DOI QR코드

DOI QR Code

Effect of temperature on the behavior of self-compacting concretes and their durability

  • Salhi, M. (Department of Civil Engineering, University of Relizane) ;
  • Li, A. (Laboratory of Civil Engineering, University of Reims Champagne Ardennes) ;
  • Ghrici, M. (Geomaterials Laboratory, Hassiba Benbouali University of Chlef) ;
  • Bliard, C. (CNRS UMR 7312 ICMR Universite de Reims)
  • Received : 2019.01.16
  • Accepted : 2019.04.23
  • Published : 2019.06.25

Abstract

The formulation of self-compacting concretes (SCC) and the study of their properties at the laboratory level were currently well mastered. The aim of this work is to characterize SCC under hot climatic conditions and their effects on the properties of fresh and hardened SCC. Particularly, the effect of the initial wet curing time on the mechanical behavior such as the compressive strength and the durability of the SCCs (acid and sulfate attack) as well as the microstructure of SCCs mixtures. In this study, we used two types of cement, Portland cement and slag cement, three water/binder (W/B) ratio (0.32, 0.38 and 0.44) and five curing modes. The obtained results shows that the compressive strength is strongly influenced by the curing methods, 7-days of curing in the water and then followed by a maturing in a hot climate was the optimal duration for the development of a better compressive strength, regardless of the type of binder and the W/B ratio.

