DOI QR코드

DOI QR Code

압력실의 크기와 운전 조건에 따른 수격펌프의 성능에 대한 실험적 고찰

Experimental Study on the Effect of Air Chamber Size and Operation Parameters on the Performance of a Hydraulic Ram Pump

  • 투고 : 2019.04.02
  • 심사 : 2019.06.24
  • 발행 : 2019.07.31

초록

Motor pumps cannot be used in those areas where electricity is not accessible such as remote rural areas in many African countries. Hydraulic ram pump is one of the solutions for supplying water for irrigation or domestic uses. The hydraulic ram pumps are working based on the water hammer effect for pumping without external power or electricity. This study was conducted to investigate the effect of air chamber volume and operation parameters on the performance of the hydraulic ram pump which was assembled with common plumbing parts. The experimental results showed the volume of the air chamber did not affect the performance such as discharge rate and head. When drive heights were 1.7 and 2.35 m, the maximum discharge heads were up to 7 m and 10 m, respectively. When the air chamber volume was 1 L, discharge rates were 0.23 and 2.12 L/min under the drive heights of 1.7 and 2.35 m, respectively. The average energy efficiency of the hydraulic ram pump assembled in this study was about 60% for all the experimental conditions.

키워드

NGHHCI_2019_v61n4_55_f0001.png 이미지

Fig. 1 Schematic of hydraulic ram pump operation

NGHHCI_2019_v61n4_55_f0002.png 이미지

Fig. 2 Components of hydraulic ram pump

NGHHCI_2019_v61n4_55_f0003.png 이미지

Fig. 3 Hydraulic ram pump assembled for the experiments

NGHHCI_2019_v61n4_55_f0004.png 이미지

Fig. 4 Fabricated air chambers with different volumes

NGHHCI_2019_v61n4_55_f0005.png 이미지

Fig. 5 The ratio of water delivered over the total water discharged from the tank

NGHHCI_2019_v61n4_55_f0006.png 이미지

Fig. 6 Power efficiencies for different chamber volumes and delivery height at drive height at 2.35 m

NGHHCI_2019_v61n4_55_f0007.png 이미지

Fig. 7 Efficiency and flow rates at drive height at 1.7 m and delivery height at 3 m

Table 1 Experimental conditions

NGHHCI_2019_v61n4_55_t0001.png 이미지

Table 2 Maximum pressure observed under different drive heights

NGHHCI_2019_v61n4_55_t0002.png 이미지

Table 3 Comparison of the ratio of waste over total drive flow for different volumes of air chamber (Drive height at 2.35 m)

NGHHCI_2019_v61n4_55_t0003.png 이미지

Table 4 Flow rates of delivered and waste discharge for different chamber volume sizes and delivery heights

NGHHCI_2019_v61n4_55_t0004.png 이미지

Table 5 Power efficiencies for different volumes of air chamber at drive height of 2.35 m

NGHHCI_2019_v61n4_55_t0005.png 이미지

참고문헌

  1. Browne, D., 2005. Design, Sizing, Construction and Maintenance of Gravity-Fed system in Rural Areas, Module 6 : Hydraulic Ram Pump Systems. Action Conre la Faim. Hermann, Paris.
  2. Maratos, D. F., 2003. Technical feasibility of wavepower for seawater desalination using the hydro-ram (Hydram). Desalination. 153(1-3): 287-293. doi:10.1016/S0011-9164(02)01148-7.
  3. Carvalho, M. O. M., A. C. G. C. Diniz, and F. J. R. Neves, 2011. Numerical model for a hydraulic ram pump. International Review of Mechanical Engineering 5(4): 733-746.
  4. Ngolle, E. E. G., and S. Hong, 2019. The effect of air chamber size on the efficiency of a hydraulic ram pump. Master's thesis, Hankyong National University.
  5. Sampath, S. S., S. Shetty, A. M. Pendanathu, W. Javaid, and C. P. Selvan, 2015. Estimation of power and efficiency of hydraulic ram pump with re-circulation system. International Journal of Computer-aided Mechanical Design and Implementation 1(1): 9-24.
  6. Seemin, S. C., C. Handa, and A. P. Ninawe, 2013. Design methodology for hydraulic ram pumps (hydram). International Journal of Mechanical Engineering and Robotic Research 2(4): 170-175.
  7. Tacke, J. H. P. M., 1988. Hydraulic Rams. A comparative investigation. Communications on Hydraulics and geotechnical Engineering. Faculty of Civil engineering. Delft University of Technology.
  8. USDA, 2007. Natural Resources and Conservation Services. Range Technical Note No. 26; Hydraulic Ram Pumps.
  9. Yang, K., J. Li, Y. Guo, H. Fu, X. Guo, T. Wang, 2014. Design and hydraulic performance of a novel hydram. International Conference on Hydro informatics. New York City, USA.
  10. Young, B. W., 1998. Generic design of ram pumps : Part A. International Journal of Mechanical Energy 212: 117-124. doi:10.1243/0957650981536646.