  18. Fabro, A.T., Ritto, T.G., Sampaio, R. and Arruda, J.R.F. (2010), "Stochastic analysis of acracked rod modeled via the spectral element method", Mech. Res. Communications, 37, 326-331. https://doi.org/10.1016/j.mechrescom.2010.03.005
  19. Flynn, E.B., Todd, M., Croxford, J., Drinkwater, B. and Wilcox, P. (2011), "Enhanced detection through low order stochastic modeling for guided-wave structural health monitoring", Struct. Health Monitoring, 1, 1-12. https://doi.org/10.1177/1475921711414232.
  20. Geers, T.L. (1984), "An objective error measure for the comparison of calculated and measured transient response histories", Shock Vib. Bull., 54, 99-107.
  21. Golebiowska, I., Dutkiewicz, M. and Usewicz, B. (2015), "Methods of damping of overhead transmission lines", TTS, 12(5), 2544-2548.
  22. Golebiowska, I. and Dutkiewicz, M. (2016), "The effectiveness of vibration damper attached to the cable due to wind action", Intern. Conf. Exper. Fluid Mech., 209-213, Czech Republic, October.
  23. Golebiowska, I. and Dutkiewicz, M. (2017a), "Vortex induced vibration and wind flow around bridge cables", Proceedings of 14th International Conference on Acoustics and Vibration of Mechanical Structures, Timisoara, Romania, May.
  24. Golebiowska I. and Dutkiewicz M. (2017b), "Analysis of wind flow around the bridge cable", Proceedings of 2th International Symposium on World Multidisciplinary Civil Engineering, Architecture and Urban Planning, Prague, Czech Republic, June.
  25. Golebiowska I. and Dutkiewicz M. (2018), "Galloping of overhead power lines conductors", Proceedings of 24th International Conference on Engineering Mechanics, 257-260, Svratka, Czech Republic, May.
  26. Gopalakrishnan, S., Chakraborty, A. and Mahapatra, D.R. (2007), Spectral Finite Element Method, Springer Verlag, New York, USA.
  27. Machado, M.R. and Santos, J. (2015), "Reliability analysis of damaged beam spectral element with parameter uncertainties", Shock Vib., 2015. http://dx.doi.org/10.1155/2015/574846.
  28. Machado, M., Adhikari, S. and Santos, J. (2017), "A spectral approach for damage quantifcation in stochastic dynamic systems", Mech. Syst. Signal Proc., 88, 253-278. https://doi.org/10.1016/j.ymssp.2016.11.018
  29. Lee, M., Park, I. and Lee, U. (2017), "An approximate spectral element model for the dynamic analysis of an FGM bar in axial vibration", Struct. Eng. Mech., 61(4), 551-561. https://doi.org/10.12989/sem.2017.61.4.551
  30. Lee, U. (2004), Spectral Element Method in Structural Dynamics, Inha University Press, Inha Univerity Incheon, Korea.
  31. Lee, U. (2009), Spectral Element Method in Structural Dynamics, Wiley and Sons, Singapore.
  32. Luongo, A., Zulli, D. and Piccardo, G. (2009), "On the effect of twist angle on nonlinear galloping of suspended cables", Comput. Struct., 87(15-16), 1003-1014. https://doi.org/10.1016/j.compstruc.2008.04.014
  33. Matt, C.F. and Castello, D.A. (2007), "On the numerical identification of the bending stiffness and the damping of transmission line conductors", Proceedings of the XII International Symposium on Dynamic Problems of Mechanics, Ilha Bela, Sao Paulo, Brazil, March.
  34. Mehta, U.B. (1996), "Guide to credible computer simulations of fluid flows", J. Propulsion Power, 12(5), 940-948. https://doi.org/10.2514/3.24126.
  35. Meynen, H., Verma, P., Hagedorn, P. and Schafer, M. (2005), "On the numerical simulation of vortex-induced vibrations of oscillating conductors", J. Fluids Struct., 21(1), https://doi.org/10.1016/j.jfluidstructs.2005.05.019.
  36. Oberkampf, W.L and Trucano, T.G. (2002), "Verification and validation incomputational fluid dynamics", Prog. Aerosp. Sci., 8, 209-272. https://doi.org/10.1016/S0376-0421(02)00005-2
  37. Rao, S.S. (2008), Mechanical Vibration, Pearson Prentice Hall, New Jersey, USA.
  38. Russell, D.M. (1997), "Error measures for comparing transient data: part I: development of a comprehensive error measure", Proceedings of the 68th Shock and Vibration Symposium, 175-184. Hunt Valley, Maryland, November.
  39. Schwer, L.E. (2007), "Validation metrics for response histories: Perspectives and case studies", Eng. Comput., 23, 295-309. https://doi.org/10.1007/s00366-007-0070-1
  40. Sprague, M.A. and Geers, T.L. (2003), "Spectral elements and field separation for an acoustic fluid subject to cavitation", J. Comput. Phys. 184, 149-162. https://doi.org/10.1007/s00366-007-0070-1.
  41. Vecchiarelli, J., Curie, I.G. and Havard, D.G. (2000), "Computational analysis of aeolian conductor vibration with a stockbridge-type damper", J. Fluids Struct., 14, 489-509. https://doi.org/10.1006/jfls.1999.0279.
  42. Wang, H.Q., Miao, J.C., Luo, J.H., Huang, F. and Wang, L.G. (1997), "The free vibration of long-span transmission line conductors with dampers", J. Sound Vibr., 208(4), 501. https://doi.org/10.1006/jsvi.1997.1196
  43. William, L., Oberkampf, W.L. and Barone, M.F. (2006), "Measures of agreement between computation and experiment: Validation metrics", J. Comput. Phys., 217, 5-36. https://doi.org/10.1016/j.jcp.2006.03.037.
  44. William, L. Oberkampf, W.L. and Smith, B. (2014), "Assessment criteria for computational fluid dynamics validation benchmark experiments", 52nd Aerospace Sciences Meeting, AIAA SciTech Forum, (AIAA 2014-0205), https://doi.org/10.2514/6.2014-0005.
  45. Yu, B.Y.J. and Soliman, M. (2014), "Estimation of cable tension force independent of complex boundary conditions", ASCE J. Eng. Mech., 60, 1-8. https://doi.org/10.1061/(ASCE)EM.1943-7889.0000836.
  46. Zienkiewicz, O.C. and Taylor R.L. (1991), The Finite Element Method, 4th Edition, McGraw-Hill, London, United Kingdom.

Cited by

  1. Vortex induced vibration and its controlling of long span Cross-Rope Suspension transmission line with tension insulator vol.78, pp.1, 2019, https://doi.org/10.12989/sem.2021.78.1.087
  2. Wind-Induced Response and Its Controlling of Long-Span Cross-Rope Suspension Transmission Line vol.12, pp.3, 2019, https://doi.org/10.3390/app12031488