참고문헌
- Appurtenant Structures for Dams (Spillways and Outlet Works) Design Standard. B. o. R. U.S. Department of the Interior. (2014).
- Bieri, M. et al. (2010), ""Spillway discharge capacity upgrade at Gloriettes dam", Int. J. Hydropower Dams, 17, 88-93.
- Chadwick, A. et al. (2013), Hydraulics in civil and environmental engineering, Crc Press.
- Chen, S.H. et al. (2015), Hydraulic structures, Springer.
- Colombo, M. et al. (2016), "Existing concrete dams: loads definition and finite element models validation", Struct.Monit.Maint., 3(2), 129-144.
- Dams, I.C.O. L. (1984), World register of dams, International Commission on Large Dams.
- Davey, R. and Ho, K.V. (2007), "Seismic assessment and remediation of the aviemore dam spillway and sluice gates".
- De Michele, C. et al. (2005), "Bivariate statistical approach to check adequacy of dam spillway", J. Hydrol. Eng., 10(1), 50-57. https://doi.org/10.1061/(ASCE)1084-0699(2005)10:1(50)
- Falvey, H.T. (1990), Cavitation in chutes and spillways, US Department of the Interior, Bureau of Reclamation.
- Hanson, G. et al. (2005), "Physical modeling of overtopping erosion and breach formation of cohesive embankments", Transactions of the ASAE, 48(5), 1783-1794. https://doi.org/10.13031/2013.20012
- Heydari, M.M. et al. (2014), "Exact solution for transverse bending analysis of embedded laminated Mindlin plate", Struct. Eng. Mech., 49(5), 661-672. https://doi.org/10.12989/sem.2014.49.5.661
- Huynh, T.C. et al. (2017), "Advances and challenges in impedance-based structural health monitoring", Struct. Monit. Maint., 4(4), 301-329. https://doi.org/10.12989/SMM.2017.4.4.301
- Kumcu, S.Y. (2017), "Investigation of flow over spillway modeling and comparison between experimental data and CFD analysis", KSCE J. Civil Eng., 21(3), 994-1003. https://doi.org/10.1007/s12205-016-1257-z
- Li, S. et al. (2010), "Numerical modeling of probable maximum flood flowing through a system of spillways", KSCE, J. Hydraul. Eng., 137(1), 66-74. https://doi.org/10.1061/(asce)hy.1943-7900.0000279
- Moradi-Dastjerdi, R. (2016), "Wave propagation in functionally graded composite cylinders reinforced by aggregated carbon nanotube", Struct. Eng. Mech., 57(3), 441-456. https://doi.org/10.12989/sem.2016.57.3.441
- Nagarajaiah, S, et al. (2016), "Structural monitoring and identification of civil infrastructure in the United States", Struct.Monit. Maint., 3(1), 51-69.
- Rutschmann, P. et al. (1990), "Air entrainment by spillway aerators", J, Hydraulic Eng,, 116(6), 765-782. https://doi.org/10.1061/(ASCE)0733-9429(1990)116:6(765)
- Song, D. et al. (2015), "Numerical simulation of pressure relief in hard coal seam by water jet cutting", Geomech. Eng., 8(4), 495-510. https://doi.org/10.12989/gae.2015.8.4.495
- Sreedhar, B. et al. (2017), "Cavitation damage: Theory and measurements-A review", Wear, 372, 177-196. https://doi.org/10.1016/j.wear.2016.12.009
- Tanchev, L. (2014), Dams and appurtenant hydraulic structures, CRC Press.
- Volkart, P. et al. (2018), Aerators on spillways. Air Entrainment in Free-surface Flow, Routledge: 85-113.
- Xu, W. et al. (2015), "Experimental study on pressure and aeration characteristics in stepped chute flows", Science China Technological Sciences, 58(4), 720-726. https://doi.org/10.1007/s11431-015-5783-6
- Yu, H. et al. (2018), "Damage detection of subway tunnel lining through statistical pattern recognition", Struct.Monit. Maint., 5(2), 231-242.
- Zargar, M. et al. (2016), "Optimization of gated spillways operation for flood risk management in multi-reservoir systems", Nat. Hazards, 82(1), 299-320. https://doi.org/10.1007/s11069-016-2202-7