Membrane and Water Treatment

  • 제10권4호
  • /
  • Pages.307-311
  • /
  • 2019
  • /
  • 2005-8624(pISSN)
  • /
  • 2092-7037(eISSN)
테크노프레스 (Techno-Press)
권호 표지
DOI QR코드

DOI QR Code

The design of an ejector type microbubble generator for aeration tanks

  • Lim, Ji-Young (Dept. of Civil & Environmental Engineering, Incheon National University) ;
  • Kim, Hyun-Sik (Dept. of Civil & Environmental Engineering, Incheon National University) ;
  • Park, Soo-Young (Dept. of Civil & Environmental Engineering, Incheon National University) ;
  • Kim, Jin-Han (Dept. of Civil & Environmental Engineering, Incheon National University)
  • 투고 : 2019.01.17
  • 심사 : 2019.04.15
  • 발행 : 2019.07.25
⟨ 이전 논문 다음 논문 ⟩

초록

The ejector type microbubble generator, which is the method to supply air to water by using cavitation in the nozzle, does not require any air supplier so it is an effective and economical. Also, the distribution of the size of bubbles is diverse. Especially, the size of bubbles is smaller than the bubbles from a conventional air diffuser and bigger than the bubbles from a pressurized dissolution type microbubble generator so it could be applied to the aeration tank for wastewater treatment. However, the performance of the ejector type microbubble generator was affected by hydraulic pressure and MLSS(Mixed Liquor Suspended Solid) concentration so many factors should be considered to apply the generator to aeration tank. Therefore, this study was performed to verify effects of hydraulic pressure and MLSS concentration on oxygen transfer of the ejector type microbubble generator. In the tests, the quantity of sucked air in the nozzle, dissolved oxygen(DO) concentration, oxygen uptake rate(OUR), oxygen transfer coefficient were measured and calculated by using experimental results. In case of the MLSS, the experiments were performed in the condition of MLSS concentration of 0, 2,000, 4,000, 8,000 mg/L. The hydraulic pressure was considered up to $2.0mH_2O$. In the results of experiments, oxygen transfer coefficient was decreased with the increase of MLSS concentration and hydraulic pressure due to the increased viscosity and density of wastewater and decreased air flow rate. Also, by using statistical analysis, when the ejector type microbubble generator was used to supply air to wasterwater, the model equation of DO concentration was suggested to predict DO concentration in wastewater.

키워드

과제정보

연구 과제 주관 기관 : Korea Ministry of SMEs and Startups

참고문헌

  1. Baki, O.T. and Aras, E. (2018), "Estimation of BOD in wastewater treatment plant by using different ANN algorithms", Membr. Water Treat., 9(6), 455-462. https://doi.org/10.12989/mwt.2018.9.6.455.
  2. Barwal, A. and Chaudhary, R. (2015), "Impact of carrier filling ratio on oxygen uptake & transfer rate, volumetric oxygen transfer coefficient and energy saving potential in a lab-scale MBBR", J. Water. Process Eng., 8, 202-208. https://doi.org/10.1016/j.jwpe.2015.10.008.
  3. Chern, J.M. and Yu, C.F. (1995), "Volatile organic compound emission rate from diffused aeration systems 1. mass transfer modeling", Indsutrial Eng. Chem. Res., 34(8), 2634-2643. https://doi.org/10.1021/ie00047a012.
  4. Han, Y.R., Choi, Y.I., Yoon, T.K., Lee, G.C. and Jung, B.K. (2011), "Comparative study of oxygen transfer efficiency between micro-nano bubble- and conventional bubble-diffuser systems", J. Korea Soc. Water Sci. Tech., 19(5), 11-22.
  5. Jamshidi, N. and Mostoufi, N. (2017), "Measurement of bubble size distribution in activated sludge bubble column bioreactor", Biochem. Eng. J., 125, 212-220. https://doi.org/10.1016/j.bej.2017.06.010.
  6. Kim, J.T., Tak, H.K. and Kim, J.K. (2012), "Development of energy saving aeration panel for aerating in activated sludge system", J. Korean Soc. Environ. Eng., 34(6), 414-420. https://doi.org/10.4491/KSEE.2012.34.6.414
  7. Kim, M.H., Ji, S.H. and Jang, J.H. (2014), "A study on energy saving effect from automatic control of air flowrate and estimation of optimal DO concentration in oxic reactor of wastewater treatment plant", J. Energy Eng., 23(2), 49-56. https://doi.org/10.5855/ENERGY.2014.23.2.049
  8. Lee, S.J., Ko, K.H., Ko, M.H., Yang, J.K. and Kim, Y.G. (2012), "Oxygen transfer and hydraulic characteristics in bubble column bioreactor applied fine bubble air diffusing system", J. Korean Soc. Environ. Eng., 34(11), 772-779. https://doi.org/10.4491/KSEE.2012.34.11.772
  9. Lim, J.Y., Kim, H.S., Park, D.S., Cho, Y.G., Song, S.J., Park, S.Y. and Kim, J.H. (2016), "Characteristic of mixing and DO concentration distribution in aeration tank by microbubble supply", J. Korea Academia-Industrial Cooperation Soc., 17(5), 251-259.
  10. Lim, J.Y., Kim, H.S., Park, S.Y. and Kim, J.H. (2015), "Evaluation of characteristics for microbubble generation according to venturi nozzle specification", J. Korea Academia-Industrial Cooperation Soc., 16(9), 6397-6402. https://doi.org/10.5762/KAIS.2015.16.9.6397
  11. Matter-Muller, C., Gujer, W. and Giger, W. (1981), "Transfer of volatile substances from water to the atmosphere", Water Res., 15(11), 1271-1279. https://doi.org/10.1016/0043-1354(81)90104-4.
  12. Maeda, Y., Hosokawa, S., Baba, Y., Tomiyama, A. and Ito, Y. (2015), "Generation mechanism of micro-bubbles in a pressurized dissolution method", Exp. Thermal Fluid Sci., 60, 201-207. https://doi.org/10.1016/j.expthermflusci.2014.09.010.
  13. Stenstrom, M.K. and Gilbert, R.G. (1981), "Effects of alpha, beta and theta factor upon the design, specification and operation of aeration systems", Water Res., 15(6), 643-654. https://doi.org/10.1016/0043-1354(81)90156-1.
  14. Sadatomi, M., Kawahara, A., Kano, K. and Ohtomo, A. (2005), "Performance of a new micro-bubble generator with a spherical body in a flowing water tube", Exp. Therm. Fluid Sci., 29(5), 615-623. https://doi.org/10.1016/j.expthermflusci.2004.08.006.
  15. Sadatomi, M., Kawahara, A., Matsuura, H. and Shikatani, S. (2012), "Micro-bubble generation rate and bubble dissolution rate into water by a simple multi-fluid mixer with orifice and porous tube", Exp. Therm. Fluid Sci., 41, 23-30. https://doi.org/10.1016/j.expthermflusci.2012.03.002.
  16. Terasaka, K., Hirabayashi, A., Nishino, T., Fujioka, S. and Kobayashi, D. (2011), "Development of microbubble aerator for waste water treatment using aerobic activated sludge", Chem. Eng. Sci., 66(15), 3172-3179. https://doi.org/10.1016/j.ces.2011.02.043.