A prediction of mold temperature distribution and lifetime with different spray process of mold release agent in high pressure diecasting mold using computer simulation

컴퓨터 시뮬레이션을 이용한 고압다이캐스팅 금형의 이형제 분사공정에 따른 금형온도분포 및 금형수명 예측

  • Received : 2019.06.11
  • Accepted : 2019.06.30
  • Published : 2019.06.30

Abstract

The temperature distribution and lifetime of molds were predicted by computer simulation analysis with various spraying and blowing process of high pressure die casting. After varying the spraying angle and time, the mold temperature, heat exchange and mold life were predicted. As the spraying angle increases, the maximum temperature of the mold decreases, which is because the spraying area increases and the heat exchange with the mold increases. Heat exchange occurs more actively in the blowing process than in the spraying process. This is because the cooling is not performed due to the steam generation. When the spraying angle is 50 degree, the minimum life of the mold is analyzed 200 times. After adjusting the blowing time from 5s to 3s, the minimum lifetime of the mold has been increased almost twice.

Keywords

References

  1. Bill Andersen, "Die casting engineering_A hydraulic, thermal and mechanical process", Marcel Dekker, 2005.
  2. E. Lugscheider, K. Bobzin, T. Hornig, M. Maes, "Increasing the lifetime of aluminium and magnesium pressure die casting moulds by arc ion plating pvd coatings", 6th International tooling conference, pp. 979-990, 2010.
  3. NADCA White paper "Technologies & Strategies for Longer Lasting Die Casting Dies",
  4. B. PAWLOWSKI, P. BALA, T. TOKARSKI, J. KRAWCZYK, "Premature cracking of dies for aluminium alloy die-casting", Archives of metallurgy and materials, Vol. 85, pp. 1275-1279, 2013.
  5. Abelardo Garza-Delgoado, "A study of casting distortion and residula stress in die casting", Thesis, The ohio state univ., 2007.
  6. Jame L. Graff, Loathar H. Kallien, "The effect of die lubricant spray on the thermal balance of dies", Chem-Trend Inc.
  7. A.J. Norwood, P.M. Dickens, R.C. Soar, R.A.Harris, "Surface temperature of tools during the high-pressure die casting of aluminium", Proc. IMechE Vol. 221 Part B: J. Engineering Manufacture, 2007.