Keywords

References

  1. Al-Abduljabbar, A.H (2008), "Effect of time and temperature on workability of SCC", http://faculty.ksu.edu.sa/28745/DocLib/Hisham.SCC.pdf.
  2. Al-Martini, S. and Nehdi, M. (2010), "Effects of heat and mixing time on self-compacting concrete", Proc. Inst. Civil Eng. Constr. Mater., 163(3), 175-182. https://doi.org/10.1680/coma.800047.
  3. Andersen, M.D., Jakobsen, H.J. and Skibsted, J. (2004), "Characterization of white Portland cement hydration and the CASAH structure in the presence of sodium aluminate by 27Al and 29Si MAS NMR spectroscopy", Cement Concrete Res., 34, 857-868. https://doi.org/10.1016/j.cemconres.2003.10.009.
  4. ASTM C 1012-95a (2000), Standard Test Method for Length Change of Hydraulic-Cement Mortars Exposed to a Sulfate Solution, Annual Book of ASTM Standards, Volume 04.01 Cement, lime, Gypsum.
  5. Aye, T., Oguchi, C.T. and Takaya, Y. (2010), "Evaluation of sulfate resistance of Portland and high alumina cement mortars using hardness test", Constr. Build. Mater., 24(6), 1020-1026. https://doi.org/10.1016/j.conbuildmat.2009.11.016.
  6. Belaidi, A.S.E., Azzouz, L., Kadri, E. and Kenai, S. (2012), "Effect of natural pozzolana and marble powder on the properties of self-compacting concrete", Constr. Build. Mater., 31, 251-257. https://doi.org/10.1016/j.conbuildmat.2011.12.109.
  7. Boukendakdji, O., Kenai, S., Kadri, E.H. and Rouis, F. (2009), "Effect of slag on the rheology of fresh self-compacted concrete", Constr. Build. Mater., 23(7), 2593-2598. https://doi.org/10.1016/j.conbuildmat.2009.02.029.
  8. Brown, P.W. and Badger, S. (2000), "The distributions of bound sulfates and chlorides in concrete subjected to mixed NaCl, MgSO4, Na2SO4 attack", Cement Concrete Res., 30(10), 1535-1542. https://doi.org/10.1016/S0008-8846(00)00386-0.
  9. Chithra, S., Kumar, S.R.R.S. and Chinnaraju, K. (2016), "The effect of Colloidal Nano-silica on workability, mechanical and durability properties of High Performance Concrete with Copper slag as partial fine aggregate", Constr. Build. Mater., 113, 794-804. https://doi.org/10.1016/j.conbuildmat.2016.03.119.
  10. EFNARC (2005), The European Guidelines for Self-Compacting Concrete: Specification, Production and Use, The Self-Compacting Concrete European Project Group.
  11. El-Chabib, H. and Ibrahim, A. (2013), "The performance of highstrength flowable concrete made with binary, ternary, or quaternary binder in hot climate", Constr. Build. Mater., 47, 245-253. https://doi.org/10.1016/j.conbuildmat.2013.05.062.
  12. Elkhadiri, I. and Puertas, F. (2008), "The effect of curing temperature on sulphate-resistant cement hydration and strength", Constr. Build. Mater., 22(7), 1331-1341. https://doi.org/10.1016/j.conbuildmat.2007.04.014.
  13. Escalante-Garcia, J.I. and Sharp, J.H. (2004), "Variation in the composition of C-S-H gel in portland cement pastes cured at various temperatures", J. Am. Ceram. Soc., 82(11), 3227-3241. https://doi.org/10.1111/j.1151-2916.1999.tb02230.x.
  14. Escalante, J.I., Gomez, L.Y., Johal, K.K., Mendoza, G., Mancha, H. and Mendez, J. (2001), "Reactivity of blast-furnace slag in Portland cement blends hydrated under different conditions", Cement Concrete Res., 31(10), 1403-1409. https://doi.org/10.1016/S0008-8846(01)00587-7.
  15. Friedemann, K., Stallmach, F. and Karger, J. (2006), "NMR diffusion and relaxation studies during cement hydration a nondestructive approach for clarification of the mechanism of internal post curing of cementitious materials", Cement Concrete Res., 36(5), 817-826. https://doi.org/10.1016/j.cemconres.2005.12.007.
  16. Khan, R.A., Satyanaryana, A. and Sharma, R. (2015b), "Development of high performance concrete", UKIERI Concrete Congress-Concrete Research Driving Profit & Sustainability-International Conference, 1090-1102.
  17. Kjellsen, K.O., Detwiler, R.J. and Gjorv, O.E. (1991), "Development of microstructures in plain cement pastes hydrated at different temperatures", Cement Concrete Res., 21(1), 179-189. https://doi.org/10.1016/0008-8846(91)90044-I.
  18. Kokubu, K., Takahashi, S. and Anzai, H. (1989), "Effect of curing temperature on the hydration and adiabatic temperature characteristic of Portland cement-blast furnace slag concrete", American Concrete Institute Concrete Journal, SP 114-66.
  19. Liu, T., Qin, S., Zou, D. and Song, W. (2018), "Experimental investigation on the durability performances of concrete using cathode ray tube glass as fine aggregate under chloride ion penetration or sulfate attack", Constr. Build. Mater., 163, 634-642. https://doi.org/10.1016/j.conbuildmat.2017.12.135.
  20. Makhloufi, Z., Kadri, E.H., Bouhicha, M. and Benaissa, A. (2012), "Resistance of limestone mortars with quaternary binders to sulfuric acid solution", Constr. Build. Mater., 26(1), 497-504. https://doi.org/10.1016/j.conbuildmat.2011.06.050.
  21. Maruyawa, I., Suzuki, M. and Sato, R. (2005), "Prediction of temperature in ultra-High Strength concrete based on the temperature dependent hydration model", American Concrete Institute Concrete Journal, SP 228-75.
  22. Okamura, H. and Ouchi, M. (2003), "Self-compacting concrete", J. Adv. Concrete Technol., 1(1), 5-15. https://doi.org/10.3151/jact.1.5.
  23. Older, I., Abdul-Maula, S. and Zhongya, L. (1986), "Effect of hydration temperature on cement paste structure", MRS Proc., 85, 139-144. https://doi.org/10.1557/PROC-85-139.
  24. Ortiz, J.A., Aguado, A., Agullo, L., Garcia, T. and Zermeno de Leon, M.E. (2008), "Experimental study of the effect of temperature on the strength of ready-mixed concrete. Theory", Mater. Constr., 58(291), 7-22. https://doi.org/10.3989/mc.2008.v58.i291.103.
  25. Oueslati, O. and Duchesne, J. (2012), "The effect of SCMs and curing time on resistance of mortars subjected to organic acids", Cement Concrete Res., 42(1), 205-214. https://doi.org/10.1016/j.cemconres.2011.09.017.
  26. Reinhardt, H.W. and Stegmaier, M. (2006), "Influence of heat curing on the pore structure and compressive strength of self-compacting concrete (SCC)", Cement Concrete Res., 36(5), 879-885. https://doi.org/10.1016/j.cemconres.2005.12.004.
  27. Rizwan, S.A. and Bier, T.A. (2012), "Blends of limestone powder and fly-ash enhance the response of self-compacting mortars", Constr. Build. Mater., 27(1), 398-403. https://doi.org/10.1016/j.conbuildmat.2011.07.030.
  28. Sahmaran, M., Christianto, H.A. and Yaman, I.O . (2006), "The effect of chemical admixtures and mineral additives on the properties of self-compacting mortars", Cement Concrete Compos., 28(5), 432-440. https://doi.org/10.1016/j.cemconcomp.2005.12.003.
  29. Santhanam, M., Cohen, M.D. and Olek, J. (2003), "Effects of gypsum formation on the performance of cement mortars during external sulfate attack", Cement Concrete Res., 33(3), 325-332. https://doi.org/10.1016/S0008-8846(02)00955-9.
  30. Senhadji, Y., Escadeillas, G., Mouli, M. and Khelafi, H. (2014), "Influence of natural pozzolan, silica fume and limestone fine on strength, acid resistance and microstructure of mortar", Pow. Tech., 254, 314-323. https://doi.org/10.1016/j.powtec.2014.01.046.
  31. Sumer, U.M. (2011), "Performance of self-compacting concrete containing different mineral admixtures", Constr. Build. Mater., 25(11), 4112-4120. https://doi.org/10.1016/j.conbuildmat.2011.04.032.
  32. Tennich, M., Ben Ouezdou, M. and Kallel, A. (2017), "Behavior of self-compacting concrete made with marble and tile wastes exposed to external sulfate attack", Constr. Build. Mater., 135, 335-342. https://doi.org/10.1016/j.conbuildmat.2016.12.193.
  33. Turk, K., Caliskan, S. and Yazicioglu, S. (2007), "Capillary water absorption of self-compacting concrete under different curing conditions", Ind. J. Eng. Mater. Sci., 14(5), 365-372.
  34. Velandia, D.F., Lynsdale, C.J., Provis, J.L. and Ramirez, F. (2018), "Effect of mix design inputs, curing and compressive strength on the durability of $Na_2SO4$-activated high volume fly ash concretes", Cement Concrete Compos., 91, 11-20. https://doi.org/10.1016/j.cemconcomp.2018.03.028.
  35. Weisheit, S., Waldmann, D. and Greger, M. (2010), "Influence of environmental conditions for the rheological properties of SCC", K. Khayat D. Feys 6th International RILEM Symposium on Self-Compacting Concrete and 4th North American Conference on the Design and Use of SCC, Montreal, Canada.
  36. Yahiaoui, W., Kenai, S., Menadi, B. and Kadri, E.H. (2017), "Durability of self-compacted concrete containing slag in hot climate", Adv. Concrete Constr., 5(3), 271-288. : https://doi.org/10.12989/acc.2017.5.3.271.
  37. Zhao, H., Sun, W., Wu, X. and Gao, B. (2012), "Effect of initial water-curing period and curing condition on the properties of self-compacting concrete", Mater. Des., 35, 194-200. https://doi.org/10.1016/j.matdes.2011.09.053.